Degradação de forças dos elasticos intermaxilares ortodônticos sintéticos

This study aimed to evaluate the force degradation of synthetic elastics over time using dynamic biomechanical tests in order to find clinical parameters of what size of elastic and frequency of exchange should be used in orthodontic therapy. It was used 240 elastics of Dental Morelli, sizes 1/8", 3/16", 1/4 "and 5/16", medium force, divided in four groups. In each group was measured forces at different times, from immediate to 72 hours after immersion in water at 37°C and incubated stretched to 600% of its initial inner diameter. Tensile tests were performed on a universal testing machine EMIC DL2000 submerged in distilled water maintained at 37°C. Data were analyzed using SPSS version 16.0, by the Analysis of Variance (One-Way) with Tukey´s post test. There was a greater increase in pattern of force decay of immediate measurement until 24 hours in all sizes of synthetic elastics, from which it was observed a decrease in force progressively smaller, with the exception of 5/16´´ elastic with a maximum force decay occurred at 12h. It was concluded that: the elastic synthetic Dental Morelli suffered significant force degradation over time, with reduction of approximately 70% of the initial force during 24 hours of stretching, followed by a progressively smaller decrease; the amount of stretch for a ideal force in intermaxillary therapies depends on the distance between the points of attachment of elastic, being necessary to consult the tables to choose the size, force and frequency of replacement.

Modificação de forma e dimensões dos arcos superior e inferior obtidas em modelos de estudo após expansão rápida da maxila com o aparelho hyrax

The aim of an orthodontic treatment is the achievement of a balanced, esthetic and, most of all, stable, intra and inter arches relationship. A common problem observed in occlusion is posterior crossbite and atresic maxilla. This problem may be treated by slow expansion, rapid expansion or surgically assisted expansion. For the present study cast models of 14 children between 7 and 11 years old were evaluated. There were 7 male and 7 female subjects that presented posterior crossbite and needed rapid maxillary expansion. The Hyrax appliance performed the therapy for correction of this transversal alteration, which is a common possibility in the treatment of this malocclusion. It was observed that the distance between the upper first molars and upper cuspids increased significantly; the length of the upper arch decreased and its perimeter increased significantly. At the lower arch there were no dimensional changes.

Avaliação radiográficada fusão das corticias lateral e medial do ramo mandibular: estudo em mandíbulas secas

Purpose: to radiographically evaluate the distance between mandibular lingula and the exact spot where buccal and lingual cortical bone plates merge in the mandibular ramus. Materials and Methods: 54 dry mandibles, divided into 3 subgroups (SG1: dentate, SG2: partially dentate and SG3: edentulous) were used in this study. Lingula position was marked with a metallic sphere and radiographs were taken. The distance between mandibular notch and lingula (I/L) and the distance between mandibular lingula and cortical bone plates fusion (L/FC) were measured. Statistical analysis was applied to the values obtained. Results: mean values for L/FC were 8,18mm, 7,30mm and 8,98mm for SG1, SG2 e SG3 respectively. Moreover, mean values for I/L were 14,02mm, 13,90mm and 12,34mm for SG1, SG 2 and SG3 respectively. The results also showed that cortical bone plates fusion took place in half I/L distance in 28,57% of the mandibles in SG1, in 46,67% of the mandibles in SG2 and in 9,09% of the pieces in SG3. Conclusions: there were no statistically significant differences in the height where cortical bone plates took place in all 3 subgroups. In SG3, the correlation between the mean value for L/FC and the mean value for I/L suggests a reduction in bone density and bone mass, which can correlate to the evaluation of older mandibles in this subgroup.

Associação da raspagem com antibioticoterapia em um caso de periodontite agressiva generalizada

The treatment of aggressive periodontitis is a challenge to the clinician, therefore the search for effective treatment protocols of this disease is important. The aim of this case report was demonstrate the effectiveness of the combination of systemic antibiotics with non-surgical periodontal therapy in the treatment of generalized aggressive periodontitis. a 27-year-old patient (RCS), smoker for 11 years (10 cigarettes/day on average), with no systemic alteration, attended the periodontal clinic with a complaint abnormal dental position. After the clinical examination, the diagnosis of generalized aggressive periodontitis was defined. The non-surgical periodontal treatment was executed associated with administration of amoxicillin plus metronidazole for ten days. Clinical parameters (Clinical Attachment level, marginal gingival level, periodontal probing depth, bleeding on probing, plaque index and gingival index) and radiographic parameters (distance between the cemento-enamel junction and the bone crest) were evaluated before and after non-surgical periodontal treatment, after antibiotic therapy and three, six and 12 months after the treatment. After one year follow-up, the results showed improvement in clinical and radiographic parameters with stabilized and decreased tooth mobility and absence of tooth loss. It was concluded that the association of non-surgical periodontal therapy with the administration of amoxicillin/metronidazole was effective in the treatment of generalized aggressive periodontitis.

Estudo anatomico da posição do forame mandibular e da língula em mandíbulas secas

Purpose: The authors tried to verify the anatomic location of the mandibular foramen and língula in dry jaws regarding the anterior and posterior border of the mandible and the incisure, alveolar border and mandibular base, in order to correlate the data with the sagittal split ramus osteotomy. Methods: There were evaluated 44 mandibles (88 sides) from the Morphology Department of the Araraquara Dental School of the São Paulo University (UNESP). The distances measured were previously deter - mined according to the figures presented in this article and were done by the use of a sliding caliper (Brow & Sharpe Digit-Cal Plus), with the mandibles positioned over a Erickson table, and the distan - ces were always measured in millimeters. Results: The pre-determined points and distances founded were X=17,67; Y=14,35; W=20,96 and Z=21,89 for the mandibular foramen, and the relationship between this anatomical structure and the língula shows that the mandibular foramen is in average 5,82 mm below the língula. Conclusions: The authors conclude that the mandibular foramen is lightly posterior in comparison with the ramus mandibular center and that the língula is a very important anatomic landmark for the ramus surgeries as well the knowledge of the distance between it and the mandibular foramen entrance.

Influence of the gutta-percha taper and finger spreader on lateral consensation effectiveness

Introduction: Lateral condensation effectiveness may be influenced by the gutta-percha and finger spreader taper used during root canal obturation. Objective: To evaluate the penetration ability of finger spreader into simulated root canals prepared using MTwo rotary system and filled with different gutta-percha and finger spreader tapers. Material and methods: Resin blocks with curved root canals had the apical diameter enlarged up to #25.06 and distributed into groups (n = 6) according to the gutta-percha taper (#25.02, #25.04, and #25.06) and the finger spreader (#30 and #35 NiTi, and stainless steel B) used to perform cold lateral condensation. After applying a load of 1.5 Kg over the finger spreaders’ head, the distance between the finger spread tip and the apical limit of the root canal preparation were obtained. The data were submitted to Anova and Tukey-Krammer’s test, with 5% of significance. Results: The gutta-percha cones with 0.02 taper enabled higher finger spreader penetration when compared to 0.04 and 0.06 tapers (p < 0.05), which were similar between each other (p > 0.05), regardless of the type and diameter of the finger spreader used. When different finger spreaders were compared among themselves, stainless steel B showed higher penetration ability (p < 0.05). Conclusion: It was concluded that the stainless-steel finger spreaders showed superior penetration ability and gutta-percha with lower tapers enabled a more effective lateral condensation at the apical third.

Políticas educacionais e mídia no Brasil: apontamentos sobre o quadro atual

This paper describes some of the key political strategies focused on the relationship between the school and the media in the country. Stand out actions taken by the media in its relationship with the formal education, the proposals on the subject found in the Parâmetros Curriculares Nacionais (PCN), the guidelines found in documents on school management, and some of the concrete initiatives undertaken by the government agencies. The framework allows us to observe the distance between the initiatives managed within the school field (involving curriculum programs, programs management and the action of the government agencies linked to field of formal education) and external proposals outside that field.

A emergência do conceito da interculturalidade no ensino e aprendizagem de língua estrangeira

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Metacommunity organisation, spatial extent and dispersal in aquatic systems: patterns, processes and prospects

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Profile and crowding of currents in mesoscopic superconductors with an array of antidots

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Differentiation of Haemonchus placei from Haemonchus contortus by PCR and by morphometrics of adult parasites and third stage larvae

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Geometrical parameter analysis of a high-sensitivity fiber optic angular displacement sensor

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

A radiologic morphometric study of sellar, infrassellar and parasellar regions by magnetic resonance in adults

To evaluate variations of some anatomic structures of sellar and parasellar regions and their possible differences between genders and age groups. Magnetic resonance images (MRI) of 380 patients were performed to analyze the dimensions of the sphenoid sinus, pituitary gland, optic chiasm, intra-cavernous carotid distances, distance between columella nasal - sphenoid sinus; and columella nasal-pituitary gland. The patients age ranged between 20 and 80 years (mean age 48 years). The study included 235 females (mean age 53 years) and 145 males (mean age 40 years). The transverse length of the pituitary, the inter-carotid distance and the height of the pituitary were similar between genders and age groups. The width and height of the optic chiasm showed differences only between females of different ages. Males presented greater distances between nasal columella and sphenoid sinus. The most common type of pneumatization of the sphenoid sinus was the sellar, and depending on the age group, sphenoid sinus was larger in males than females. The anatomy of the Sellar and parasellar regions is complex and varies widely within the normal range. They are a small area, rich in anatomical details affecting multiple physiological systems in the body and, therefore, have great importance in several medical fields. A better understanding of these complex structures is essential in clinical diagnosis and treatment of disease.

Desempenho do RTK em rede sob efeito da cintilação ionosférica

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Variabilidade no andar com ultrapassagem de obstáculo de idosos com doença de Parkinson

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)