Effect of apparent viscosity on the pressure drop during fluidized bed drying of soursop pulp

Pressure drop and minimum fluidization velocity were experimentally studied in a vibro-fluidized bed of inert particles subjected to different vibration intensities during drying of soursop pulp. Maltodextrin was added to the pulp in order to prevent stickiness between particles and the consequent bed collapse. Pulps were initially concentrated, resulting in pastes with different soluble solids content, and a constant fraction of maltodextrin was guaranteed in the final pulp samples. The pulp theological behavior as affected by temperature and total soluble solids content, including maltodextrin, was evaluated and the effect of pulp apparent viscosity on pressure drop and minimum vibro-fluidization velocity were investigated. Two types of inert particles -3.6 mm glass beads and 3 mm Teflon cylinders (length and diameter) - were tested and, due to lower pressure drop presented by Teflon cylinders during operation of the dry vibro-fluidized bed, these particles were adopted for pulp drying process. Increasing pulp apparent viscosity caused a considerable increase in the vibro-fluidized bed pressure drop during pulp drying and, as a consequence resulted in a larger value of minimum vibro-fluidization velocity. on the other hand, the negative effect of increasing apparent viscosity could be attenuated by increasing the fluidized bed vibration intensity, which could prevent stickiness between particles. (c) 2006 Elsevier B.V. All rights reserved.

Effect of drying method on the sorption isotherms and isosteric heat of persimmon pulp powder

Moisture equilibrium data of persimmon pulp powders with 50% maltodextrin (dry basis) obtained with different drying methods were determined at 20, 30, 40 and 50 degrees C. The spray-dryer gave a dry product with a higher adsorption capacity than the other methods. The vacuum- and freeze-dried products had the same adsorption capacity. The highest isosteric heat of sorption was observed for powders produced by spray-drying. The isokinetic temperature (T(B)) calculated for persimmon pulp powder obtained by vacuum-, spray- and freeze-drying were 541.4 K, 616.3 K, 513.2 K, respectively. The sorption process was spontaneous and enthalpy controlled.

Evaluation of dental pulp repair using low level laser therapy (688 nm and 785 nm) morphologic study in capuchin monkeys

The aim of this study was to evaluate the hypothesis that low-level laser therapy (LLLT) 688 nm and 785 nm accelerate dentin barrier formation and repair process after traumatic pulp exposure. The sample consisted of 45 premolars of capuchin monkeys (Cebus apella) with pulp exposure Class V cavities. All premolars were treated with calcium hydroxide (Ca(OH)(2)), divided in groups of 15 teeth each, and analyzed on 7(th), 25(th), and 60(th) day. Group GI - only Ca(OH)(2), GIF- laser 688 nm, and GIII - laser 785 nm. Laser beam was used in single and punctual dose with the parameters: continuous, 688 nm and 785 nm wavelength, tip's area of 0.00785 cm(2), power 50 mW, application time 20 s, dose 255 J/cm(2), energy 2 J. Teeth were capped with Ca(OH)(2), Ca(OH)(2) cement and restored with amalgam. All groups presented pulp repair. on 25(th) day the thickness of the formed dentin barrier was different between the groups GI and GII (p < 0.05) and between groups GI and GIII (p < 0.01). on 60(th) day there was difference between GI and GIII (p < 0.01). It may be concluded that, LLLT 688 nm and 785 nm accelerated dentin barrier formation and consequently pulp repair process, with best results using infrared laser 785 nm. (c) 2009 by Astro Ltd. Published exclusively by WLLEY-VCH Verlag GmbH & Co. KGaA

Pectin lyase from Aspergillus giganteus: Comparative study of productivity of submerged fermentation on citrus pectin and orange waste

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Heat-killed Enterococcus faecalis Alters Nitric Oxide and CXCL12 Production but not CXCL8 and CCL3 Production by Cultured Human Dental Pulp Fibroblasts

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Use of fungal inocula and pumice for decomposing coffee pulp

A study of decomposition of coffee pulp (from Guatemala City, Guatemala) was carried out with several inocula. Fresh and pressed pulps were studied in field and laboratory experiments. Results showed that the best inoculum among the eight examined in the experiments was the fungus Trichoderma viride, the only one not isolated from the coffee pulp itself. This inoculum, together with pumice, accelerated the decomposition of coffee pulp at ambient temperature during a 45-day test period. © 1985.

Biocompatibility of an adhesive system applied to exposed human dental pulp

Human pulp tissue was directly capped with All Bond 2, or calcium hydroxide and evaluated 7, 30, or 60 days after the procedures. Histological analysis was performed to assess the inflammatory cell response, tissue disorganization, dentin bridging, and the presence of bacteria. At 7 days, with All Bond 2 capping, there was a large area of neutrophilic infiltrate underlying the pulp capping material, and the death of adjacent odontoblasts, was observed. However, with time, the neutrophilic reaction was replaced by fibroblastic proliferation with macrophages and giant cells surrounding globules of resin scattered in the coronal pulp tissue. The persistent inflammatory reaction and hyaline alteration of extracellular matrix inhibited complete pulp repair or dentin bridging. In contrast, at 7 days, the pulp tissue capped with calcium hydroxide exhibited odontoblast-like cells organized underneath coagulation necrosis. Pulp repair evolved into apparent complete dentin bridge formation at 60 days. All Bond 2 did not appear to allow any pulp repair and does not appear to be indicated for direct pulp capping of human teeth. Copyright © 1999 by The American Association of Endodontists.

Water sorption thermodynamic properties applied to persimmon skin and pulp

Moisture equilibrium data of persimmon skin and pulp were determined using the static gravimetric method. Adsorption and desorption isotherms were obtained in the range of 20-70°C, to water activities (a w) from 0.02 to 0.85. The application of the GAB model to the experimental results, using direct nonlinear regression analysis, provided a good agreement between experimental and calculated values. The net isosteric heat of sorption was estimated from equilibrium sorption data, using the Clausius-Clapeyron equation. Isosteric heats of sorption were found to increase with increasing temperature and could be well adjusted by an exponential relationship. The enthalpy-entropy compensation theory was applied to sorption isotherms and plots of ΔH versus ΔS for skin and pulp provided the isokinetic temperatures, indicating an enthalpy controlled sorption process. © 2000 Elsevier Science B.V.

Distribution of Xylella fastidiosa in citrus rootstocks and transmission of citrus variegated chlorosis between sweet orange plants through natural root grafts

To study translocation of Xylella fastidiosa to citrus rootstocks, budsticks from citrus variegated chlorosis (CVC)-affected cv. Pera sweet orange (Citrus sinenesis (L.) Osb.) were top grafted on 15 citrus rootstocks. Disease symptoms were conspicuous 3 months later on all 15 rootstocks tested. The presence of X. fastidiosa was confirmed by light microscopy, double-antibody sandwich enzyme-linked immunosorbent assays, and polymerase chain reaction in rootlets and main roots of CVC-symptomatic Pera sweet orange in 11 of the 15 rootstocks tested. These results suggest that bacterial translocation from the aerial plant parts to the root system occurs but is not essential for X. fastidiosa to induce symptoms in the aerial parts. Bacterial translocation to the roots was not correlated with CVC leaf-symptom severity in the Pera scion. To determine if CVC disease could be transmitted by natural root grafts, two matched seedlings of each of four sweet orange cultivars (Pera, Natal, Valencia, and Caipira) were transplanted into single pots. One seedling rootstock of each pair was inoculated by top grafting with a CVC-contaminated budstick while the other seedling rootstock was cut but not graft inoculated. Transmission of X. fastidiosa from an inoculated plant to a noninoculated plant sharing the same pot was observed in all four sweet orange cultivars tested. Transmission was confirmed by observation of natural roots grafts between the two plants, presence of X. fastidiosa in the root grafts, and disease development in the uninoculated plants. This is the first report of transmission of CVC disease through natural root grafts.

Aspects of IFP for citrus production in Brazil

Brazilian citriculture represents about 25% of the total world citrus production with an area of 851,518 ha and a total production of more than 17 million tons in 1996. Besides its importance to the brazilian economy, represented by more than 1 billion US $ by year from FCOJ exportation, the citriculture has problems related to low productivity, due to several cultural practices and management. The productivity would be improved by an IFP system. The main problems are related to soil, as poor conservation, use of poor drained soils and bad preparation for planting; diseases-canker, CVC, leprosis, Phytophtora gummosis and other fungus diseases; pests - mites, scales, nematodes and others; the use of disease free and improved scion and rootstocks propagative material is usual; cultural practices - as nutrition, irrigation, wind breaks, weed control, pruning, replant and others, as density planting could be improved. Some possible solutions will be discussed for improving the brazilian citrus productivity and quality by IFP, based on research made.

Susceptibility of tangerines to citrus variegated chlorosis

Citrus variegated chlorosis (CVC), a citrus disease first discovered in Brazil in 1987, is caused by the bacterium Xylella fastidiosa and transmitted by sharpshooters and budwood. Since the disease affects almost all sweet orange cultivars, it has become one of the most serious problems for Brazilian citriculture. To evaluate their resistance to CVC disease, fifteen tangerines or mandarins (C. reticulata Blanco) and their hybrids were grafted on Rangpur lime (C. limonia Osb.) and inoculated with CVC-contaminated Pera sweet orange (C. sinensis (L.) Osb.) by twig grafting in a greenhouse. Tangerines and their hybrids Wilking, Fortune, Sunki, Ellendale, Orlando tangelo, Nunes clementine, Nova, Sun Shu Sha Kat, Suenkat, and Batangas showed CVC leaf symptoms and gave positive results on enzyme-linked immunosorbent assay (ELISA) and polymerase chain reaction (PCR) (with specific primers for X. fastidiosa), indicating that they are susceptible to CVC. Although X. fastidiosa bacteria were detected by ELISA and PCR in inoculated plants of tangerines Cravo and Oneco, no CVC leaf symptoms were observed on these two cultivars, suggesting that they are tolerant to the disease. CVC leaf symptoms were not observed and X. fastidiosa was not detected in tangerine Dancy and mandarins Okitsu satsuma and Ponkan after inoculation, showing that they are resistant to the disease.

Evaluation of microsatellite markers in cultivars of sweet orange (Citrus sinensis [L.] Osbeck)

Sweet orange is considered a very important species in the citrus world market and presents wide morphological variability. However, its characterization at the molecular level by random amplified polymorphic DNA (RAPD) and isozyme markers is not appropriate. Microsatellite or simple sequence repeats (SSRs) have been suggested as ideal for studies in cultures of vegetative propagation and as value markers for mapping in several species. However, information on microsatellite polymorphism in citrus species is scarce. In this work, microsatellite markers (AG-repeats) were developed from an enrichment library of genomic DNA of sweet orange cv. Pera (Citrus sinensis [L.] Osbeck), and 31 cultivars of sweet orange were evaluated. Evaluation of 18 microsatellite primers did not permit differentiation of the varieties studied. New microsatellite primers are being evaluated with the aim of detecting polymorphisms among the cultivars and closely related species to be used in genetic mapping programs.

Adubação verde em Citrus: Influência na porosidade e retenção de água de um latossolo vermelho-escuro do noroeste do estado de São Paulo

The objective of this research was to study the porosity, bulk density and retention of water of an Oxisol, located in the Northwestern region of Sn̄o Paulo state, Brazil. The soil was cultivated with Citrus sp., to which green manure was applied between rows for three years. Each of six species of green manure crops (Crotalaria juncea L., Mucuna deeringiana Steph. & Bart., Canavalia ensiformis L. DC., Cajanus cajan L., Lablab purpureum L. and Ricinus communis L.) were seeded for three years (1995, 1996 and 1997) between Citrus rows, plus a treatment with a mix of all six species and a control (natural regrowth af vegetation). The experimental design was a randomized complete block design, with four replications for each of the eight treatments. Water retention, microporosity, macroporosity, total porosity and bulk density were analyzed in the beginning (1995) and end (1997) of the experiment, at three depth ranges (0-0.10; 0.10-0.20 and 0.20-0.40m). We concluded that there were statistically significant differences for bulk density, macroporosity, total porosity and retention of water among the different soil depth ranges; there were no significant differences among treatments though.

Healing process of dog dental pulp after pulpotomy and pulp covering with mineral trioxide aggregate or Portland cement.

Considering several reports about the similarity between the chemical compositions of the mineral trioxide aggregate (MTA) and Portland cement (PC), the subject of this investigation was to analyze the behavior of dog dental pulp after pulpotomy and direct pulp protection with these materials. After pulpotomy, the pulp stumps of 26 roots of dog teeth were protected with MTA or PC. Sixty days after treatment, the animal was sacrificed and the specimens removed and prepared for histomorphological analysis. There was a complete tubular hard tissue bridge in almost all specimens. In conclusion, MTA and PC show similar comparative results when used in direct pulp protection after pulpotomy.