Sensibilidade de stenocarpella macrospora a fungicidas

The application of fungicides in the aerial organs is control strategy to macrospora spot caused by fungus Stenocarpella macrospora. The objective of this study was to determine the sensitivity of S. macrospora to fungicides by inhibition of mycelial growth (MG) and conidial germination (CG). It was eval uated 12 fungicides belonging to the chemical groups of the benzimidazoles, triazoles and strobilurins, six concentrations and two isolates of the fungus (SC and MT). The fungicides were diluted in sterile distilled water and added to the culture medium of potato dextrose agar (mycelium) and water-agar (spore) after sterilization. The percentage of inhibition of MC and CG was calculed in comparison with control, estimating of 50% inhibitory concentration (IC50). The fungicides tested were effective in inhibiting the MC. The IC50 was less than 1 ppm for all fungicides. There was no difference between isolates. The inhibition of CG had higher fungitoxicity strobilurins, and the IC50 was between 0.0035 and 0.03 ppm, and the isolated SC showed the higher sensitivity to the fungicides. The IC50 values obtained for fungicides and specific S. macrospora will be useful in monitoring the sensitivity of the fungus, especially in regions with intense demand for fungicides in corn.

Giant Chemo-Resistance of SnO disk-like structures

Single crystalline SnO micro-disks, synthesized by a carbothermal reduction process, exhibited a nearly 1000-fold increase in resistance upon exposure to 100 ppm of NO2 without addition of catalysts or dopants nor the existence of nano-sized dimensions. Moreover, the SnO displayed a greater than 100-fold selectivity to NO2 over potential interferents including CO, H2 and CH4. The high sensor signal and exceptional selectivity for this novel sensor material are attributed to the existence of a high density of active lone pair electrons on the exposed (0 0 1) planes of the single crystalline SnO disks. This, thereby, identifies new means, not utilizing nano-dimensions, to achieve high gas sensitivity. © 2013 Elsevier B.V. All rights reserved.

Sodium fluoride effect on erosion-abrasion under hyposalivatory simulating conditions

Objectives: To investigate the effect of fluoride (0, 275 and 1250 ppm F; NaF) in combination with normal and low salivary flow rates on enamel surface loss and fluoride uptake using an erosion-remineralization-abrasion cycling model. Design: Enamel specimens were randomly assigned to 6 experimental groups (n = 8). Specimens were individually placed in custom made devices, creating a sealed chamber on the enamel surface, connected to a peristaltic pump. Citric acid was injected into the chamber for 2 min followed by artificial saliva at 0.5 (normal flow) or 0.05 (low flow) ml/min, for 60 min. This cycle was repeated 4×/day, for 5 days. Toothbrushing with abrasive suspensions containing fluoride was performed for 2 min (15 s of actual brushing) 2×/day. Surface loss was measured by optical profilometry. KOH-soluble fluoride and enamel fluoride uptake were determined after the cycling phase. Data were analysed by two-way ANOVA. Results: No significant interactions between fluoride concentration and salivary flow were observed for any tested variable. Low caused more surface loss than normal flow rate (p < 0.01). At both flow rates, surface loss for 0 was higher than for 275, which did not differ from 1250 ppm F. KOH-soluble and structurally-bound enamel fluoride uptake were significantly different between fluoride concentrations with 1250 > 275 > 0 ppm F (p < 0.01). Conclusions: Sodium fluoride reduced enamel erosion/abrasion, although no additional protection was provided by the higher concentration. Higher erosion progression was observed in low salivary flow rates. Fluoride was not able to compensate for the differences in surface loss between flow rates. © 2013 Elsevier Ltd. All rights reserved.

Synthesis and characterization of lead zirconate titanate (PZT) obtained by two chemical methods

Lead zirconate titanate (PZT) was synthesized at the ratio of Zr/Ti=52/48 using two synthesis methods: the polymeric precursor method (PPM) and the microwave-assisted hydrothermal method (MAHM). The synthesized materials were characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), particle size distribution by sedimentation, hysteresis measurements and photoluminescence (PL). The results showed that PZT powders are composed of tetragonal and rhombohedral phases. Different particle sizes and morphologies were obtained depending upon the synthesis method. From the hysteresis loop verified that PZT powders synthesized by the PPM have a typical loop of ferroelectric material and are more influenced by spatial charges while particles synthesized by the MAHM have a hysteresis loop similar to paraelectric material and are less influenced by spatial charges. Both samples showed PL behavior in the green region (525 nm) whereas the sample synthesized by the PPM showed higher intensity in spectra. © 2013 Elsevier Ltd and Techna Group S.r.l.

Dose-response of diuron [3-(3,4-dichlorophenyl)-1,1-dimethylurea] in the urothelial mucosa of Wistar rats

Diuron [3-(3,4-dichlorophenyl)-1,1-dimethylurea] is a herbicide that induced urothelial tumors in the urinary bladder of Wistar rats fed 2500. ppm during a long-term study. The currently suggested non-genotoxic mode of action (MOA) of diuron encompasses in succession urothelial necrosis induced by direct cytotoxicity, regenerative cell proliferation and sustained urothelial hyperplasia that increases the likelihood of neoplasia development. This study evaluated the dose-response profile of urothelial histological and ultrastructural lesions induced by diuron. Sixty male Wistar rats were fed ad libitum diuron mixed in the diet at 0, 60, 125, 500, 1250, or 2500. ppm for 20 weeks. The incidences of urothelial simple hyperplasia and the cell proliferation index were significantly increased in the diuron-fed 1250 and 2500. ppm groups. By scanning electron microscopy, the incidences and severity of lesions were significantly increased in the 500 and 1250. ppm groups. The incidences of urothelial hyperplasia in the kidney pelvis were significantly increased in the 500, 1250 and 2500. ppm groups. The present study documents the dose-response influence of diuron on the rat urothelium, with a no observed effect level (NOEL) at 125. ppm; 1250. ppm was as effective as 2500. ppm at inducing urothelial lesions. © 2013 Elsevier B.V.

Effect of sodium trimetaphosphate on hydroxyapatite solubility: An in vitro study

This study evaluated the effect of different concentrations of sodium trimetaphosphate (TMP) with and without fluoride (F) on the concentration of calcium (Ca), phosphorus (P) and F in hydroxyapatite (HA). Synthetic HA powder (0.15 g) was suspended (n=6) in solutions (75 mL) of TMP at 0%, 0.1%, 0.2%, 0.4%, 0.6%, 0.8%, 1.0%, 2.0%, 4.0%, 6.0%, 8.0% and 10% concentrations in the presence and absence of 100 ppm F and subjected to a pH-cycling process. The precipitates were filtrated, dried at 70° C for 24 h and ground onto a fine powder. The concentrations of F (KOH (CaF2) and HCl (FA) soluble), Ca (Arsenazo III), and P (molybdate method) in HA were determined. The Ca P, and Ca/P ratio data were subjected to Tukey's test and the F data were subjected to Student-Newman-Keuls test (p<0.05). The addition of TMP to the samples reduced F deposition to 98% (p<0.001). The groups containing 100 ppm F and 0.4% or 0.6% TMP exhibited a higher Ca concentration than the group containing only 100 ppm F (p<0.05). Furthermore, the HA treated with 0.2% and 0.4% TMP and 100 ppm F showed a higher Ca/P ratio than the other groups (p<0.001). In conclusion, TMP at 0.2%, 0.4% and 0.6% concentrations combined with F seemed to be able to precipitate HA with low solubility. However, especially at high concentrations, TMP interferes with F deposition on HA.

Influence of the preparation method and the support on H2O 2electrogeneration using cerium oxide nanoparticles

This work describes the influence of the preparation method and the carbon support using a low contentof cerium oxide nanoparticles (CeO2/C 4%) on H2O2electrogeneration via the oxygen reduction reac-tion (ORR). For this purpose, the polymeric precursor (PPM) and sol-gel (SGM) methods with Vulcan XC72R (V) and Printex L6 (P) supports were employed. The materials were characterized by X-ray diffrac-tion (XRD), X-ray photoelectron spectroscopy (XPS) and transmission electron microscopy (TEM). TheXRD analysis identified two phases comprising CeO2and CeO 2-x. The smallest mean crystallite size wasexhibited for the 4% CeO2/C PPM P material, which was estimated using the Debye-Scherrer equation tobe 6 nm and 4 nm for the CeO2and the CeO 2-xphases, respectively, and was determined by TEM to be5.9 nm. XPS analysis was utilized to compare the oxygen content of the 4% CeO2/C PPM P to Printex L6.The electrochemical analysis was accomplished using a rotating ring-disk electrode. The results showedthat the 4% CeO2/C specimen, prepared by PPM and supported on Printex L6, was the best electrocatalystfor H2O2production in 1 mol L -1NaOH. This material showed the highest ring current, producing 88%H2O2and transferring 2.2 electrons per O 2molecule via the ORR at the lowest onset potential. Addition-ally, the ring-current of the 4% CeO2/C PPM P material was higher than that of Vulcan XC 72R and PrintexL6, the reference materials for H2O 2production, indicating the highest electrocatalytic activity for the 4%CeO2/C PPM P material. © 2013 Elsevier Ltd. All rights reserved.

Low tungsten content of nanostructured material supported on carbon for the degradation of phenol

A comparative study using different mass proportions of WO3/C (1%, 5%, 10% and 15%) for H2O2 electrogeneration and subsequent phenol degradation was performed. To include the influence of the carbon substrate and the preparation methods, all synthesis parameters were evaluated. The WO3/C materials were prepared by a modified polymeric precursor method (PPM) and the sol-gel method (SGM) on Vulcan XC 72R and Printex L6 carbon supports, verifying the most efficient metal/carbon proportion. The materials were physically characterized by X-ray diffraction (XRD) and by X-ray photoelectron spectroscopy (XPS) techniques. The XRD and the XPS techniques identified just one phase containing WO3 and elevated oxygen concentration on carbon with the presence of WO3. The oxygen reduction reaction (ORR), studied by the rotating ring-disk electrode technique, showed that WO3/C material with the lowest tungsten content (1% WO3/C), supported on Vulcan XC 72R and prepared by SGM, was the most promising electrocatalyst for H2O2 electrogeneration. This material was then analyzed using a gas diffusion electrode (GDE) and 585mgL-1 of H2O2 was produced in acid media. This GDE was employed as a working electrode in an electrochemical cell to promote phenol degradation by an advanced oxidative process. The most efficient method applied was the photo-electro-Fenton; this method allowed for 65% degradation and 11% mineralization of phenol during a 2-h period. Following 12h of exhaustive electrolysis using the photo-electro-Fenton method, the total degradation of phenol was observed after 4h and the mineralization of phenol approached 75% after 12h. © 2013 Elsevier B.V.

Effect of forced-molting methods and rearing temperatures on the performance and organ biometrics of laying hens

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Avaliação qualitativa e quantitativa na deposição de calda de pulverização em quatro espécies do gênero commelina

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Efeito de pontas e volumes de aplicação sobre os depósitos da pulverização em plantas de feijoeiro, Bidens pilosa L. e Brachiaria plantaginea (Link) Hitchc

Pós-graduação em Agronomia (Agricultura) - FCA

Tratamento térmico na manutenção da qualidade de lichias armazenadas sob refrigeração

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Efeito do tocoferol no desempenho e na estabilidade lipidica da tilápia nilotica (Oreochromis niloticus)

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Retenção do cátion do sulfato de cobre nos compartimentos biótico e abiótico de mesocosmos com sistema de fluxo contínuo de água

Pós-graduação em Aquicultura - FCAV

Alterações histológicas no intestino de fêmeas de carrapatos Rhipicephalus sanguineus (Latreille, 1806) (Acari: Ixodidae) expostas a diferentes concentrações de selamectina

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)