Differential seed germination of a keystone palm (Euterpe edulis) dispersed by avian frugivores

The effectiveness of seed dispersal by vertebrates has been analysed by examining both quantitative and qualitative components (Jordano & Schupp 2000, Schupp et al. 2010). While the quantitative component is relatively easily assessed in the field (e.g. visitation rate, number of fruits eaten per visit), the qualitative component (e.g. fate of dispersed seeds, seed treatment in the digestive system of the disperser) is rarely studied under natural conditions, because it is difficult to measure the effects on seeds once ingested by the dispersers (Cortes et al. 2009). © Cambridge University Press 2012.

A comparison between neutron-fluence measurements using metal-activation monitors and standard glasses calibrated via thin uranium-fission monitors and via ηq method

The two fundamental approaches to fission-track dating involve either an explicit determination of the thermal neutron fluence (φ-method) or a calibration against age standards (ζ-method). The neutron fluence measurements are carried out with metal-activation monitors or with uranium-fission monitors, co-irradiated with the samples. Uranium-fission monitors consist of either a thin mono-atomic) film, or a thick fission source (standard uranium glass) irradiated against a muscovite external track detector. In this work, different techniques for performing neutron-fluence measurements were compared: based on thin-film calibration, based on thick-source calibration, and based on gamma spectrometry of co-irradiated metal monitors (Au, Co). The results suggest that more experiments are needed to make all calibrations consistent, including new measurements of the length of etched induced tracks in mica. Also the standard glass calibration carried out with thin films should be confirmed with a greater number of calibrating irradiations. © 2013 Elsevier Ltd. All rights reserved.

Photodetection with gate-controlled lateral BJTs from standard CMOS technology

The silicon-based gate-controlled lateral bipolar junction transistor (BJT) is a controllable four-terminal photodetector with very high responsivity at low-light intensities. It is a hybrid device composed of a MOSFET, a lateral BJT, and a vertical BJT. Using sufficient gate bias to operate the MOS transistor in inversion mode, the photodetector allows for increasing the photocurrent gain by 106 at low light intensities when the base-emitter voltage is smaller than 0.4 V, and BJT is off. Two operation modes, with constant voltage bias between gate and emitter/source terminals and between gate and base/body terminals, allow for tuning the photoresponse from sublinear to slightly above linear, satisfying the application requirements for wide dynamic range, high-contrast, or linear imaging. MOSFETs from a standard 0.18-μm triple-well complementary-metal oxide semiconductor technology with a width to length ratio of 8 μm /2 μm and a total area of ∼ 500μm2 are used. When using this area, the responsivities are 16-20 kA/W. © 2001-2012 IEEE.

Multiple higgs and vector boson production beyond the standard model

If the electroweak symmetry breaking is originated from a strongly coupled sector, as for instance in composite Higgs models, the Higgs boson couplings can deviate from their Standard Model values. In such cases, at sufficiently high energies there could occur an onset of multiple Higgs boson and longitudinally polarised electroweak gauge boson (V L ) production. We study the sensitivity to anomalous Higgs couplings in inelastic processes with 3 and 4 particles (either Higgs bosons or V L 's) in the final state. We show that, due to the more severe cancellations in the corresponding amplitudes as compared to the usual 2 → 2 processes, large enhancements with respect to the Standard Model can arise even for small modifications of the Higgs couplings. In particular, we find that triple Higgs production provides the best multiparticle channel to look for these deviations. We briefly explore the consequences of multiparticle production at the LHC. © 2013 SISSA.

Search for a standard-model-like Higgs boson with a mass in the range 145 to 1000 GeV at the LHC

A search for a standard-model-like Higgs boson in the H→WW and H→ZZ decay channels is reported, for Higgs boson masses in the range 145standard-model-like Higgs boson in the range 145

Search for the standard model Higgs boson produced in association with a top-quark pair in pp collisions at the LHC

A search for the standard model Higgs boson produced in association with a top-quark pair is presented using data samples corresponding to an integrated luminosity of 5.0 fb-1 (5.1 fb-1) collected in pp collisions at the center-of-mass energy of 7 TeV (8 TeV). Events are considered where the top-quark pair decays to either one lepton+jets (tt̄ → ℓvqq̄bb̄) or dileptons (tt̄ → ℓ+vl- rfvn1̄bb̄), ℓ being an electron or a muon. The search is optimized for the decay mode H → bb̄. The largest background to the tt̄H signal is top-quark pair production with additional jets. Artificial neural networks are used to discriminate between signal and background events. Combining the results from the 7 TeV and 8 TeV samples, the observed (expected) limit on the cross section for Higgs boson production in association with top-quark pairs for a Higgs boson mass of 125 GeV is 5.8 (5.2) times the standard model expectation. [Figure not available: see fulltext.] © 2013 Cern for the benefit of the CMS collaboration.

Search for physics beyond the standard model in events with τ leptons, jets, and large transverse momentum imbalance in pp collisions at √s = 7 TeV

A search for physics beyond the standard model is performed with events having one or more hadronically decaying τ leptons, highly energetic jets, and large transverse momentum imbalance. The data sample corresponds to an integrated luminosity of 4.98 fb-1 of proton-proton collisions at √ = 7 TeV collected with the CMS detector at the LHC in 2011. The number of observed events is consistent with predictions for standard model processes. Lower limits on the mass of the gluino in supersymmetric models are determined. © 2013 CERN for the benefit of the CMS collaboration.

Morphology and initial growth in the germination of dictyosperma album (bory) h. wendl. & drude ex scheffer (Arecaceae) seeds

Dictyosperma album, commonly known as Princess Palm, due to its graceful appearance and its ability to withstand strong hurricane force winds is largely used in landscaping areas. The aim of this work was to describe the diaspores (seeds with the stuck endocarp) morphology and the stages of the D. album germination process. Therefore we concluded that the species germination is of the tubular remote type and begins with the opening of a circular operculum in the fruit endocarp, through which emerges a bulbous and hollow structure, named cotyledonal petiole or embryophore. With the embryo growth, the endosperm is being gradually consumed. The embryo grows approximately up to 10 cm, when the dilation begins in its extremity. Starting from this extensive area, it begins the growth of the primary root and the opening of a longitudinal rift, through which emerges the aerial part that is composed by two sheaths that cover the first juvenile leaf. In this phase, the emergence of secondary roots is observed. The first leaves are simple and lance-shaped.

Temperature and scarification on seeds germination of copernicia prunifera (Mill) H.E. Moore (Arecaceae)

Copernicia prunifera, known as carnauba, is native to Brazil and presents great potential to be used in gardens and cultivation in pot. Palms species, with relatively few exceptions, can only be propagated by seeds; even so, there are no reports in the literature about the germination of this palm seeds. Several species of the Arecaceae family present seed physical dormancy in varying degrees, demanding treatments to improve germination. The objective of this work was to study the effects of temperature and mechanical scarification on seed germination of C. prunifera. The experimental design was entirely randomized in a factorial arrangement 6 x 2 (six conditions of temperature with or without mechanical scarification) with 4 replications and 25 seeds each. In accordance with the treatment, lateral scarifications were made on the seeds until appearance of the endosperm. Seeds were sown in moist fine vermiculite. Germination (%) and germination rate (GR) were evaluated. Germination data were arcsine (x/100)1/2 transformed before analysis of variance and germination rate data were not transformed. The means of the resulting values were then compared by the Scott-Knott test at 1% confidence level. It was concluded that the biggest germination percentage were obtained at alternated temperature of 25-35°C (92%) and at constant temperature of 25°C (87%). Seeds germinated faster at alternated temperature of 25- 35°C. Germination percentage was similar for the scarified and non-scarified seeds; however, scarified seeds germinated faster.

Seed germination of two Syagrus species native to Brazil

Palm species native to Brazil such as Syagrus picrophylla and S. schizophylla have great ornamental value and for this reason are much demanded for use in landscape. Its propagation is by seeds and often presents considerable problems to nursery managers because their seed has a hard and impermeable shell. Temperature is one of the factors that influence the seed germination process; however, the information for these species is scarce. Thus, this work aimed to study the effects of temperature regimes on the germination of S. picrophylla and S. schizophylla seeds and develop some recommendations in which temperature will obtain high rates of seed germination. The experimental design was entirely randomized with six temperatures and four replications of 25 seeds for each species. Germination and germination rate were evaluated. Higher and faster germination of S. picrophylla and S. schizophylla seeds were verified at constant temperature of 30°C and 35°C; and alternated temperature at 25-35°C.

Effect of temperature on seed germination of ornamental herbaceous perennials

Antirrhinum majus L. and Senecio douglasii DC. are herbaceous perennial ornamental plants used in landscaping. The multiplication of these plants is by seed; however, there are still doubts about the temperature that can provide higher rates and speed of germination. Thus the aim was to study the effect of temperature on seed germination of A. majus and S. douglasii. The study was conducted separately for each species. The experimental design was entirely randomized with six temperature conditions (temperature controlled constant of 20, 25, 30, 35°C and alternating temperatures of 20-30 and 25-35°C with a photoperiod of 12 hours) with four replications of 100 seeds each. Total germination percentage and germination rate were determined. The means were compared by Tukey test at 5%. For A majus the highest germination percentage was observed at 20°C that did not differ statistically from other temperatures. The highest germination rate was obtained at the temperature of 20 and 25°C. For S. douglasii seeds it was observed that the highest germination percentage and germination rate occurred at 20°C. The lower temperature showed the better percentage and germination rate for these species.

Eco-physiological aspects of melaleuca seed germination

The invasive behavior of melaleuca (Melaleuca quinquenervia) plants in wetlands is due to its aggressive regeneration strategy, which is based on its seeds germination performance. Understanding of the eco-physiological aspects of the seed germination in melaleuca plants may significantly contribute for the development of management strategies. The objective of this research was to learn how the germination of M. quinquenervia seeds are affected by light and temperature. Melaleuca seeds were placed on filter paper moistened with 12 ml of distilled water at temperatures between 10 and 45°C. Germination was evaluated in dark and light conditions. Seed germination, first count of seed germination (seven days), germination speed index and germination mean time were determined up to 40 days after seeding, when germination had ceased in most of the treatments. After that period, the seeds were transferred to conditions of 30°C and light, which was found to be ideal in the previous phase. Seed germination was daily evaluated up to 63 days when it was again observed no longer to occur. The treatment repetitions were distributed in the growth-chamber according to a completely randomized design in a factorial scheme (eight temperatures x two light conditions) and four repetitions. The data were submitted to analysis of variance with the F test and the means were adjusted to polynomial and non linear regression models. The highest seed germination performance was observed to take place under conditions of 27.3°C with light. The temperatures of 35 and 40°C in the dark induced thermal inhibition of seed germination. The temperature of 45°C was lethal to the seeds.

Evaluation of sample preparation procedures and krypton as an interference standard probe for arsenic speciation by HPLC-ICP-QMS

Different conditions of extraction using water, a methanol-water mixture and nitric acid solutions were evaluated for speciation of As(iii), As(v), DMA and MMA in plant samples that previously received As(v) after being sown and emergence was investigated. Microwave-assisted extraction (MAE) using diluted nitric acid solutions was also performed for arsenic extraction from chicken feed samples. The separation and determination of arsenic species were performed using HPLC-ICP-MS. The interference standard method (IFS) using 83Kr+ as the IFS probe was employed to minimize spectral interferences caused by polyatomic species, such as 40Ar 35Cl+. The extraction procedures tested presented adequate extraction efficiencies (90%), and the four arsenic species evaluated were found in plant samples. Extractions with diluted nitric acid solution at 90 °C were the most efficient strategy, with quantitative recoveries for all four As species in plant tissues. On the other hand, the methanol-water mixture was the solvent with the lowest extraction efficiency (50-60%). For chicken feed samples, MAE at 100 °C for 30 min resulted in an extraction efficiency of 97% and only As(v) was found, without any species interconversion. The IFS method contributed to improving precision and limits of detection and quantification for all tested extraction procedures. Significant improvements on accuracy were obtained by applying the IFS method and recoveries between 77 and 94%, and 82 and 93% were obtained for plant extracts and chicken feed samples, respectively. This journal is © 2013 The Royal Society of Chemistry.

Otimização de protocolos de germinação in vitro de pinhão-manso (Jatropha curcas L.)

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Produtos alternativos com atividade fungitóxica sobre patógenos da videira para quebra da dormência de gemas

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)