Inhibition of tooth erosion by milk containing different fluoride concentrations: An in vitro study

Objectives: This in vitro study assessed the effect of milk containing different fluoride concentrations on tooth erosion.Methods: Bovine enamel and root dentine specimens were treated with: (1) bovine whole milk with 0 ppmF; (2) 2.5 ppm F; (3) 5 ppmF;(4) 10 ppmF (all after erosion); (5) whole milk with 0 ppm F (before erosion); (6) NaF (0.05% F, positive control, after erosion) or (7) 0.9% NaCl (negative control, after erosion). The specimens were submitted to pH cycles (4 x 90 s in soft drink) and treatments for 5 days. The specimens were immersed in the treatment solutions for 1 min(only at the first cycle each day) with further exposition to 1: 1 milk: saliva slurry for 10 min. The tooth loss was measured using a contact profilometer and statistically analysed (p < 0.05).Results: Rinsing with milk before erosive challenge significantly reduced tooth loss compared to negative control (67% and 24% reduction in dentine and enamel loss, respectively) and to milk after erosive challenge, only for dentine. The addition of fluoride to milk also reduced tooth loss compared to negative control, but with no significant differences among fluoride concentrations for enamel and dentine (mu m), respectively: 0 ppm (3.63 +/- 0.04 and 2.51 +/- 0.53), 2.5 ppm F (2.86 +/- 0.42 and 1.96 +/- 0.47), 5 ppm F (2.81 +/- 0.27 and 1.77 +/- 0.44), 10 ppm F (2.03 +/- 0.49 and 1.68 +/- 0.59). There was a negative and significant correlation between [F] and the tooth loss.Conclusions: Daily rinse with milk containing F is able to reduce both enamel and dentine erosion in vitro.Clinical significance: Since the prevalence of dental erosion is steadily increasing, rinse with milk or its derivate might be an important strategy to reduce the progression of tooth erosion. (C) 2013 Elsevier Ltd. All rights reserved.

The effect of chronic treatment with fluoride on salivary activity, tooth, and bone in spontaneously hypertensive rats (SHR)

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Clinical Trial Evaluating Color Change and Tooth Sensitivity Throughout and Following In-office Bleaching

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Effective tooth-bleaching protocols capable of reducing H2O2 diffusion through enamel and dentine

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

18-Year Follow-up of Dens Invaginatus: Retrograde Endodontic Treatment

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Tooth Discoloration Induced by Endodontic Phenothiazine Dyes in Photodynamic Therapy

Objective: This study sought to assess if discoloration of tooth structures occurs after photodynamic therapy (PDT) and to determine the efficacy of a protocol to remove the photosensitizers. Background data: PDT has been used in root canal treatment to enhance cleaning and disinfection of the root canal system. PDT uses a low power laser in association with a dye as a photosensitizer. Photosensitizers can induce staining of the dental structures, resulting in an unaesthetic appearance. Methods: Forty teeth were randomly divided into four groups according to the photosensitizer used and pre-irradiation time: 0.01% methylene blue for 5 min (MB5); 0.01% methylene blue for 10 min (MB 10); 0.01% toluidine blue for 5 min (TB5); and 0.01% toluidine blue for 10 min (TB 10). Specimens were irradiated with a 660 nm diode laser with a 300 mu m diameter optical fiber, at 40 mW power setting for 3 min. Immediately after, the photosensitizers were removed with Endo-PTC cream +2.5% sodium hypochlorite (NaOCl). The shade was measured by a Vita Easyshade spectrophotometer based on the CIELAB color system (L*a*b* values) at three different experimental times: before PDT (T0), immediately after PDT (T1), and after removal of the photosensitizer (T2). Results: The results showed a decrease in the averages of the L*a*b* coordinate values after PDT (T1) in all the groups, when compared with the number at T0, with a significant statistical difference in group MB10. After photosensitizer removal (T2), all the values of the coordinates increased with significant statistical differences (p < 0.05) between T1 and T2 in L* and a*. Conclusions: It can be concluded that both methylene blue and toluidine blue dyes cause tooth discoloration, and that Endo-PTC cream associated with 2.5% NaOCl effectively remove these dyes, regardless of the pre-irradiation time used for PDT.

Proteins, Pathogens, and Failure at the Composite-Tooth Interface

In the United States, composites accounted for nearly 70% of the 173.2 million composite and amalgam restorations placed in 2006 (Kingman et al., 2012), and it is likely that the use of composite will continue to increase as dentists phase out dental amalgam. This trend is not, however, without consequences. The failure rate of composite restorations is double that of amalgam (Ferracane, 2013). Composite restorations accumulate more biofilm, experience more secondary decay, and require more frequent replacement. In vivo biodegradation of the adhesive bond at the composite-tooth interface is a major contributor to the cascade of events leading to restoration failure. Binding by proteins, particularly gp340, from the salivary pellicle leads to biofilm attachment, which accelerates degradation of the interfacial bond and demineralization of the tooth by recruiting the pioneer bacterium Streptococcus mutans to the surface. Bacterial production of lactic acid lowers the pH of the oral microenvironment, erodes hydroxyapatite in enamel and dentin, and promotes hydrolysis of the adhesive. Secreted esterases further hydrolyze the adhesive polymer, exposing the soft underlying collagenous dentinal matrix and allowing further infiltration by the pathogenic biofilm. Manifold approaches are being pursued to increase the longevity of composite dental restorations based on the major contributing factors responsible for degradation. The key material and biological components and the interactions involved in the destructive processes, including recent advances in understanding the structural and molecular basis of biofilm recruitment, are described in this review. Innovative strategies to mitigate these pathogenic effects and slow deterioration are discussed.

Evaluation of tensile tetention of Y-TZP crowns after long-term aging: Effect of the core substrate and crown surface conditioning

This study evaluated the effect of the core substrate type (dentin and composite resin) on the retention of crowns made of yttrium oxide stabilized tetragonal zirconia polycrystal (Y-TZP), submitted to three inner surface conditionings. For this purpose, 72 freshly extracted molars were embedded in acrylic resin, perpendicular to the long axis, and prepared for full crowns: 36 specimens had crown preparations in dentin; the remaining 36 teeth had the crowns removed, and crown preparations were reconstructed with composite resin plus fiber posts with dimensions identical to the prepared dentin. The preparations were impressed using addition silicone, and 72 Y-TZP copings for the tensile test were produced. Cementation was performed with a dual-cured cement containing phosphate monomers. For cementation, the crown preparation (dentin or resin) was conditioned with the adhesive system, and the ceramic was subjected to one of three surface treatments: isopropyl alcohol, tribochemical silica coating, or thin low-fusing glassy porcelain layer application plus silanization. After 24 hours, all specimens were submitted to thermocycling (6000 cycles) and placed in a special tensile testing device in a universal testing machine to determine failure loads. The failure modes of all samples were analyzed under a stereomicroscope. Two-way analysis of variance showed that the surface treatment and substrate type (alpha=0.05) affected the tensile retention results. The dentin substrate presented the highest tensile retention values, regardless of the surface treatment. When the substrate was resin, the tribochemical silica coating and low-fusing glaze application plus silanization groups showed the higher retention values.

Análise da qualidade de vida de pacientes com a doença de Charcot-Marie-Tooth tipo 1A

A doença de Charcot-Marie-Tooth (CMT) é a mais freqüente das neuropatias hereditárias, mas a sua história natural é pouco conhecida. Apesar da maioria dos pacientes apresentarem uma evolução com características mais “benignas”, é associado à doença com um comprometimento funcional, o que pode ser acompanhado de limitações e incapacitações. O presente estudo teve como objetivo avaliar a qualidade de vida de pacientes afetados pela CMT1A. Considerando que a qualidade de vida pode sofrer influência de variáveis sócio-culturais, um estudo neste contexto mostra-se oportuno. Nenhum estudo de nosso conhecimento realizou tal avaliação no contexto brasileiro. Fizeram parte deste estudo pacientes com CMT decorrente da duplicação 17p11.2-p12 (CMT1A) que foram avaliados quanto ao comprometimento funcional por meio da aplicação do SF-36. Esse questionário é utilizado internacionalmente para aferir a qualidade de vida dos indivíduos. Os resultados obtidos foram submetidos à análise estatística. Como resultados não se observaram associações entre o gênero e os domínios avaliados para a qualidade de vida. Os dados obtidos revelaram que a qualidade de vida dos pacientes com CMT1A se mostrou comprometida principalmente quanto aos seus Aspectos Sociais (p = 0,02) e Aspectos emocionais (p = 0,04). Adicionalmente, houve uma tendência ao comprometimento da Capacidade Funcional (p = 0,08), sendo que os outros índices de avaliação de comprometimento físico se mostraram preservados. A presença ou ausência de ocupação parece influenciar os Aspectos Sociais apresentando uma tendência de diferença significativa (p = 0,07), possuindo o grupo com ocupação valores superiores. Apesar da CMT1A apresentar piora clínica ao longo dos anos, a idade mais avançada não implicou em uma pior percepção da qualidade de vida no grupo de pacientes estudados no presente trabalho... (Resumo completo, clicar acesso eletrônico abaixo)

Efeito de protocolos de cimentação na carga de fratura para uma cerâmica de dissilicato de lítio

Pós-graduação em Odontologia Restauradora - ICT

Digital radiography for determination of primary tooth length: in vivo and ex vivo studies

Background. Methods for determining the root canal length of the primary tooth should yield accurate and reproducible results. In vitro studies show some limitations, which do not allow their findings to be directly transferred to a clinical situation. Aim. To compare the accuracy of radiographic tooth length obtained from in vivo digital radiograph with that obtained from ex vivo digital radiograph. Method. Direct digital radiographs of 20 upper primary incisors were performed in teeth (2/3 radicular resorption) that were radiographed by an intraoral sensor, according to the long-cone technique. Teeth were extracted, measured, and mounted in a resin block, and then radiographic template was used to standardise the sensor-target distance (30 cm). The apparent tooth length (APTL) was obtained from the computer screen by means of an electronic ruler accompanying the digital radiography software (CDR 2.0), whereas the actual tooth length (ACTL) was obtained by means of a digital calliper following extraction. Data were compared to the ACTL by variance analysis and Pearson’s correlation test. Results. The values for APTL obtained from in vivo radiography were slightly underestimated, whereas those values obtained from ex vivo were slightly overestimated. No significance was observed between APTL and ACTL. Conclusion. The length of primary teeth estimated by in vivo and ex vivo comparisons using digital radiography was found to be similar to the actual tooth length.

Controlling mechanical undesirable side effects with a tooth indicated for extraction: free anchorage

This manuscript describes the use of a tooth indicated for extraction due
to orthodontic reasons as an anchorage aid to receive undesirable side effects caused by orthodontic uprighting of a contralateral molar tooth. The mandibular right second molar was mesially tipped as a result of loss of the adjacent first molar. Since the treatment plan involved extraction of the mandibular left first premolar, undesirable side effects associated with the molar uprighting movement were transferred to this tooth. Once the second molar was vertical, the premolar was extracted and the treatment continued. The results suggest that treatment time can be reduced if undesirable orthodontic mechanical side effects can be directed to a tooth whose extraction is indicated.

Tratamento do sorriso gengival: como estabelecer proporção e harmonia

The etiology of gingival smile is multifactorial and the correct diagnosis eill determine a successful treatment planning. Altered passive eruption occurs during the final stages of tooth eruption, when apical migration of the periodontal tissues does not occur, resulting in a distance > 2mm between the alveolar crest and the cement-enamel juncrion. This change leads to the shortening of the clinical crown and even further may lead to excessive gingival exposure. For treatment, there is a necessity for the combined removal of gingiva and bone tissue. This article discusses the literature on the issue and reports a case where periodontal plastic surgery was performed for the correcrion of a gingival smile.

A combined approach for the treatment of resorbed fresh sockets allowing immediate implant restoration: a 2-year follow-up

Introduction: The demand for optimal esthetics has increased with the advance of the implant dentistry and with the desire for easier, safer and faster technique allowing predictable outcomes. Thus, the aim of this case report was to describe a combined approach for the treatment of a periodontally compromised tooth by means of atraumatic tooth extraction, immediate flapless implant placement, autogenous block and particulate bone graft followed by connective tissue graft and immediate provisionalization of the crown in the same operatory time. Case Report: A 27-year-old woman underwent the proposed surgical procedures for the treatment of her compromised maxillary right first premolar. The tooth was removed atraumatically with a periotome without incision. A dental implant was inserted 3 mm apical to the cement-enamel junction of the adjacent teeth enabling the ideal tridimensional implant position. An osteotomy was performed in the maxillary tuber for block bone graft harvesting that allowed the reconstruction of the alveolar buccal plate. Thereafter, an autogenous connective tissue graft was placed to increase both the horizontal and vertical dimensions of the alveolar socket reaching the patient functional and esthetic expectations. Conclusion: This treatment protocol was efficient to create a harmonious gingival architecture with sufficient width and thickness, maintaining the stability of the alveolar bone crest yielding excellent aesthetic results after 2-years of follow-up. We suggest that this approach can be considered a viable alternative for the treatment of periodontally compromised tooth in the maxillary esthetic area enhancing patient comfort and satisfaction.