Reabilitação estético-funcional sobre implantes agulhados e endósseos

This report shows the resolution of a case study whose aim was promote the aesthetic and functional rehabilitation of upper left hemi-arch over endosseous and needle implant prostheses. To improve the position of the needle implants, we performed the bucco-palatal bending of needles splinting them with composite resin; we removed the screwed implant prosthesis in the regions of the premolars (24 and 25) and molar (26). The mini-abutments of the last two implants were replaced, and in the first premolar and canine, we used cemented abutments due to implant angulation having planned soldering because of implant size and contact with one needle implant that could interfere with intimate contact bone/implant damaging biomechanics. Pick-up impressions were performed with an open tray, using a retractor cord in the needle implants and respective transfer copings. Therefore, models were related on semi-adjustable articulator after a face-bow recording and interocclusal indexes. After working cast fabrication and try-in of infra-structures, these were adjusted and related into the articulator again. Then, after ceramic build-up, adjustments, finishing, and torque, chemically-activated resin cement was applied on units 21 to 24. At the end of the case, we concluded that a good aesthetic and functional rehabilitation depends on thorough knowledge of techniques for each clinical situation.

Effect of post-polymerization heat treatment on a denture base acrylic resin: histopathological analysis in rats

This work examined the histological effects, on the rat palatal mucosa, of a denture base acrylic resin, submitted or not to a post-polymerization heat-treatment. Methods: Fifteen adult female Wistar rats, with sixty days old, weighting 150 g – 250 g were divided in G1: animals being maintained under the same conditions as the experimental groups following described, but without the use acrylic palatal plates (control group); G2: use of heat-polymerized acrylic resin palatal plates made of Lucitone 550; G3: use of palatal plates identical to G2, but subjected to a post-polymerization treatment in a water bath at 55°C for 60 min. The plates covered all the palate and were fixed in the molar region with light-cured resin, thus being kept there for 14 days. After the sacrifice, the palate was removed, fixed in formaldehyde 10% and decalcified with EDTA. Sections were stained using haematoxylin and eosin. Images in duplicate were made from the central region of the cuts, to measure the thickness (μm) of the keratin layers (TKC), epithelium total (TET) and connective tissue (TCC). Statistical analyses were carried out by one-way ANOVA and Tukey post-tests (α=0.05). Results: According to the results there was significant difference in the thickness of keratin between G2 and G3, with G1 having the intermediate value and similar to the other groups. There was a significant difference in the connective tissue with G3

Dental and skeletal components of Class II open bite treatment with a modified Thurow appliance

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Pharyngeal airway space cephalometric evaluation in transverse maxillary deficient patients after SARME

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Avaliação tridimensional das alterações maxilomandibulares após expansão rápida de maxila assistida cirurgicamente

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

O impacto do preparo, da cerâmica e do contato oclusal na distribuição de tensões em facetas

Pós-graduação em Odontologia Restauradora - ICT

Dentifrício fluoretado suplementado com hexametafosfato de sódio sobre o processo de desmineralização do esmalte: estudos in vitro e in situ

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Effect of toothpaste with nano-sized trimetaphosphate on dental caries: In situ study

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Uncommon crown-root fracture treated with adhesive tooth fragment reattachment: 7 years of follow-up

Crown-root fractures account for 5% of all fractures in permanent teeth and can involve enamel, dentin, and cementum. Depending on whether there is pulpal involvement, these problems may be classified as complicated (which are more common) or noncomplicated. The treatment depends on the level of the fracture line, root length and/or morphology, and esthetic needs. Several treatment strategies are available for esthetic and functional rehabilitation in crown-root fractures. Adhesive tooth fragment reattachment is the most conservative restorative option when the tooth fragment is available and the biological width has no or minimal violation. This article reports a case of an uncomplicated crown-root fracture in the permanent maxillary right central incisor of a young patient who received treatment with adhesive tooth fragment reattachment, preserving the anatomic characteristics of the fractured tooth after periodontal intervention. The fracture line of the fragment had an unusual shape, starting on the palatal side and extending to the buccal side subgingivally. After 7 years, the attached coronal fragment remained in position with good esthetics, as well as clinical and radiographic signs of pulpal vitality, periodontal health, and root integrity, thus indicating success.

In situ remineralizing effect of fluoride varnishes containing sodium trimetaphosphate

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Fluoride gel supplemented with sodium hexametaphosphate reduces enamel erosive wear in situ

This study evaluated the effect of fluoride gels, supplemented or not with sodium hexametaphosphate (HMP), on enamel erosive wear in situ. Twelve healthy volunteers wore palatal appliances containing four bovine enamel discs. Subjects were randomly allocated into four experimental phases (double-blind, crossover protocol) according to the gels: Placebo (no fluoride or HMP), 1% NaF, 2% NaF, and 1% NaF+9% HMP. Enamel discs were selected after polishing and surface hardness analysis, and treated only once with the respective gels prior to each experimental phase. Erosion (ERO) was performed by extra-oral immersion of the appliance in 0.05M citric acid, pH 3.2 (four times/day, five minutes each, 5 days). Additional abrasion (ERO+ABR) was produced on only two discs by toothbrushing with fluoridated dentifrice after ERO (four times/day, 30s, 5 days). The specimens were submitted to profilometry and hardness analysis. The results were analyzed by two-way ANOVA and the Student-Newman-Keuls test (p<0.05). The 1% NaF+9% HMP gel promoted significantly lower enamel wear for ERO compared to the other groups, being statistically lower than 1% NaF and Placebo for ERO+ABR. Similarly, the lowest values of integrated lesion area were found for 1% NaF+9% HMP and 2% NaF, respectively, for ERO and ERO+ABR. The addition of HMP to the 1% NaF gel promoted greater protective effect against ERO and ERO+ABR compared to the 1% NaF gel, achieving similar protective levels to those seen for the 2% NaF gel. Gel containing 1% NaF+9% HMP showed a high anti-erosive potential, being a safer alternative when compared to a conventional 2% NaF gel.

Correção da deficiência transversa da maxila por meio da expansão rápida da maxila cirurgicamente assistida

Fundamentation: The correction of maxillary transverse deficiencies involves orthodontic and surgical procedures that can be performed before or after skeletal maturity. The surgically assisted rapid maxillary expansion (SAR ME) is performed by osteotomies through the lateral walls of the maxilla, zygomatic and canines buttresses, palatal and pterygomaxillary sutures, causing the maxillary disjunction. Followed by activation of the expander to the desired over-expansion in order to correct intercuspal later. Objective: The purpose of this study was to discuss the issues involved in the diagnosis of maxillary atresia, SAR ME indications, as well as surgical technique, through a case study. Methods: The male patient, 19 years old, had severe transverse maxillary deficiency with facial pattern III , Class III , with great lip incompetence. The patient underwent general anesthesia in a hospital environment, the osteotomies was done according to the technique described by Epker and Wolford (1980). Postoperatively, the patient underwent activations daily for 15 days and after 6 months, the orthodontist installed fixed orthodontic appliance to prepare the patient to orthognathic surgery later. Conclusion: The diagnosis by clinical evaluation and models study is essential for the indication of SAR ME and this procedure provides good predictability in the correction of transverse deficiency, with minimal morbidity.

Effect of toothpastes with different abrasives on eroded human enamel: an in situ/ex vivo study

The aim of the present study was to investigate the abrasive effect of CaCO3 and SiO2-based fluoride-free experimental toothpastes on eroded human permanent dental enamel and evaluate the effectiveness of waiting periods between acid exposure and tooth brushing. Twelve volunteers wore palatal appliances containing human enamel blocks for two periods of five days each. The appliances were immersed in a soft drink for five minutes four times a day (9:00 am, 11:00 am, 2:00 pm and 4:00 pm). On two occasions, two blocks were not submitted to additional treatment; two blocks were brushed (30 s) either with a CaCO3 or SiO2 toothpaste immediately after erosion and two blocks were brushed 1 h after erosion. Thus, the sample was divided into six groups: erosion alone (CaCO3 and SiO2 control); brushing with fluoride- free toothpaste (CaCO3 immediate and 1 h after erosion; SiO2 immediate and 1 h after erosion). Significant differences in wear depth were found between the enamel blocks in the CaCO3 immediate and 1 h after erosion groups and the blocks in the CaCO3 control group (p=0.001; p=0.022). No significant differences were found regarding the change in roughness and wear depth between blocks submitted to immediate abrasion and 1 h after erosion (CaCO3 and SiO2). The data revealed that surface roughness and wear depth is increased when erosion is combined with dental abrasion, regardless of the abrasive used. Waiting for 1 h to brush the eroded blocks offered no protective effect.

Evaluation in situ of tag formation in dental enamel submitted to microabrasion technique: effect of two etching times

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Prótese de palato em sujeitos com disfunção velofaríngea: expectativa e ansiedade

Cleft lip and palate (CLL) is a very common craniofacial anomaly. The cleft is usually corrected with surgery which may fail resulting in velopharyngeal dysfunction (VPD). The use of palatal prosthesis is an alternative treatment for correcting both, CLP and VPD. This study evaluated anxiety symptoms expectations of subjects of both genders, with velopharyngeal dysfunction, referred to palatal prosthesis program for VPD treatment. In this cross sectional and descriptive study 30 subjects with velopharyngeal dysfunction, aged 15 to 64 years old (mean age of 28) were interviewed at the Hospital for Rehabilitation of Craniofacial Anomalies (HRAC). All subjects referred to the palatal prosthesis program at HRAC in the year of 2005 were considered for participation in the study but only the first 30 candidates were included. A questionnaire addressing expectation elaborated by the researcher and the Beck Scale on anxiety were used. All subjects showed expectation regarding speech modification. Changes in professional and affective aspects of their lives after changes in speech were obtained with palatal prosthesis were the most reported expectations. Subjects’ age and gender influenced anxiety levels significantly which were minimum across subjects. High levels of expectation were more frequent than anxiety in the sample population.