Ethanol is inneficient to remove endodontic sealer residues of dentinal surface

Introduction: Endodontic sealer residues on dentinal surface have negative effects on adhesion of adhesives system and/or can cause discoloration of the dental crown. Objective: To evaluate the efficacy of 95% ethanol in removal of residues of epoxy-based (AH Plus), methacrylate-based (Epiphany SE) or calcium-based (Sealapex) sealers on dentinal surface. Material and methods: Thirty-two bovine incisor dental crown fragments (0.5 mm x 0.5 mm) were treated with 17% EDTA and 2.5% NaOCl. The specimens were divided into three experimental groups (n = 10): G1 (AH Plus), G2 (Epiphany SE) and G3 (Sealapex). In each group was applied a coating of one endodontic sealer type and were left undisturbed for 5 minutes. After this period, the specimens were cleaned with 95% ethanol. The control group was composed by two specimens that did not receive any sealer or cleaning treatment. The sealer residues persistence after cleaning with 95% ethanol was evaluated by scanning electron microscopy (x500) and a score system was applied. Data obtained were analyzed by Kruskal-Wallis and Dunn tests (α = 5%). Results: Moderate amount of endodontic sealer residues were observed in all groups, regardless of the endodontic sealer compositions. G1, G2 and G3 presented similar amount of sealer residues on dentinal surface after cleaning with 95% ethanol (p > 0.05). Conclusion: 95% ethanol was inefficiency to remove completely AH Plus, Epiphany SE and Sealapex residues of sealercontaminated dentin.

Spermatic and testicular damages in rats exposed to ethanol: Influence of lipid peroxidation but not testosterone

Chronic consumption of ethanol causes morphological and physiological changes in the reproductive system of mammals. Vitamin C has an antioxidant role in organisms by neutralizing the ROS (reactive oxygen species) produced by oxidizing agents and this vitamin has an important function in the male reproductive system. The aim of this study was to evaluate whether vitamin C could prevent or attenuate the alterations in the male reproductive system caused by ethanol consumption. To test this hypothesis, male rats were divided into three experimental groups and treated by gavage for 63 days. The ethanol (E) and ethanol +vitamin C (EC) groups received 2 g/kg of ethanol (25% v/v) daily. In addition to ethanol, the EC group received vitamin C at a dose of 100 mg/day, diluted in water. The control group (C) received only the vehicle. On the 64th experimental day, the animals were anesthetized and euthanized, and blood was collected for plasmatic hormonal analysis. The testis, epididymis, vas deferens, and seminal vesicles were removed and weighed. Sperm from the vas deferens was submitted to morphological and motility analysis. The testis and epididymis were used for oxidative stress and histopathological analysis, sperm count, morphometric analysis of the testis, and stereological analysis of the epididymis. The results showed that vitamin C has a protective effect in the testes of adult male rats, entirely normalizing the parameters of sperm count, spermatogenesis kinetics, lipid peroxidation levels, and sperm motility, as well as partially normalizing the histopathological damage in the testis, epididymis, and sperm morphology. Thus, we concluded that lipid peroxidation is a major mechanism by which ethanol affects the testes and sperm, whereas no plasmatic testosterone alterations were found.

Effect of ethanol, dry extract and reducing sugars on density and viscosity of Brazilian red wines

BACKGROUND Density and viscosity are properties that exert great influence on the body of wines. The present work aimed to evaluate the influence of the alcoholic content, dry extract, and reducing sugar content on density and viscosity of commercial dry red wines at different temperatures. The rheological assays were carried out on a controlled stress rheometer, using concentric cylinder geometry at seven temperatures (2, 8, 14, 16, 18, 20 and 26 degrees C).RESULTSWine viscosity decreased with increasing temperature and density was directly related to the wine alcohol content, whereas viscosity was closely linked to the dry extract. Reducing sugars did not influence viscosity or density. Wines produced from Italian grapes were presented as full-bodied with higher values for density and viscosity, which was linked to the higher alcohol content and dry extract, respectively.CONCLUSIONThe results highlighted the major effects of certain physicochemical properties on the physical properties of wines, which in turn is important for guiding sensory assessments. (c) 2014 Society of Chemical Industry

Bioenergy from stillage anaerobic digestion to enhance the energy balance ratio of ethanol production

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Thermodynamic, Economic and Emissions Analysis of a Micro Gas Turbine Cogeneration System operating on Biofuels

Pós-graduação em Engenharia Mecânica - FEG

Otimização de método para analise de tebutiurom, diurom e seus produtos de degradação em água superficial

In 2001, it was estimated that pesticide used worldwide exceeded 2.27 billion kilograms, over 35%, of which, were herbicides. Brazil is considered one of the leaders in the production of sugarcane and mainly ethanol as fuel. The monoculture of sugarcane requires the usage of a range of pesticides, among these, the herbicides diuron and tebuthiuron. The degradation products most studied (DCA and DCPU) are diuron's, especially for toxicological characteristics of this herbicide that is identified as carcinogen and suspected to be endocrine disruptor in mammals. After optimization of the chromatographic separation using HPLC-UV, the analytical curve was constructed in solvent and subsequently in the matrix (surface water). The extraction method contains the usage of SPE (solid phase extraction) (Strata-X, 200 mg/6 mL), applicating 1L of sample and elution with 5 mL of acetonitrile / methanol (50:50, v/v). Analysis by HPLC/UV was performed in gradient mode, acetonitrile/water (70/30-74/26 by 1 min, 74/26 - 78/22 till 3.2 min, returning to initial conditions and remaining this way until 10 min), 018 column (Phenomenex, 4.6 mm diameter, 250 mm long and 5pm particle size) and detection at 254 nm. Tests F and t were performed to verify the presence of the matrix effect. There was matrix effect to all analytes, ranging from -33% (DCA) and 38% (tebuthiuron). Thereby the method was optimized and validated for analysis of diuron, tebuthiuron, and DCPU DCA in surface water using HPLC/UV. The data obtained show that in order to assure the analytical reliability desired the use of the analytical curves in the matrix for the quantification of these analytes in water is required.

Development of an innovative, ecological and stability-indicating analytical method for semiquantitative analysis of ampicillin sodium for injection by thin layer chromatography (TLC)

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Análise Energética do processo experimental de produção de Biodiesel a partir do óleo de frango

There is a great global concern about the depletion and the high cost of fossil fuel reserves exploitation, more than ever, it is necessary to make a profound study and take advantage of alternative sources that can be used as energy efficiency with an appropriate pricing and low environmental impact. Brazil, which has highlighted using alternative energy sources as the use of ethanol and, in recent years, has been encouraging the expansion of its energy matrix in which the biodiesel will have a strategic importance within the agrobusiness area. Biodiesel is a fuel that can replace the diesel, which is a petroleum derivative. It is an ester, produced in the transesterification reaction of vegetable oils and animal greases, in an alcohol with an additional catalyst, are converted into fatty acids and result in esters with glycerol as sub products. The objective of this study was to estimate the final energy balance for the process biodiesel production from oil chicken waste. The energy balance estimation was quantified in calorific value according to the energy expenditure by calorimetric bomb method. The relationship between input and output of energy was around 0.97. In a first evaluation, the procedures adopted should be improved enough, so the process can become energetic and economically viable.

Extração e caracterização qualitativa do óleo da polpa e amendoas de frutos de macaúba [Acrocomia aculeata (Jacq) Lodd. ex Mart] coletada na região de Botucatu - SP

The international energy situation indicates to the depletion of oil reserves in the short term. Brazil, considering its potential, has sought through public policy, encourage the study of alternative forms of energy. Many of these forms are based on sub-products and agricultural products, especially the ethanol industry for fuel purposes. Another alternative of vegetable origin, most recently discussed, would be the production of fuel oil called biodiesel. The study aimed to extract and measure the pulp oil production of macaúba palm [Acrocomia aculeata (Jacq) Lodd. ex Mart], collected in Botucatu (SP). In addition, the qualitative analysis of the pulp and almond oil are determined. The results showed low productivity in oils, compared to the reported for macauba natural populations of Minas Gerais. The qualitative analysis of the macauba pulp shows to be rich in long chain fatty acids, while the almond have significant amounts of lauric acid.

Um Modelo para Análise do Balanço e Eficiência Energética na Logística de Transporte Dutoviário para Exportação do Etanol.

This paper analyzed the energy flow of a route currently designed to transport ethanol from the Midwest region of Brazil for exportation, more precisely from the city of Aparecida do Taboado (MS) to the port of São Sebastiao (SP). The route studied a single modal combined into two pieces, duct - duct. The direct and indirect energy, involved in the operations were used to account for the inputs and outputs of energy from and into the system. The energy input and output were the variables, diesel fuel, lubricants, greases, indirect energy consumption of machinery and equipment, power consumption of labor, the energy consumption and energy consumption in depreciation and maintenance of roads. We found that this route has specific energy consumption of 0,14 MJ km-1 m-3 . The Net Energy Gain (GEl), the Energy Efficiency global (EEg) and Renewable Energy Balance (BEr), which were the energy indicators adopted in this study were obtained respectively: 1.585.958.977,00 MJ; 200,72 and 1.593.900.000,00MJ.

Células-combustível a etanol direto embarcadas em aeronaves: estudo de utilização e recuperação de calor residual

Pós-graduação em Engenharia Mecânica - FEG