Estudo sobre uma turbina a gás instalada em uma refinaria de petróleo

The gas turbine (GT) is known to have: low cost of capital over the amount of energy, high flexibility, high reliability, short delivery time, commissioning and commercial operation at the beginning and quick departure. The gas turbine is also recognized for its superior environmental performance, manifested in air pollution containment and reducing greenhouse gases (Mahi, 1994). Gas turbines in simple cycle mode (SC) have long been used by utilities to limited power generation peak. In addition, manufacturing facilities use gas turbines for power generation units on site, often in combination with the process of heat production, such as hot water and steam process. In recent years, the performance of industrial gas turbines has been improved due to significant investments in research and development, in terms of fuel to electricity conversion efficiency, plant capacity, availability and reliability. The greater availability of energy resources such as natural gas (NG), the significant reduction of capital costs and the introduction of advanced cycles, have also been a success factor for the increased use of gas turbines to load applications base (Poulikas, 2004). Open Cycle Gas Turbine with a greater degree of heat to the atmosphere may alternatively be used to produce additional electricity using a steam cycle, or to compose a cogeneration process. The combined cycle (CC) uses the heat from the gas turbine exhaust gas to increase the power output and increase the overall efficiency of more than 50% second (Najjar, 2001). The initial discovery of these cycles in the commercial power generation market was possible due to the development of the gas turbine. Only from the 1970s that gas turbine inlet temperature and therefore the exhaust gas temperature was sufficiently high to allow a better efficiency in the combined cycle ... (Complete Abstract click electronic access below)

Análise da qualidade de energia elétrica proveniente de uma planta solar fotovoltaica conectada à rede de distribuição de energia

Ce document présente l'analyse de la qualité de l'énergie dans une centrale solaire photovoltaïque - avec une capacité installée de 1 MWpico, relié au réseau de distribution d’électricité en 11,9 kV, qui a comme but connaître et également de comparer à la norme nationale actuelle, les effets de la qualité de l'énergie électrique résultant de l'utilisation de cette type matrice génératrice. Le rapport a été basé sur des niveaux spécifiés dans le module 8 des Procédures de distribution d'électricité dans le réseau national d'électricité - PRODIST, qui précise les directrices sur la question de la qualité de l'énergie électrique sur le territoire brésilien. Il a été considéré aussi les recommandations internationales 929 et 1547, qui proposent des pratiques recommandées concernant des systèmes de génération de l'énergie solaire PV (photovoltaïque), et également des normes pour le raccordement de ces types de sources au réseau de distributions d'électricité, tous deux établis par l'Institut des ingénieurs électriciens et électroniciens, largement connu comme IEEE. Le développement et le travail sur le terrain a eu lieu de manière continué, et non dans des moments spécifiques, assurant de cette manière, la fiabilité des données obtenues

Estudo e análise comparativa da eficiência de um sistema alimentado por células fotovoltaicas para utilização em luminárias do tipo LED com e sem etapas de conversão

Energy efficiency is an increasingly important issue due to the current scenario where increasing demand is growing faster than the energy supplied. It is important, therefore, analyze and minimize electrical system losses. This study conducts a comparison of a system formed by a photovoltaic generator feeding an LED lamp directly without steps DC-AC -DC conversion, and a system using these conversion steps for the same lamp power. Losses in conversion steps are quantified and the degradation of power quality occurred due to conversion is evaluated

Chaveamento de cargas intermitentes usando sensor de corrente

Due to concerns about rational use of energy, several alternative technologies of power generation appeared, including the conversion of solar energy into electrical energy by photovoltaic panels. In low-income households, the refrigerator represents considerable impact on the electric bill, since it requires constant power given its use in food preservation. It is possible to reduce this share, with the use of an alternative energy source. This work presents a timed switching electronic system, which allows commercial equipment that is not affected by short interruptions in the power supply to use a photovoltaic panel as a source of alternative energy, which usually do not provide energy continuously. Switching is made automatically in case of low incidence of sunlight, and without any form of energy storage. Between each switching, there is a dead time without power supply, therefore preventing the use of synchronizers circuits between the photovoltaic panel and the public power grid. A circuit containing a 80C31 microcontroller is used to control the system’s switching. The photovoltaic panel’s voltage inverter is in H bridge configuration, and is also controlled by the microcontroller through Pulse Width Modulation, which makes use of preprogrammed tables to generate the control signals of the power transistors. Through the use of software simulations, the proposed system was tested, which is capable of supplying intermittent single-phase loads. The simulations indicates that the project developed in this paper can be assembled into a prototype and be tested under real operating conditions, as long as the scaling of components, the characteristics of the photovoltaic panel to be used, and the project involved load are taken into account

Desenvolvimento de estrutura para purificação de água potável, através da irradiação de UV com lâmpadas fluorescentes especiais

Pós-graduação em Engenharia Elétrica - FEIS

Study of thermal decomposition of ignition temperature of bagasse, coal and their blends

In Brazil, due to its availability, sugar cane bagasse has a high potential for power generation. The knowledge of ignition behavior, as well as the knowledge of the chemical kinetics, in of fuels combustion process is important features in boilers projects and in the stability of the combustion process control. The aim of this study is to investigate the thermal behavior of sugar cane bagasse, coal and their blends. The methodology proposed by Tognotti et al. (1985) was applied to determine the ignition temperature for all samples. Ignition temperatures were 256oC for neat bagasse and 427oC for neat coal, and 275oC for both blends (50-50% and 25-75%). The ModelFree Kinetics was applied to determine the apparent activation energy (Eα) of the thermal decomposition of sugar cane bagasse. For the two major events of mass loss of bagasse which correspond to the thermal decomposition of organic matter (mainly hemicellulose, cellulose and lignin), average values of Eα were obtained for both combustion and pyrolysis processes. In synthetic air atmosphere, the Eα were 170.8±26.3 kJ⋅mol-1 and 277.8±58.6 kJ⋅mol-1, while in nitrogen atmosphere, the Eα were 185.0 ± 11.4 kJ⋅mol-1 and 82.1±44.4 kJ⋅mol-1. The results obtained can be explained by synergistic effects when both bagasse and coal were blended, changing the fuel reactivity.

Estudo da viabilidade de implantação de plantas para conversão de energia térmica do oceano (OTEC) no Brasil

Pós-graduação em Engenharia Mecânica - FEIS

Utilização da cinza de folha de cana-de-açúcar como material pozolânico em matrizes cimentantes

Pós-graduação em Engenharia Civil - FEIS

Alocação ótima de chaves de interconexão nas redes de distribuição de energia elétrica

Pós-graduação em Engenharia Elétrica - FEIS

Desenvolvimento de sistema eletrônico para instrumentar um DPL em ensaio dinâmico de resistência do solo

Pós-graduação em Engenharia Elétrica - FEIS

Utilização de procedimentos multivariados no consumo de água e energia elétrica em habitações sociais com sistema de aquecimento solar

Pós-graduação em Agronomia (Energia na Agricultura) - FCA

Utilização de melaço, manipueira e soro de queijo como substratos para produção de biossurfactante por Bacillus Pumilus e sua aplicação em biorremediação de solo

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Otimização da operação de sistemas de distribuição radiais usando um algoritmo genético especializado

Pós-graduação em Engenharia Elétrica - FEIS

Kinetic study of the co-firing of bagasse-sludge blends

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Volt-VAR multiobjective optimization to peak-load relief and energy efficiency in distribution networks

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)