167 resultados para resistencia a herbicidas
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
The purpose of this study was to use a fluorescent dye and CLSM microscope to observe the effect of different light intensities on dentin tensile bond strength. Flat dentin surfaces were created on 16 intact human third molars and divided in 4 groups: Group G1 - halogen - KM -200R®; Group G2 - LED - Ultraled®; Group G3 - LED - UltraLume LED5® and Group G4 - LED - Biolux Single V®. For all the groups, the restoration procedure used Single Bond® adhesive, mixed with rodamin B and InTen-S® composite resin. Then, they were cut on serial sections to obtain 1 mm2 area and submitted to micro tensile test and after words, the fractures were analyzed with a digital microscope and CLSM. The statistical analysis showed that all in all groups, except Group G2, which had a significant smaller tensile bond strength ratio. The fracture mode analysis showed that there were significant differences when comparing groups G1 / G2, and G2 / G4. There is no evidence of relevant differences among the other groups. With these results, we conclude that the use of fluorescent dye and CLSM demonstrated to be a simple and nondestructive technique, and that there are evidences that light intensities influenced the dentine tensile.
Resumo:
Pós-graduação em Agronomia (Agricultura) - FCA
Resumo:
Pós-graduação em Agronomia (Proteção de Plantas) - FCA
Resumo:
Pós-graduação em Agronomia - FEIS
Resumo:
Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)
Resumo:
Pós-graduação em Agronomia (Genética e Melhoramento de Plantas) - FCAV
Resumo:
This project aimed to relate the efficiency of control of ACCase inhibiting herbicides applied post-emergence in Cenchrus echinatus under different soil water contents. The experiments were conducted in a greenhouse, with the application of three different herbicides (fluazifop-p-butyl, haloxyfop-methyl and sethoxydim + oil Assist) and the experimental design for each herbicide was completely randomized design with four replications, consisting a 3 x 4 factorial, with the combination of water management strategies (-0.03, -0.07 and -1.5 MPa) and four doses of these products (100, 50, 25 and 0% of the recommended dose). Herbicide application was made at vegetative stage of 2-3 tillers. The water management strategies were initiated in the development stage of two leaves, replacing the water until the soil reaches the potential of -0.01 MPa, when it came to severe pre-determined for each water management. The physiological parameters evaluated were: photosynthetic rate, stomatal conductance, transpiration, leaf temperature and plant dry matter. The visual assessments of phytotoxicity were performed at 7, 14, 21 and 28 days after application. The efficiency of these herbicides was influenced by soil management and water lowest in plants grown in the minimal potential of water in the soil of -1.5 MPa. All the herbicides were unsatisfactory controls in applications late (2-3 tiller plants).
Resumo:
The aim of this study was to evaluate the effect of low soil moisture on the efficacy of applying herbicides ametryn + clomazone, sulfentrazone and tebuthiuron in pre-emergence application submitted to simulated rainfalls at different time intervals after application in control of B. pilosa, C. echinatus and U. plantaginea plants. The experiment was carried out in pots with a capacity of 2.5 L in green-house conditions and experimental design was completely randomized with four replications, arranged in a 3x5 factorial (three herbicides and five rains intervals). The herbicides clomazone + ametryn (Sinerge EC) 5.0 L commercial product (cp) ha(-1), sulfentrazone (Boral 500 SC) 1.2 L cp ha(-1) and tebuthiuron (combine SC) 2.0 L cp ha(-1) were applied in pre-emergence and the precipitation of 20 mm were applied under de pots in five time intervals after the herbicide application (0h, 4h, 8h, 12h and 24hours). Visual evaluations of plants control that emerged plants were realized at 14 and 21 days after treatment application and the plant emergence percentage was calculated. The application of these three herbicides in dry soil then rain within 24 hours after application provided C. echinatus plants emergence, reduced B. pilosa emergency but in the end of the experiment effectively controlled these two species and U. plantaginea plants.
Resumo:
The increased use of herbicides, coupled with inadequate use of these molecules, also increased concerns about the risks of environmental contamination and its effects on humans and animals. The objective of this work evaluates the potential for leaching of herbicides in the crop of cane sugar, in contrasting soils. Used samples were used Psament (NR - sandy texture) and Oxisol Red (LR - clay texture). After application of herbicides ametryne (NR 1.60 kg ha(-1) and LR 2.40 kg ha(-1)), clomazone (NR 0.90 kg ha(-1) and LR 1.10 kg ha(-1)) and diuron (NR 1.60 kg ha(-1) and LR 3.20 kg ha(-1)), were irrigated blades of 0, 20, 40, 60, 80 and 100 mm of water in soil columns. Results indicate that ametryne in NR samples submitted to the handling layer of 5-10 cm when applied blades of 20 and 40 mm of water. It was evident that the clomazone, regardless of the soil, did not exceed 0-5 cm water depths of 0 to 20 mm of water and 5-10 cm deep in the blades above 40 mm of water. With blades up to 80 mm, the diuron leaching only in layers 0-5 cm deep in LR. Conclude that the potential of leaching of diuron and ametryne was influenced by soil texture together with the organic matter content, the same was not true for clomazone.
Resumo:
Pós-graduação em Agronomia - FEIS
Resumo:
Pós-graduação em Agronomia (Proteção de Plantas) - FCA
Resumo:
Pós-graduação em Agronomia (Produção Vegetal) - FCAV
Resumo:
The electrical measures of the soil have been used as variables that correlate with its characteristics. This study aimed at developing an electrical capacitance sensor of low cost, to evaluate its performance on the field and verify the correlation between the measurements of electrical capacitance with physical properties (sand, silt and clay) and chemical properties of soil (pH, MO, P resin, H + Al, K, Ca, Mg, SB, CTC and V%) and the moisture content. The data sampling was performed at the farm named "Capão da Onça" which belongs to the State University of Ponta Grossa. The samples collection was conducted in an area of approximately 13 hectares, totalizing 81 samples. In each sampling the electrical capacitance of the soil was measured. After the sensor withdrawal, soil samples were collected and sent to be analysed in the laboratory of the College of Agronomics Science of the Paulista State University. The measuring instrument used to collect data on electric capacitance of the soil a digital multimeter was used. The data were submitted to the analysis of correlation and regression. The developed system presented a low cost and it was capable to measuring variation of the electrical capacitance of the soil. The obtained measures satisfactorily correlated with the levels of clay and sand, and weakly with the moisture content. This had demonstrated the possibility to use a sensor to verify the soil texture in not homogeneous areas. The measures of the electrical capacitance of the soil obtained by the sensor had significantly correlated with the soil attributes: calcium, magnesium, pH, SB and CTC. These results had demonstrated the possibility to use a sensor for soil fertility control.
Resumo:
The objective of this work was to evaluate the efficacy of different herbicides applied in post-emergence in the desiccation of pearl millet with different doses and spray volumes. For the desiccation, doses at 0, 25, 50 and 100% of the herbicide glyphosate (1,440 g ha-1) were used in 3 formulations (Original Round up, Round up Transorb and Round up WG), paraquat + diuron (500 + 250 g ha-1) and glufosinateammonium (800 g ha-1). In all treatments, 2 spray volumes (200 and 400 l ha-1) were used, and there was 1 treatment (control) without the application of herbicides. The treatment effects were evaluated visually at 3, 7, 14, 21 and 28 days after application (DAA). At the end of the evaluations, the dry mass of the plants was determined. The field trial was carried out in randomized block design. At the end of the study, at 28 DAA, all treatments presented total control of plant pearl millet, regardless of the dose and spray volume, except the treatments with paraquat + diuron and glufosinate-ammonium at the lower dose (25%), in 2 spray volumes, which nevertheless showed good and very good control, these two herbicides presenting an effect of volume, in which the control was higher with the use of smaller volume.