Identification of haploid maize by flow cytometry, morphological and molecular markers

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Comparative cytogenetic and morphological analysis of Astyanax scabripinnis paranae (Pisces, Characidae, Tetragonopterinae)

Foram realizados estudos citogenéticos e morfológicos em nove populações locais de Astyanax scabripinnis paranae. Todas as populações apresentaram 2n = 50 cromossomos e conspícuas diferenças envolvendo a morfologia dos cromossomos, número e posição das NORs e quantidade e localização dos blocos de heterocromatina constitutiva. O estudo quantitativo dos dados citogenéticos, usando a análise das variáveis canônicas (CVA), mostraram que oito populações apresentaram diferentes constituições cariotípicas. Análises morfológicas baseadas em nove caracteres morfométricos e dois merísticos foram eficazes no estabelecimento de uma clara identificação de cinco populações. Análises comparativas dos dados citogenéticos e morfológicos sugerem que as modificações cromossômicas e morfológicas ocorreram em diferentes taxas, sendo as cromossômicas mais rápidas do que as morfológicas. A despeito da similaridade morfológica encontrada entre algumas populações, diferenças cromossômicas foram detectadas entre todas as populações estudadas.

Study on the orientation degree of Pb1-xLaxTiO3 thin films by the rocking curve technique and its morphological aspects

Thin films of perovskite-type materials such as PbTiO3, BaTiO3, (Pb,La)TiO3, (Pb, La)(ZrTi)O-3, KNbO3, and Pb(Mg,Nb)03 have been attracting great interest for applications like non-volatile memories, ultrasonic sensors and optical devices. Thin film should be epitaxially grown or at least highly textured since the properties of this anisotropic material depend on the crystallographic orientation. For optical devices, in particular, an epitaxial thin film without defects are essential to reduce optical propagation losses. Pb1-xLaxTiO3 (PLT) where x=0, 13 and 27% thin films were prepared by a chemical method (polymeric precursors method), and deposited by the spin coating technique onto substrates of SrTiO3 (STO) and LaAlO3 (LAO). The films were then beat treated at 500 degrees C in a controlled atmosphere of 0,. The orientation degree of the thin films was obtained from rocking curve technique, by means of X-ray difftaction analysis. A microstructural study revealed that the films were crack-free, homogeneous and have low roughness. (c) 2006 Elsevier B.V. All rights reserved.

The taxonomy and morphological and anatomical differentiation of populations of Leiothrix crassifolia (Eriocaulaceae)

The morphological and anatomical leaf and scape differentiation of Leiothrix crassifolia is analysed and classified into seven types (I, II, III, IV, V, VI, Vn). The species has a relatively wide distribution in the campo rupestre of Minas Gerais in Brazil. Variation in the isolated populations on different mountain ranges is complex, does not follow a clear geographical pattern, and defies taxonomic classification. L. nubigena and L. obtusifolia are included in L. crassifolia.

Morphological and molecular characterization of Colletotrichum spp. from citrus orchards affected by postbloom fruit drop in Brazil

Brazilian isolates of Colletotrichum spp. from citrus orchards affected by postbloom fruit drop were examined for colony colour, mycelial growth, benomyl-resistance, pathogenicity, and genetic variability by random amplified polymorphic DNA (RAPD) analysis. All isolates were obtained from flowers and persistent calyxes from different citrus hosts from São Paulo, Brazil. DNA polymorphisms detected after amplification with random 10-mer primers were used to classify the isolates into two groups. Group I isolates grew rapidly on potato-dextrose agar (PDA) and were sensitive to benomyl, and group II isolates grew slowly on PDA and were benomyl-resistant. Colletotrichum acutatum was analyzed by RAPD and had high genetic similarity with group II isolates of Colletotrichum from citrus. Probably, the group I is C, gloeosporioides and group II is C. acutatum.

Morphological analysis of pits formed on Al 2024-T3 in chloride aqueous solution

It has been used a new image analysis method, based on segmentation by shape parameters, for pits morphology examination from Al 2024 aluminum-copper alloy in chloride aqueous solution. Corrosion behavior of this alloys in naturally aerated 3.5% NaCl solution has been investigated through open circuit potential measurements. Afterwards, pits have been characterized by image analysis taking density and size measurements right from corroded surfaces. Morphological investigation has been conducted for profiles, cut orthogonally from mean surface planes, and observed through light microscopy. Image analysis data could demonstrate that pits are wider than deep, evoluting for conical, quasi-conical or irregular shapes. Most pits have presented a quasi-conical morphology, but the wider ones have evoluted to an irregular shape influenced by sub-surface microstructure. Image analysis based on shape segmentation could enhance the differences on morphological behavior. (C) 2004 Elsevier B.V. All rights reserved.

Influence of the solution pH on the morphological, structural and electrical properties of Bi3.50La0.50Ti3O12 thin films obtained by the polymeric precursor method

Lanthanum-doped Bi4Ti3O12 thin films (BLT) were deposited on Pt/Ti/SiO2/Si substrates using a polymeric precursor solution. The spin-coated films were specular, crack-free and crystalline after annealing at 700 degrees C for 2 h. Crystallinity and morphological evaluation were examined by X ray diffraction (YRD) and atomic force microscopy (AFM). The stability of the formed complex is of extreme importance for the formation of the perovskite phase. Films obtained from acid pH solution present elongated grains around 200 ran in size, whereas films obtained from basic solution present a dense microstructure with spherical grains (100 nm). The dielectric and ferroelectric properties of the BLT films are strongly affected by the solution pH. The hysteresis loops are fully saturated with a remnant polarization and coercive voltage of P-r=20.2 mu C/cm(2) and V-c = 1.35 V and P-r= 15 mu C/cm(2) and V-c = 1.69 V for the films obtained from basic and acid solutions, respectively. (C) 2005 Elsevier B.V. All rights reserved.

Morphological characterization of Langmuir-Blodgett films from polyaniline and a ruthenium complex (Rupy): influence of the relative concentration of Rupy

We report on the use of dynamic scale theory and fractal analyses in a study of the growth stages of Langmuir-Blodgett (LB) films of polyaniline and a neutral biphosphinic ruthenium complex, namely mer-[ RuCl3 (dppb)(py)] (dppb = 1,4-bis(diphenylphosphine) buthane, py = pyridine), Rupy. The LB films were deposited onto indium-tin-oxide substrates and characterized with atomic force microscopy. From the granular morphology exhibited by the films one could infer growth processes inside and outside the grains. Growth outside was found to follow the Kardar-Parisi-Zhang model, with fractal dimensions of about 2.7. As one would expect, inside the grains the morphology is close to a Euclidian surface with fractal dimension of about 2.

Morphological characterization of the venom secretory epidermal cells in the stinger of marine and freshwater stingrays

Marine and freshwater stingrays are characterized by the presence of one to three mineralized serrated stingers on the tail, which are covered by epidermal cells secreting venom. When these animals are dorsally touched, the stinger can be introduced into the aggressor by a whip reflex mechanism of the tail, causing severe mechanical injuries and inoculating the venom. Accidents in humans are frequent causing intense local pain, oedema and erythema. Bacterial secondary infection is also common. In addition, injuries involving freshwater stingrays frequently cause a persistent cutaneous necrosis. The exact localization of the venom secretory epidermal cells in the stinger is controversial, but it is known that it is preferentially located in the ventrolateral grooves. A comparative morphological analysis of the stinger epidermal tissue of different marine and freshwater Brazilian stingray species was carried out. The results indicate that in freshwater species there is a larger number of protein secretory cells, of two different types, spread over the whole stinger epidermis, while in marine species the protein secretory cells are located only around or inside the stinger ventrolateral grooves. These differences between the stingers of the two groups can justify the more severe envenomation accidents with the freshwater species when compared with the marine species. (c) 2007 Elsevier Ltd. All rights reserved.