Assembleias fitoplanctônicas no gradiente longitudinal barragem-jusante do reservatório de Itaipu, rio Paraná (Brasil/Paraguai)

The freshwater phytoplankton, responsible for a significant part of primary production in rivers and lakes, is of great importance for matter and energy available to other trophic levels of structuring aquatic food chains. In recent decades, the construction of dams, especially for the generation of electricity, produced changes not only in physical and chemical characteristics of rivers, but also in biocoenosis of these ecosystems. Thus, research is needed to expand the basic knowledge about these environments and subsidize actions appropriate conservation and management. Considering that lotic environments are relatively little studied, and the river-reservoir interaction, the work aims to analyze the limnological conditions and assemblies phytoplankton along the gradient established by the Itaipu reservoir and downstream stretch of the Paraná River. During two periods of the year, winter and summer, we analyzed nine sampling stations: one in lentic environment (the dam), six on the Parana River (each 5 km), at the mouth of a river Monday and another at the mouth of the Iguazu river. The phytoplankton community was composed of 315 taxa, with the class Bacillariophyceae most specious. At every point the richness was higher in summer and with a longitudinal trend in the increasing points after falling after the dam and the contribution of the tributaries. The number of taxa common to the three rivers was low in both study periods. The higher taxa can be explained by the variety of environments sampled, different residence times of water and nutrient concentrations, whereas the rivers Iguazu and Monday suffer high human influence. The greater abundance of organisms in the dam, in both periods, it should be the class Cryptophyceae contributing over 75% of total phytoplankton in point. In cluster analysis (composition and abundance)...(Complete abstract click electronic access below)

Amostragem de poluentes particulados emitidos pela queima de biomassa em correntes confinadas

It is clear today the ever-accelerating search for new fuels that will eventually replace those that will survive in our society, which are fossil fuels. For this reason, a fuel used since the dawn of humanity and much studied since then, considered the generator of clean, renewable energy, can earn more and more space in the power generation sector, which is biomass. We performed two experiments with two different types of biomass, one from the Amazon rainforest and other pine and eucalyptus as waste from the sawmill UNESP Itapeva. In the first experiment, conducted at the Laboratory of Combustion and Propulsion INPE Cachoeira Paulista were conducted three tests in a chimney with a fan creating forced ventilation, where the biomass was burned and deposited on a support beneath the hood. In the second experiment was conducted to analyze the emission of particulate matter using biomass (waste) from the sawmill on the campus of UNESP experimental Itapeva the burning of it in a burner for heating water for a wood oven. In these experiments we used a particle called DATARAM4 sampler that is capable of sampling both outdoors and inside of pipelines, which is the focus of this work. With this equipment it was possible to measure the concentration of particulate matter in all the firings as above, and compare them to levels acceptable in the current law, always trying to analyze the so-called fine particles, which are those with diameters less than 2.5 μm. Using data obtained from the equipment was also possible to evaluate the diametral distribution of particulate matter in question, and verify which phases of the flares in the concentration and the diameters of the particles are the most critical. In this work we concluded that in all firings conducted concentrations of particulate matter were higher than that allowed by the law, and the diameters were found that are more harmful to human health

Sistema fotovoltaico interligado á rede eletrica no Campus da UNESP-FEG Guaratinguetá

Solar energy can be considered the largest source of energy available on earth and has attracted in recent decades, attention and interest for its rational use. The use of energy sources in a sustainable manner is essential to the survival of future generations, due to the scarcity of natural resources and their exploitation in a disorderly way. Studies related to the applications of renewable sources becomes then relevant, given its great importance as regards the conscious use of resources provided by nature, with the least possible impact on it. The present study presents an evaluation of generation potential and feasibility of implementing a solar photovoltaic connected to the grid and connected to the roofs of some buildings of the Faculty of Engineering of Guaratinguetá - FEG, to supply the demand of electric energy consumption on campus and attempting to inject a possible surplus power generation in local power grid, increasing network capacity and reducing peak loads

Viabilidade técnica e econômica na utilização de um sistema fotovoltaico para alimentação de luminárias LED na Faculdade de Engenharia do Campus de Guaratinguetá SP

Solar energy can be considered the largest source of energy available on earth and has attracted in recent decades, attention and interest for its rational use. The use of energy sources in a sustainable way is essential to the survival of future generations, due to the scarcity of natural resources and their exploitation in a disorderly way. This academic work aims to bring a possible alternative to reduce the consumption of eletrical energy, at the University of Engineering – Campus of Guaratinguetá, through the use of a photovoltaic system interconnected to the LED bulbs. For this, the necessary data for the design of the photovoltaic system componentes and their acquisition costs were obtained and three differents configurations were developed to choose the one that bests fits the studied case, considering the return time of the initial investment (payback)

Simulação de ciclo combinado utilizando software comercial

In Brazil, The power generation has always depended on the rivers, in other words, there are moments that the power generation can vary, which can cause variations in energy supply and even blackout according to the level of water in the reservoirs of the hydroelectric plants. For this reason, many options has been studied, like our example, which is about a combined cycle power plant in Canas. The use of combined cycle is interesting from the point o view of energy, because its efficiency is between 50 and 60%, and from the point of view of environment, because it can burn natural gas, which is cleaner than coal, it reduces the emission of gases that influence on the greenhouse effect. This work aims to perform a technical analysis of a case study of a power plant proposed to be built in Canas by the AES/AES Tietê Group. For the analysis will be used the commercial software GateCycle 6.0.0 from GE, this software has the power of simulating power generation cycles (nuclear, combined, etc.). The energy department of UNESP has the license, which makes possible the academic use of this tool. Two combined cycles were simulated, one using one pressure level HRSG, and another one closer to the real power plant, which is a combined cycle with a three pressure level HRSG. The results were close to expected, for the combined cycle with one pressure HRSG the power was 513,9 MW and a efficiency of 53,27%, in the case with the three pressure level HRSG the power was 517,1 MW and a efficiency of 53,5%. We conclude that the software requires that the user must have the knowledge about the subjects involved in the use of GateCycle in problems resolutions

Estudo de falhas por fadiga em caldeiras

In recent years, increasing demand for energy has led to studies to increase the amount of electricity produced. Due to this fact, more and more boilers are becoming important sources of electricity generation. To raise the efficiency of energy generated in the boilers is necessary to raise the steam pressure and temperature to values previously unimaginable. The use of more resistant materials and maintenance practices and most appropriate operation made it possible. The objective of this study is to test the main types of failure in a chemical recovery boiler, in particular due to fatigue in the superheater, because it is a component subjected to high temperatures and thus more subject to different failures. In this manner this study aims to reduce the incidence of unscheduled maintenance shutdowns, increasing the operation time under appropriate conditions. Modeling performed in this study, the failure did not occur, because we considered only the mechanical stress. Under normal conditions, mechanical stress in combination with thermal stresses can cause cracks in the tubes due to cyclical stresses, leading to fatigue failure

Aplicação de cinza do bagaço de cana-de-açúcar em latossolo cultivado com cana-de-açúcar

Pós-graduação em Agronomia (Produção Vegetal) - FCAV

Estudo sobre uma turbina a gás instalada em uma refinaria de petróleo

The gas turbine (GT) is known to have: low cost of capital over the amount of energy, high flexibility, high reliability, short delivery time, commissioning and commercial operation at the beginning and quick departure. The gas turbine is also recognized for its superior environmental performance, manifested in air pollution containment and reducing greenhouse gases (Mahi, 1994). Gas turbines in simple cycle mode (SC) have long been used by utilities to limited power generation peak. In addition, manufacturing facilities use gas turbines for power generation units on site, often in combination with the process of heat production, such as hot water and steam process. In recent years, the performance of industrial gas turbines has been improved due to significant investments in research and development, in terms of fuel to electricity conversion efficiency, plant capacity, availability and reliability. The greater availability of energy resources such as natural gas (NG), the significant reduction of capital costs and the introduction of advanced cycles, have also been a success factor for the increased use of gas turbines to load applications base (Poulikas, 2004). Open Cycle Gas Turbine with a greater degree of heat to the atmosphere may alternatively be used to produce additional electricity using a steam cycle, or to compose a cogeneration process. The combined cycle (CC) uses the heat from the gas turbine exhaust gas to increase the power output and increase the overall efficiency of more than 50% second (Najjar, 2001). The initial discovery of these cycles in the commercial power generation market was possible due to the development of the gas turbine. Only from the 1970s that gas turbine inlet temperature and therefore the exhaust gas temperature was sufficiently high to allow a better efficiency in the combined cycle ... (Complete Abstract click electronic access below)

Estudo da produção de hidrogênio eletrolítico a partir de fontes eólica, solar e hidrelétrica

Introduces technical, economic and environmentally competitive solutions in the energy market is a great challenge for society. This work examines each of these aspects considering the production of electrolytic hydrogen with energy from wind power, solar and hydropower, in order to ensure an overview of this energy carrier. Initially, an assessment of the technical aspects is made addressing existing electrolysers technologies, its main characteristics and differences. The geographical distribution of wind, solar and hydroelectric potential in Brazil is also mapped, and a configuration scheme of a hydrogen production system is discussed. Subsequently, the economic analysis calculates the cost of investment in the alkaline electrolyser of 60 Nm³ / h, similar to the Brazilian bus powered by hydrogen project, coordinated by EMTU. Since the main input of electrolysis is electricity, is analyzed the latest energy auctions of each primary source and it is calculated the cost of production of the wind, solar and hydropower hydrogen. Postponed to this, are investigated the intrinsic environmental impacts of electricity generation process, proposing a readjustment of an indicator of ecological efficiency for the production of hydrogen. Finally, the work discusses the concept of externalities and demonstrates how the incorporation of external costs can leverage the hydrogen economy. In short, it is evident that the wind and hydroelectric hydrogens are more promising compared to solar hydrogen, whether in the economic aspect, because it achieved lower costs, whether in the environmental aspect, because it reached the highest ecological efficiency

Estudo e análise comparativa da eficiência de um sistema alimentado por células fotovoltaicas para utilização em luminárias do tipo LED com e sem etapas de conversão

Energy efficiency is an increasingly important issue due to the current scenario where increasing demand is growing faster than the energy supplied. It is important, therefore, analyze and minimize electrical system losses. This study conducts a comparison of a system formed by a photovoltaic generator feeding an LED lamp directly without steps DC-AC -DC conversion, and a system using these conversion steps for the same lamp power. Losses in conversion steps are quantified and the degradation of power quality occurred due to conversion is evaluated

Chaveamento de cargas intermitentes usando sensor de corrente

Due to concerns about rational use of energy, several alternative technologies of power generation appeared, including the conversion of solar energy into electrical energy by photovoltaic panels. In low-income households, the refrigerator represents considerable impact on the electric bill, since it requires constant power given its use in food preservation. It is possible to reduce this share, with the use of an alternative energy source. This work presents a timed switching electronic system, which allows commercial equipment that is not affected by short interruptions in the power supply to use a photovoltaic panel as a source of alternative energy, which usually do not provide energy continuously. Switching is made automatically in case of low incidence of sunlight, and without any form of energy storage. Between each switching, there is a dead time without power supply, therefore preventing the use of synchronizers circuits between the photovoltaic panel and the public power grid. A circuit containing a 80C31 microcontroller is used to control the system’s switching. The photovoltaic panel’s voltage inverter is in H bridge configuration, and is also controlled by the microcontroller through Pulse Width Modulation, which makes use of preprogrammed tables to generate the control signals of the power transistors. Through the use of software simulations, the proposed system was tested, which is capable of supplying intermittent single-phase loads. The simulations indicates that the project developed in this paper can be assembled into a prototype and be tested under real operating conditions, as long as the scaling of components, the characteristics of the photovoltaic panel to be used, and the project involved load are taken into account

Caracterização da cinza de bagaço de cana-de-açúcar e aplicação no solo

Pós-graduação em Agronomia (Ciência do Solo) - FCAV

Utilização da cinza de folha de cana-de-açúcar como material pozolânico em matrizes cimentantes

Pós-graduação em Engenharia Civil - FEIS

A mercantilização dos bens naturais no setor elétrico: o caso da UHE Barra Grande

Pós-graduação em Geografia - FCT

Análise técnica, econômica e ecológica do uso de biogás em célula a combustível de óxido sólido (SOFC)

Pós-graduação em Engenharia Mecânica - FEG