Influence of presence or absence of keratinized mucosa on the alveolar bony crest level as it relates to different buccal marginal bone thicknesses. an experimental study in dogs

Objective: To investigate the influence of the presence or absence of keratinized mucosa on the alveolar bony crest level as it relates to different buccal marginal bone thicknesses. Material and methods: In six beagle dogs, the mandibular premolars and first molars were extracted bilaterally. In the right side of the mandible (test), flaps were elevated, and the buccal as well as part of the lingual masticatory mucosa was removed. The flap was released coronally to allow a primary wound closure. In the left side, the wounds were left unsutured with the keratinized mucosa remaining (control). After 3 months of healing, a complete absence of keratinized mucosa was found at the test sites. Two recipient sites were prepared at each side of the mandible, one in the premolar and one in the molar region. A buccal bony ridge width of approximately 1 and 2 mm was obtained at the premolar and molar region, respectively. Implants were installed with the shoulder flush with the buccal alveolar bony crest, and abutments were connected to allow a nonsubmerged healing. At least 2 mm of keratinized mucosa was surrounding the control sites, while at the test sites, the implants were bordered by alveolar mucosa. After 3 months, the animals were euthanized and ground sections obtained. Results: A higher vertical bony crest resorption was observed at the test compared with the control sites both at the premolar and molar regions, the differences being statistically significant. The top of the peri-implant mucosa was located more coronally at the control compared with the test sites. The horizontal resorption measured 1 mm below the implant shoulder was similar at the test and control sites. Only limited differences were found between premolar and molar sites, with the exclusion of the horizontal resorption that was higher at the test compared with the control sites. Conclusions: A higher alveolar buccal bony crest resorption and a more apical soft tissue marginal position should be expected, when implants are surrounded with thin alveolar mucosa at the time of installation, independently of the thickness of the buccal bony crest. © 2013 John Wiley & Sons A/S.

Corrosion and tribocorrosion behaviour of Al-Si-Cu-Mg alloy and its composites reinforced with B4C particles in 0.05M NaCl solution

The corrosion behaviour of metal matrix composites (MMCs) is strictly linked with the presence of heterogeneities such as reinforcement phase, microcrevices, porosity, secondary phase precipitates, and interaction products. Most of the literature related to corrosion behaviour of aluminium matrix composites (AMCs) is focused on SiC reinforced AMCs. On the other hand, there is very limited information available in the literature related to the tribocorrosion behaviour of AMCs. Therefore, the present work aims to investigate corrosion and tribocorrosion behaviour of Al-Si-Cu-Mg alloy matrix composites reinforced with B4C particulates. Corrosion behaviour of 15 and 19% (vol) B4C reinforced Al-Si-Cu-Mg matrix composites and the base alloy was investigated in 0.05M NaCl solution by performing immersion tests and potentiodynamic polarisation tests. Tribocorrosion behaviour of Al-Si-Cu-Mg alloy and its composites were also investigated in 0.05M NaCl solution. The tests were carried out against alumina ball using a reciprocating ball-on-plate tribometer. Electrochemical measurements were performed before, during, and after the sliding tests together with the recording of the tangential force. Results suggest that particle addition did not affect significantly the tendency of corrosion of Al-Si-Cu-Mg alloy without mechanical interactions. During the tribocorrosion tests, the counter material was found to slide mainly on the B4C particles, which protected the matrix alloy from severe wear damage. Furthermore, the wear debris were accumulated on the worn surfaces and entrapped between the reinforcing particles. Therefore, the tendency of corrosion and the corrosion rate decreased in Al-Si-Cu-Mg matrix B4C reinforced composites during the sliding in 0.05M NaCl solution. © 2013 Elsevier B.V.

Endaural access to remove the projectile from a firearm

Background: Surgical approaches to temporomandibular region have been the subject of numerous controversies in the literature. Pre-auricular approaches have been used with the observance of high success rate, and during surgery history, various modifications of this approach were conducted in order to reduce irreversible sequelae. Thus, given the relevance of the study, this article proposes to alert the professionals that carry out these surgical approaches in relation to the anatomical structures involved and to describe and emphasise the benefits of endaural approach. Case report: A Caucasian male patient, victim of a firearm injury, sustained a wound on the right pre-auricular region, and at the time of assessment, he complained of pain, mouth opening difficulty and dysphagia. On physical examination, there was oedema and ecchymosis in the right periorbital region. In the radiological examination, a foreign body compatible with a firearm projectile was observed in the right pre-auricular region, being in accordance with the information collected. The endaural incision and divulsion by plans was then made until the projectile. Discussion: For proper exposure of the region, several studies were designed to evaluate the patterns of branching and anastomosis of the facial nerve. As for the best cosmetic result with the different pre-auricular approaches, the endaural approach was described as an approach that offers great cosmetic results because the incision design guides the surgeon in the wound closure and causes a decrease in the tension of flap, unlike that observed by some authors. © 2012 Springer-Verlag Berlin Heidelberg.

Peixoto's Theorem for vector fields on S2 with impasse points

The structural stability of vector fields with impasse regular curves on S2 is studied and a version of Peixoto's Theorem is established. Moreover a global analysis of normal forms of the constrained systems. A(x).ẋ=F(x),x∈R3,A∈M(3),F:R3→R3 in the Poincaré ball (i.e. in the compactification of R3 with the sphere S2 of the infinity) is made. © 2013 Elsevier Masson SAS.

Glaucoma secundário em cães e gatos

Glaucoma is a syndrome that affects animals of different species and in different moments of his life, having variables causes in function of this presentation. It is an ophthalmic emergency that may develop irreversible vision damage as well as the patient's aesthetic presentation. Increased intraocular pressure, presence of engorged episcleral vessels, conjunctival hyperemia, pain, anterior uveitis, lens luxation and buftalmia are commonly clinical signs presented by dogs while in cats, signs are less expressive, noting mydriasis, mild ciliary injection and progressive buftalmia. For diagnosis are carried out three basic procedures: tonometry, gonioscopy and ophthalmoscopy. The treatment can establish with medical therapy with or without surgical intervention, however, at some point it will be necessary to perform enucleation or evisceration of the eye bulb.

Resistência da parede abdominal após a remoção cirúrgica dos músculos retos abdominais: estudos experimental em ratos

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Alterações clínicas e morfológicas das córneas de coelhos implantadas com anéis intraestromais de FERRARA® com e sem revestimento de condrointin sulfato

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Projeto de controle robusto para acomodação de falhas no módulo do helicóptero 3-DOF

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Multicontroladores para melhoria da robustez e acomodação de falhas em sistemas

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Detecção de falhas em sistemas incertos com atraso no sinal de controle

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Detecção e acomodação de falhas em sistemas incertos com atraso no sinal de controle utilizando modo deslizante

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Controle com Estrutura Variável e Modos Deslizantes Aplicado em Sistema de Suspensão Ativa

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Lógica ANFIS aplicada na estimação da rugosidade e do desgaste da ferramenta de corte no processo de retificação plana de cerâmicas avançadas

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Aplicação de observadores e controladores com modos deslizantes no controle da geração

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Modos deslizantes discretos em sistemas incertos com atraso na computação do sinal de controle

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)