207 resultados para Variable Sampling Interval Control Charts


Relevância:

30.00% 30.00%

Publicador:

Resumo:

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Relevância:

30.00% 30.00%

Publicador:

Resumo:

The aim of this study was to examine the coupling between visual information and body sway and the adaptation in this coupling of individuals with cerebral palsy (CP). Fifteen children with and 15 without CP. 6-15 years old, were required to stand upright inside of a moving room. All children first performed two trials with no movement of the room and eyes open or closed, then four trials in which the room oscillated at 0.2 or 0.5 Hz (peak velocity of 0.6 cm/s), one trial in which the room oscillated at 0.2 Hz (peak velocity of 3.5 cm/s), and finally two other trials in which the room oscillated again at 0.2 Hz (peak velocity of 0.6 cm/s). Participants with CP coupled body sway to visual information provided by the moving room, comparable to the coupling of participants without CP. However, participants with CP exhibited larger body sway in maintaining upright position and more variable sway when body sway was induced by visual manipulation. They showed adaptive sensory motor coupling, e.g. down-weighting visual influence when a larger stimulus was provided, but not with the same magnitude as typically developing participants. This indicates that participants with CP have less capability of adaptation. (C) 2011 Published by Elsevier Ltd.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Realizou-se um estudo caso-controle com o propósito de se detectar possíveis fatores de risco para o aparecimento de fissuras orais. Foram objeto de análise: local de moradia da mãe nos quatro primeiros meses de gestação, poluição, aplicação de pesticida/herbicida na lavoura, doenças dos pais, doenças da mãe nos quatro primeiros meses de gestação, ingestão medicamentosa nesse período, hereditariedade, tabagismo, consumo de bebida alcoólica e exposição a raio-X. Foram aplicados formulários às mães referentes aos 450 casos, sendo 354 portadores de fissuras labiais ou lábio-palatais e 96 de fissuras palatinas, e às mães referentes aos 450 controles. Empregou-se análise multivariada e as variáveis hereditariedade (RR=4,96), epilepsia na mãe (RR=2,39) e ingestão de anti-inflamatório (RR=2,59) foram consideradas fatores de risco para fissuras labiais ou lábio-palatais. As variáveis hereditariedade (RR=2,82) e poluição (RR=2,58) foram consideradas fatores de risco para fissuras palatinas.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Relevância:

30.00% 30.00%

Publicador:

Resumo:

OBJETIVO: Verificar se a exposição ocupacional ao ruído é fator de risco relevante para acidentes do trabalho. MÉTODOS: Estudo de caso-controle de base populacional. Os dados foram coletados entre 16/5/2002 e 15/10/2002, na cidade de Botucatu, Estado de São Paulo. Os casos foram definidos como trabalhadores que sofreram acidentes ocupacionais típicos nos últimos 90 dias, identificados por intermédio de amostragem aleatória sistemática de domicílios residenciais. Os controles foram trabalhadores não acidentados, aleatoriamente alocados a partir da mesma população que originou os casos, emparelhados na razão 3:1 segundo sexo, faixa etária e setor censitário de moradia. Ajustou-se um modelo de regressão logística múltipla, tendo como variável independente a exposição ocupacional ao ruído, controlada por covariáveis de interesse. RESULTADOS: Foram analisados 94 casos e 282 controles. Ajustando-se um modelo de regressão logística condicional múltipla observou-se que trabalhar sempre e às vezes exposto a ruído intenso associou-se a um risco relativo de acidentar-se de 5,0 (IC 95%: 2,8-8,7; p<0,001) e 3,7 (IC 95%: 1,8-7,4; p=0,0003), respectivamente, tendo como referência trabalhar não exposto a ruído, controlado para diversas covariáveis. CONCLUSÕES: Com base nos resultados encontrados, justifica-se o investimento em programas de conservação auditiva particularmente voltados para o controle da emissão de ruídos na fonte. Essas medidas objetivam não apenas a manutenção da saúde auditiva, mas também a diminuição da acidentabilidade dos trabalhadores.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Nasopharyngeal colonization with methicillin-resistant Staphylococcus aureus (MRSA) often precedes the development of nosocomial infections. In order to identify risk factors for MRSA colonization, we conducted a case-case-control study, enrolling 122 patients admitted to a medical-surgical intensive care unit (ICU). All patients had been screened for nasopharyngeal colonization with S. aureus upon admission and weekly thereafter. Two case-control studies were performed, using as cases patients who acquired colonization with MRSA and methicillin-susceptible S. aureus (MSSA), respectively. For both studies, patients in whom colonization was not detected during ICU stay were selected as control subjects. Several potential risk factors were assessed in univariate and multivariable (logistic regression) analysis. MRSA and MSSA were recovered from nasopharyngeal samples from 27 and 10 patients, respectively. Independent risk factors for MRSA colonization were: length-of-stay in the ICU (Odds Ratio [OR]=1.12, 95%Confidence Interval[CI]=1.06-1.19, p<0.001) and use of ciprofloxacin (OR=5.05, 95%CI=1.38-21.90, p=0.015). The use of levofloxacin had a protective effect (OR=0.08, 95%CI=0.01-0.55, p=0.01). Colonization with MSSA was positively associated with central nervous system disease (OR=7.45, 95%CI=1.33-41.74, p=0.02) and negatively associated with age (OR=0.94, 95%CI=0.90-0.99, p=0.01). In conclusion, our study suggests a role for both cross-transmission and selective pressure of antimicrobials in the spread of MRSA.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

A portable or field test method for simultaneous spectrophotometric determination of calcium and magnesium in water using multivariate partial least squares (PLS) calibration methods is proposed. The method is based on the reaction between the analytes and methylthymol blue at pH 11. The spectral information was used as the X-block, and the Ca(II) and Mg(II) concentrations obtained by a reference technique (ICP-AES) were used as the Y-block. Two series of analyses were performed, with a month's difference between them. The first series was used as the calibration set and the second one as the validation set. Multivariate statistical process control (MSPC) techniques, based on statistics from principal component models, were used to study the features and evolution with time of the spectral signals. Signal standardization was used to correct the deviations between series. Method validation was performed by comparing the predictions of the PLS model with the reference Ca(II) and Mg(II) concentrations determined by ICP-AES using the joint interval test for the slope and intercept of the regression line with errors in both axes. (C) 1998 John Wiley & Sons, Ltd.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

In greenhouse trials, copper hydroxide, pyraclostrobin, and famoxadone were applied to actively crowing young citrus seedlings to determine the duration of protection of young leaves provided by these fungicides against melanose, caused by Diaporthe citri, citrus scab, caused by Elsinoe fawcettii, and Alternaria brown spot, caused by Alternaria alternata. Fungicides were applied to different sets of potted plants of grapefruit for control of melanose, of rough lemon for control of scab, and of Dancy tangerine for control of Afternaria brown spot 1 to 6 days prior to inoculation. as well as on the day of inoculation. Leaf area of treated shoots was estimated on the day of fungicide application and the day of inoculation and disease severity evaluated subsequently. In most cases. copper hydroxide and famoxadone provided at least 50% control of all three diseases for only about 2 days after application. Generally, there was little or no disease control when the products were applied 4 or more days before inoculation. In contrast, pyraclostrobin usually provided a high level of control of all three diseases when applied up to 5 days prior to inoculation. The level of disease control decreased as the interval between a fungicide application and inoculation increased and the relationship between disease control and leaf expansion best fit a quadratic equation. Effective disease control was observed with copper hydroxide and famoxadone until leaf area had increased by 100 to 200%, whereas control with pyraclostrobin was observed up to 400 to 500% increase in leaf area. In postinoculation tests with scab and melanose, pyraclostrobin provided high levels of disease control (>75%) when applied up to 2 days after inoculation. whereas copper hydroxide and famoxadone had minimal postinoculation activity. Applications of pyraclostrobin to the spring flush growth of citrus trees are much more likely to provide control of melanose, scab, and Alternaria brown spot than those of famoxadone or copper hydroxide.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

This paper presents a multi-cell single-phase high power factor boost rectifier in interleave connection, operating in critical conduction mode, employing a soft-switching technique, and controlled by Field Programmable Gate Array (FPGA). The soft-switching technique is based on zero-current-switching (ZCS) cells, providing ZC (zero-current) turn-on and ZCZV (zero-current-zero-voltage) turn-off for the active switches, and ZV (zero-vohage) turn-on and ZC (zero-current) turn-off for the boost diodes. The disadvantages related to reverse recovery effects of boost diodes operated in continuous conduction mode (additional losses, and electromagnetic interference (EMI) problems) are minimized, due to the operation in critical conduction mode. In addition, due to the interleaving technique, the rectifier's features include the reduction in the input current ripple, the reduction in the output voltage ripple, the use of low stress devices, low volume for the EMI input filter, high input power factor (PF), and low total harmonic distortion (THD) in the input current, in compliance with the IEC61000-3-2 standards. The digital controller has been developed using a hardware description language (VHDL) and implemented using a XC2S200E-SpartanII-E/Xilinx FPGA device, performing a true critical conduction operation mode for all interleaved cells, and a closed-loop to provide the output voltage regulation, like as a preregulator rectifier. Experimental results are presented for a implemented prototype with two and with four interleaved cells, 400V nominal output voltage and 220V(rms) nominal input voltage, in order to verify the feasibility and performance of the proposed digital control through the use of a FPGA device.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

This work describes a methodology for power factor control and correction of the unbalanced currents in four-wire electric circuits. The methodology is based on the insertion of two compensation networks, one wye-grounded neutral and other in delta, in parallel to the load. The mathematical development has been proposed in previous work [3]. In this paper, however, the determination of the compensation susceptances is based on the instantaneous values of load currents. The results are obtained using the MatLab-Simulink enviroment

Relevância:

30.00% 30.00%

Publicador:

Resumo:

This work will propose the control of an induction machine in field coordinates with imposed stator current based on theory of variable structure control and sliding mode. We describe the model of an induction machine in field coordinates with imposed stator current and we show the design of variable structure control and sliding mode to get a desirable dynamic performance of that plant. To estimate the inaccessible states we will use a state observer (estimator) based on field coordinates induction machine. We will present the results of simulations in any operation condition (start, speed reversal and load) and with parameters variation of the machine compared to a PI control scheme.