SURFACE MODIFICATION of SUGARCANE BAGASSE CELLULOSE and ITS EFFECT on MECHANICAL and WATER ABSORPTION PROPERTIES of SUGARCANE BAGASSE CELLULOSE HDPE COMPOSITES

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

WATER ABSORPTION of THE FUR and SWIMMING BEHAVIOR of SEMIAQUATIC and TERRESTRIAL ORYZOMINE RODENTS

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

INVITRO ACTION OF VASOPRESSIN ON WATER-ABSORPTION BY RAT COLON

The action of vasopressin on water absorption was studied in vitro in the colon of rats, weighing approximately 250 g. Everted sacs of intestinal segments (ascending and descending colons) prepared with mucosa only were used. Vasopressin (10 mM) significantly stimulated water absorption in both the proximal (4.85 +/- 3.78 vs 1.51 +/- 1.16 ml/mg) and distal (10.39 +/- 3.52 vs 7.22 +/- 3.58 ml/mg) colon, which corresponds to an increase of 220% and 50%,respectively. The results indicate the need for a study of the possible physiological function of vasopressin in enhancing intestinal water absorption, when it is released in response to plasma hyperosmolarity.

Extrinsic factors affecting water absorption in chilling of broiler chicken carcasses

Brazil occupies an outstanding position as a producer and exporter of chicken meat, and the maintenance and expansion of this position require a constant evolution, especially in variables which determine quality. An important quality parameter of poultry meat is the amount of water absorbed by the carcass during processing. In Brazil, carcasses chilling is done by immersion in chilled water. In this process, the carcass is rehydrated and the water lost during transport and initial operations is replaced. At this stage, some care is needed to prevent the absorption of water upper than the level allowed by Brazilian law. This project aimed to evaluate extrinsic factors that can influence the absorption of water by the chicken meat. For this, 144 Cobb chickens divided into 24 groups of six birds were used. At 42 days of age, one chicken of each group, with weight ranging up to 10% more or less from the average of the group, was slaughtered in an experimental pilot scale abattoir where slaughter procedures were conducted under strictly controlled conditions. The chilling procedure was performed following a completely randomized design with factorial arrangement 3x2, where the factors were: three temperatures in the first section of the chilling system (4, 10 and 16ºC) and two degrees of water hardness (hard and soft water), with six treatments and four replications. Brazilian law provides that the water temperature in the first section of the chiller must not be higher than 16ºC, and the length of the carcasses in this section shall not exceed 30 minutes. All carcasses remained in the first section of the chiller for 30 minutes and then were transferred to another tank with water at 4ºC, remaining there until reaching 7ºC. The carcasses were weighed before and after chilling, to evaluate the percentage of water absorbed. The water absorption was influenced by the initial temperature of the water in the chiller and by the water hardness. When initially immersed in water at 4ºC, carcasses water absorption averaged 2.70%, a significantly lower absorption than the values found for the carcasses that were initially immersed in water at 16ºC, 3.83% (p<0.05). The carcasses immersed in water at 10ºC had mean water absorption of 3.66%, not differing from the means observed in the other two treatments (p>0.05). In hard water, the average water absorption was 2.46% and, in soft water, 4.33% (p<0.05). In all treatments, the water absorption did not exceed the limit established by Brazilian legislation, which is a maximum of 8%. This information is important to control the absorption of water by carcasses in chicken meat processing, preventing consumers from being harmed.

Imbibition phases and germination response of Mimosa bimucronata (Fabaceae: Mimosoideae) to water submersion

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

WATER BALANCE and SPATIAL DISTRIBUTION of AN ANURAN COMMUNITY FROM BRAZIL

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

The Effect of Water Immersion and UV Radiation Aging on the Shear Behavior of Woven Continuous Fiber/PEI Laminates

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Water sorption, solubility, and bond strength of two autopolymerizing acrylic resins and one heat-polymerizing acrylic resin.

STATEMENT OF PROBLEM: Because water sorption of autopolymerizing acrylic reline resins is accompanied by volumetric change, it is a physical property of importance. As residual monomer leaches into the oral fluids and causes tissue irritation, low solubility of these resins is desired. Another requirement is a satisfactory bond between the autopolymerizing acrylic resins and the denture base acrylic resin. PURPOSE: This study compared the water sorption, solubility, and the transverse bond strength of 2 autopolymerizing acrylic resins (Duraliner II and Kooliner) and 1 heat-polymerizing acrylic resin (Lucitone 550). MATERIAL AND METHODS: The water sorption and solubility test was performed as per International Standards Organization Specification No. 1567 for denture base polymers. Bond strengths between the autopolymerizing acrylic resins and the heat-polymerizing acrylic resin were determine with a 3-point loading test made on specimens immersed in distilled water at 37 degrees C for 50 hours and for 30 days. Visual inspection determined whether failures were adhesive or cohesive. RESULTS: Duraliner II acrylic resin showed significantly lower water sorption than Kooliner and Lucitone 550 acrylic resins. No difference was noted in the solubility of all materials. Kooliner acrylic resin demonstrated significantly lower transverse bond strength to denture base acrylic resin and failed adhesively. The failures seen with Duraliner II acrylic resin were primarily cohesive in nature. CONCLUSIONS: Autopolymerizing acrylic reline resins met water sorption and solubility requirements. However, Kooliner acrylic resin demonstrated significantly lower bond strength to denture base acrylic resin.

Changes in physical properties of extruded sour cassava starch and quinoa flour blend snacks

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Produção de snacks funcionais à base de farinha de soja e polvilho azedo

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Effect of citrus sudden death on yield and quality of sweet orange cultivars in Brazil

Citrus sudden death (CSD) has greatly affected sweet orange cultivars grafted on Rangpur lime in São Paulo and Minas Gerais States, Brazil. To characterize and quantify CSD damage, fruit yield and quality were assessed in each combination of sweet orange cultivar (Hamlin, Pera, Natal, and Valencia), age class (3 to 5, 6 to 10, and 11 to 15 years old), and CSD severity class (0 = no symptom, 1 = initial symptoms, and 2 = severe symptoms). For each combination, 10 trees were harvested and 20 fruit were taken for quality analysis. Damage was characterized by reduc_ tion of: (i) total weight of fruit/tree (36 and 67% for severity class 1 and 2, respectively), (ii) number of fruit/tree (27 and 55%), (iii) fruit size (13 and 25% in diameter and height [stem to styler distance]), (iv) fruit weight (32 and 56%), (v) total soluble solids (TSS)/fruit (18 and 42%), and increase of (vi) Brix (14 and 34%), (vii) acidity (16 and 41%), and (viii) TSS/90-1b. box (21 and 33%). There was no alteration on Brix/acidity ratio and percentage of juice on fruit of affected trees. Sweet orange cultivars did not differ in percentage of reduction or increase of all yield and quality variables, with the exception of Pera, which expressed increases of Brix and acidity. For more severe affected trees, the youngest plants showed a higher reduction in fruit number/tree, whereas plants 6 to 10 years old showed a higher increase in fruit acidity and TSS/box. However, no differences in percentage of reduction or increase for other variables were observed among different age classes. The damage to the above probably was associated with reduced water absorption capacity of CSD-affected trees.

Produtividade, eficiência agronômica, características nutricionais e tecnológicas do feijão adubado com nitrogênio em plantio direto e convencional

Altas produtividades do feijoeiro são obtidas sob condições tecnológicas adequadas, destacando-se o uso de sistemas de manejos de solo e a adubação nitrogenada, porém, há pouco conhecimento sobre tais técnicas culturais interferindo nas características nutricionais e tecnológicas de grãos. Desse modo, o trabalho teve como objetivo verificar a interferência da adubação nitrogenada em cobertura (0, 40, 80, 120 e 160 kg ha-1 de N) no feijoeiro, cultivar Pérola, cultivado no preparo convencional do solo e no plantio direto e suas relações com a produtividade, eficiência agronômica, características nutricionais e tecnológicas do grão. O delineamento experimental empregado foi o de blocos ao acaso em esquema de parcelas subdivididas, com quatro repetições, onde as parcelas foram constituídas pelos sistemas de manejo de solo e as subparcelas pelas doses de N em cobertura. A produtividade do feijoeiro é influenciada positivamente pela adubação nitrogenada em cobertura, com maior necessidade de fertilizante no plantio direto. A eficiência agronômica é superior no sistema de preparo convencional do solo. O aumento do teor de proteína bruta é em função das doses crescentes de N em cobertura nos sistemas de plantio direto e de preparo convencional do solo. O tempo para cozimento dos grãos é diminuido em função das doses de N empregadas no sistema de plantio direto em relação ao preparo convencional. Há aumento no tempo para a máxima hidratação dos grãos até a aplicação de 120 kg ha-1 de N no sistema de plantio direto e no preparo convencional do solo.

Ionized-air-treated curaua fibers as reinforcement for phenolic matrices

Curaua fibers were treated with ionized air to improve the fiber/phenolic matrix adhesion.The treatment with ionized air did not change the thermal stability of the fibers. The impact strength increased with increase in the fiber treatment time. SEM micrographs of the fibers showed that the ionized air treatment led to separation of the fiber bundles. Treatment for 12 h also caused a partial degradation of the fibers, which prompted the matrix to transfer the load to a poorer reinforcing agent during impact, thereby decreasing the impact strength of the related composite. The composites reinforced with fibers treated with ionized air absorbed less water than those reinforced with untreated fibers.

Resistência a compressão de tijolos de solo-cimento fabricados com o montículo do cupim Cornitermes cumulans (Kollar, 1832)

Objetivou-se neste trabalho, comparar a resistência à compressão de tijolos de solo-cimento fabricados com o montículo do cupim Cornitermes cumulans (Kollar, 1832), com tijolos que utilizaram como matéria prima um NEOSSOLO QUARTZARÊNICO (Empresa Brasileira de Pesquisa Agropecuária (EMBRAPA), 1999), ambos submetidos a duas idades de cura (07 ou 28 dias). O experimento foi montado em delineamento inteiramente casualizado, em esquema fatorial 2x2, sendo analisados dois cofatores: a matéria prima base e a idade de cura. Os ensaios físicos e mecânicos obedeceram às prescrições das normas da Associação Brasileira de Normas Técnicas NBR-8492 (ABNT, 1982) e NBR-8491 (ABNT, 1984). Concluiu-se que a resistência à compressão dos tijolos foi maior com o aumento das idades de cura. O tratamento T4 apresentou maior valor de resistência à compressão, não diferindo estatisticamente dos tratamentos T2 e T1. Os tijolos fabricados com o montículo do cupim C. cumulans (Kollar, 1832) apresentaram diminuição da absorção de água com o aumento das idades de cura, o que normalmente corresponde a um maior aumento da resistência à compressão, ao contrário dos que utilizaram o NEOSSOLO QUARTZARÊNICO (Empresa Brasileira de Pesquisa Agropecuária (EMBRAPA), 1999).

Efeitos na taxa de transporte de elétrons de plantas daninhas após aplicação de amicarbazone

Entre os herbicidas registrados para cana-de-açúcar, o amicarbazone é um dos mais importantes para o controle das plantas daninhas, sendo preciso que o herbicida seja absorvido, translocado e que ele alcance os cloroplastos das células das folhas para atuar em seu sítio de ligação no fotossistema II. O objetivo deste trabalho foi avaliar os efeitos da aplicação do amicarbazone na taxa de transporte de elétrons (ETR) de Ipomoea grandifolia, Brachiaria decumbens e Digitaria horizontalis. Foi verificada a resposta dessas plantas daninhas, em relação à ETR, quando submetidas ao amicarbazone em solução e na sequência à solução sem herbicida, por meio de leituras da ETR, realizadas em folhas novas e adultas com o uso de um fluorômetro portátil. Verificou-se também o consumo de água das plantas daninhas pela pesagem diária dos recipientes contendo a solução e as plantas. Assim, verificou-se por meio do experimento que a redução dos valores da ETR pode ser utilizada para indicar o nível de intoxicação nas plantas daninhas em estudo. As plantas daninhas I. grandifolia, B. decumbens e D. horizontalis apresentaram respostas diferenciadas quando submetidas a solução sem herbicida após solução com amicarbazone. I. grandifolia apresentou-se mais sensível ao amicarbazone devido à maior dificuldade em recuperar os níveis iniciais de ETR, além de apresentar alterações nas folhas novas após o termino de fornecimento do herbicida. O consumo de água pode explicar esse comportamento em I. grandifolia, visto tratar-se da espécie que mais consumiu água e, consequentemente, mais absorveu o amicarbazone. Já para B. decumbens e D. horizontalis ocorreram menores níveis de absorção de água e, por conseguinte, as folhas velhas tiveram melhor recuperação do transporte de elétrons e não houve intoxicação em folhas novas.