Computations of the flow past a still sphere at moderate reynolds numbers using an immersed boundary method

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Changes on emitter discharge under different water temperature and pressure

The study was conducted at the Research Laboratory of Hydraulic and Irrigation Group in the Rural Engineering Department, Technical University of Madrid (Universidad Politecnica de Madrid), Madrid, Spain. Water temperatures of 20, 30, 40 degrees C and system pressures often encountered in irrigation practices of 80, 90, 100, 110, 120, 130, 140, 150, 160, 170, 180, 190 and 200 k Pa were applied to determine the effects of different water temperatures and pressures on emitter discharge. Non-pressure compensating in-line emitter which has turbulent flow regime with a long-path (labyrinth), emitter discharge was 4 L h(-1) at system pressure of 100 kPa according to the manufacturer recommended, was used. Emitters were spaced 20 cm along the drip laterals with 16 mm diameter. Discharge equations and coefficients of variation related to temperatures of 20, 30 and 40 degrees C were obtained as q = 0.375H(0.51), q = 0.358H(0.52), q = 0.346H(0.53) and 2.68, 2.09, 3.65, respectively. Discharge of the emitter was affected by different system pressures and increased as potentially (R = 0993-0996). In general. the emitter discharge increased with increasing temperature. However, especially in the common system pressures of 90-120 k Pa, differences of obtained emitter discharges between the different water temperatures were not significant (1%).

Hydrodynamic aspects of the amorphous alloy ribbon fabrication

Conditions for as-quenched amorphous ribbon fabrication by a single roll-casting method are analyzed from a hydrodynamic standpoint. The analysis is based on the investigation of the processing conditions for Fe 4 0Ni 40P 14B 6 amorphous ribbons. It is shown that the dependence of ribbon thickness on the ejection pressure for different roll angular velocities and different dimensions of crucible and orifice can be obtained from general considerations on the melt flow regime.

Carbon dioxide evaporation in a single microchannel

Despite its importance for designing evaporators and condensers, a review of the literature shows that heat transfer data during phase change of carbon dioxide is very limited, mainly for microchannel flows. In order to give a contribution on this subject, an experimental study of CO 2 evaporation inside a 0.8 mm-hydraulic diameter microchannel was performed in this work. The average heat transfer coefficient along the microchannel was measured and visualization of the flow patterns was conducted. A total of 67 tests were performed at saturation temperature of 23.3°C for a heat flux of 1800 W/(m2°C). Vapor qualities ranged from 0.005 to 0.88 and mass flux ranged from 58 to 235 kg/(m2s). An average heat transfer coefficient of 9700 W/(m2°C) with a standard deviation of 35% was obtained. Nucleate boiling was found to characterize the flow regime for the test conditions. The dryout of the flow, characterized by the sudden reduction in the heat transfer coefficient, was identified at vapor qualities around 0.85. Flow visualization results showed three flow patterns. For low vapor qualities (up to about 0.25), plug flow was predominant, while slug flow occurred at moderated vapor qualities (from about 0.25 to 0.50). Annular flow was the flow pattern for higher vapor qualities. Copyright © 2006 by ABCM.

Aplicação da transformada integral generalizada no escoamento potencial em contrações

Pós-graduação em Engenharia Mecânica - FEIS

Um panorama sobre roll waves em escoamentos laminares e turbulentos com superfície livre

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Avaliação de um biorreator rotativo para fermentação em estado sólido

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Simulação de modelagem quali-quantitativa para avaliação preliminar da qualidade da água na bacia do Ribeirão das Perdizes em Campos do Jordão/SP como subsídio ao enquadramento

Pós-graduação em Engenharia Civil e Ambiental - FEB

Desenvolvimento de um biorreator rotativo para produção de enzimas celulolíticas por fermentação em estado sólido

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

A comparative evaluation of the CF:CS and CRS models in Pb-210 chronological studies applied to hydrographic basins in Brazil

The Constant Flux: Constant Sedimentation (CF:CS) and Constant Rate of Supply (CRS) of unsupported/excess Pb-210 models have been applied to a Pb-210 data set providing of eighteen sediments profiles sampled at four riverine systems occurring in Brazil, South America: Corumbatai River basin (S1=Site 1, Sao Paulo State), Atibaia River basin (S2=Site 2, Sao Paulo State), Ribeirao dos Bagres basin (S3=Site 3, Sao Paulo State) and Amazon River mouth. (S4=Site 4, Amapa State). These sites were chosen for a comparative evaluation of the performance of the CF:CS and CRS models due to their pronounced differences on the geographical location, geological context, soil composition, biodiversity, climate, rainfall, and water flow regime, among other variable aspects. However, all sediments cores exhibited a common denominator consisting on a database built from the use of the same techniques for acquiring the sediments major chemical composition (SiO2, Al2O3, Na2O, K2O, CaO, MgO, Fe2O3, MnO, P2O5, TiO2 and LOI-Loss on Ignition) and unsupported/excess 210Pb activity data. In terms of sedimentation rates, the performance of the CRS model was better than that of the CF:CS model as it yielded values more compatible with those expected from field evidences. Under the chronological point of view, the CRS model always provided ages within the permitted range of the Pb-210-method in the studied sites, whereas the CF:CS model predicted some values above 150 years. The SiO2 content decreased in accordance with the LOI increase in all cores analyzed and such inverse relationship was also tracked in the SiO2-LOI curves of historical trends. The SiO2-LOI concentration fluctuations in sites S1 and S3 also coincided with some Cu and Cr inputs in the drainage systems. (C) 2014 Elsevier Ltd. All rights reserved.

Fácies e associação de fácies da formação Pirambóia na região de Descalvado/SP

The Pirambóia Formation is a lithostratigraphic unit of the Paraná Basin, positioned between the Corumbataí (lower) and Botucatu (upper) Formations on the eastern edge of the basin. This unit is focused by many studies due to its great importance as an essential component in the Guarani Aquifer System (SAG) and the petroleum system “Irati-Pirambóia”, as excellent reservoirs. The Pirambóia Formation is historically the subject of several controversies on issues like age, contact relationships with the upper unit and depositional paleoenvironment. Despite these aspects, the Pirambóia Formation is commonly taken to be of Triassic age and is considered a product of wet aeolian systems, with plenty of wet interdunes and subordinate fluvial facies. In this work, by using techniques such as facies analysis, depositional architecture and facies association, facies of this unit were characterized and their depositional paleoenvironment was inferred particularly in Jundu Mining, region of Descalvado in northeastern São Paulo. Techniques such as grain size and petrographic analyses, aimed to characterize this unit as a potential reservoir rock. Five facies were described for the Pirambóia Formation in the studied region: St, Sh, Sm, Sr and Gt facies, generated by sedimentary processes of the bottom load type, mostly under low flow regime (with exception for the Sh facies, which is formed by upper flow regime processes). In addition to that, four facies associations were recognized from the architectural elements, primarily contained within the main channel: complex channel bars, composed by foreset macroforms (FM), sandy bedforms (SB) and gravel bars and bedforms (GB); flood deposits, constituted by laminated sand sheets (LS); deposits of hyperconcentrated flows and eolian deposits. It was interpreted that the Pirambóia Formation in Descalvado (SP) is the record of the sedimentation of braided rivers, with dunes and interdunes deposits...

Influence of structural nonlinearities in stall-induced aeroelastic response of pitching airfoils

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Tratamento de águas residuárias de suinocultura em reatores anaeróbios horizontais de alta taxa seguidos de filtro biológico percolador

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Simulação de modelagem qualitativa para avaliação preliminar da qualidade da água na Bacia do Ribeirão das Perdizes em Campos do Jordão/SP, como subsídio ao enquadramento

The purpose of this research was to present the principles for the implementation of a future water body classification program at the UGRHI-1 (Management Unit of Water Resources-1/São Paulo, Brazil) using qualitative and quantitative water modeling. Our study area was in Campos do Jordão, a city in the state of São Paulo, specifically in the Perdizes river watershed, which is included in the UGRHI-1. The water quality assessment used a modeling mehtodology that can support a future study for the classification of water bodies in the region. The behavior of DO and BOD parameters was assessed in the water quality scenarios, considering the variations of flows, loads, reductions in withdrawals and different efficiencies in sewage treatment. The model used was QUAL2E developed by USEPA (United States Environmental Protection Agency) that received a new graphic interface named QUAL2R model. The reference flows Q7,10, Q95% and Qm used were obtained through the DAEE (Department of Water and Electric Energy) hydrologic regionalization method. It was noted that of the 9 proposed scenarios, only scenario 6 that was predicted in the flow regime Qm with the existence of a treatment system capable of removing 93% of the BOD, in the Perdizes River remained 67.5% of the time in class 2. Scenario 8 predicted a 50% reduction in In scenario 8 a reduction of 50% in the flow captured in CA-04, associated with the efficiency of 93% of BOD removal keeping the river in class 2. In scenario 9 the minimum required efficiency in sewage treatment in the flow regime Q95% for keeping the river in class 2 was also calculated and the value of 94.7% was obtained.

Dinâmica fluvial e regime hidrológico na bacia hidrográfica do rio Paranapanema

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)