The Variable Sample Size (X)over-bar Chart with Estimated Parameters

The VSS X chart, dedicated to the detection of small to moderate mean shifts in the process, has been investigated by several researchers under the assumption of known process parameters. In practice, the process parameters are rarely known and are usually estimated from an in-control Phase I data set. In this paper, we evaluate the (run length) performances of the VSS chart when the process parameters are estimated, we compare them in the case where the process parameters are assumed known and we propose specific optimal control chart parameters taking the number of Phase I samples into account.

Preliminary results concerning the VSS X- chart with unknow in-control parameters

The VSS X- chart is known to perform better than the traditional X- control chart in detecting small to moderate mean shifts in the process. Many researchers have used this chart in order to detect a process mean shift under the assumption of known parameters. However, in practice, the process parameters are rarely known and are usually estimated from an in-control Phase I data set. In this paper, we evaluate the (run length) performances of the VSS X- control chart when the process parameters are estimated and we compare them in the case where the process parameters are assumed known. We draw the conclusion that these performances are quite different when the shift and the number of samples used during the phase I are small. ©2010 IEEE.

Fuzzy modeling to predict chicken egg hatchability in commercial hatchery

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Application of ionospheric corrections in the equatorial region for L1 GPS users

In the absence of the selective availability, which was turned off on May 1, 2000, the ionosphere can be the largest source of error in GPS positioning and navigation. Its effects on GPS observable cause a code delays and phase advances. The magnitude of this error is affected by the local time of the day, season, solar cycle, geographical location of the receiver and Earth's magnetic field. As it is well known, the ionosphere is the main drawback for high accuracy positioning, when using single frequency receivers, either for point positioning or relative positioning of medium and long baselines. The ionosphere effects were investigated in the determination of point positioning and relative positioning using single frequency data. A model represented by a Fourier series type was implemented and the parameters were estimated from data collected at the active stations of RBMC (Brazilian Network for Continuous Monitoring of GPS satellites). The data input were the pseudorange observables filtered by the carrier phase. Quality control was implemented in order to analyse the adjustment and to validate the significance of the estimated parameters. Experiments were carried out in the equatorial region, using data collected from dual frequency receivers. In order to validate the model, the estimated values were compared with ground truth. For point and relative positioning of baselines of approximately 100 km, the values of the discrepancies indicated an error reduction better than 80% and 50% respectively, compared to the processing without the ionospheric model. These results give an indication that more research has to be done in order to provide support to the L1 GPS users in the Equatorial region.

Extração de feições retas com precisão subpixel: estudo comparativo entre três métodos

In the fields of Machine Vision and Photogrammetry, extracted straight lines from digital images can be used either as vector elements of a digital representation or as control entities that allow the determination of the camera interior and exterior orientation parameters. Applications related with image orientation require feature extraction with subpixel precision, to guarantee the reliability of the estimated parameters. This paper presents three approaches for straight line extraction with subpixel precision. The first approach considers the subpixel refinement based on the weighted average of subpixel positions calculated on the direction perpendicular to the segmented straight line. In the second approach, a parabolic function is adjusted to the grey level profile of neighboring pixels in a perpendicular direction to the segmented line, followed by an interpolation of this model to estimate subpixel coordinates of the line center. In the third approach, the subpixel refinement is performed with a parabolic surface adjustment to the grey level values of neighboring pixels around the segmented line. The intersection of this surface with a normal plane to the line direction generates a parabolic equation that allows estimating the subpixel coordinates of the point in the straight line, assuming that this is the critical point of this function. Three experiments with real images were made and the approach based on parabolic surface adjustment has presented better results.

Senna occidentalis Link. (Caesalpiniaceae) imbibition curves for NaCl osmotic potential levels up to 0.6 MPa

An investigation is reported on the statistical model of imbibition curves of the seeds of Senna occidentalis Link. (Caesalpiniaceae), up to Phase II (start of root emission) in osmotic potential levels (0; -0.2; -0.4 and -0.6 MPa), induced NaCl or PEG 6000. The statistical model for both solutions was y = a [1 b exp(-cx)] where y is the fresh matter of seed in g, and x the time of evaluation in h. The analysis of variance of the estimated parameters, showed that with the NaCl solution, the -0.4 and -0.6 MPa levels differed significantly from the 0 and -0.2 MPa levels, and that with the PEG solution, the -0.6 MPa differed from the rest. Prolongation of Phase II occurred as the potential decreased, with both solutions. More reduction in water uptake and prolongation of this phase occurred with the PEG treatment.

Biologia populacional de Cyphocarax modestus (Osteichthyes, Curimatidae) no córrego Ribeirão Claro, município de Rio Claro (SP)

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Crescimento e mortalidade de Oligosarcus hepsetus (Cuvier, 1829) (Characiformes, Characidae) no Parque Estadual da Serra do Mar, Núcleo Santa Virgínia, São Paulo, Brasil

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Crescimento e mortalidade de Brycon opalinus (Characiformes, Characidae) no Parque Estadual da Serra do Mar, Mata Atlântica, Estado de São Paulo

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Biologia populacional de Cyphocarax modestus no córrego Ribeirão Claro, município de Rio Claro (SP)

This work aimed a better understanding of the annual cycle of Cyphocarax modestus in the reservoir of water captation of Ribeirao Claro stream. The growth parameters were estimated through the analysis of length distribution and the relationships among time of smaller growth, alimentary activity, fat accumulation and reproductive period were considered. Besides, the instantaneous rate of natural mortality was calculated. Monthly samplings were accomplished in the Ribeirao Claro stream, in the reservoir of water captation of Rio Claro city. For that, 50 m of wait net was used, with meshes of 1.5, 2.0, 2.5, 3.0 and 3.5 cm measured between adjacent knots. The ELEFAN I program was used to estimate the growth parameters, and its application was done using the FISAT program. It was also used the seasonal version of von Bertalanffy's growth curve. It was considered that the reproduction of C. modestus is annual and concentrated from December to February, allowing the identification of different modas in the distributions, an essential condition for the conduction of that analysis type. The estimated parameters were: K = 0.34/year, L [infinity] = 15.40 cm, C = 0.2, Wp = 0.6 and M = 0.949/year, with the identification of four cohorts. The physiologic sequence in the annual cycle of the specie could be noted when data of accumulated fat in the visceral cavity, alimentary activity, reproduction time and time of smaller growth were analyzed together. It was noted that with the beginning of the maturation of gonads, the energy resources stopped being invested in the growth and passed to be used for reproduction.

Growth of the tambaqui Colossoma macropomum (Cuvier) (Characiformes: Characidae): which is the best model?

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Modelos alternativos para detecção de locos de características quantitativas (QTL) de carcaça e crescimento nos cromossomos 4, 5 e 7 de suínos

O conhecimento do genoma pode auxiliar na identificação de regiões cromossômicas e, eventualmente, de genes que controlam características quantitativas (QTLs) de importância econômica. em um experimento com 1.129 suínos resultantes do cruzamento entre machos da raça Meishan e fêmeas Large White e Landrace, foram analisadas as características gordura intramuscular (GIM), em %, e ganho dos 25 aos 90 kg de peso vivo (GP), em g/dia, em 298 animais F1 e 831 F2, e espessura de toucinho (ET), em mm, em 324 F1 e 805 F2. Os animais das gerações F1 e F2 foram tipificados com 29 marcadores microsatélites. Estudou-se a ligação entre os cromossomos 4, 6 e 7 com GIM, ET e GP. Análises de QTL utilizando-se metodologia Bayesiana foram aplicadas mediante três modelos genéticos: modelo poligênico infinitesimal (MPI); modelo poligênico finito (MPF), considerando-se três locos; e MPF combinado com MPI. O número de QTLs, suas respectivas posições nos três cromossomos e o efeito fenotípico foram estimados simultaneamente. Os sumários dos parâmetros estimados foram baseados nas distribuições marginais a posteriori, obtidas por meio do uso da Cadeia de Markov, algoritmos de Monte Carlo (MCMC). Foi possível evidenciar dois QTLs relacionados a GIM nos cromossomos 4 e 6 e dois a ET nos cromossomos 4 e 7. Somente quando se ajustou o MPI, foram observados QTLs no cromossomo 4 para ET e GIM. Não foi possível detectar QTLs para a característica GP com a aplicação dessa metodologia, o que pode ter resultado do uso de marcadores não informativos ou da ausência de QTLs segregando nos cromossomos 4, 6 e 7 desta população. Foi evidenciada a vantagem de se analisar dados experimentais ajustando diferentes modelos genéticos; essas análises ilustram a utilidade e ampla aplicabilidade do método Bayesiano.

Heat transfer in fixed bed: a model non-linearity approach

Studies have been carried out on the heat transfer in a packed bed of glass beads percolated by air at moderate flow rates. Rigorous statistic analysis of the experimental data was carried out and the traditional two parameter model was used to represent them. The parameters estimated were the effective radial thermal conductivity, k, and the wall coefficient, h, through the least squares method. The results were evaluated as to the boundary bed inlet temperature, T-o, number of terms of the solution series and number of experimental points used in the estimate. Results indicated that a small difference in T-o was sufficient to promote great modifications in the estimated parameters and in the statistical properties of the model. The use of replicas at points of high parametric information of the model improved the results, although analysis of the residuals has resulted in the rejection of this alternative. In order to evaluate cion-linearity of the model, Bates and Watts (1988) curvature measurements and the Box (1971) biases of the coefficients were calculated. The intrinsic curvatures of the model (IN) tend to be concentrated at low bed heights and those due to parameter effects (PE) are spread all over the bed. The Box biases indicated both parameters as responsible for the curvatures PE, h being somewhat more problematic. (C) 2000 Elsevier B.V. Ltd. All rights reserved.

Nonlinear parameter estimation in laminar forced convection within a circular sector tube

In this article we examine an inverse heat convection problem of estimating unknown parameters of a parameterized variable boundary heat flux. The physical problem is a hydrodynamically developed, thermally developing, three-dimensional steady state laminar flow of a Newtonian fluid inside a circular sector duct, insulated in the flat walls and subject to unknown wall heat flux at the curved wall. Results are presented for polynomial and sinusoidal trial functions, and the unknown parameters as well as surface heat fluxes are determined. Depending on the nature of the flow, on the position of experimental points the inverse problem sometimes could not be solved. Therefore, an identification condition is defined to specify a condition under which the inverse problem can be solved. Once the parameters have been computed it is possible to obtain the statistical significance of the inverse problem solution. Therefore, approximate confidence bounds based on standard statistical linear procedure, for the estimated parameters, are analyzed and presented.

Função Gompertz aplicada a modelagem de produção do biogás em biodigestor tipo batelada

Pós-graduação em Agronomia (Energia na Agricultura) - FCA