Compósitos de matriz metálica à base níquel com adição de TaC e NbC produzidos via metalurgia do pó

Carbide reinforced metallic alloys potentially improve some important mechanical properties required for the overall use of important engineering materials such as steel and nickel. Nevertheless, improved performance is achieved not only by composition enhancement but also by adequate processing techniques, such as novel sintering methods in the case of powder metallurgy. The method minimizes energy losses in addition to providing uniform heating during sintering. Thus, the general objective of this study was to evaluate the density, hardness, flexural strength, dilatometric behavior and to analyze the microstructure of metal matrix composites based nickel with addition of carbides of tantalum and / or niobium when sintered in a conventional furnace and Plasma assisted debinding and sintering (PADS). Initially, were defineds best parameters of granulation, screening and mixing procedure. After, mixtures of carbonyl Ni and 5%, 10% and 15 wt.% NbC and TaC were prepared in a Y-type mixer under wet conditions during 60 minutes. The mixtures were then dried and granulated using 1.5 wt. % paraffin diluted in hexane. Granulates were cold pressed under 600 MPa. Paraffin was then removed from the pressed pellets during a pre-sintering process carried out in a tubular furnace at 500 °C during 30 min. The heating rate was 3 ºC/min. The pellets were then sintered using either a plasma assisted reactor or a conventional resistive tubular furnace. For both methods, the heating rate was set to 8 ºC/min up to 1150 °C. The holding time was 60 minutes. The microstructure of the sintered samples was evaluated by SEM. Brinell hardness tests were also carried out. The results revealed that higher density and higher hardness values were observed in the plasma-assisted sintered samples. Hardness increased with the concentration of carbides in the Ni-matrix. The flexural strength also increased by adding the carbides. The decline was larger for the sample with addition of 5% 5% TaC and NbC. In general, compositions containing added carbide 10% showed less porous and more uniform distribution of carbides in the nickel matrix microstructural appearance. Thus, both added carbide and plasma sintering improved density, hardness, flexural strength and microstructural appearance of the composites

Efetividade da terapia fisica descongestiva na cicatrização de úlceras venosas

A venous ulcer is the most serious clinical manifestation of chronic venous failure, and the most frequent in lower limbs, accounting for 70% of all ulcers. Patients may suffer from this infirmity for several years without healing of the lesion if treatment is inadequate. The aim of this investigation was to verify the effectiveness of decongestive physical therapy in the healing of venous ulcers. This is a quasi-experimental, interventionist study, with paired, non-probabilistic sampling, composed of 50 patients divided into two groups: control and intervention, each composed of 25 patients. Both groups were identically treated for six months with daily dressings and the latter also underwent complex physical therapy consisting of a combination of the following techniques: manual lymphatic drainage, compression bandaging, lower limb elevation, myolymphokinetic exercises and skin care. The study was approved (Protocol no. 59/2007) by the Ethics Committee of the State University of Southeast Bahia. The Mann-Whitney and Chi-square tests were applied for data analysis. After statistical analysis the patients who underwent therapy showed a statistically significant difference with respect to wound contraction starting in the second month of treatment. Compared to the control, the intervention group showed a greater reduction in both pain and edema starting in the third and fourth month of therapy, respectively. To reinforce these findings, the mean percentage of tissue present at the base of the ulcer (granulation/fibrin ratio) was calculated. The intervention group showed greater granulation at the base of the ulcer compared to the control, significant from the second month of treatment on. It was observed in this study that lymphotherapy, when compared between the intervention and control groups, accelerated the healing process, and reduced pain and edema in the affected limbs. It is expected, therefore, that these results widen scientific knowledge and we suggest that this therapy be used 78 not only to reduce lymphedema, but also as a treatment option for venous ulcers, given its easy application and low cost. The data, therefore, demonstrated the importance of basic care on the part of a multiprofessional and transdisciplinary health team involved in the healing process of these infirmities, thereby contributing to better quality of life in these individuals

Custo-efetividade da terapia compressiva no processo de cicatrização de úlceras venosas

Analytical study of therapeutic nonrandomized intervention type, intra-group controlled, with the aim of analyzing the cost-effectiveness of compression therapy with manipulated Unna boot in relation to conventional therapy in the healing of venous ulcers (VU) of patients treated in ambulatory clinic. The study population was composed by patients with VU treated by angiologists in Surgical Clinic Ambulatory of the Onofre Lopes University Hospital (HUOL) with a sample of 18 patients. It obtained the assent of the HUOL Ethics in Research Committee (Protocol 276/09). Data collection was performed over a period of four months by the own master's student and 34 nursing students, through the application of the research instrument in the admission of patients to the study and in the ten subsequent evaluations, performed at the time of changing Unna boot, weekly, for a maximum period of 10 weeks. The data were analyzed with SPSS 15.0 software, using descriptive and inferential statistics, and presented as tables, charts and graphs. Among those surveyed, prevailed: females, mean age 57.6 years, low education and income levels, most retired, unemployed or off work, with the standing position more than six hours per day and up to eight hours daily of domestic or occupational activities. In health status profile of respondents there were predominantly sleep, rest and inadequate elevation of the lower limbs, no smoking and/or alcohol use, presence of hypertension and no use of drugs. Most presented the first VU for over 10 years, recurrences, present VU for more than five years, involvement of left leg, in malleolar and / or distal leg region, mild edema, hyperpigmentation, lipodermatosclerosis, telangiectasies, reticular and varicose veins, mild pain, serous exudate in moderate quantity, small lesions (up to 50cm2), with predominance of granulation tissue and / or epithelialization and demarcated, elevated and irregular borders, with crusts and macerated. Most patients reported that in the 10 weeks prior to admission, made bandages at home and / or Basic Health Unit and / or ambulatory, with nursing aides or technicians, daily, and on weekends or holidays, performed by patients themselves, using healing ointment on the lesion, being observed granulation / epithelialization and increase in VU prevalent in the 10 weeks of traditional treatment. After follow up with manipulated Unna boot, was observed a decrease of lesions in all study patients, with complete healing in 27.8% of those between 1 and 5 weeks of treatment, with satisfactory evolution of the lesions, pain and ankle and calf circumferences, and unsatisfactory development of the borders of ulcers, edema, sleep, rest and elevation of the lower limbs, especially in more chronic patients. Furthermore, patients who achieved total healing and exhibited the greatest percentage reduction of lesions had a higher number of wound healing factors (ρ = 0.01 and ρ = 0.027, respectively). The manipulated Unna boot showed better results in those patients with shorter duration of injury, leading them to a satisfactory outcome within a short period of treatment. After the cost-effectiveness analysis, we conclude that the manipulated Unna boot is more effective than conventional therapy in the healing process of VU and is more cost-effective in patients with shorter lesions (ρ = 0.001), shorter treatment (ρ = 0.000) and greater number of wound healing factors (ρ = 0.005).

Qualidade da assistência e o conhecimento sobre o direito à saúde das pessoas com úlcera venosa crônica

The study aimed to identify the quality of care and knowledge of health rights of people with chronic venous ulcers (VU) in Brasilian National Health Care System (SUS). It is a cross-sectional study, with quantitative approach, performed at the University Hospital Onofre Lopes (HUOL). The study was approved by the Ethics Committee of HUOL (CAAE nº 0148.0.051.000-10). The sample by accessibility was composed for 30 people with VU treated at the outpatient surgical clinic of HUOL. For data collection we used a structured questionnaire composed of two parts: sociodemographic characteristics and of health, of care and the clinical course of VU; and knowledge of people with VU about the rights of health. The results were processed using SPSS 15.0 and analyzed by descriptive statistics. Given the characterizations sociodemographic and health presented, we identified a clientele of users with VU predominantly female (76,7%), aged from 60 years (66,7%), married/ stable union (60,0%), low education level (83,3%), family income lower than a minimum wage (73,3%), unemployeds and with chronic diseases (53,3%), sleep greater than or equal to 6 hours (76,7%) and were not alcoholics or smokers (93,3%). In relation to clinical conditions, were shown the presence of one or more relapses of VU (73,3%), predominance of granulation tissue/epithelialization in the bed of VU (60,0%), exudate serosanguineous (43,3%), in quantity medium/large (60,0%), with no predominance of presence or absence of odor (50,0%), all patients with tissue loss in grade III / IV, no signs of infection (73,3%) and presence of intense pain (50,0%). In the last 30 days the main venue of achievement of dressing was the HUOL (100,0%), the main compression therapy used was the Unna boot (60,0%) and on inability to perform the dressing on the unit were the own patients who made the exchange at home (40,0%). The majority of respondents listed out more positive factors associated with quality of care (56,7%) were satisfied with the care of SUS (76,7%), claimed to have knowledge about their rights (70,0%), but at the same time did not know the meaning of the acronym SUS (90,0%) and classified their level of information as inappropriate (70,0%). We realize that people with VU identified as good the quality of care and demonstrated inadequate knowledge about their rights to health in the SUS, but showed interest in acquiring more information. The basic rights to entry in the SUS are constitutionally guaranteed and need to be disseminated in order to make them known to the population, so it can be implemented and ensured a greater resolution assistance in treating this type of injury

Estudo das variáveis de processamento das matérias-primas da região do crato - ce na fabricação de produtos cerâmicos por extrusão e por prensagem

The limits to inform is about the character stico of basic, quimica, mineralogical and mechaniques of matlaughed material used in the manufacturing process the product certified in economic region the Cariri, specifically in the city of Crato, Ceará state, motivated the development of this work, since in this region the exist ing economic context that a general appear as important in the production chains. Were made twentyfive soils-test specimen collection and the study was performed to differentiate the mat laugh materials of variaveis processing of mathing raw materials in the factory The product mica monkeys by extrusion and pressing. The results were obtained ap s as analyzes: grain size, index of plasticity, fluoresce incidence X-ray difration the X-ray, and analyzes thermicals and properties technological. through s of curves gresifica returned to was a comparison between the retro the linear, absorb to water, porosity and bulk density. the results show that the excellent distribution and character acceptable available for the processing of the structure color dark red. needing, therefore, of the mixture of a less plastic clay with thick granulation, that works as plasticity reducer. In spite of the different resignation forms for prensagem and extrusion, the characteristics of absorption of water and rupture tension the flexing was shown inside of the patterns of ABNT

Compósitos de matriz metálica à base níquel com adição de TaC e NbC produzidos via metalurgia do pó

Carbide reinforced metallic alloys potentially improve some important mechanical properties required for the overall use of important engineering materials such as steel and nickel. Nevertheless, improved performance is achieved not only by composition enhancement but also by adequate processing techniques, such as novel sintering methods in the case of powder metallurgy. The method minimizes energy losses in addition to providing uniform heating during sintering. Thus, the general objective of this study was to evaluate the density, hardness, flexural strength, dilatometric behavior and to analyze the microstructure of metal matrix composites based nickel with addition of carbides of tantalum and / or niobium when sintered in a conventional furnace and Plasma assisted debinding and sintering (PADS). Initially, were defineds best parameters of granulation, screening and mixing procedure. After, mixtures of carbonyl Ni and 5%, 10% and 15 wt.% NbC and TaC were prepared in a Y-type mixer under wet conditions during 60 minutes. The mixtures were then dried and granulated using 1.5 wt. % paraffin diluted in hexane. Granulates were cold pressed under 600 MPa. Paraffin was then removed from the pressed pellets during a pre-sintering process carried out in a tubular furnace at 500 °C during 30 min. The heating rate was 3 ºC/min. The pellets were then sintered using either a plasma assisted reactor or a conventional resistive tubular furnace. For both methods, the heating rate was set to 8 ºC/min up to 1150 °C. The holding time was 60 minutes. The microstructure of the sintered samples was evaluated by SEM. Brinell hardness tests were also carried out. The results revealed that higher density and higher hardness values were observed in the plasma-assisted sintered samples. Hardness increased with the concentration of carbides in the Ni-matrix. The flexural strength also increased by adding the carbides. The decline was larger for the sample with addition of 5% 5% TaC and NbC. In general, compositions containing added carbide 10% showed less porous and more uniform distribution of carbides in the nickel matrix microstructural appearance. Thus, both added carbide and plasma sintering improved density, hardness, flexural strength and microstructural appearance of the composites