Um algoritmo para estimação de estado em alimentadores de distribuição de energia elétrica com base no método da soma de potências

Most algorithms for state estimation based on the classical model are just adequate for use in transmission networks. Few algorithms were developed specifically for distribution systems, probably because of the little amount of data available in real time. Most overhead feeders possess just current and voltage measurements at the middle voltage bus-bar at the substation. In this way, classical algorithms are of difficult implementation, even considering off-line acquired data as pseudo-measurements. However, the necessity of automating the operation of distribution networks, mainly in regard to the selectivity of protection systems, as well to implement possibilities of load transfer maneuvers, is changing the network planning policy. In this way, some equipments incorporating telemetry and command modules have been installed in order to improve operational features, and so increasing the amount of measurement data available in real-time in the System Operation Center (SOC). This encourages the development of a state estimator model, involving real-time information and pseudo-measurements of loads, that are built from typical power factors and utilization factors (demand factors) of distribution transformers. This work reports about the development of a new state estimation method, specific for radial distribution systems. The main algorithm of the method is based on the power summation load flow. The estimation is carried out piecewise, section by section of the feeder, going from the substation to the terminal nodes. For each section, a measurement model is built, resulting in a nonlinear overdetermined equations set, whose solution is achieved by the Gaussian normal equation. The estimated variables of a section are used as pseudo-measurements for the next section. In general, a measurement set for a generic section consists of pseudo-measurements of power flows and nodal voltages obtained from the previous section or measurements in real-time, if they exist -, besides pseudomeasurements of injected powers for the power summations, whose functions are the load flow equations, assuming that the network can be represented by its single-phase equivalent. The great advantage of the algorithm is its simplicity and low computational effort. Moreover, the algorithm is very efficient, in regard to the accuracy of the estimated values. Besides the power summation state estimator, this work shows how other algorithms could be adapted to provide state estimation of middle voltage substations and networks, namely Schweppes method and an algorithm based on current proportionality, that is usually adopted for network planning tasks. Both estimators were implemented not only as alternatives for the proposed method, but also looking for getting results that give support for its validation. Once in most cases no power measurement is performed at beginning of the feeder and this is required for implementing the power summation estimations method, a new algorithm for estimating the network variables at the middle voltage bus-bar was also developed

Arquitetura de Software para Barcos Robóticos

We propose in this work a software architecture for robotic boats intended to act in diverse aquatic environments, fully autonomously, performing telemetry to a base station and getting this mission to be accomplished. This proposal aims to apply within the project N-Boat Lab NatalNet DCA, which aims to empower a sailboat navigating autonomously. The constituent components of this architecture are the memory modules, strategy, communication, sensing, actuation, energy, security and surveillance, making these systems the boat and base station. To validate the simulator was developed in C language and implemented using the graphics API OpenGL resources, whose main results were obtained in the implementation of memory, performance and strategy modules, more specifically data sharing, control of sails and rudder and planning short routes based on an algorithm for navigation, respectively. The experimental results, shown in this study indicate the feasibility of the actual use of the software architecture developed and their application in the area of autonomous mobile robotics

Prospecção e formação no domínio das competências e habilidades em tecnologia da informação: o caso do projeto metrópole digital em Natal/RN

This study deals with cognitive competences and abilities that are relevant to selection and education regarding Information Technology (IT). These competences relate to problem solving, decision making, and practical intelligence that regard scholar and extracurricular knowledge mobilization. The research aimed to contribute for the improvement of a selection instrument, consisting of five arrays of skills (dealing with objectives and prospection), as well as the development and comprehension of those skills that are involved in IT education. This is done by means of an analysis on the selection instrument used in the first selective process that occurred at Metropole Digital an Institute at the Federal University of Rio Grande do Norte in Brazil. This was evaluated aiming to acknowledge IT education (with basic training and emphasis on Web programming and electronics). The methodology used was of quantitative method involving performance scores relating education delivery. An Anova analysis of variance was done along with descriptive analysis involving socioeconomic data that was not observed in the meaningful relations between parental instruction and student performance in the graduate course. These analyses were able to point out the importance and need of the policies for vacancy reservation on behalf of public school students. A Spearman correlation analysis was done considering the instrument selection performance in the training course. The instrument is presented as a predictor that is significantly moderate and presents a good performance in the course as a whole. A Cluster and Regression analysis was also realized in the process. The first analysis allowed finding performance groups (Clusters) that ranged from medium and inferior. The regression analysis was able to point out association amongst criterion variables and the (average performance in basic and advanced modules) and explanatory (five matrixes). Regression analysis indicated that matrix 1 and matrix 3 were pointed out as being the strongest ones. In all the above analysis, the correlation between the instrument and the course was considered moderate. Thus this can be related in some of the aspects present in the course such as emphasis on evaluation itself as well as in technical contents and practical skills (educational ones) and competences and selection skills. It is known that the mediation of technological artifact in cultural context can foster the development of skills and abilities relevant to IT training. This study provides subsidies to reflect on the adoption of selection instrument and IT training in the Institute. Thus the research offers means to achieve a interdisciplinary discussion and enriching of areas such as Psychology and Information Technology; all of which regarding competencies and skills relevant in IT training