Determinação da composição química de quatro variedades de feijão caupi (Vigna unguiculata L. Walp) cultivadas em solo potiguar

The cowpea (Vigna unguiculata L. Walp) is a major food crops in northeastern Brazil. In Rio Grande do Norte, the cowpea, vigna beans or cowpea, as it is known, has great socioeconomic importance as a source of nutrients in food, with great emphasis among agricultural products. To improve productivity and resistance to pests, two cultivars were developed exclusively by EMPARN (Agricultural Research Corporation of Rio Grande do Norte), for breeding. The samples were provided by EMPARN, two improved (Potiguar and Laugh year) and two landraces (Rib of beef and Canapu). The seeds were ground and made into flour samples and the determination of moisture and ash by graviméticos methods, lipids by Soxhlet extraction, fibers with determiner fiber, carbohydrates by difference and minerals by ICP-OES were performed except the match analyzed by UVvis. The results showed a high fiber content (55.55% and 55.32% and 50.04% improved samples and 50.32% creole samples) and protein (25.52% and 25.27% improved and 27 samples, 23% and 24.99% creole samples). Comparing the results of the mineral content, the improved cultivars stood out in relation to Ca, Co, P, Mg, Mo and Na. Creole cultivars showed better results for Cu, Cr (low), Fe, Mn, Ni, K and Zn. The results will be important in future nutritional research and to build a table of Brazilian chemical composition of foods.

Avaliação da compactação do solo no crescimento inicial de espécies florestais da caatinga

Despite the importance of the study of roots, little is known about the negative effects of soil compaction in the development of the Caatinga forest species. In this sense, the objective was to evaluate the initial growth of Mimosa caesalpiniifolia, Tabebuia caraiba and Erythina velutina in soil under varying levels of compression. The experiment was conducted in a greenhouse located at the Academic Unit Specialized in Agricultural Sciences, UFRN. To perform the experiment, was used Oxisoil of sandy loam texture, from forest trial Area Agricultural School of Jundiaí (EAJ) of the municipality of Macaíba-RN, in an experimental unit consisting of three overlapping PVC rings, 10 cm in diameter and 25 cm in height, with a central ring which has undergone compression. The experimental design was a randomized block with six replications, being tested four levels of soil compaction (1.35; 1.45; 1.60 and 1.80 kg.dm-³), evaluating the following variables: diameter, height, number of leaves, dry weight of shoot and root system in each layer of the vessels. Overall, the species M. caesalpiniifolia, T. caraiba and E. velutina had initial growth favored by treatment consists of uncompressed soil. The M. caesalpiniifolia and T. caraiba species proved relatively resistant to compaction of the soil does not undergo any significant reduction in root growth density equal to or less than 1.60 kg.dm-³, whereas E. velutina proved susceptible effects of soil compaction, with significant changes in root growth under soil densities equal to or greater than 1.45 kg.dm-³. Increased soil compaction caused the impediment to the expansion of taproot inside the experimental units, promoting the accumulation of roots in the upper layers of the soil for the studied species. The subsoil physical impediment changed the initial aerial growth of M. caesalpiniifolia and E. velutina, but did not influence the growth of air T. caraiba seedlings the tested compression levels.

Análise da variabilidade climática sobre a produtividade da soja no município de Bom Jesus (PI)

The climate is still main responsible for the variations soybean productivity (Glycine max (L.) Merrill), exerting a limiting action on these agricultural systems. The bomjesuense cerrado, this culture has proved, over the years, an increase of cultivated areas, however, productivity does not keep the same pace, going through periods of oscillations. Thus, although the crop is added to high technology, culture has great vulnerability to climatic adversities. Thus, the present study aims to analyze possible trends in meteorological variables, which can influence the soybean yield in Bom Jesus. For this purpose, different datasets were used, as follows: i) two periods of daily data (1984-2014 and 1974-2014), both obtained from the National Meteorological Institute (INMET); ii) climate normals from 1961-1990 as defined by INMET; iii) local agricultural production data of soybean-year (1997/1998 to 2012/2013) obtained from the Municipal Agricultural Production (PAM) dataset, which is management by Brazilian Institute of Geography and Statistics (IBGE). The analysis procedures included calculations of climate normals for 1984 to 2014 period and some statistical applications, as follows: i) the Wilcoxon test, used to evaluate differences between climate normals (1961 to 1990 and 1984 to 2014); ii) the Mann-Kendall nonparametric test, in order to analyze the linear trend of agrometeorological variables (rainfall, maximum temperature, minimum temperature and diurnal range of temperature; iii) cluster analysis by Ward method and the Spearman correlation test (rs) to identify the relationship between agrometeorological variable and soybean annual productivity. We adopted a statistical significance level of 5%. The results indicate changes in seasonality of the 1984-2014 climatology with respect to past climatology for all variables analyzed, except for insolation and precipitation. However, the monthly analysis of precipitation indicate negative trend during October and positive trend in December, causing a delay in start of rainy season. If this trend is persistent this result must be considered in futures definitions of the soybean crop sowing date over the region studied. With Mann-Kendall test was possible to identify positive trends with statistical significance in maximum temperature for all month forming part of soybean cycle (from November to April), which in turn tends to cause adverse effects on crop physiology, and consequently impacts on the final yield. Was identified a significant positive correlation between soybean yield and precipitation observed in March, thus precipitation deficit in this month is harmful to the soybean crop development. No statistically significant correlation was identified among maximum temperature, minimum temperature, and DTR with annual soybean productivity due these range of meteorological variables are not limiting factors in the final soybean yield in Bom Jesus (PI). It is expected that this study will contribute to propose planning strategies considering the role of climate variability on soybean crop final yield.

Análise de microestrutura e de características geotécnicas de misturas de resíduo de polimento de porcelanato e solo

Brazil is a country in development, rich in natural resources. In order to grow sustainably, it is necessary to Brazil to preserve its environment, which is an expressive challenge, especially to industries, such as those producing ceramic materials. This study was developed using Porcelain Tile Polishing Residue (RPP) in blends with soil to build compacted fills. This residue is a slurry generated during the polishing process of porcelain tiles and contains powdery material from the polished tile, the abrasives used during the process and cooling water. The RPP was collected from a private company located in Conde/PB and it was mixed with a sandy-clayey soil, to build the fills. Laboratorial tests were conducted with pure soil, pure RPP and blends in proportions of 5%, 10%, 15% and 20% of RPP in addition to the dry mass of pure soil. The Chemical and Physical Characterization tests performed were: specific solid weight, grain size distribution, laser analysis of grain size distribution, Atterberg limits, X ray fluorescence, X ray diffraction, scanning electron microscopy and soil compaction,. The materials and blends were also compacted and direct shear tests and plate load tests were performed. Plate load tests were conducted using a circular plate with 30 cm diameter, on specimens of pure soil and 5% blend, compacted in a metallic box inside the Soil Mechanics Laboratory of the Federal University of Rio Grande do Norte, Brazil. Both mechanical tests performed were conducted under inundated conditions, willing to reduce the influence of soil suction. An evaluation of the results of the tests performed shows that RPP is a fine material, with grain size distribution smaller than 0,015mm, composed mainly of silica and alumina, and particles in angular shape. The soil was characterized as a clayey sand, geologically known as a lateritic soil, with high percentages of alumina and iron oxide, and particles with rounded shape. Both the Soil and the blends presented low plasticity, while the residue showed a medium plasticity. Direct shear tests showed that the addition of RPP did not cause major changes into blends’ friction angle data, however, it was possible to note that, for the proportions studied, that is a tendency of obtain lower shear stresses for higher percentages of RPP in the blends. Both pure soil and 5% mixture showed a punching disruption for the Plate load test. For this same test, the allowable stress for 5% mixture was 44% higher than the pure soil, and smaller vertical settlement results for all stresses.

Análise de microestrutura e de características geotécnicas de misturas de resíduo de polimento de porcelanato e solo

Brazil is a country in development, rich in natural resources. In order to grow sustainably, it is necessary to Brazil to preserve its environment, which is an expressive challenge, especially to industries, such as those producing ceramic materials. This study was developed using Porcelain Tile Polishing Residue (RPP) in blends with soil to build compacted fills. This residue is a slurry generated during the polishing process of porcelain tiles and contains powdery material from the polished tile, the abrasives used during the process and cooling water. The RPP was collected from a private company located in Conde/PB and it was mixed with a sandy-clayey soil, to build the fills. Laboratorial tests were conducted with pure soil, pure RPP and blends in proportions of 5%, 10%, 15% and 20% of RPP in addition to the dry mass of pure soil. The Chemical and Physical Characterization tests performed were: specific solid weight, grain size distribution, laser analysis of grain size distribution, Atterberg limits, X ray fluorescence, X ray diffraction, scanning electron microscopy and soil compaction,. The materials and blends were also compacted and direct shear tests and plate load tests were performed. Plate load tests were conducted using a circular plate with 30 cm diameter, on specimens of pure soil and 5% blend, compacted in a metallic box inside the Soil Mechanics Laboratory of the Federal University of Rio Grande do Norte, Brazil. Both mechanical tests performed were conducted under inundated conditions, willing to reduce the influence of soil suction. An evaluation of the results of the tests performed shows that RPP is a fine material, with grain size distribution smaller than 0,015mm, composed mainly of silica and alumina, and particles in angular shape. The soil was characterized as a clayey sand, geologically known as a lateritic soil, with high percentages of alumina and iron oxide, and particles with rounded shape. Both the Soil and the blends presented low plasticity, while the residue showed a medium plasticity. Direct shear tests showed that the addition of RPP did not cause major changes into blends’ friction angle data, however, it was possible to note that, for the proportions studied, that is a tendency of obtain lower shear stresses for higher percentages of RPP in the blends. Both pure soil and 5% mixture showed a punching disruption for the Plate load test. For this same test, the allowable stress for 5% mixture was 44% higher than the pure soil, and smaller vertical settlement results for all stresses.