Avaliação do efeito da adição de resíduo de borracha de pneu e brita calcária na formulação de compósitos cimentíceos

Researches have shown that the introduction of rubber in concrete improves the features of its deformability, as well as contributes to environmental disposal of waste generated in the tire retreading process. Furthermore, there is a high availability of limestone within RN and CE country. Ignorance about this stone, does not allow its wide use as aggregate, leaving, this abundant supply idle. A composite of limestone gravel, with proportions of tire rubber waste which could be used as concrete would be an alternative to concrete for low applications. Therefore, this research aims to evaluate the characteristics of concrete containing limestone gravel and proportions of little aggregate replacement (sand) by tire rubber waste. To this goal, the material components of the concrete were characterized, concrete specimens with limestone gravel were made, from the dash 1.0: 2.5: 3.5, varying the water/cement ratio, and inserting a commercial plasticizer, without a proportion of residue, known as reference. From this, concrete with and without the presence of the additive in the same proportions were chosen, as well as these with the use of granite gravel, for being the most used. Selected the references, to these, replacements of little aggregate (sand) were added replaced by rubber waste from the tire retreading process, treated with 1M NaOH in proportions from 5.0 to 20.0 % by mass, cured and exposed to the semiarid environment. The results indicate the possibility of using limestone gravel in the concrete composition with workability correction using plasticizer. There was a decrease in the mechanical properties of the concrete with increments of waste rubber, but there is an improvement in toughness and deformability of the composite, which makes it interesting for the construction of non-structural concrete floors, as well as, the rubber waste delayed the hardening process, continuing to gain resistance after 28 days

Avaliação do efeito da adição de resíduo de borracha de pneu e brita calcária na formulação de compósitos cimentíceos

Researches have shown that the introduction of rubber in concrete improves the features of its deformability, as well as contributes to environmental disposal of waste generated in the tire retreading process. Furthermore, there is a high availability of limestone within RN and CE country. Ignorance about this stone, does not allow its wide use as aggregate, leaving, this abundant supply idle. A composite of limestone gravel, with proportions of tire rubber waste which could be used as concrete would be an alternative to concrete for low applications. Therefore, this research aims to evaluate the characteristics of concrete containing limestone gravel and proportions of little aggregate replacement (sand) by tire rubber waste. To this goal, the material components of the concrete were characterized, concrete specimens with limestone gravel were made, from the dash 1.0: 2.5: 3.5, varying the water/cement ratio, and inserting a commercial plasticizer, without a proportion of residue, known as reference. From this, concrete with and without the presence of the additive in the same proportions were chosen, as well as these with the use of granite gravel, for being the most used. Selected the references, to these, replacements of little aggregate (sand) were added replaced by rubber waste from the tire retreading process, treated with 1M NaOH in proportions from 5.0 to 20.0 % by mass, cured and exposed to the semiarid environment. The results indicate the possibility of using limestone gravel in the concrete composition with workability correction using plasticizer. There was a decrease in the mechanical properties of the concrete with increments of waste rubber, but there is an improvement in toughness and deformability of the composite, which makes it interesting for the construction of non-structural concrete floors, as well as, the rubber waste delayed the hardening process, continuing to gain resistance after 28 days

Análise do desempenho térmico de sistema constutivo de concreto com EPS como agregado graúdo

In the last decades there was a concentrate effort of researchers in the search for options to the problem of the continuity of city development and environmental preservation. The recycling and reuse of materials in industry have been considerate as the best option to sustainable development. One of the relevant aspects in this case refers to the rational use of electrical energy. At this point, the role of engineering is to conceive new processes and materials, with the objective of reducing energy consumption and maintaining, at the same time the benefits of the technology. In this context, the objective of the present research is to analyze quantitatively the thermal behavior of walls constructed with concrete blocks which composition aggregates the expanded polystyrene (EPS) reused in the shape of flakes and in the shape of a board, resulting in a “light concrete”. Experiments were conducted, systematically, with a wall (considerate as a standard) constructed with blocks of ordinary concrete; two walls constructed with blocks of light concrete, distinct by the proportion of EPS/sand; a wall of ceramic bricks (“eight holes” type) and a wall with ordinary blocks of cement, in a way to obtain a comparative analysis of the thermal behavior of the systems. Others tests conducted with the blocks were: stress analysis and thermal properties analysis (ρ, cp e k). Based on the results, it was possible to establish quantitative relationship between the concentration (density) of EPS in the constructive elements and the decreasing of the heat transfer rate, that also changes the others thermal properties of the material, as was proved. It was observed that the walls of light concrete presents better thermal behavior compared with the other two constructive systems world wide used. Based in the results of the investigation, there was shown the viability of the use of EPS as aggregate (raw material) in the composition of the concrete, with the objective of the fabrication of blocks to non-structural masonry that works as a thermal insulation in buildings. A direct consequence of this result is the possibility of reduction of the consume of the electrical energy used to climatization of buildings. Other aspect of the investigation that must be pointed was the reuse of the EPS as a raw material to civil construction, with a clear benefit to reducing of environmental problems

Avaliação da potencialidade de incorporação de um lodo de uma indústria de produtos de limpeza como adição mineral em concretos de cimento Portland

The generation of industrial wastes has been increased more and more in recent decades, motivating studies about a correct sustainable allocation and that also represents advantages for their generators. In this context, are included two companies of cleaning products niche, located in São José do Mipibu/RN, that produces industrial sludge at a sewage treatment plant, and that is the main approach of this research. Given this, it was studied the incorporation potentiality of this sludge as a mineral addition in cement matrix for concrete production due it high capacity of wastes immobilization inside this material, which are subsequently used in the company for making precast articles. Were added different sludge concentrations (5, 10, 15 and 20%) in a common trait (1: 2: 3), and evaluated their techniques and microstructural implications via workability test in fresh state and compressive strength, full porosity and scanning electron microscopy (SEM) in the hardened state. The results demonstrated the feasibility of the process both from a technical and environmental view as economical. All concretes produced with residue showed an increase of workability given the nature of the waste that had surfactants substances capable of adsorbing tiny particles of air into the batter. However, for all concentrations were obtained lower compressive resistances than standard concrete, with a reduction of 39% for samples with 20% of sludge. This are attributed mainly to an increase of porosity in the transition zone of these material, resulting from increased formation of ettringite at the detriment to the formation of other compounds, but which still allows the use of these for the manufacture of concrete articles with non-structural nature, such as precast floor. In addition, the water absorption and void ratio increased slightly for all samples, except the concrete with 20% of waste that has a reduction for the last parameter. Given this context, the recommended maximum level is 20%, constituting a significant proportion and able to allocate sustainably all waste generated in the industry.

Estudo in silico das interações da protease NS3-NS2B de DENV-2 com o inibidor peptídico Bz-nKRR-H com finalidades terapêuticas

Dengue virus is an important patogen that causes Dengue desease in all world, and belongs to Flavivirus gender. The virus consists of enveloped RNA with a single strand positive sense, 11Kb genome. The RNA is translated into a polyprotein precursor, wich is cleaved into 3 structural proteins (C, prM e E) and 7 non-structural proteins (NS1, NS2A, NS2B, NS3, NS4A, NS4B e NS5). The NS3 is a multifunctional protein, that besides to promote the polyprotein precursor cleavage, also have NTPase, helicase and RTPase activity. The NS3 needs a hydrophilic segment of 40 residues from the transmembrane NS2B protein (who acts like cofator) to realize this functions. Actually, there's no vacines available on the market, and the treatment are just symptomatic. The tetrapeptide inhibitor Bz-Nle-Lys-Arg-Arg-H (Ki de 5,8-7,0 M) was showed as a potent inhibitor μ for NS3prot in Dengue virus. That is a inteligent alternative to treat the dengue desease. The present work aimed analyse the interactions of the ligand bounded to the activity site to provid a clear and depth vision of that interaction. For this purpouse, it was conducted an in silico study, by using quantum mechanical calculations based on Density Functional Theory (DFT), with Generalized Gradient approximation (GGA) to describe the effects of exchange and correlation. The interaction energy of each amino acid belonging to the binding site to the ligand was calculated the using the method of molecular fragmentation with conjugated caps (MFCC). Besides energy, we calculated the distances, types of molecular interactions and atomic groups involved. The theoretical models used were satisfactory and show a more accurate description when the dielectric constant = 20 ε and 80 was used. The results demonstrate that the interaction energy of the system reached convergence at 13.5 A. Within a radius of 13,5A the most important residues were identified. Met49, Met84 and Asp81 perform interactions of hydrogen with the ligant. The Asp79 and Asp75 residues present high energy of attraction. Arg54, Arg85 and Lys 131 perform hydrogen interactions with the ligand, however, appear in BIRD graph having high repulsion energy with the inhibitor. The data also emphasizes the importance of residue Tyr161 and the involvement of the catalytic triad composed by Asp75, His51 and Ser135

Crescimento urbano e seus impactos no sistema de drenagem de uma bacia em Natal/RN

The uncontrolled growth of most Brazilian cities is not accompanied by the development of urban infrastructure. With increasing soil sealing, runoff and decreased infiltration volume, impacts on water resources and on population of the areas affected by urban growth are inevitable. This study aims to evaluate the use and occupation of a watershed and analyze the drainage system in order to control the impact using tools to integrate urban development with the drainage of rainwater in an important watershed in the Natal City, Rio Grande do Norte State. The study involved the characterization of the basin XII.4 on the land use and occupation, for the years 2005 and 2014. With the application of SWMM model was possible to analyze the impacts caused by the urbanization process in the existing drainage system, showing the two years analyzed have their areas very close to percentage saturation of impervious areas. Although the region is still predominantly single family residential, suffers increasing verticalization of mainly commercial buildings. The drainage system is inefficient for the area's needs by the year 2005. The drainage system was also tested for four variations of land use by developing scenarios. Scenario 1 is related to the year 2014, considered current. Scenario 2 was adopted the maximum rate of 80% for land use, allowed for the Natal City. Scenario 3 gives the critical condition of land use, with the area 100% impervious. Scenario 4 is applied to the existence of LID (Low Impact Device). The scenarios analysis showed that all indicate deficiency at some point of the drainage system as a result of the high degree of occupation of the area that generate higher flows than the initial drainage system capacity. With the study it became clear that the adoption of non-structural tools are effective in reducing flooding and improving the drainage system capacity.

Crescimento urbano e seus impactos no sistema de drenagem de uma bacia em Natal/RN

The uncontrolled growth of most Brazilian cities is not accompanied by the development of urban infrastructure. With increasing soil sealing, runoff and decreased infiltration volume, impacts on water resources and on population of the areas affected by urban growth are inevitable. This study aims to evaluate the use and occupation of a watershed and analyze the drainage system in order to control the impact using tools to integrate urban development with the drainage of rainwater in an important watershed in the Natal City, Rio Grande do Norte State. The study involved the characterization of the basin XII.4 on the land use and occupation, for the years 2005 and 2014. With the application of SWMM model was possible to analyze the impacts caused by the urbanization process in the existing drainage system, showing the two years analyzed have their areas very close to percentage saturation of impervious areas. Although the region is still predominantly single family residential, suffers increasing verticalization of mainly commercial buildings. The drainage system is inefficient for the area's needs by the year 2005. The drainage system was also tested for four variations of land use by developing scenarios. Scenario 1 is related to the year 2014, considered current. Scenario 2 was adopted the maximum rate of 80% for land use, allowed for the Natal City. Scenario 3 gives the critical condition of land use, with the area 100% impervious. Scenario 4 is applied to the existence of LID (Low Impact Device). The scenarios analysis showed that all indicate deficiency at some point of the drainage system as a result of the high degree of occupation of the area that generate higher flows than the initial drainage system capacity. With the study it became clear that the adoption of non-structural tools are effective in reducing flooding and improving the drainage system capacity.