Estudo da recuperação de óleo por drenagem gravitacional assistida por injeção de vapor

Steam assisted gravity drainage process (SAGD) involves two parallel horizontal wells located in a same vertical plane, where the top well is used as steam injector and the bottom well as producer. The dominant force in this process is gravitational. This improved oil recovery method has been demonstrated to be economically viable in commercial projects of oil recovery for heavy and extra heavy oil, but it is not yet implemented in Brazil. The study of this technology in reservoirs with characteristics of regional basins is necessary in order to analyze if this process can be used, minimizing the steam rate demand and improving the process profitability. In this study, a homogeneous reservoir was modeled with characteristics of Brazilian Northeast reservoirs. Simulations were accomplished with STARS , a commercial software from Computer Modelling Group, which is used to simulate improved oil recovery process in oil reservoirs. In this work, a steam optimization was accomplished in reservoirs with different physical characteristics and in different cases, through a technical-economic analysis. It was also studied a semi-continuous steam injection or with injection stops. Results showed that it is possible to use a simplified equation of the net present value, which incorporates earnings and expenses on oil production and expenses in steam requirement, in order to optimize steam rate and obtaining a higher net present value in the process. It was observed that SAGD process can be or not profitable depending on reservoirs characteristics. It was also obtained that steam demand can still be reduced injecting in a non continuous form, alternating steam injection with stops at several time intervals. The optimization of these intervals allowed to minimize heat losses and to improve oil recovery

Processamento e caracterização da blenda poli (metacrilato de metila) (PMMA) elastomerico e poli (tereftalato de etileno) (PET) pós-consumo

This work studied the immiscible blend of elastomeric poly(methyl methacrylate) (PMMA) with poly(ethylene terephthalate) (PET) bottle grade with and without the use of compatibilizer agent, poly(methyl methacrylate-co-glycidyl methacrylate - co-ethyl acrylate) (MGE). The characterizations of torque rheometry, melt flow index measurement (MFI), measuring the density and the degree of cristallinity by pycnometry, tensile testing, method of work essential fracture (EWF), scanning electron microscopy (SEM) and transmission electron microscopy (TEM) were performed in pure polymer and blends PMMA/PET. The rheological results showed evidence of signs of chemical reaction between the epoxy group MGE with the end groups of the PET chains and also to the elastomeric phase of PMMA. The increase in the concentration of PET reduced torque and adding MGE increased the torque of the blend of PMMA/PET. The results of the MFI also show that elastomeric PMMA showed lower flow and thus higher viscosity than PET. In the results of picnometry observed that increasing the percentage of PET resulted in an increase in density and degree crystallinity of the blends PMMA/PET. The tensile test showed that increasing the percentage of PET resulted in an increase in ultimate strength and elastic modulus and decrease in elongation at break. However, in the phase inversion, where the blend showed evidence of a co-continuous morphology and also, with 30% PET dispersed phase and compatibilized with 5% MGE, there were significant results elongation at break compared to elastomeric PMMA. The applicability of the method of essential work of fracture was shown to be possible for most formulations. And it was observed that with increasing elastomeric PMMA in the formulations of the blends there was an improvement in specific amounts of essential work of fracture (We) and a decrease in the values of specific non-essential work of fracture (βWp)

Desenvolvimento de uma unidade pirolítica com reator de cilindro rotativo: obtenção de bio-óleo

The demand for alternative sources of energy drives the technological development so that many fuels and energy conversion processes before judged as inadequate or even non-viable, are now competing fuels and so-called traditional processes. Thus, biomass plays an important role and is considered one of the sources of renewable energy most important of our planet. Biomass accounts for 29.2% of all renewable energy sources. The share of biomass energy from Brazil in the OIE is 13.6%, well above the world average of participation. Various types of pyrolysis processes have been studied in recent years, highlighting the process of fast pyrolysis of biomass to obtain bio-oil. The continuous fast pyrolysis, the most investigated and improved are the fluidized bed and ablative, but is being studied and developed other types in order to obtain Bio-oil a better quality, higher productivity, lower energy consumption, increased stability and process reliability and lower production cost. The stability of the product bio-oil is fundamental to designing consumer devices such as burners, engines and turbines. This study was motivated to produce Bio-oil, through the conversion of plant biomass or the use of its industrial and agricultural waste, presenting an alternative proposal for thermochemical pyrolysis process, taking advantage of particle dynamics in the rotating bed that favors the right gas-solid contact and heat transfer and mass. The pyrolyser designed to operate in a continuous process, a feeder containing two stages, a divisive system of biomass integrated with a tab of coal fines and a system of condensing steam pyrolytic. The prototype has been tested with sawdust, using a complete experimental design on two levels to investigate the sensitivity of factors: the process temperature, gas flow drag and spin speed compared to the mass yield of bio-oil. The best result was obtained in the condition of 570 oC, 25 Hz and 200 cm3/min, temperature being the parameter of greatest significance. The mass balance of the elementary stages presented in the order of 20% and 37% liquid pyrolytic carbon. We determined the properties of liquid and solid products of pyrolysis as density, viscosity, pH, PCI, and the composition characterized by chemical analysis, revealing the composition and properties of a Bio-oil.

Estimativa populacional e uso do hábitat do boto-cinza (Sotalia guianensis) no litoral sul do Rio Grande do Norte

Four areas are known as of frequent usage by Guiana dolphins (Sotalia guianensis) in the south coast of Rio Grande do Norte state, northeast Brazil: Tabatinga, Pipa, Lagoa de Guaraíras and Baia Formosa. This extension of 40 km of shoreline is under increasing anthropogenic impacts due to continuous development of the coastal areas and vessel traffic. The objective of this study was to investigate aspects of population biology and habitat use of the population of Sotalia guianensis in the south coast of Rio Grande do Norte. It was applied the photo-identification technique and posterior methods of capture-recapture for population estimation (POPAN extension in MARK). The distribution, movement and site fidelity of the dolphins were analyzed trough the geographic information system (GIS) and group characteristics and behavior trough non-parametric statistics. Field work was conducted on board a 10m motor vessel from March 2008 to March 2009. Photo-identification effort was 329h with 113h of direct observation of the dolphins. The population estimatives for each area: Tabatinga: 75 (63-92); Pipa 105 (88-129); Lagoa de Guaraíras: 27 (18-54) e Baia Formosa: 112 (89-129) individuals. Total population estimative was: 223 (192 a 297). High site fidelity was detected for only part of the population (<15%) as low site fidelity and transients individuals were also detected (>20%). It was observed frequent movements between Tabatinga, Lagoa de Guaraíras and Pipa, but not Baía Formosa. This suggests a division in two communities along this shore extension: one in Pipa and other in Baía Formosa. Group size was small, most groups with up to 10 dolphins. The areas were use intensively, only in Lagoa de Guaraíras dolphins were not seen in all field trips. Lagoa de Guaraíras is an area used by small groups exclusively for foraging. In Tabatinga and Pipa dolphins concentrated close to the shore, in the inner sector of the area and the main activity is also foraging. Significant larger groups were seen in socializing behavior but there was no difference in group size between the inner and external sectors of the area. The presence of calves and juveniles were significant greater in the inner areas of Tabatinga and Pipa, confirming the hypothesis that these beaches are also used for parental care. In Baia Formosa dolphins concentrated in the outer sector and foraging was also predominant. Significant larger groups were seen in the outer sector, mainly engaged in mixed behaviors of travel/foraging, possibly in some kind of group foraging. Calves and juveniles were significant more present in the outer sector where group size was also larger. In general there was no difference in area usage and period of the day. Sotalia guianensis has characteristics that make the species vulnerable to human activities such as small population concentrated in patches of suitable habitats restrict to coastal areas. We hope that this study bring new information for the species and help for the adequate management of the area in order to assure the presence of the dolphins as well as its behavior pattern and gene flow betweencommunities.

Avaliação da execução de aplicações orientadas à dados na arquitetura de redes em chip IPNoSys

The increasing complexity of integrated circuits has boosted the development of communications architectures like Networks-on-Chip (NoCs), as an architecture; alternative for interconnection of Systems-on-Chip (SoC). Networks-on-Chip complain for component reuse, parallelism and scalability, enhancing reusability in projects of dedicated applications. In the literature, lots of proposals have been made, suggesting different configurations for networks-on-chip architectures. Among all networks-on-chip considered, the architecture of IPNoSys is a non conventional one, since it allows the execution of operations, while the communication process is performed. This study aims to evaluate the execution of data-flow based applications on IPNoSys, focusing on their adaptation against the design constraints. Data-flow based applications are characterized by the flowing of continuous stream of data, on which operations are executed. We expect that these type of applications can be improved when running on IPNoSys, because they have a programming model similar to the execution model of this network. By observing the behavior of these applications when running on IPNoSys, were performed changes in the execution model of the network IPNoSys, allowing the implementation of an instruction level parallelism. For these purposes, analysis of the implementations of dataflow applications were performed and compared

Finding the way home: movement of butterflies in non-familiar habitats

Paisagens naturais tem sido afetadas dramaticamente pela perda de habitat e fragmentação, os quais transformam paisagens contínuas em manchas de habitat circundadas por áreas de não-habitat (matrizes). Essas matrizes, inóspitas ou não, afetam incontáveis processos ecológicos, como a dispersão. Uma das formas de compreender o efeito da matriz no processo de dispersão é estudando o alcance da percepção do habitat dos animais, o qual é definido como o alcance (distância) em que um animal pode perceber elementos da paisagem. Essa percepção está diretamente relacionada ao sucesso de chegada à um novo habitat, enquanto o animal navega por uma matriz. Nós avaliamos a percepção do habitat em Heliconius erato, uma borboleta tropical. Entretanto nós também estávamos interessados em avaliar o efeito da idade das borboletas e do tipo de matriz na percepção do habitat. Consequentemente, nós criamos borboletas em laboratório e pareamos com borboletas coletadas na floresta durante um experimento de soltura. Para determinar o alcance da percepção, nós realizamos solturas em duas diferentes matrizes (coqueiral e campo em regeneração) à três distâncias da floresta (0,30 e 100 metros) e medimos o ângulo final alcançado pelas borboletas. Nós encontramos que (I) borboletas soltas na borda se orientaram fortemente para a floresta; (II) quanto maior a distância de soltura, menor a habilidade de perceber o habitat e (III) há interação entre matriz e idade da borboleta. Borboletas inexperientes se orientaram melhor no campo aberto (alcance da percepção: 30-100 metros) e experientes se orientaram melhor no coqueiral (alcance da percepção entre 30-100 metros).