Caracterização da resistência do algodoeiro a Ramularia areola e variabilidade molecular do patógeno

This research was conducted with the aim to study the genetic and pathogenic structure of Ramularia areola isolates collected in Brazil and to characterize the resistance response in cotton plants to ramularia spot. The genetic variability of 28 isolates of R. areola was studied using RAPD markers. The pathogenicity evaluation was realized by the inoculation of 6 isolates on cotton varieties Guazuncho-2 (Gossypium hirsutum) and VH8-4602 (Gossypium barbadense). The inheritance of disease resistance was studied using an artificially inoculated population of F2 individuals derived from the intercross of Guazuncho-2 (susceptible variety) end VH8-4602 (resistant variety), and also the parents and F1 individuals. Molecular polymorphism between the G. hisutum varieties DeltaOpal (suscetible) and CNPA CO-11612 (resistant) was estimated by 118 SSR and 24 AFLP markers. The parental genotypes Guazuncho-2 and VH8-4602 were selected for mapping, and then Recombinant Inbred Lines (RIL´s) derived from this crossing were evaluated with SSR 12 markers. The analysis of population structure of R. areola revealed that the three subpopulations were genetically simillar (Gst=0.18), and the isolates from Goiás and Minas Gerais were more similar to each other (0,92). This probability can be related to the relatively high gene flow among the three subpopulations (Nm=2.20). The isolates R. areola 9.1, from Minas Gerais State and 8.1 and 8.3 from Goiás State were the most aggressive ones to the susceptible variety Guazuncho-2. The variety VH8-4602 presented high level of resistance to ramularia spot. No differential interaction was observed between the pathogens and the analyzed varieties, and the resistance was classified as horizontal. The quantification of disease by number of necrotic lesions and number of spores in individual plants of F1 and F2 generations from the crossing between the varieties Guazuncho-2 and VH8-4602 presented continuous distribution, suggesting polygenic resistance. The resistance is probabilly recessive, since necrotic lesions and sporulation were observed on F1 plants. The molecular polymorphism between DeltaOpal e CNPA CO-11612 lineages was low (6%), then would be difficult to accomplish molecular mapping of disease resistance using this intercross. With the genotyping of the RIL s it was verified that 25% of the markers segregated in the proportions proposed by Mendel s Law and 75% of the studied markers presented segregation distortion in favor to the parental G. hirsutum. Both the low genetic variability of the pathogen and the number of resistance genes suggest that durable genetic resitance may be achieved

Concentração do óleo de girassol em compostos insaturados utilizando destilação molecular

Vegetable oils are characterized as important raw materials in the supplying of natural substances of interest pharmaceutical, food and cosmetic industry. Sunflower oil stands out for its important composition present in unsaturated fatty acids such as oleic acid (C18:1) and linoleic (C18:2), responsible for many health benefits. The main objective of this study is obtain enriched fractions in unsaturated compounds from refined sunflower oil. The oil used in this study was characterized by the determination of some properties, like iodine number, acid number and viscosity. A transesterification was done to transform the triglycerides into their corresponding methyl esters of fatty acids. These was submitted the molecular distillation process, for present as an efficient alternative to separation and purification of these substances, using high vacuum and low temperatures. Of the esters fractions that was obtained, were analyzed by gas chromatography. The experimental design technique was used to evaluate the influence of the temperature variation of evaporation and condensation system on the percentage obtained residue. The evaporator temperature proved to be the most influential variable on the studied response. The optimized conditions for the answer was studied at 100 °C for evaporator temperature and 10 °C for the condenser temperature. The graph of "split ratio" showed that for the lowest flow feed (1 mL/min) and higher evaporator temperature (110 °C) was obtained in the largest fraction of distillate. It also used the study of the influence of evaporator temperature on the concentration of unsaturated compounds. The best operating conditions for temperature was 90 °C reached 82.21 % of unsaturated compounds. Elimination curves of the unsaturated compounds present in the distillate stream were obtained. The simulation results of the molecular distillation process of sunflower oil showed the concentration profiles for three different feed flow rates. The speed, temperature and thickness profiles of the liquid film were obtained. The speed of the film increases as the fluid flows through the walls of the evaporator, reaching a maximum on length of 0.075 m. The film thickness decreases on the route, since many compounds are volatilized. The result of the temperature profile had to be consistent with the literature reproduced, being constant after reaching the maximum operating temperature in the length of 0.15 m. This study allowed characterizing and focusing, through experimental analysis, unsaturated compounds and observing the sunflower oil´s behavior through process simulation.

Concentração do óleo de girassol em compostos insaturados utilizando destilação molecular

Vegetable oils are characterized as important raw materials in the supplying of natural substances of interest pharmaceutical, food and cosmetic industry. Sunflower oil stands out for its important composition present in unsaturated fatty acids such as oleic acid (C18:1) and linoleic (C18:2), responsible for many health benefits. The main objective of this study is obtain enriched fractions in unsaturated compounds from refined sunflower oil. The oil used in this study was characterized by the determination of some properties, like iodine number, acid number and viscosity. A transesterification was done to transform the triglycerides into their corresponding methyl esters of fatty acids. These was submitted the molecular distillation process, for present as an efficient alternative to separation and purification of these substances, using high vacuum and low temperatures. Of the esters fractions that was obtained, were analyzed by gas chromatography. The experimental design technique was used to evaluate the influence of the temperature variation of evaporation and condensation system on the percentage obtained residue. The evaporator temperature proved to be the most influential variable on the studied response. The optimized conditions for the answer was studied at 100 °C for evaporator temperature and 10 °C for the condenser temperature. The graph of "split ratio" showed that for the lowest flow feed (1 mL/min) and higher evaporator temperature (110 °C) was obtained in the largest fraction of distillate. It also used the study of the influence of evaporator temperature on the concentration of unsaturated compounds. The best operating conditions for temperature was 90 °C reached 82.21 % of unsaturated compounds. Elimination curves of the unsaturated compounds present in the distillate stream were obtained. The simulation results of the molecular distillation process of sunflower oil showed the concentration profiles for three different feed flow rates. The speed, temperature and thickness profiles of the liquid film were obtained. The speed of the film increases as the fluid flows through the walls of the evaporator, reaching a maximum on length of 0.075 m. The film thickness decreases on the route, since many compounds are volatilized. The result of the temperature profile had to be consistent with the literature reproduced, being constant after reaching the maximum operating temperature in the length of 0.15 m. This study allowed characterizing and focusing, through experimental analysis, unsaturated compounds and observing the sunflower oil´s behavior through process simulation.