Sistemas de automação e supervisão do laboratório de avaliação dos processos de medição de vazão e BSW

During a petroleum well production process, It is common the slmultaneous oil and water production, in proportion that can vary from 0% up to values close to 100% of water. Moreover, the production flows can vary a lot, depending on the charaeteristies of eaeh reservoir. Thus being, the meters used in field for the flow and BSW (water in the oil) measurement must work well in wide bands of operation. For the evaluation of the operation of these meters, in the different operation conditions, a Laboratory will be built in UFRN, that has for objective to evaluate in an automatic way the processes of flow and BSW petroleum measurement, considering different operation conditions. The good acting of these meters is fundamental for the accuracy of the measures of the volumes of production liquid and rude of petroleum. For the measurement of this production, the petroleum companies use meters that should indicate the values with tha largast possible accuracy and to respect a series of conditions and minimum requirements, estabelished by the united Entrance ANP/INMETRO 19106/2000. The laboratory of Evafuation of the Processes of Measurement of Flow and BSW to be built will possess an oil tank basically, a tank of water, besides a mixer, a tank auditor, a tank for separation and a tank of residues for discard of fluids, fundamental for the evaluation of the flow metars and BSW. The whole process will be automated through the use of a Programmable Logicat Controller (CLP) and of a supervisory system.This laboratory besides allowing the evaluation of flow meters and BSW used by petroleum companies, it will make possible the development of researches related to the automation. Besides, it will be a collaborating element to the development of the Computer Engineering and Automation Department, that it will propitiate the evolution of the faculty and discente, qualifying them for a job market in continuous growth. The present work describes the project of automation of the laboratory that will be built at of UFRN. The system will be automated using a Programmable Logical Controller and a supervisory system. The programming of PLC and the screens of the supervisory system were developed in this work

Processamento embarcado aplicado a um sistema de deteccão de vazamentos

Embedded systems are widely spread nowadays. An example is the Digital Signal Processor (DSP), which is a high processing power device. This work s contribution consist of exposing DSP implementation of the system logic for detecting leaks in real time. Among the various methods of leak detection available today this work uses a technique based on the pipe pressure analysis and usesWavelet Transform and Neural Networks. In this context, the DSP, in addition to do the pressure signal digital processing, also communicates to a Global Positioning System (GPS), which helps in situating the leak, and to a SCADA, sharing information. To ensure robustness and reliability in communication between DSP and SCADA the Modbus protocol is used. As it is a real time application, special attention is given to the response time of each of the tasks performed by the DSP. Tests and leak simulations were performed using the structure of Laboratory of Evaluation of Measurement in Oil (LAMP), at Federal University of Rio Grande do Norte (UFRN)

Biodistribuição do pertecnetato de sódio (Na99mTcO4) em ratos submetidos à ressecção extensa de intestino delgado

Massive resection of the small intestine results in short bowel syndrome with anti-absorptive effect and repercussions on the metabolism. Morphologic and functional evaluation may be necessary in order to control wrapped organs. Scintigraphy an examination with little invading and no biologic damage can be used. The purpose were to assess the biodistribution of sodium pertecnetate in organs of rats subjected to massive resection of the small intestine, the intestinal adaptation of the remnant intestinal mucosa and weight curve evaluation in the postoperative period. Twenty-one Wistar rats were randomly allocated into three groups (n = 7). The operated group named short bowel (SB) after anesthetized was subjected to massive resection of the small intestine; the control group (C), and sham group (SHAM). On the 30th postoperative day, 0.l mL of sodium pertechnetate was injected into the venous orbital plexus. After 30 minutes, the rats were killed with an overdose of anesthetic, and fragments of the liver, spleen, pancreas, stomach, duodenum, small intestine, thyroid, lung, heart, kidney, bladder, muscle, femur and brain were harvested. The percentage of radioactivity per gram of tissue (%ATI/g) was determined using Gama Counter WizardTM 1470, PerkinElmer to all samples. Biopsies of 3 cm remaining jejunum were removed to histological analyses. Analysis of variance (ANOVA) and the Tukey test for multiple comparisons were used, considering p<0.05 as significant. The study had the participation of some departments and laboratories, as Nucleus of Experimental Surgery, Department of Surgery, Laboratory of Radiobiology, Department of Pathology and Service of Nuclear Medicine, certifying the character of a multidisciplinary research. The results were no significant differences in %ATI/g of the sodium pertechnetate in the organs of the groups studied (p>0.05). An increase in the weight of the SB rats was observed after the second postoperative week. The jejunal mucosal thickness of the SB rats was significantly greater than that of C and sham rats (p<0.05. The biodistribution of sodium pertechnetate was not affected by massive intestinal resection in rats. An adaptive response by the intestinal mucosa probably contributed to the reversion of weight loss and the biodistribution of sodium pertechnetate was not affected by the surgery

Análise de desempenho de um refrigerador de pequeno porte com drop in de refrigerantes hidrocarbonetos

From what was stated in the Montreal Protocol, the researchers and refrigeration industry seek substitutes for synthetic refrigerants -chlorofluorocarbons (CFCs) and HCFCs (HCFC) - that contribute to the depletion of the ozone layer. The phase-out of these substances was started using as one of the replacement alternatives the synthetic fluids based on hydro fluorocarbons (HFCs) that have zero potential depletion of the ozone layer. However, contribute to the process of global warming. HFC refrigerants are greenhouse gases and are part of the group of gases whose emissions must be reduced as the Kyoto Protocol says. The hydrocarbons (HC's), for not contribute to the depletion of the ozone layer, because they have very low global warming potential, and are found abundantly in nature, has been presented as an alternative, and therefore, are being used in new home refrigeration equipment in several countries. In Brazil, due to incipient production of domestic refrigerators using HC's, the transition refrigerants remain on the scene for some years. This dissertation deals with an experimental evaluation of the conduct of a drinking fountain designed to work with HFC (R-134a), operating with a mixture of HC's or isobutane (R-600a) without any modification to the system or the lubricating oil. In the refrigeration laboratory of Federal University of Rio Grande do Norte were installed, in a drinking fountain, temperature and pressure sensors at strategic points in the refrigeration cycle, connected to an acquisition system of computerized data, to enable the mapping and thermodynamics analysis of the device operating with R-134a or with a mixture of HC's or with R-600a. The refrigerator-test operating with the natural fluids (mixture of HC's or R-600a) had a coefficient of performance (COP) lower than the R-134a

Construção e avaliação térmica de um fogão solar tipo caixa

The present work presents a contribution in the study of modelings of transference of heat for foods submitted to the experimental tests in the considered solar oven, where the best modeling for the beefburger of chicken in study was evaluated, comparing the results, considering this food as a half-infinite(1er object considered model) and,after that, considered the chicken beefburger as a plain plate in transient regimen in two distinct conditions: not considering and another model considering the contribution of the generation term, through the Criterion of Pomerantsev. The Sun, beyond life source, is the origin of all the energy forms that the man comes using during its history and can be the reply for the question of the energy supplying in the future, a time that learns to use to advantage in rational way the light that this star constantly special tax on our planet. Shining more than the 5 billion years, it is calculated that the Sun still in them will privilege for others 6 billion years, or either, it is only in the half of its existence and will launch on the Earth, only in this year, 4000 times more energy that we will consume. Front to this reality, would be irrational not to search, by all means technical possible, to use to advantage this clean, ecological and gratuitous power plant. In this dissertation evaluate the performance of solar cooker of the type box. Laboratory of Solar Energy of the Federal University of the Great River of North - UFRN was constructed by the group (LES) a model of solar stove of the type box and was tested its viability technique, considering modeling foods submitted when baking in the solar oven, the cooker has main characteristic the easiness of manufacture and assembly, the low cost (was used material accessible composition to the low income communities) and simplicity in the mechanism of movement of the archetype for incidence of the direct solar light. They had been proposals modeling for calculations of food the minimum baking time, considering the following models of transference of heat in the transient state: object the halfinfinite, plain plate and the model of the sphere to study the necessary temperature for the it bakes of bread (considering spherical geometry). After evaluate the models of transmission of heat will be foods submitted you the processes of to it bakes of, the times gotten for the modeling with the experimental times of it bakes in the solar oven had been compared, demonstrating the modeling that more good that it portraies the accuracies of the results of the model

Uma abordagem dialógica para a utilização de atividades experimentais em sala de aula

The belief of using experimental activities in the teaching of Physics as a strategy to produce a more efficient teaching-learning process is great among teachers and the school community. However, there are many difficulties for their implementation and when it happens they do not contribute for an improvement in class efficiency due to the method used. In this work, we developed a proposal for using these activities in Physics classes in high school, from a critical-reflexive approach in which the constant dialogue between the participants in the teaching-learning process is fundamental. The work was developed in two ways. The first, where the author/writer created an educational material and applied it in classroom and a second one, where he presented the idea to other teachers and undergraduate students from the Physics course at UFRN and IFRN (former CEFET-RN) through an extended workshop entitled "The role of experimental activities in the Physics teaching". This workshop had the duration of 60 hours and was implemented in 4 steps: i) sensitization and formation, ii) material development, iii) material implementation and iv) evaluation by teachers and students from the classes where the material was applied. The goal of this workshop was to present the approach, evaluate how the participants received the idea and how they would apply it in real situations. The results of the application in classroom allowed us to reach some conclusions. This approach was well received by the students as well as by the workshop participants. Despite some difficulties in relation to the handling of the implementation results by the workshop participants, they indicated changes in these professionals teaching practice and the introduction of experimental activities has been an important subsidy to assist them in Physics class in high school