Avaliação do desempenho de argamassas à base de cimento Portland para rejuntamento de placas cerâmicas tipo II com adição de pó de borracha de pneus

In this work it is assessed the performance of Portland cement-based mortar to the grouting of type II ceramic plates with the addition of unusable tire rubber powder. It is presented a bibliographical review about the subject in which is done the theoretical and methodological foundation of the whole investigative process. The analyzed universe comprises a sample of mortar to the grouting of conventional ceramic plates type II (reference sample) and five more samples to the grouting of ceramic plates type II, which were made up of the addition of unusable tire rubber powder in the respective proportion (in mass) of 4%, 8%, 12%, 16% and 20%. These mortar samples were subject to the trials of determination of the consistency index (Brazilian Standard NBR 13276:2005), water retention ( Brazilian Standard NBR 14992 Attachment B:2003), permeability in 240 minutes (Brazilian Standard NBR 14992 Attachment G:2003), absorption of water by immersion (Brazilian Standard NBR 9781:2013), resistance to compression (Brazilian Standard NBR14992 Attachment D: 2003), resistance to traction in the flexion (Brazilian Standard NBR 13279:2005), resistance of traction adherence (Brazilian Standard NBR 14081 part 4:2012) and hardened mass density (Brazilian Standard NBR 13280: 2005). It has been found out from the analyzes of the results in the trial the following situation: the reference mortar used met the established requirements in the norms of specifications corresponding to only six from the eight parameters assessed in the research; the mortar with addition of 4,0% of tire rubber powder met the established requirements corresponding to only the resistance to compression and the resistance of adherence to traction. Thus, the other kinds of mortar with addition of 8,0 %, 12,0 %, 16,0 % and 20,0 % of tire rubber powder met the requirements of specifications corresponding to only the resistance to compression and the resistance of adherence to traction. This result concludes that the adding of tire rubber powder does not grant improvement to the mortar of type II grouting to the laying of ceramic plates.

Avaliação do desempenho de argamassas à base de cimento Portland para rejuntamento de placas cerâmicas tipo II com adição de pó de borracha de pneus

In this work it is assessed the performance of Portland cement-based mortar to the grouting of type II ceramic plates with the addition of unusable tire rubber powder. It is presented a bibliographical review about the subject in which is done the theoretical and methodological foundation of the whole investigative process. The analyzed universe comprises a sample of mortar to the grouting of conventional ceramic plates type II (reference sample) and five more samples to the grouting of ceramic plates type II, which were made up of the addition of unusable tire rubber powder in the respective proportion (in mass) of 4%, 8%, 12%, 16% and 20%. These mortar samples were subject to the trials of determination of the consistency index (Brazilian Standard NBR 13276:2005), water retention ( Brazilian Standard NBR 14992 Attachment B:2003), permeability in 240 minutes (Brazilian Standard NBR 14992 Attachment G:2003), absorption of water by immersion (Brazilian Standard NBR 9781:2013), resistance to compression (Brazilian Standard NBR14992 Attachment D: 2003), resistance to traction in the flexion (Brazilian Standard NBR 13279:2005), resistance of traction adherence (Brazilian Standard NBR 14081 part 4:2012) and hardened mass density (Brazilian Standard NBR 13280: 2005). It has been found out from the analyzes of the results in the trial the following situation: the reference mortar used met the established requirements in the norms of specifications corresponding to only six from the eight parameters assessed in the research; the mortar with addition of 4,0% of tire rubber powder met the established requirements corresponding to only the resistance to compression and the resistance of adherence to traction. Thus, the other kinds of mortar with addition of 8,0 %, 12,0 %, 16,0 % and 20,0 % of tire rubber powder met the requirements of specifications corresponding to only the resistance to compression and the resistance of adherence to traction. This result concludes that the adding of tire rubber powder does not grant improvement to the mortar of type II grouting to the laying of ceramic plates.

Resposta clínica periodontal e controle glicêmico em pacientes com e sem diabetes tipo II portadores de periodontite crônica ao tratamento periodontal “full mouth desinfection”

There is a bidirectional association between periodontal disease (PD) and diabetes mellitus, in which diabetes favors the development of PD and PD, if left untreated, can worsen the metabolic control of diabetes. Thus, periodontal disease should be treated to restore periodontal health and reduce the complications of diabetes. Therefore, the objective is assess the effect of full mouth periodontal therapy decontamination (Full Mouth Desinfection - FMD) in diabetic type II patients with chronic periodontitis during 12 months. Thirty-one patients in group one (G1) and 12 in group two (G2) were followed at baseline, 03, 06 09 and 12 months. There following clinical parameters were accessed: probing on bleeding (BOP), visible plaque index (PI), probing depth (PD), clinical attachment level (CAL) and gingival recession (GR). For diabetic patients, there were also made laboratory tests to evaluate blood parameters: fasting glucose and glycated hemoglobin. The results had been analyzed in two ways: all sites in the mouth and another with diseased sites. The Mann-Whitney, Friedman and Wilcoxon tests were used with 5% significance. Intergroup analysis of all sites it is clear that there was no significant difference over time concerning PD, BOP, PI, CAL and RG. However, when evaluating the diseased sites, we observed significant difference for CAL and PD, with higher values in G1. The intragroup analysis for all sites showed a statistically significant reduction at PD, PI and BOP in both groups. Intragroup analysis of periodontal affected sites showed a statistically significant reduction in PD, BOP and CAL in both groups. There was also a statistically significant increase in RG values. There was no significant change concerning glycated hemoglobin and fasting glucose in the G1. Therefore, it can be concluded that there were improvements in periodontal parameters over the 12 months of research, but without changes in glycemic levels of diabetic patients. Thus, periodontal therapy proved effective in maintaining oral health.

O elo microbiano como alimento alternativo para o zooplâncton em reservatórios dominados por cianobactérias

Protozoa may be an important alternative food source for Calanoida copepods in these environments. Aiming to quantify the feeding preferences of N. cearensis by ciliates in the presence of cyanobacteria, in vitro experiments were conducted, using mixed cultures in different concentrations of total food for copepod. Two ciliates species (Paramecium sp. and Cyclidium sp.) and a cyanobacteria toxic strain (Microcystis aeruginosa) were offered as food. Previous experiments were done to identify the copepod s maximum ingestion rate through the use of a type II functional response model when each prey is offered separately. High maximum ingestion rate were found when those protists were offered as prey. N. cearensis showed significant preference for protozoal prey over the cyanobacterium tested both in low (corresponding 95.15% of the diet) and in high food concentration treatments (about 91.56% of the diet), preferring the bigger ciliate in lower concentrations (67.52% of the diet). The meaningful involvement of heterotrophic organisms in the zooplankton diet emphasis the microbial loop participation in the energy transition from copepods to higher trophic levels. This data contributes to understand the stability of existing trophic interactions in reservoirs subjected to eutrophication and assists trophic cascade studies in these environments

Propriedades ópticas de nanocristais de SiGe: efeitos de dopagem e desordem

We have used ab initio calculations to investigate the electronic structure of SiGe based nanocrystals (NC s). This work is divided in three parts. In the first one, we focus the excitonic properties of Si(core)/Ge(shell) and Ge(core)/Si(shell) nanocrystals. We also estimate the changes induced by the effect of strain the electronic structure. We show that Ge/Si (Si/Ge) NC s exhibits type II confinement in the conduction (valence) band. The estimated potential barriers for electrons and holes are 0.16 eV (0.34 eV) and 0.64 eV (0.62 eV) for Si/Ge (Ge/Si) NC s. In contradiction to the expected long recombination lifetimes in type II systems, we found that the recombination lifetime of Ge/Si NC s (τR = 13.39μs) is more than one order of magnitude faster than in Si/Ge NC s (τR = 191.84μs). In the second part, we investigate alloyed Si1−xGex NC s in which Ge atoms are randomly positioned. We show that the optical gaps and electron-hole binding energies decrease linearly with x, while the exciton exchange energy increases with x due to the increase of the spatial extent of the electron and hole wave functions. This also increases the electron-hole wave functions overlap, leading to recombination lifetimes that are very sensitive to the Ge content. Finally, we investigate the radiative transitions in Pand B-doped Si nanocrystals. Our NC sizes range between 1.4 and 1.8 nm of diameters. Using a three-levels model, we show that the radiative lifetimes and oscillator strengths of the transitions between the conduction and the impurity bands, as well as the transitions between the impurity and the valence bands are strongly affected by the impurity position. On the other hand, the direct conduction-to-valence band decay is practically unchanged due to the presence of the impurity