Estudo paramétrico da recuperação de petróleo pesado por aquecimento eletromagnético resistivo

Electrical resistive heating (ERH) is a thermal method used to improve oil recovery. It can increase oil rate and oil recovery due to temperature increase caused by electrical current passage through oil zone. ERH has some advantage compared with well-known thermal methods such as continuous steam flood, presenting low-water production. This method can be applied to reservoirs with different characteristics and initial reservoir conditions. Commercial software was used to test several cases using a semi-synthetic homogeneous reservoir with some characteristics as found in northeast Brazilian basins. It was realized a sensitivity analysis of some reservoir parameters, such as: oil zone, aquifer presence, gas cap presence and oil saturation on oil recovery and energy consumption. Then it was tested several cases studying the electrical variables considered more important in the process, such as: voltage, electrical configurations and electrodes positions. Energy optimization by electrodes voltage levels changes and electrical settings modify the intensity and the electrical current distribution in oil zone and, consequently, their influences in reservoir temperature reached at some regions. Results show which reservoir parameters were significant in order to improve oil recovery and energy requirement in for each reservoir. Most significant parameters on oil recovery and electrical energy delivered were oil thickness, presence of aquifer, presence of gas cap, voltage, electrical configuration and electrodes positions. Factors such as: connate water, water salinity and relative permeability to water at irreducible oil saturation had low influence on oil recovery but had some influence in energy requirements. It was possible to optimize energy consumption and oil recovery by electrical variables. Energy requirements can decrease by changing electrodes voltages during the process. This application can be extended to heavy oil reservoirs of high depth, such as offshore fields, where nowadays it is not applicable any conventional thermal process such as steam flooding

Flebotomíneos (Diptera: Psychodidae) em um sistema agroflorestal da Região Metropolitana de Natal, Rio Grande do Norte, Brasil

Sandflies stand out as important vectors of leishmaniasis. The females need to ingest blood meals, enabling them to transmit protozoa of the genus Leishmania, which may give rise to visceral leishmaniasis (VL) or American tegumentary leishmaniasis (ATL), in addition to transmitting other parasites. Leishmaniasis are important infirmities, distributed worldwide, whose infection results from the interaction of reservoir animals, the vector insect, parasitic protozoa and the healthy host. In the state of Rio Grande do Norte (RN), Brazil, these insects are important transmitters of VL, which usually presents in the most serious form. It occurs mainly in metropolitan areas, with the dog as its main reservoir and Lutzomyia longipalpis as the vector. ATL is most present in the highland areas of the state. In addition to hematophagia, engaged in by the females, both sexes need to ingest carbohydrates, which are essential to the sand flies energy requirements and may interfere in the development of Leishmania. The aim of this study was to determine the occurrence and abundance of sand flies in different environments on the farm belonging to the Empresa de Pesquisas Agropecuárias do RN (Institute of Agricultural Research of RN), in the municipality of Parnamirim, in order to relate this occurrence with climatological and biological references and eating habits. Three consecutive monthly collections were carried out with CDC traps in a fragment of the Atlantic Forest, in a residence, on a goat breeding farm and on cashew, dwarf and giant coconut, mango, banana, eucalyptus, acacia and bean plantations. A total of 1241 sandflies from eight species (Lutzomyia evandroi, Lutzomyia longipalpis, Lutzomyia shannoni, Lutzomyia sordellii Lutzomyia walkeri, Lutzomyia wellcomei, Lutzomyia whitmani, and Lutzomyia intermedia) were collected, most in the forest environment. L. longipalpis, the main VL transmitter, was confirmed as a species adapted to anthropic environments, whereas others such as L. wellcomei, the vector of ATL, occurred predominantly in forests. Carbohydrate characterization of the sand flies and plants of the region demonstrated that a number of exotic plants such as hay and eucalyptus may play some role in the adaptation of these species to modified environments. Breeding in laboratory showed a mean biological cycle of 53.5 days from egg to adulthood for L. shannoni and the possibility of diapause behavior in L. wellcomei. This study serves as a source of information that may contribute to the epidemiological vigilance of tegumentary and visceral leishmaniasis in the state, given that it analyzes the bioecology of transmitting species, as well as their potential to adapt to new environments

Tecnologia eletroquímica como tratamento alternativo de efluentes têxteis sintéticos utilizando ânodos de platina e diamante

In this work, the treatment of synthetic wastewaters containing Remazol Red BR (RRB) and Novacron Blue C-D (NB) by anodic oxidation using boron doped diamond anodes (BDD) and Novacron Yellow (YN) using BDD and Platinum (Pt) anodes was investigated. Galvanostatic electrolyses of RRB and NB synthetic wastewaters have led to the complete decolorization removal at different operating conditions (current density, pH and temperature). The influence of these parameters was investigated in order to find the best conditions for dyestuff colour removal. According to the experimental results obtained, the electrochemical oxidation process is suitable for decolorizing wastewaters containing these textile dyes, due to the electrocatalytic properties of BDD and Pt anode. Energy requirements for removing colour during galvanostatic electrolyses of RRB, NB and YN synthetic solutions depends mainly on the operating conditions; for example for RRB, it passes from 3.30 kWh m-3 at 20 mA cm-2 to 4.28 kWh m-3 at 60 mA cm-2 (pH = 1); 15.23 kWh m-3 at 20 mA cm-2 to 24.75 kWh m-3 at 60 mA cm-2 (pH = 4.5); 10.80 kWh m-3 at 20 mA cm-2 to 31.5 kWh m-3 at 60 mA cm-2 (pH = 8) (data estimated per volume of treated effluent). In order to verify the Brazilian law regulations of NB and RRB synthetic solutions after electrochemical decolourisation treatment, Hazen Units values were determined and the total colour removal was achieved; remaining into the regulations. Finally, electrical energy cost for removing colour was estimated

Tecnologia eletroquímica como tratamento alternativo de efluentes derivados da indústria têxtil e petroquímica

In this work, the treatment of wastewater from the textile industry, containing dyes as Yellow Novacron (YN), Red Remazol BR (RRB) and Blue Novacron CD (NB), and also, the treatment of wastewater from petrochemical industry (produced water) were investigated by anodic oxidation (OA) with platinum anodes supported on titanium (Ti/Pt) and boron-doped diamond (DDB). Definitely, one of the main parameters of this kind of treatment is the type of electrocatalytic material used, since the mechanisms and products of some anodic reactions depend on it. The OA of synthetic effluents containing with RRB, NB and YN were investigated in order to find the best conditions for the removal of color and organic content of the dye. According to the experimental results, the process of OA is suitable for decolorization of wastewaters containing these textile dyes due to electrocatalytic properties of DDB and Pt anodes. Removal of the organic load was more efficient at DDB, in all cases; where the dyes were degraded to aliphatic carboxylic acids at the end of the electrolysis. Energy requirements for the removal of color during OA of solutions of RRB, NB and YN depends mainly on the operating conditions, for example, RRB passes of 3.30 kWh m-3 at 20 mA cm-2 for 4.28 kWh m-3 at 60 mA cm-2 (pH = 1); 15.23 kWh m-3 at 20 mA cm-2 to 24.75 kWh m-3 at 60 mA cm-2 (pH 4.5); 10.80 kWh m-3 at 20 mA cm-2 to 31.5 kWh m-3 at 60 mA cm-2 (pH = 8) (estimated data for volume of treated effluent). On the other hand, in the study of OA of produced water effluent generated by petrochemical industry, galvanostatic electrolysis using DDB led to the complete removal of COD (98%), due to large amounts of hydroxyl radicals and peroxodisulphates generated from the oxidation of water and sulfates in solution, respectively. Thus, the rate of COD removal increases with increasing applied current density (15-60 mAcm-2 ). Moreover, at Pt electrode, approximately 50% removal of the organic load was achieved by applying from 15 to 30 mAcm-2 while 80% of COD removal was achieved for 60 mAcm-2 . Thus, the results obtained in the application of this technology were satisfactory depending on the electrocatalytic materials and operating conditions used for removal of organic load (petrochemical and textile effluents) as well as for the removal of color (in the case of textile effluents). Therefore, the applicability of electrochemical treatment can be considered as a new alternative like pretreatment or treatment of effluents derived from textiles and petrochemical industries.

Estudo paramétrico da recuperação de petróleo pesado por aquecimento eletromagnético resistivo

Electrical resistive heating (ERH) is a thermal method used to improve oil recovery. It can increase oil rate and oil recovery due to temperature increase caused by electrical current passage through oil zone. ERH has some advantage compared with well-known thermal methods such as continuous steam flood, presenting low-water production. This method can be applied to reservoirs with different characteristics and initial reservoir conditions. Commercial software was used to test several cases using a semi-synthetic homogeneous reservoir with some characteristics as found in northeast Brazilian basins. It was realized a sensitivity analysis of some reservoir parameters, such as: oil zone, aquifer presence, gas cap presence and oil saturation on oil recovery and energy consumption. Then it was tested several cases studying the electrical variables considered more important in the process, such as: voltage, electrical configurations and electrodes positions. Energy optimization by electrodes voltage levels changes and electrical settings modify the intensity and the electrical current distribution in oil zone and, consequently, their influences in reservoir temperature reached at some regions. Results show which reservoir parameters were significant in order to improve oil recovery and energy requirement in for each reservoir. Most significant parameters on oil recovery and electrical energy delivered were oil thickness, presence of aquifer, presence of gas cap, voltage, electrical configuration and electrodes positions. Factors such as: connate water, water salinity and relative permeability to water at irreducible oil saturation had low influence on oil recovery but had some influence in energy requirements. It was possible to optimize energy consumption and oil recovery by electrical variables. Energy requirements can decrease by changing electrodes voltages during the process. This application can be extended to heavy oil reservoirs of high depth, such as offshore fields, where nowadays it is not applicable any conventional thermal process such as steam flooding

Flebotomíneos (Diptera: Psychodidae) em um sistema agroflorestal da Região Metropolitana de Natal, Rio Grande do Norte, Brasil

Sandflies stand out as important vectors of leishmaniasis. The females need to ingest blood meals, enabling them to transmit protozoa of the genus Leishmania, which may give rise to visceral leishmaniasis (VL) or American tegumentary leishmaniasis (ATL), in addition to transmitting other parasites. Leishmaniasis are important infirmities, distributed worldwide, whose infection results from the interaction of reservoir animals, the vector insect, parasitic protozoa and the healthy host. In the state of Rio Grande do Norte (RN), Brazil, these insects are important transmitters of VL, which usually presents in the most serious form. It occurs mainly in metropolitan areas, with the dog as its main reservoir and Lutzomyia longipalpis as the vector. ATL is most present in the highland areas of the state. In addition to hematophagia, engaged in by the females, both sexes need to ingest carbohydrates, which are essential to the sand flies energy requirements and may interfere in the development of Leishmania. The aim of this study was to determine the occurrence and abundance of sand flies in different environments on the farm belonging to the Empresa de Pesquisas Agropecuárias do RN (Institute of Agricultural Research of RN), in the municipality of Parnamirim, in order to relate this occurrence with climatological and biological references and eating habits. Three consecutive monthly collections were carried out with CDC traps in a fragment of the Atlantic Forest, in a residence, on a goat breeding farm and on cashew, dwarf and giant coconut, mango, banana, eucalyptus, acacia and bean plantations. A total of 1241 sandflies from eight species (Lutzomyia evandroi, Lutzomyia longipalpis, Lutzomyia shannoni, Lutzomyia sordellii Lutzomyia walkeri, Lutzomyia wellcomei, Lutzomyia whitmani, and Lutzomyia intermedia) were collected, most in the forest environment. L. longipalpis, the main VL transmitter, was confirmed as a species adapted to anthropic environments, whereas others such as L. wellcomei, the vector of ATL, occurred predominantly in forests. Carbohydrate characterization of the sand flies and plants of the region demonstrated that a number of exotic plants such as hay and eucalyptus may play some role in the adaptation of these species to modified environments. Breeding in laboratory showed a mean biological cycle of 53.5 days from egg to adulthood for L. shannoni and the possibility of diapause behavior in L. wellcomei. This study serves as a source of information that may contribute to the epidemiological vigilance of tegumentary and visceral leishmaniasis in the state, given that it analyzes the bioecology of transmitting species, as well as their potential to adapt to new environments

Parallel Cyclostationarity-Exploiting Algorithm for Energy-Efficient Spectrum Sensing

The evolution of wireless communication systems leads to Dynamic Spectrum Allocation for Cognitive Radio, which requires reliable spectrum sensing techniques. Among the spectrum sensing methods proposed in the literature, those that exploit cyclostationary characteristics of radio signals are particularly suitable for communication environments with low signal-to-noise ratios, or with non-stationary noise. However, such methods have high computational complexity that directly raises the power consumption of devices which often have very stringent low-power requirements. We propose a strategy for cyclostationary spectrum sensing with reduced energy consumption. This strategy is based on the principle that p processors working at slower frequencies consume less power than a single processor for the same execution time. We devise a strict relation between the energy savings and common parallel system metrics. The results of simulations show that our strategy promises very significant savings in actual devices.

Parallel Cyclostationarity-Exploiting Algorithm for Energy-Efficient Spectrum Sensing

The evolution of wireless communication systems leads to Dynamic Spectrum Allocation for Cognitive Radio, which requires reliable spectrum sensing techniques. Among the spectrum sensing methods proposed in the literature, those that exploit cyclostationary characteristics of radio signals are particularly suitable for communication environments with low signal-to-noise ratios, or with non-stationary noise. However, such methods have high computational complexity that directly raises the power consumption of devices which often have very stringent low-power requirements. We propose a strategy for cyclostationary spectrum sensing with reduced energy consumption. This strategy is based on the principle that p processors working at slower frequencies consume less power than a single processor for the same execution time. We devise a strict relation between the energy savings and common parallel system metrics. The results of simulations show that our strategy promises very significant savings in actual devices.