Freqüência e etiologia das dermatomicoses em pacientes atendidos no Hospital Giselda Trigueiro, Natal, RN

Dermatomycoses are fungal infections that attack the skin, hair and nails, in addition to the mucosal and cutaneous-mucosal zones. Objective: Observe the frequency of dermatomycoses, identify etiological agents and establish an association between the results and sex. Age, collection site, time and lesion location. Methods: Between February, 2002 and December, 2004, samples were collected from patients at Giselda Trigueiro Hospital in Natal, Brazil, by lesion scraping and hair removal, following 70% alcohol disinfection, and submitted to direct and culture examination. Results: Of the 817 lesions collected, 325 (39.8%) were fungus positive, with the hair collection site yielding the highest number of positive results (65.8%) and the scalp and hair representing the most frequent lesion sites (65.9%). Negative results occurred mainly in the lower limbs (78.6%). Of the species identified, 55.9% were yeasts, 41.6% dermatophytes and 2.5% Fusarium spp. Non-albicans Candida was the most isolated yeast (43.3%), mainly in females (61.7%) over the age of 40 years (56.4%). T. rubrum was the most isolated dermatophyte (67.9%),notably in males (59.2%) in the 0-20 age group (44.7%). With respect to collection site, 73.9% of the dermatophytes were present in the skin and 61.1% of the yeasts in the nails. When assessing the collection site, the inguinocrural regional was 22.6% positive for dermatophytes, and the nails and hands, 41.8% for yeasts. Conclusions: The results obtained verified that: most of the positive lesions were found in the hair, whereas skin and nail lesions yielded more negative results; T. rubrum was the most isolated dermatophyte and non-albicans candida the most commonly found yeast; positivity was greater in males in the 0-20 year age group at the skin site and in the inguinocrural region, while yeasts were more frequent in females in the over-40 age group at the nail sites

Desenvolvimento de compósito de pu de mamona com carga de resíduo de couro para isolação térmica

The standardization of the bovine skin thickness in the leather industry generates a residue known as wet-blue . At the end of twentieth century, the brazilian industry discarded about 131 thousand tons of this residue in nature, provoking a great environmental liability. In this paper is presented the analyses of the termophysical properties, thermal and volumetric expansion performance of a composite of vegetable resin of castor oil plant (Ricinus communis) with load of industrial residue of leather "wet-blue", for application as thermal isolation material of warm surfaces. There were considered four percentile levels of residue load in the proportions in mass of 0%, 5%, 10% and 15%, added to the expansible resin of castor oil plant in two configurations: sawed leather and crushed leather in a smaller particle (powder) by grinding in a mill of balls. Twenty-one proof bodies were produced for termophysical properties analysis (three for each configuration) and four proof bodies for rehearsals of thermal acting. Analyses of thermal acting were done in test cameras. The results of the rehearsals were compared to those obtained considering the castor oil plant foam without residue addition. A small reduction of the thermal conductivity of the composite was observed in the proportion of 10% of leather residue in both configurations. Regarding thermal conductivity, calorific capacity and diffusivity, it was verified that the proposed composite showed very close values to the commercial insulating materials (glass wool, rock wool, EPS). It was still demonstrated the technical viability of the use of composite as insulating thermal for systems of low potency. The composite presented larger volumetric expansion with 15% of sawed residue of leather.

O sertão vai para o Além-Mar : a relação centro e periferia e as fábricas de couro em Pernambuco nos setecentos

This thesis focuses on the economic relations in the interior of the Portuguese America, more specifically in Pernambuco Captancy in the 17th Century, concerning the discussion about center-periphery relationship and also the context of Brazilian colonial history. In addition, it portrays the exportations of leather to Portugal, their consequences in the Captaincy of Pernambuco and the businessmen involved in the trade and manufacturing of that product. In order to accomplish this work, manuscripts of Arquivo Histórico Ultramarino (Ultramarine Historical Archives), colonial narratives and maps of the mercantile loads have been used so that one can visualize that the manufacturing of leather and other products have provided a social and economical connection among Pernambuco, Recife as trade center, Olinda as administrative municipality and Portugal

Otimização do processo de recuperação do cromo de efluentes de curtumes por microemulsões no extrator Morris

The tanning industries are those which transform animal hide or skin into leather. Due to the complexity of the transformation process, greater quantities of chemicals are being used which results in the generation of effluents with residual solids. The chromium in the residual waters generated by tanning tend to be a serious problem to the environment, therefore the recovery of this metal could result in the reduction of manufacturing costs. This metal is usually found in a trivalent form which can be converted into a hexavalent compound under acidic conditions and in the presence of organic matter. The present study was carried out with the objective to recover chromium through an extraction/re-extraction process using micro emulsions. Micro emulsions are transparent and thermodynamically stable system composed of two immiscible liquids, one forming the continuous phase and the other dispersed into micro bubbles, established by an interfacial membrane formed by surface active and co-surface active molecules. The process of recovering the chromium was carried out in two stages. The first, an extraction process, where the chromium was extracted in the micro emulsion phase and the aqueous phase in excess was separated. In the second stage, a concentrated acid was added to the micro emulsion phase rich in chromium in order to obtain a Winsor II system, where the water that formed in the micro emulsion phase separates into a new micro emulsion phase with a higher concentration of chromium, due to the lowering of the hydrophiles as well as the ionisation of the system. During the experimental procedure, a study was initiated with a synthetic solution of chromium sulphate passing onto the effluent. A Morris extractor was used in the extraction process. Tests were carried out according to the plan and the results were analysed by statistical methods in order to optimise the main parameters that influence the process: the total rate of flow (Q), stirring speed (w) and solvent rate (r). The results, after optimization, demonstrated that the best percentuals in relation to the chromium extraction (99 %) were obtained in the following operational conditions: Q= 2,0 l/h, w= 425 rpm and r= 0,375. The re-extraction was carried out at room temperature (28 °C), 40 °C and 50°C using hydrochloric acid (8 and 10 M) and sulphuric acid (8 M) as re-extracting agents. The results obtained demonstrate that the process was efficient enough in relation to the chromium extraction, reaching to re-extraction percentage higher than 95 %.

As condições de trabalho na área de saúde e o processo de adoecimento da (o) assistente social

The requirements in the world of work in the contemporary impact on quality of life, health workers in their relations with users and other professionals of the healthcare team. Given this reality, this study discusses the working conditions in health and disease process of (a) having social goals as analyze the implications of working conditions in the disease (the) social workers in state hospitals Metropolitan Region Christmas (NMR); identify the main diseases affecting social workers in hospitals in the SESAP NMR and reveal the relationship between the disease processes of social and working conditions in hospitals in the state NMR. The research was guiding questions to reveal how to configure the work, conditions of work and of the disease process (the) social worker. To grasp the socioeconomic profile of (the) social workers, the characterization of the work, duties and responsibilities in the sociooccupational, factors that interfere with the disease process of (the) social workers of RMN, and actions and investments Policy on Occupational Health RN correlating to illness today is that we set for the unveiling of the movement of the object of study through the methodological approach with documentary research aimed at literature review; extensive direct observation correlated to real life observation and application of 66 (sixty-six) questionnaires. The data from the closed questions were treated using the Statistical Package for the Social Sciences (SPSS). The open questions were transcribed and then analyzed the light of theoretical work on the subject. The research reveals that social workers are subject to conditions and labor relations precarious illness causing health problems because some of these professionals, among them are: stress, allergies and skin conditions or, Read / WMSD among other diseases. Thus, we understand the need for debates about the relationship work (the) social worker and worker health before the contradictions of capital also present in public health services

Trissoralen um medicamento de baixa dosagem: estudos termoanalíticos da compatibilidade do fármaco-excipientes e determinação de parâmetros de qualidade para cápsulas magistrais

The trioxsalen (Tri) is a low-dose drug used in the treatment of psoriasis and other skin diseases. The aim of the study was applying the thermal analysis and complementary techniques for characterization, evaluation of the trioxsalen stability and components of manipulated pharmaceutical formulations. The thermal behavior of the Tri by TG/DTG-DTA in dynamic atmosphere of synthetic air and nitrogen showed the same profile with a melting peak followed by a volatilization-related event. From the curves TG / DTG is observed a single stage of mass loss. By heating the drug in the stove at temperatures of 80, 240 and 260 °C, it had no change in chemical structure through the techniques of XRD, HPLC, MIR, OM and SEM. From the non-isothermal and isothermal TG kinetic studies was possible to calculate the activation energy and reaction order for the Tri. The drug showed good thermal stability. Studies on drug-excipient compatibility showed interaction of trissoralen with sodium lauryl sulfate 1:1. There was no interaction with aerosol, pregelatinized starch, sodium starch glycolate, cellulose, croscarmellose sodium, magnesium stearate, lactose and mannitol.The characterization of three trioxsalen formulations at concentrations of 2.5, 5, 7.5, 10, 12.5 and 15 mg was performed by DSC, TG / DTG, XRD, NIR and MIR. The PCA classification method based on spectral data from the NIR and MIR of trissoralen formulations allows successful differentiation into three groups. The formulation 3 was the one that best showed analytical profile with the following composition of aerosil excipients, pre-gelatinized starch and cellulose. The activation energy of the volatilization process of the drug was determined in binary mixtures and formulation 3 through fitting and isoconversional methods. The binary mixture with sodium starch glycolate and lactose showed differences in kinetic parameters compared to the drug isolated. The thermoanalytical techniques (DSC and TG / DTG) were shown to be promising methodologies for quantifying trioxsalen obtained by the linearity, selectivity, no use solvents, without sample preparation, speed and practicality.