Extração de metais (K, Mg, Ba, Ca, Cr, Mn, Li, Fe) de água produzida utilizando sistema microemulsionado

The produced water is a byproduct formed due to production of petroleum and carries with it a high amount of contaminants such as oil particles in suspension, organic compounds and metals. Thus, these latter pollutants are very difficult to treat because of its high solubility in water. The objective of this work is to use and evaluate a microemulsioned system to remove metals ( K , Mg , Ba , Ca , Cr , Mn , Li , Fe ) of synthetic produced water. For the extraction of metals, it was used a pseudoternary diagram containing the following phases: synthetic produced water as the aqueous phase (AP), hexane as organic phase (OP), and a cosurfactant/surfactant ratio equal to four (C/S = 4) as the third phase, where the OCS (saponified coconut oil) was used as surfactant and n-butanol as cosurfactant. The synthetic produced water was prepared in a bench scale and the region of interest in the diagram for the removal of metals was determined by experimental design called. Ten points located in the phase Winsor II were selected in an area with a large amount of water and small amounts of reagents. The samples were analyzed in atomic absorption spectrometer, and the results were evaluated through a statistical assesment, allowing the efficiency analysis of the effects and their interactions. The results showed percentages of extraction above 90% for the metals manganese, iron, chromium, calcium, barium and magnesium, and around 45% for metals lithium and potassium. The optimal point for the simultaneous removal of metals was calculated using statistical artifact multiple response function (MR). This calculation showed that the point of greatest extraction of metals occurs was the J point, with the composition [72% AP, 9% OP, 19% C/S], obtaining a global extraction percentage about 80%. Considering the aspects analyzed, the microemulsioned system has shown itself to be an effective alternative in the extraction of metals on synthetic produced water remediation

A busca de sintomáticos respiratórios de tuberculose na prática e perspectiva do agente comunitário de saúde nos distritos sanitários de Natal

The objective of this work - which is characterized analyze the search for symptomatic tuberculosis in practice and perspective of the Community Health Agent (ACS) in the districts of Natal. Methods: This is a cross-sectional study. The study population was 646 professionals, and conducted a probabilistic random sampling, stratified by districts. The data were collected from one instrument to collect data based on Primary Care Assesment Toll (PCAT) and analyzed by descriptive statistics. The sample consisted of ACS was 87% female. Among the study participants 58% completed high school and 120 months of exercise training (95% CI 111.9 to 129.5) on average. 90% were USF. The average follow-up of cases found were 2 cases of TB since the beginning of the career of the ACS and the last three years the average is presented in a case accompanied. The ACS received satisfactory ratings on the bond of trust with the user, so as access to homes in the community. The ACS reported for denying the fear of being positive result was the biggest reason for not performing the sputum. All units have a professional that responds to the Tuberculosis Control Program. Regarding the structural capacity of primary care settings for the diagnosis of TB, we observed satisfactory levels in different districts of pots for sputum collection, however, a point that deserves attention from managers is lack of materials for packaging sputum. Fear of positive result was one of the reasons for the refusal of sputum collection, followed by alcoholism. With regard to TB suspects, all responded that ACS always suspect when the user has TB coughs, but in all districts were noticed at low delivery of requests for applications for smear. BSR in TB control, is characterized in practice as a complex action goes beyond technical expertise and contact with the family that breaks with the Cartesian. The BSR is part of the ACS can perform them from the daily visits. We conclude that the ACS is difficult to achieve. This practice should not be the privilege of this actor, but the entire team of primary care. We must rethink the practices of TB care, seeing the health surveillance while aegis of the working process of primary care teams for early diagnosis and thereby reduce TB in communities

Extração de metais (K, Mg, Ba, Ca, Cr, Mn, Li, Fe) de água produzida utilizando sistema microemulsionado

The produced water is a byproduct formed due to production of petroleum and carries with it a high amount of contaminants such as oil particles in suspension, organic compounds and metals. Thus, these latter pollutants are very difficult to treat because of its high solubility in water. The objective of this work is to use and evaluate a microemulsioned system to remove metals ( K , Mg , Ba , Ca , Cr , Mn , Li , Fe ) of synthetic produced water. For the extraction of metals, it was used a pseudoternary diagram containing the following phases: synthetic produced water as the aqueous phase (AP), hexane as organic phase (OP), and a cosurfactant/surfactant ratio equal to four (C/S = 4) as the third phase, where the OCS (saponified coconut oil) was used as surfactant and n-butanol as cosurfactant. The synthetic produced water was prepared in a bench scale and the region of interest in the diagram for the removal of metals was determined by experimental design called. Ten points located in the phase Winsor II were selected in an area with a large amount of water and small amounts of reagents. The samples were analyzed in atomic absorption spectrometer, and the results were evaluated through a statistical assesment, allowing the efficiency analysis of the effects and their interactions. The results showed percentages of extraction above 90% for the metals manganese, iron, chromium, calcium, barium and magnesium, and around 45% for metals lithium and potassium. The optimal point for the simultaneous removal of metals was calculated using statistical artifact multiple response function (MR). This calculation showed that the point of greatest extraction of metals occurs was the J point, with the composition [72% AP, 9% OP, 19% C/S], obtaining a global extraction percentage about 80%. Considering the aspects analyzed, the microemulsioned system has shown itself to be an effective alternative in the extraction of metals on synthetic produced water remediation