Simulating autonomous robot teams with Microsoft robotics studio

This paper presents an application of Microsoft Robotics Studio (MSRS) in which a team of six four wheel drive, ground based robots explore and map simulated terrain. The user has the ability to modify the terrain and assign destination objectives to the team while the simulation is running. The terrain is initially generated using a gray scale image, in which the intensity of each pixel in the image gives an altitude datum. The robots start with no knowledge of their surroundings, and map the terrain as they attempt to reach user-defined target objectives. The mapping process simulates the use of common sensory hardware to determine datum points, including provision for field of view, detection range, and measurement accuracy. If traversal of a mapped area is indicated by the users’ targeting commands, path planning heuristics developed for MSRS by the author in earlier work are used to determine an efficient series of waypoints to reach the objective. Mutability of terrain is also explored- the user is able to modify the terrain without stopping the simulation. This forces the robots to adapt to changing environmental conditions, and permits analysis of the robustness of mapping algorithms used when faced with a changing world.

Communications for underwater robotics research platforms

This paper presents a distributed protocol for communication among autonomous underwater vehicles. It is a complementary approach for coordination between the autonomous underwater vehicles. This paper mainly describes different methods for underwater communication. One of the methods is brute force approach in which messages are broadcasted to all the communication nodes, which in turn will broadcast the acknowledgement. Issues relating to this brute force approach are time delay, number of hops, power consumption, message collision and other practical issues. These issues are discussed and solved by proposing a new method to improve efficiency of this proposed approach and its effectiveness in communication among autonomous underwater vehicles.

Applications and prototype for systems of systems swarm robotics

In order to develop a robotic system of systems the robotic platforms must be designed and built. For this to happen, the type of application involved should be clear. Swarm robots need to be self contained and powered. They must also be self governing. Here the authors examine various applications and a prototype robot that may be useful in these scenarios.

Design of a prototype underwater research platform for swarm robotics

To perform under water robotic research requires specialized equipment. A few pieces of electronics atop a set of wheels are not going to cut it. An underwater research platform must be waterproof, reliable, robust, recoverable and easy to maintain. It must also be able to move in 3 dimensions. Also it must be able to navigate and avoid obstacles. Further if this platform is to be part of a swarm of like platforms then it must be cost effective and relatively small. To purchase such a platform can be very expensive. However, for shallow water, a suitable platform can be built from mostly off the shelf items at little cost. This article describes the design of one such underwater robot including various sensors and communications systems that allow for swarm robotics. Whilst the robotic platform performs well, to explore what many of them would do, that is more than are available, simulation is required. This article continues to study how best to simulate these robots for a swarm, or system of systems, approach.

A hybrid approach for fault tolerance in robotics

This paper studies the difference between the human behaviours for fault tolerance with a pseudo inverse reconfiguration approach for fault tolerance of robotic arms. If this difference is well understood then it can be used to introduce a hybrid approach for fault tolerant motion of robotic arms. The proposed approach is expected to combine human fault-tolerance dexterity and advantages of a model based fault tolerance. The main aim is to add human dexterity for fault tolerance of robotic arms.

Robotics to enable older adults to remain living at home

Given the rapidly ageing population, interest is growing in robots to enable older people to remain living at home. We conducted a systematic review and critical evaluation of the scientific literature, from 1990 to the present, on the use of robots in aged care. The key research questions were as follows: (1) what is the range of robotic devices available to enable older people to remain mobile, independent, and safe? and, (2) what is the evidence demonstrating that robotic devices are effective in enabling independent living in community dwelling older people? Following database searches for relevant literature an initial yield of 161 articles was obtained. Titles and abstracts of articles were then reviewed by 2 independent people to determine suitability for inclusion. Forty-two articles met the criteria for question 1. Of these, 4 articles met the criteria for question 2. Results showed that robotics is currently available to assist older healthy people and people with disabilities to remain independent and to monitor their safety and social connectedness. Most studies were conducted in laboratories and hospital clinics. Currently limited evidence demonstrates that robots can be used to enable people to remain living at home, although this is an emerging smart technology that is rapidly evolving.

Underwater swarm robotics consensus control

The control of a swarm of underwater robots requires more than just a control algorithm, it requires a communications system. Underwater communications is difficult at the best of times and so large time delays and minimal information is a concern. The control system must be able to work on minimal and out of date information. The control system must also be able to control a large number of robots without a master control, a decentralized control approach. This paper describes one such control method.

Learning skills : robotics technology in automotive powertrain assembly

The past 40 years have seen industrial robots establish their superiority over humans in most areas of manufacturing requiring endurance or repeatability. One important application domain, however, has so far lagged behind the industry’s expectations: mechanical assembly. As fast, precise and dependable as they are, traditional industrial robots just don’t seem able to perform certain assembly operations as well as a skilled human worker. A task as simple as screwing a light bulb into a lamp socket shows why. Applying the right amount of force and turning the bulb at just the right time, at exactly the right angle, is something a human does intuitively. How can a robot be programmed to do this? For robots to successfully emulate humans on an assembly line, they need to have force-sensing capability and exhibit compliance. They must be able to direct forces and moments in a controlled way, and react to contact information. New robot force control technology from ABB shows how.

Underwater swarm robotics review

Underwater robotics is a growing field in which more research is required. A literature review has been conducted on underwater robotics, focusing on the swarm problem with this type of robotics to help overcome this gap. Consensus control of robotic swarms is focused on, with a brief description of formation control and how it can be applied in the underwater setting. The basic concepts behind Particle Swarm Optimization, Ant Colony Optimization, Bees Algorithm and Heterogeneous Swarms has also been presented. The problems that are associated with communicating underwater are shown, with some possible solutions to this problem also being presented. Possible future work is described to conclude the paper.

Underwater swarm robotics : challenges and opportunities

Underwater swarm robotics today faces a series of challenges unique to its aquatic environment. This chapter explores some possible applications of underwater swarm robotics and its challenges. Those challenges include the environment itself, sensor types required, problems with communication and the difficulty in localisation. it notes the serious challenges in underwater communication is that radio communications is practically non-existent in the underwater realm. Localisation also becomes problematic due to the lack of radio waves as GPS cannot be used. it also looks at the platforms required by underwater robots and includes a possible low-cost platform. Also explored is a method of swarm robotics control known as consensus control. It shows possible solutions to the challenges and where swarm robotics may head.