Distributed generation capacity planning for distribution networks to minimize energy loss: an unbalanced multi-phase optimal power flow based approach

This chapter presents an unbalanced multi-phase optimal power flow (UMOPF) based planning approach to determine the optimum capacities of multiple distributed generation units in a distribution network. An adaptive weight particle swarm optimization algorithm is used to find the global optimum solution. To increase the efficiency of the proposed scheme, a co-simulation platform is developed. Since the proposed method is mainly based on the cost optimization, variations in loads and uncertainties within DG units are also taken into account to perform the analysis. An IEEE 123 node distribution system is used as a test distribution network which is unbalanced and multi-phase in nature, for the validation of the proposed scheme. The superiority of the proposed method is investigated through the comparisons of the results obtained that of a Genetic Algorithm based OPF method. This analysis also shows that the DG capacity planning considering annual load and generation uncertainties outperform the traditional well practised peak-load planning.

Nonlinear adaptive backstepping controller design for controlling bidirectional power flow of BESSs in DC microgrids

In this paper, a nonlinear adaptive backstepping controlleris designed to control the bidirectional power flow (charging/discharging) of battery energy storage systems (BESSs) in a DCmicrogrid under different operating conditions. The controller isdesigned in such a manner that the BESSs can store the excess energyfrom the renewable energy sources (RESs) in a DC microgrid aftersatisfying the load demand and also feeding back the stored energyto the load when RESs are not sufficient. The proposed controller isalso designed to maintain a constant voltage at the DC bus, whereall components of DC microgrids are connected, while controllingthe power flow of BESSs. This paper considers solar photovoltaic(PV) systems as the RES whereas a diesel generator equipped witha rectifier is used as a backup supply to maintain the continuity ofpower supply in the case of emergency situations. The controller isdesigned recursively based on the Lyapunov control theory whereall parameters within the model of BESSs are assumed to beunknown. These unknown parameters are then estimated throughthe adaptation laws and whose stability is ensured by formulatingsuitable control Lyapunov functions (CLFs) at different stages ofthe design process. Moreover, a scheme is also presented to monitorthe state of charge (SOC) of the BESS. Finally, the performanceof the proposed controller is verified on a test DC microgrid undervarious operating conditions. The proposed controller ensures the DCbus voltage regulation within the acceptable limits under differentoperating conditions.

Nonlinear backstepping controller design for sharing active and reactive power in three-phase grid-connected photovoltaic systems

In this paper, a nonlinear backstepping controller is designed for three-phase grid-connected solar photovoltaic (PV) systems to share active and reactive power. A cascaded control structure is considered for the purpose of sharing appropriate amount of power. In this cascaded control structure, the dc-link voltage controller is designed for balancing the power flow within the system and the current controller is designed to shape the grid current into a pure sinusoidal waveform. In order to balance the power flow, it is always essential to maintain a constant voltage across the dc-link capacitor for which an incremental conductance (IC) method is used in this paper. This approach also ensures the operation of solar PV arrays at the maximum power point (MPP) under rapidly changing atmospheric conditions. The proposed current controller is designed to guarantee the current injection into the grid in such a way that the system operates at a power factor other than unity which is essential for sharing active and reactive power. The performance of the proposed backstepping approach is verified on a three-phase grid-connected PV system under different atmospheric conditions. Simulation results show the effectiveness of the proposed control scheme in terms of achieving desired control objectives.

Influences of wind energy integration into the distribution network

Wind energy is one of the most promising renewable energy sources due to its availability and climate-friendly attributes. Large-scale integration of wind energy sources creates potential technical challenges due to the intermittent nature that needs to be investigated and mitigated as part of developing a sustainable power system for the future. Therefore, this study developed simulation models to investigate the potential challenges, in particular voltage fluctuations, zone substation, and distribution transformer loading, power flow characteristics, and harmonic emissions with the integration of wind energy into both the high voltage (HV) and low voltage (LV) distribution network (DN). From model analysis, it has been clearly indicated that influences of these problems increase with the increased integration of wind energy into both the high voltage and low voltage distribution network, however, the level of adverse impacts is higher in the LV DN compared to the HV DN.

A comparative study of guided wave propagation in timber poles with isotropic and transversely isotropic material models

Guided wave (GW) has been used for many years in non-destructive testing (NDT). There are various ways to generate the guided wave, including impact or impulse either manually or using devices. Although the method of impact or impulse is considered to be simple and practical in guided wave generation, it produces waves with broadband frequencies, which often make analysis much more difficult. The frequency bandwidth produced by manual impacts is usually at the low end, and is therefore justified when dealing with one dimensional wave propagation assumption in low strain integrity testing of cylindrical structures. Under such assumption if the velocity is known accurately, NDTs can produce reasonably good results for the condition assessment of the structure. However, for guided wave propagation in timber pole-like structures, it is rather complicated as timber is an orthotropic material and wave propagation in an orthotropic medium exhibits different characteristics from that in isotropic medium. It is possible to obtain solutions for guided wave propagation in orthotropic media for cylindrical structures, even though the orthotropic material greatly complicates GW propagation. In this paper, timber has been considered as a transversely isotropic (i.e. simplified orthotropic) material and a comparative study of GW propagation in a timber pole is conducted considering isotropic and transversely isotropic modelling. Phase velocity, group velocity and attenuation are the main parameters for this comparative study. Moreover, tractionfree situation and embedded geotechnical condition are also taken into consideration to evaluate the effect of boundary. Displacement profile, wave propagation pattern and power flow at particular frequency are utilized to determine different displacement components of longitudinal and flexural waves along and across the timber pole. Effect of temperature and moisture content (in terms of modulus of elasticity) in timber pole is also compared to show the variation in phase velocity.

Effects of baffles on flow distribution in an electrostatic precipitator (ESP) of a coal based power plant

Electrostatic Precipitators (ESP) are the most reliable and industrially used control devices to capture fine particles for reducing exhaust emission. Its efficiency is 99% or more. However, capturing submicron particles which are hazardous is still a problem as it involves complex flow phenomena and ESP design limitations. In this study, the effect of baffles on flow distribution inside the ESP is investigated computationally. Baffles are expected to increase the residence time of flue gas which helps to collect more particles into the collector plates, and hence increase the collection efficiency of an ESP. Besides, the placement of a baffle is likely to cause swirling of flue gas and hence sub-micron particles move towards the collector plate due to eccentric and electrostatic force. Therefore, the effects of position, shape and thickness of the baffles on collection efficiency which are also important for ESP design are reported in this study. The fluid flow distribution has been modelled using computational fluid dynamics (CFD) software Fluent and the result and outcome are presented and discussed. The result shows that baffles have significant influence on fluid flow pattern and the efficiency of ESP.

Influence of deformation conditions and texture on the high temperature flow stress of magnesium AZ31

The evolution of hot working flow stress with strain is examined in torsion, uniaxial compression and channel die compression. The flow stress was found to be strongly dependent on texture and deformation mode. At low strains this dependency accounted for a difference in flow stress of up to a factor of two. At higher strains the influence of texture and deformation mode was less marked. The stresses corresponding to an equivalent strain of 0.5 were modelled using a power law expression with an activation energy of 147 kJ/mol and a strain rate exponent of 0.15. The influence of texture and deformation mode on flow stress is rationalised in terms of the influence of prismatic slip, twinning and dynamic recrystallisation on deformation stress and structure.

Hierarchial patterns of invertebrate assemblage structure in stony upland streams change with time and flow permanence

1. Studies in several parts of the world have examined variation in univariate descriptors of macroinvertebrate assemblage structure in perennially flowing stony streams across hierarchies of spatial scale using nested analyses of variance. However, few have investigated whether this spatial variation changes with time or whether these results are representative of habitats other than riffles or of other stream types, such as intermittently flowing streams.

2. We describe patterns in taxon richness and abundance from two sets of samples from stony streams in the Otway Range and the Grampians Range, Victoria, Australia, collected using hierarchical designs. Sampling of riffles was repeated in the Otways, to determine whether spatial patterns were consistent among times. In the Grampians, spatial patterns were compared between intermittent and perennially flowing streams (stream type) by sampling pools.

3. In the Otways streams, most variation in the dependent variables occurred between sample units. Patterns of variation among the other scales (streams, segments, riffles, groups of stones) were not consistent between sampling times, suggesting that they may have little ecological significance.

4. In the Grampians streams, variation in macroinvertebrate taxon richness and abundance differed significantly between replicate streams within each stream type but not between stream types or pools. The largest source of variation in taxon richness was stream type. Little variation occurred among sample units.

5. The pattern of most variation occurring among sample units is robust both to differences in the method of sampling and different dependent variables among studies and increasingly appears to be a property of riffles in stony, perennial upland streams. High variation among sample units (residual variation) limits the explanatory power of linear models and therefore, where samples are from a single sampling time, small but significant components of variation are unlikely to represent features of assemblage structure that will be stable over time.

A semianalytical Sachs model for the flow stress of a magnesium alloy

A semianalytical Sachs-type equation for the flow stress of magnesium-base alloys is developed using the Schmid law, power law hardening, and a sigmoidal increase in the twinning volume fraction with strain. Average Schmid factors were estimated from electron backscattered diffraction (EBSD) data. With these, the equation provides a reasonable description of the flow curves obtained in compression and tension for samples of Mg-3Al-1Zn cut in different orientations from rolled plate. The model illustrates the general importance of basal slip and twinning in magnesium alloys. The significance of prismatic slip in room temperature tension testing is also highlighted. This is supported with EBSD slip line trace analysis and rationalized in terms of a possible sensitivity of the critical resolved shear stress for prismatic (cross) slip to the stress on the basal plane.

Power ultrasound offers an environmentally friendly approach to cleaning dairy UF membranes

Flat sheet polymeric UF membranes of 30000 MWCO were obtained from Millipore Inc. Polypropylene spacers of a 50 mil (1.3 mm) thickness were obtained from KOCH membrane systems. A single 30 cm^sup 2^ membrane sheet was sandwiched with a spacer on the feed side of a cross flow Minitan S unit (Millipore Inc). The unit was immersed in a 50 kHz ultrasonic bath that was switched on as required. All experiments used re-constituted spray-dried whey powder to foul the membrane.

Moderate-intensity resistance exercise training in patients with chronic heart failure improves strength, endurance, heart rate variability, and forearm blood flow

Thirty-nine CHF patients (New York Heart Association Functional Class = 2.3±0.5; left ventricular ejection fraction 28%±7%; age 65±11 years; 33:6 male:female) underwent 2 identical series of tests, 1 week apart, for strength and endurance of the knee and elbow extensors and flexors, VO_2peak, HRV, FBF at rest, and FBF activated by forearm exercise or limb ischemia. Patients were then randomized to 3 months of resistance training (EX, n = 19), consisting of mainly isokinetic (hydraulic) ergometry, interspersed with rest intervals, or continuance with usual care (CON, n = 20), after which they underwent repeat endpoint testing. Combining all 4 movement patterns, strength increased for EX by 21±30% (mean±SD, P<.01) after training, whereas endurance improved 21±21% (P<.01). Corresponding data for CON remained almost unchanged (strength P<.005, endurance P<.003 EX versus CON). VO_2peak improved in EX by 11±15% (P<.01), whereas it decreased by 10±18% (P<.05) in CON (P<.001 EX versus CON). The ratio of low-frequency to high-frequency spectral power fell after resistance training in EX by 44±53% (P<.01), but was unchanged in CON (P<.05 EX versus CON). FBF increased at rest by 20±32% (P<.01), and when stimulated by submaximal exercise (24±32%, P<.01) or limb ischemia (26±45%, P<.01) in EX, but not in CON (P<.01 EX versus CON).

Fine-scale effects of habitat loss and fragmentation despite large-scale gene flow for some regionally declining woodland bird species

Habitat loss and associated fragmentation effects are well-recognised threats to biodiversity. Loss of functional connectivity (mobility, gene flow and demographic continuity) could result in population decline in altered habitat, because smaller, isolated populations are more vulnerable to extinction. We tested whether substantial habitat reduction plus fragmentation is associated with reduced gene flow in three 'decliner' woodland-dependent bird species (eastern yellow robin, weebill and spotted pardalote) identified in earlier work to have declined disproportionately in heavily fragmented landscapes in the Box-Ironbark forest region in north-central Victoria, Australia. For these three decliners, and one 'tolerant' species (striated pardalote), we compared patterns of genetic diversity, relatedness, effective population size, sex-ratios and genic (allele frequency) differentiation among landscapes of different total tree cover, identified population subdivision at the regional scale, and explored fine-scale genotypic (individual-based genetic signature) structure. Unexpectedly high genetic connectivity across the study region was detected for 'decliner' and 'tolerant' species. Power analysis simulations suggest that moderate reductions in gene flow should have been detectable. However, there was evidence of local negative effects of reduced habitat extent and structural connectivity: slightly lower effective population sizes, lower genetic diversity, higher within-site relatedness and altered sex-ratios (for weebill and eastern yellow robin) in 10 x 10 km 'landscapes' with low vegetation cover. We conclude that reduced structural connectivity in the Box-Ironbark ecosystem may still allow sufficient gene flow to avoid the harmful effects of inbreeding in our study species. Although there may still be negative consequences of fragmentation for demographic connectivity, the high genetic connectivity of mobile bird species in this system suggests that reconnecting isolated habitat patches may be less important than increasing habitat extent and/or quality if these need to be traded off.