Performance and gaseous and particle emissions from a liquefied petroleum gas (LPG) fumigated compression ignition engine

In this study, an LPG fumigation system was fitted to a Euro III compression ignition (CI) engine to explore its impact on performance, and gaseous and particulate emissions. LPG was introduced to the intake air stream (as a secondary fuel) by using a low pressure fuel injector situated upstream of the turbocharger. LPG substitutions were test mode dependent, but varied in the range of 14-29% by energy. The engine was tested over a 5 point test cycle using ultra low sulphur diesel (ULSD), and a low and high LPG substitution at each test mode. The results show that LPG fumigation coerces the combustion into pre-mixed mode, as increases in the peak combustion pressure (and the rate of pressure rise) were observed in most tests. The emissions results show decreases in nitric oxide (NO) and particulate matter (PM2.5) emissions; however, very significant increases in carbon monoxide (CO) and hydrocarbon (HC) emissions were observed. A more detailed investigation of the particulate emissions showed that the number of particles emitted was reduced with LPG fumigation at all test settings – apart from mode 6 of the ECE R49 test cycle. Furthermore, the particles emitted generally had a slightly larger median diameter with LPG fumigation, and had a smaller semi-volatile fraction relative to ULSD. Overall, the results show that with some modifications, LPG fumigation systems could be used to extend ULSD supplies without adversely impacting on engine performance and emissions.

A study on energy and environmental management techniques used in petroleum process industries

Petroleum process industries are one of the most energy and emission intensive sectors throughout the world.There are natural gas processing plant, crude oils and condensate fractionation plant, liquefied natural gas plantand liquefied petroleum gas plant etc. creates environmental pollution by processing and handling of petroleumproducts. The study critically reviewed and discussed the energy and environmental management includingpollution control of petroleum process industries of Bangladesh. They produce both gaseous (process gas, wastegas etc.) and liquid (produced water, waste oil and grease etc.) pollutants. The study found that the liquid pollutantlike waste water is more hazardous and its treatment process is highly complicated due to its higher salinity, morecorrosivity and grease contain characteristics. As part of energy management, the rational use of energy and energyflow diagram of the petroleum industry is presented. Finally, a time frame measures which can be implemented inorder to save energy is outlined. The study concluded that the rational use of energy and proper environmentalmanagement are essential for achieving energy and environmental sustainability of process industries.

Evaluation of a heat pump system for greenhouse heating

Greenhouse heating costs for some commercial growers in southern Australia are now a significant production cost. This is particularly the case for those operators who installed heating systems using liquefied petroleum gas (LPG) when this fuel was relatively inexpensive. Heat pump systems used in various configurations have been suggested as an option for reducing energy use and costs for greenhouse heating, particularly if off-peak electricity is used. This paper investigates the financial and environmental viability of an air-to-water heat pump system for a 4000 m2 greenhouse, located 120 km north of Melbourne, Victoria. The simulation software, TRNSYS, was used to predict the performance of the system. The heat pump system was found to have a simple payback period of approximately six years and reduce LPG consumption by 16%. Greenhouse gas emissions were 3% higher using the heat pump system, compared to the existing LPG boiler.