Spin-crossover, mesomorphic and thermoelectrical properties of cobalt(II) complexes with alkylated N3-Schiff bases

Three new cobalt(ii) complexes, [Co(L12)2](BF4)2 (1), [Co(L14)2](BF4)2·H2O (2) and [Co(L16)2](BF4)2·H2O (3), where L12-16 are N3-Schiff bases appended with linear C12-16 carbon chains at the nitrogen atoms, were obtained in good yields by facile one-pot reactions. The single crystal X-ray structure of complex 1 shows a tetragonally compressed CoN6 coordination geometry. The melting temperatures of 1-3 were lower than 373 K, while their decomposition temperatures were above 473 K. All complexes have high-spin Co(ii) centres at 300 K and exhibit a columnar mesophase above 383 K. Complexes 1 and 3 showed normal thermal spin-crossover behaviour with weak hysteresis loops at about 320 K. Hence, these complexes showed uncoupled phase transitions (class iiia). The values for the Seebeck coefficient (Se) of the cobalt redox couples formed from 1 and 2 were 1.89 ± 0.02 mV K-1 and 1.92 ± 0.08 mV K-1, respectively, identifying them as potential thermoelectrochemical materials.

Internet-based treatment for panic disorder : does frequency of therapist contact make a difference?

Internet-based interventions with therapist support have proven effective for treating a range of mental health conditions. This study examined whether frequency of therapist contact affected treatment outcomes. Fifty-seven people with panic disorder (including 32 with agoraphobia) were randomly allocated to an 8-week Internet-based cognitive behavioural treatment intervention (Panic Online) with either frequent (three e-mails per week) or infrequent (one e-mail per week) support from a psychologist. Posttreatment, intention-to-treat analyses revealed that both treatments were effective at improving panic disorder and agoraphobia severity ratings, panicrelated cognitions, negative affect, and psychological and physical quality of life domains, with no differences between conditions. High end-state functioning was achieved by 28.6% of the frequent and infrequent participants, respectively. Therapist alliance, treatment credibility, and satisfaction also did not differ between groups, despite significantly greater therapist time invested in the frequent contact condition. The results provide evidence that the effectiveness of Internet-based mental health interventions may be independent of the frequency of therapist support and may, therefore, be more cost-effective than previously reported.

Arg1098 is critical for the chloride dependence of human angiotensin I-converting enzyme C-domain catalytic activity

Angiotensin (Ang) I-converting enzyme (ACE) is a Zn²+ metalloprotease with two homologous catalytic domains. Both the N- and C-terminal domains are peptidyl dipeptidases. Hydrolysis by ACE of its decapeptide substrate Ang I is increased by Cl−, but the molecular mechanism of this regulation is unclear. A search for single substitutions to Gln among all conserved basic residues (Lys/Arg) in human ACE C-domain identified R1098Q as the sole mutant that lacked Cl− dependence. Cl−dependence is also lost when the equivalent Arg in the N-domain, Arg⁵⁰⁰, is substituted with Gln. The Arg¹⁰⁹⁸ to Lys substitution reduced Cl− binding affinity by ∼100-fold. In the absence of Cl−, substrate binding affinity (1/K m) of and catalytic efficiency (k cat/K m) for Ang I hydrolysis are increased 6.9- and 32-fold, respectively, by the Arg¹⁰⁹⁸ to Gln substitution, and are similar (<2-fold difference) to the respective wild-type C-domain catalytic constants in the presence of optimal [Cl−]. The Arg¹⁰⁹⁸ to Gln substitution also eliminates Cl− dependence for hydrolysis of tetrapeptide substrates, but activity toward these substrates is similar to that of the wild-type C-domain in the absence of Cl−. These findings indicate that: 1) Arg¹⁰⁹⁸ is a critical residue of the C-domain Cl−-binding site and 2) a basic side chain is necessary for Cl− dependence. For tetrapeptide substrates, the inability of R1098Q to recreate the high affinity state generated by the Cl−-C-domain interaction suggests that substrate interactions with the enzyme-bound Cl− are much more important for the hydrolysis of short substrates than for Ang I. Since Cl− concentrations are saturating under physiological conditions and Arg¹⁰⁹⁸ is not critical for Ang I hydrolysis, we speculate that the evolutionary pressure for the maintenance of the Cl−-binding site is its ability to allow cleavage of short cognate peptide substrates at high catalytic efficiencies.

High mobility I− / I3− redox couple in a molecular plastic crystal: A potential new generation of electrolyte for solid-state photoelectrochemical cells

A series of new electrolyte materials based on a molecular plastic crystal doped by different iodide salts together with iodine have been prepared and characterized by thermal analysis, ionic conductivity, electrochemical and solid-state NMR diffusion measurements. In these materials, the plastic crystal phase of succinonitrile acts as a good matrix for the quaternary ammonium based iodides and iodine and appears to act in some cases as a solid-state “solvent” for the binary dopants. The materials were prepared by mixing the components in the molten state with subsequent cooling into the plastic crystalline state. This resulted in waxy-solid electrolytes in the temperature range from − 40 to 60 °C. The combination of structural variation of the cations, and fast redox couple diffusion (comparable with liquid-based electrolytes), as well as a high ionic conductivity of up to 3 × 10^{− 3} S cm^{− 1} at ambient temperature, make these materials very attractive for potential use in solid-state photoelectrochemical cells.

Organic ionic plastic crystal electrolytes; a new class of electrolyte for high efficiency solid state dye-sensitized solar cells

Dye-sensitized solar cells are an increasingly promising alternative to conventional silicon solar cells as a method of converting solar energy to electricity and thus providing an effectively inexhaustible energy source. However, the most efficient of these devices currently utilize liquid electrolytes, which suffer from the associated problems of leakage and evaporation. Hence, significant research is currently focused on the development of solid state alternatives. Here we report a new class of solid state electrolyte for these devices, organic ionic plastic crystal electrolytes, that allow relatively rapid diffusion of the redox couple through the matrix, which is critical to the cell performance. A range of different organic ionic plastic crystal materials, utilizing different cation and anion structures, have been investigated and the conductivities, diffusion rates and photovoltaic performance of the electrolytes are reported. The best material, utilizing the dicyanamide anion, achieves efficiencies of more than 5%.

High-temperature laser-scanning confocal microscopy as a tool to study the interface instability during unsteady-state solidification of low-carbon steel

Solidification microstructure is a defining link between production techniques and the mechanical properties of metals and in particular steel. Due to the difficulty of conducting solidification studies at high temperature, knowledge of the development of solidification microstructure in steel is scarce. In this study, a laser-scanning confocal microscopy (LSCM) has been used to observe in situ and in real-time the planar to cellular to dendritic transition of the progressing solid/liquid interface in low carbon steel. Because the in situ observations in the laser-scanning confocal microscopy are restricted to the surface, the effect of sample thickness on surface observations was determined. Moreover, the effect of cooling rate and alloy composition on the planar to cellular interface transition was investigated. In the low-alloyed, low-carbon steel studied, the cooling rate does not seem to have an effect on the spacing of the cellular microstructure. However, in the presence of copper and manganese, the cell spacing decreased at higher cooling rates. Higher concentrations of copper in steel resulted on an increased cell spacing at the same cooling rates.

Solid-state NMR as a probe of anion binding: molecular dynamics and associations in a [5]polynorbornane bisurea host complexed with terephthalate

A range of solid-state NMR techniques is used to characterise a molecular host:guest complex consisting of a [5]polynorbornane bisurea host binding a terephthalate dianion guest. Detailed information is obtained on the molecular dynamics and associations from the point of view of both the host and guest molecules. The formation of the complex in the solid state is confirmed using (1)H 2D exchange NMR, and the 180° flipping of the (2)H-labelled terephthalate guest and its eventual expulsion from the complex at elevated temperatures are quantified using variable-temperature (2)H spin-echo experiments. Two-dimensional (1)H-(13)C HETCOR spectra obtained under fast magic angle spinning conditions (60 kHz) show a high resolution despite the poor crystallinity of the solid complex, and clearly reveal changes in the rigidity of the host molecule when complexed. Short-range intra- and intermolecular (1)H-(1)H proximities are also detected using 2D SQ-DQ correlation methods, providing insight into the molecular packing in the solid phase.

High-performance flexible all-solid-state supercapacitor from large free-standing graphene-PEDOT/PSS films

Although great attention has been paid to wearable electronic devices in recent years, flexible lightweight batteries or supercapacitors with high performance are still not readily available due to the limitations of the flexible electrode inventory. In this work, highly flexible, bendable and conductive rGO-PEDOT/PSS films were prepared using a simple bar-coating method. The assembled device using rGO-PEDOT/PSS electrode could be bent and rolled up without any decrease in electrochemical performance. A relatively high areal capacitance of 448 mF cm(-2) was achieved at a scan rate of 10 mV s(-1) using the composite electrode with a high mass loading (8.49 mg cm(-2)), indicating the potential to be used in practical applications. To demonstrate this applicability, a roll-up supercapacitor device was constructed, which illustrated the operation of a green LED light for 20 seconds when fully charged.