Amino-functionalized mesoporous silica based polyethersulfone-polyvinylpyrrolidone composite membranes for elevated temperature proton exchange membrane fuel cells

It is important to find alternative membranes to the state-of-the-art polybenzimidazole based high temperature proton exchange membranes with high proton conductivity at elevated temperature but with simple synthesis procedures. In this work, inorganic-organic nanostructured hybrid membranes are developed based on a polyethersulfone-polyvinylpyrrolidone (PES-PVP) polymeric matrix with hollow mesoporous silica (HMS), amino-functionalized hollow mesoporous silica (NH2-HMS) and amino-functionalized mesoporous silica (NH2-meso-silica). The composite membranes show a significant increase in proton conductivity and a decrease in the activation energy for proton diffusion in comparison with the phosphoric acid (H3PO4, PA) doped PES-PVP membrane. And the composite membrane with NH2-HMS shows the best performance under the conditions in this study, achieving the highest proton conductivity of 1.52 × 10-1 S cm-1 and highest peak power density of 480 mW cm-2 at 180 °C under anhydrous conditions, which is 92.7% higher than that of the PA doped PES-PVP membrane at identical conditions. Such enhancement results from the facilitated proton transportation in the ordered mesoporous channels via the hydrogen bond between the -NH2 groups and H3PO4. The high water retention capability of silica materials with a hollow structure also contributes to the decrease of the activation of proton diffusion. Consequently, the results show promising potential of the NH2-HMS based PES-PVP composite membrane for the elevated temperature proton exchange membrane fuel cells.

Photochromic wool fabrics from a hybrid silica coating

In this work, a photochromic wool fabric has been prepared by applying a photochromic-dye hybrid silica sol-gel onto the surface of fabric. The photochromic fabric was found to have a very quick optical response. Two types of silica were used as the matrix material, and the type of silica had a small effect only on the photochromic performance, the fabric washing fastness, and water contact angle, but affected the fabric handle property considerably. The silica from a precursor containing a long alkyl chain showed very little influence on the fabric handle and better photochromic performance than that containing a phenyl group.

Fast response photochromic textiles from hybrid silica surface coating

In this study, a hybrid silica sol-gel embedded with a photochromic dye has been applied to wool fabric to form a photochromic coating. The treated wool fabrics showed very quick photochromic response. Five different silanes have been used as the silica precursor, and the resultant coating showed slight differences in photochromic performance, fabric washing fastness, and surface hydrophilicity. However, the silica type had a considerable influence on fabric handle property. The silica matrix from the silane containing a long alkyl chain had a very little influence on the fabric handle and better photochromic performance than those from other different silane precursors.

Photochromic textiles from hybrid silica coating with improved photostability

Photochromic surface coating on textiles may create new fashion opportunities. It also enhances the ultraviolet (UV) protection ability of the coated products. In this study, a spirooxazine dye and a silane that bears a long alkyl chain have been used to produce hybrid photochromic silica coatings on wool fabrics. Four stabilisers are added separately to the photochromic silica coatings to examine their influence on photostability and photochromic behaviour. It is found that the addition of UV stabilisers slightly reduces the photochromic response speed and photochromic absorption. However, the addition of UV stabilisers to the photochromic coating considerably improves the photochromic lifetime. Among the four UV stabilisers studied, the quencher results in the best improvement to photostability with the lowest reduction in photochromic absorption.

Superhydrophobic fabrics from hybrid silica sol-gel coatings: Structural effect of precursors on wettability and washing durability

Particle-containing silica sol was synthesized by co-hydrolysis and co-condensation of two silane precursors, tetraethylorthosilicate (TEOS) and an organic silane composed of a non-hydrolyzable functional group (e.g., alkyl, flourinated alkyl, and phenyl), and used to produce superhydrophobic coatings on fabrics. it has been revealed that the non-hydrolyzable functional groups in the organic silanes have a considerable influence on the fabric surface wettability. When the functional group was long chain alkyl (C16), phenyl, or flourinated alkyl (C8), the treated surfaces were highly superhydrophobic with a water contact angle (CA) greater than 170°, and the CA value was little affected by the fabric type. The washing durability of the superhydrophobic coating was improved by introducing the third silane containg epoxide group, 3-glycidoxypropyltrimethoxsilane (GPTMS), for synthesis. Although the presence of epoxide groups in the coating slightly reduced the fabrics' superhydrophobicity, the washing durability was considerably improved when polyester and cotton fabrics were used as substrates.

Photochromic fabrics from hybrid silica surface coatings

In this study, hybrid silica prepared by a sol-gel technique and doped with a photochromic dye was used to produce photochromic coatings on fabric surfaces. The coated fabrics showed a strong photochromic effect with very fast optical response speed. Good coating adhesion was obtained on wool fabrics. The photostability of the photochromic fabrics was improved by three different processes: adding a photo stabilizer, adjusting the surface wettability and sealing off the dye-containing pores with additional silica coating. Four UV stabilizers were added separately to the photochromic silica coatings to investigate their influence on the photostability and photochromic behaviour. The addition of UV stabilizers retarded the photochromic response and reduced photochromic absorption, but increased photochromic lifetime. Among the four UV stabilizers studied, the quencher resulted in the best improvement to the photostability with minimal reduction in the photochromic absorption. Increasing the hydrophobicity of the coating, and sealing-off the dye-containing pores were also found to improve photostability.

Functionalized mesoporous silica nanoparticles with redox-responsive short-chain gatekeepers for agrochemical delivery.

The controlled release of salicylic acid (SA), a key phytohormone, was mediated by using a novel decanethiol gatekeeper system grafted onto mesoporous silica nanoparticles (MSNs). The decanethiol was conjugated only to the external surfaces of the MSNs through glutathione (GSH)-cleavable disulfide linkages and the introduction of a process to assemble gatekeepers only on the outer surface so that the mesopore area can be maintained for high cargo loading. Raman and nitrogen sorption isotherm analyses confirmed the successful linkage of decanethiol to the surface of MSNs. The in vitro release of SA from decanethiol gated MSNs indicated that the release rate of SA in an environment with a certain amount of GSH was significantly higher than that without GSH. More importantly, in planta experiments showed the release of SA from decanethiol gated MSNs by GSH induced sustained expression of the plant defense gene PR-1 up to 7 days after introduction, while free SA caused an early peak in PR-1 expression which steadily decreased after 3 days. This study demonstrates the redox-responsive release of a phytohormone in vitro and also indicates the potential use of MSNs in planta as a controlled agrochemical delivery system.

Functionalized mesoporous silica nanoparticles for smart agrochemical delivery system

The agrochemical delivery system has been built up based on mesoporous silica nanoparticles as carriers in a controllable fashion. Several peer reviewed papers have been published with this research work. This delivery system will benefit for the future agricultural application.

Exceptional durability enhancement of PA/PBI based polymer electrolyte membrane fuel cells for high temperature operation at 200°C

The incorporation of phosphotungstic acid functionalized mesoporous silica in phosphoric acid doped polybenzimidazole (PA/PBI) substantially enhances the durability of PA/PBI based polymer electrolyte membrane fuel cells for high temperature operation at 200°C.

Photochromic wool fabrics with enhanced durability and photochromic performance

In our previous work, we have produced a photochromic wool fabric by applying a thin layer of hybrid silica-photochromic dye onto the wool surface. The coating showed a very fast optical response, but had little influence on the fabric handle, however durability was low. In this context, we reported that durability of the hybrid layer can be improved by introducing epoxy groups into the silica matrix via co-hydrolysis and co-condensation of an alkyl trialkoxysilane (ATAS) and 3-glycidoxypropyltrimethoxysilane (GPTMS). The presence of epoxy groups in the silica enhanced both washing and abrasion durabilities. Also, the optical response speed was slightly increased as well. Effects of the type of alkyl silane and the GPTMS:alkyl silane ratio on the coating durability, fabric handle and optical response were examined.

Photochromic coloration of wool fabric

A method has been developed for producing photochromic wool fabric by applying a layer of hybrid silica containing a photochromic dye onto wool fibres. A number of different hybrid silicas were prepared by the sol-gel technique involving co-hydrolysis and co-condensation of alkyltrialkoxysilanes together with 3-glycidoxypropyltrimethoxysilane. With the dye Photorome II, it was possible to obtain a photo chromic coating which showed fast optical response. The coating had only a slight effect on the fabric handle. The durability of the coating appeared to be acceptable, at least for fashion wear.