Abnormal transmittance of refractive-index-modified ZnO/organic hybrid films

The refractive index of ZnO/organic nanocomposite films was modified in the range from 1.44 to 1.55, while maintaining high visible transparency. The transparency of the nanocomposite films showed an abnormal behaviour as a function of the loading level of inorganic particles, because it did not decrease according to the Beer-Lambert law, but rather saturated to a near-constant value at high particle loading levels above 8 vol.-%. On the other hand, the refractive index of the film showed good agreement with the Bruggemann model, linearly increased as particle concentration increased. This result indicates the possibility of fabricating highly transparent nanocomposite films with controlled refractive indices.

Abnormally high optical transmittance of refractive-index modified ZnO / organic hybrid films

Hybrid films consisting of ZnO nanoparticles and organic matrices were fabricated at particle concentration levels of up to 60 wt%. The correlation between the refractive index and optical transmittance in the visible light region was investigated. The refractive index of the hybrid films was modified in a continuous manner in the range from 1.44 to 1.55. The refractive index increased linearly as a function of particle concentration. On the other hand, optical transmittance showed little change above the particle volume fraction of 0.08.

ZnO flower/PEDOT:PSS thermoelectric composite films

ZnO flower/poly(3,4-ethylenedioxythiophene):poly(4-styrenesulfonate) (PEDOT:PSS) composite films were prepared by spin-coating dimethyl sulfoxide doped PEDOT:PSS on the ZnO flowers grown on glass substrate. The thermoelectric properties of the ZnO flower/PEDOT:PSS composite films were measured at room temperature. As the number of spin coated PEDOT:PSS layer increased, the electrical conductivity of the ZnO flower/PEDOT:PSS composite films increases dramatically from 1-layer (177.3 S/m) to 4-layer (910.4 S/m), however, all the composite films have almost the same Seebeck coefficient (~20–22 μV/K). A maximum power factor of ~0.4 μWm−1 K−2 at room temperature was obtained from the composite film with 4-layer PEDOT:PSS.

Bioactive hydroxyapatite coating on titanium-niobium alloy through a sol-gel process

Hydroxyapatite (HA) was coated on the surface of a titanium-niobium (Ti-Nb) alloy by a sol-gel process. Triethyl phosphite and calcium nitrate were used as the phosphorus (P) and calcium (Ca) precursors respectively to prepare a Ca/P sol solution. The Ti-Nb alloy was dip-coated in the sol and heated at 600°C for 30 minutes. X-ray diffraction (XRD) analysis indicated the major phase constituent of the coating after heat treatment was HA. Scanning electron microscopy (SEM) observation showed that a few cracks were distributed on the HA coating. The in-vitro bioactivity of the HA coated Ti-Nb alloy was assessed using a cell culture of SaOS-2 osteoblast-like cells. The density of cell attachment was determined by MTT assay; the cell morphology was observed by SEM. Results indicated that the density of cell attachment on the surface of the Ti-Nb alloy was significantly increased by HA coating. Cell morphology observation showed that cells attached, spread and grew well on the HA coated surface. It can be concluded that the HA coating improved the in-vitro bioactivity of Ti-Nb alloy effectively.