Short communication: Influence of labeling on Australian and Chinese consumers' liking of milk with short (pasteurized) and long (UHT) shelf life

Sixty percent of milk consumed in China has a long shelf life (UHT), presumably because milk with a short shelf life (pasteurized) is comparatively expensive. This in contrast to Australia, where 10% of consumed milk is UHT and the price between UHT and pasteurized milk is equivalent. Whether UHT is actually more liked than pasteurized milk by Chinese consumers is unknown. However, the potential positive halo around the expensive pasteurized milk might result in Chinese consumers liking milk more when it is labeled as "short shelf-life milk." To test these hypotheses, Chinese (n=48, 20 males, 28 females, 23±7.2 yr) and Australian (n=93, 11 males, 82 females, 24±5.6 yr) consumers tasted and rated (9-point hedonic scale), in a randomized order, 3×30-mL samples of UHT milk (labeled as "long shelf-life milk," "short shelf-life milk," or "milk") and 3×30-mL samples of pasteurized milk (also labeled as "long shelf-life milk," "short shelf-life milk," or "milk"). Australian participants' liking of milk was not influenced by labeling. Regardless of what the label stated, they always preferred the taste of pasteurized milk over the taste of UHT milk. This was different for Chinese participants, who preferred the taste of UHT milk over the taste of pasteurized milk, but in general had a higher liking for any milk that was labeled "short shelf-life milk." Both Australian and Chinese were more positive about pasteurized than UHT milk. In conclusion, Chinese, but not Australian, consumers' liking of milk was guided by the positive expectations of pasteurized milk and the negative expectations of UHT milk. Further research is needed to investigate if the present findings can be extrapolated to a larger and more varied group of Chinese and Australian consumers.

Effect of different potting media combinations on growth and vase life of tuberose (Polianthes tuberosa Linn.)

The present study was carried out in the agro-metrological conditions of Rawalpindi, Pakistan. Different potting media were used in different combinations to check their effect on the morphological parameters as well as on the vase life of the tuberose. The different treatments included the combinations of FYM, poultry manure, sand, leaf compost and coconut coir in equivalent ratio. The data was analyzed statistically which showed significant effect of media combinations over control values. Maximum plant spread, number of leaves and vase life was recorded in sand+FYM. Coconut coir + FYM contributed to the maximum values of plant height, leaf area and spike length. Maximum plantlets were counted for sand+poultry manure. The highest values of floral diameter, number of flowers per spike and shelf life were observed in sand+leaf compost. These findings lead toward better quality cut flower production with maximum vase life.

Solid state actuators based on polypyrrole and polymer-in-ionic liquid electrolytes

Novel polymer-in-ionic liquid electrolytes (PILEs) have been developed for solid state electrochemical actuators based on polypyrrole. The active polymer electrodes are readily oxidized/reduced without degradation in the PILE. It was found that the actuator cycle life is significantly enhanced in the PILE as is the ‘shelf life’ of the device.

Stabilization of highly unsaturated fatty acids and delivery into foods

Highly unsaturated fatty acids derived from fish or algal oils, particularly EPA and DHA, are in high demand as healthy food ingredients in fortified foods. Due to their oxidative instability most food products incorporate stabilized microencapsulated EPA and DHA oils to avoid negative sensory impact associated with oxidation of these fatty acids. Complex coacervation has been particularly successful in stabilizing fish oil and providing an ingredient with a sensory shelf-life consistent with that of the food product. Overcoming the technical challenges associated with the instability of these oils will help drive growth of the omega-3 fortified healthy food ingredient market.

Antibacterial activity of stevioside towards food-borne pathogenic bacteria

This study determines the inhibitory effect of Stevia rebaudiana leaf extracts and its purified bioactive compound ‘stevioside’ against food-related pathogens. The S. rebaudiana solvent extracts (1000 μg/mL) displayed antibacterial activity to Serratia marcescens, Klebsiella pneumoniae, Bacillus cereus, Pseudomonas aeruginosa, B. subtilis, Alcaligenes denitrificans and Salmonella typhimurium. Of the six solvents, ethanol and acetone extracts displayed the highest zone of inhibition. The bioactive compound from S. rebaudiana was purified by solvent extraction, thin-layer chromatography followed by structural characterization by spectroscopy evidence. Purified stevioside prevented the growth of tested bacterial species, i.e. B. subtilis, K. pneumoniae and S. typhimurium. Significant zone of inhibition (12 mm) was observed against B. cereus which proposes potential application of stevioside in foods to increase their shelf life.

Chemical and thermal stability of surface‐modified porous polyethylene membranes

In this paper, we describe the surface modification of porous polyethylene by the adsorption of polyelectrolyte mutilayers on plasma‐activated polyethylene surfaces. We use the migration rates of deionized water as an effective alternative to contact angle measurements in order to probe the interfacial energy of the modified surface. The newly acquired surface properties that result from the surface modification are monitored with respect to several key chemical and environmental variables. These variables were chosen so that they will reflect some of the common handling procedures in a laboratory or health care environments, such as exposure to solvents of different pH and polarities, and fluctuations of ambient temperature over an extended period, i.e., “shelf‐life” duration. The stability of these surface properties of the modified membranes is a fundamental requirement for their potential use in a variety of applications involving lateral flow and binding media for bio‐assays. In this paper, we show that a membrane modified by a polyelectrolyte monolayer is more stable than a membrane that has undergone plasma activation alone, while a membrane modified by a polyelectrolyte bilayer exhibits retention of the enhanced surface hydrophilic properties under various conditions and over a long period of time.

Detection of nitro-explosive compounds using derivatization and tris(2,2'-bipyridyl)ruthenium(II) chemiluminescence

This thesis describes a novel approach towards the trace level detection of nitramine explosives, by exploring various reduction strategies and utilising ruthenium chemiluminescence. Synthesis of novel chemiluminescence compounds has been achieved, as well as the development of a detection method for determining the shelf life of ammunition.

Nucleic acid-based aptamers: applications, development and clinical trials

Short single-stranded oligonucleotides called aptamers, often termed as chemical antibodies, have been developed as powerful alternatives to traditional antibodies with respect to their obvious advantages like high specificity and affinity, longer shelf-life, easier manufacturing protocol, freedom to introduce chemical modifications for further improvement, etc. Reiterative selection process of aptamers over 10-15 cycles starting from a large initial pool of random nucleotide sequences renders them with high binding affinity, thereby making them extremely specific for their targets. Aptamer-based detection systems are well investigated and likely to displace primitive detection systems. Aptamer chimeras (combination of aptamers with another aptamer or biomacromolecule or chemical moiety) have the potential activity of both the parent molecules, and thus hold the capability to perform diverse functions at the same time. Owing to their extremely high specificity and lack of immunogenicity or pathogenicity, a number of other aptamers have recently entered clinical trials and have garnered favorable attention from pharmaceutical companies. Promising results from the clinical trials provide new hope to change the conventional style of therapy. Aptamers have attained high therapeutic relevance in a short time as compared to synthetic drugs and/or other modes of therapy. This review follows the various trends in aptamer technology including production, selection, modifications and success in clinical fields. It focusses largely on the various applications of aptamers which mainly depend upon their selection procedures. The review also sheds light on various modifications and chimerizations that have been implemented in order to improve the stability and functioning of the aptamers, including introduction of locked nucleic acids (LNAs). The application of various aptamers in detection systems has been discussed elaborately in order to stress on their role as efficient diagnostic agents. The key aspect of this review is focused on success of aptamers on the basis of their performance in clinical trials for various diseases.