Adaptation of LEACH routing protocol to cognitive radio sensor networks

One of the drawbacks of LEACH protocol is the uncontrolled selection of cluster heads which, in some rounds, leads to the concentration of them in a limited area due to the randomness of the selection procedure. LEACH-C is a variant of LEACH that uses a centralized clustering algorithm and forms good clusters through sink control. According to experimental results, the IEEE 802.15.4 packets are damaged by WLAN interferences in ISM band. It seems that, sensor nodes equipped with cognitive radio capabilities can overcome this problem. In cognitive radio sensor networks (CRSN), routing must be accompanied by channel allocation. This requires spectrum management which can be devolved to cluster heads. For this networks, new duty cycle mechanisms must be designed that jointly consider neighbor discovery, and spectrum sensing/allocation. Cluster-based network architecture is a good choice for effective dynamic spectrum management. In such architecture, cluster heads have a proper spatial distribution and are optimally located all over the network. In this paper, using the physical layer information and preserving the feature of random cluster head selection in LEACH, it has been tried to both move the position of cluster heads to appropriate locations and make their quantity optimal. The simulation results show that the transferal of cluster heads to appropriate locations increases the network lifetime significantly though this comes at the price of early instability appearance. By considering the energy level in cluster head election algorithm, one can overcome the network stability issues too. However, this will move the cluster heads away from their appropriate locations. © 2012 IEEE.

Reflectance response of tapered optical fiber coated with graphene oxide nanostructured thin film for aqueous ethanol sensing

In this work, optical sensing performance of tapered multimode fiber tip coated with graphene oxide (GO) nanostructured thin film towards aqueous ethanol with different concentrations is investigated. The tapering process of the optical fiber is done by a glass processing machine. The multimode optical fiber tip is dip-coated with GO and annealed at 70 °C to enhance the binding of the nanomaterials to the silica fiber. FESEM, Raman microscopy and XRD analyses are performed to micro-characterize the GO thin films. The morphology of the GO is observed to be in sheets forms. The reflectance response of the GO coated fiber tip is compared with the uncoated tip. The measurements are taken using a spectrophotometer in the optical wavelength range of 550-720 nm. The reflectance response of the GO coated fiber tip reduced proportionally, upon exposure to ethanol with concentration range of 5-80%. The dynamic response of the developed sensor showed strong reversibility and repeatability when it is exposed to ethanol with concentrations of 5%, 20% and 40% in distilled water. At room temperature, the sensor shows fast response and recovery as low as 19 and 25 s, respectively. © 2014 Elsevier B.V.

Mobile phone-based electrochemiluminescence sensing exploiting the 'USB On-The-Go' protocol

A low-cost system to generate, control and detect electrochemiluminescence using a mobile smartphone is described. A simple tone-detection integrated circuit is used to switch power sourced from the phone's Universal Serial Bus (USB) 'On-The-Go' (OTG) port, using audible tone pulses played over the device's audio jack. We have successfully applied this approach to smartphones from different manufacturers and with different operating system versions. ECL calibrations of a common luminophore, tris(2,2′-bipyridine)ruthenium(II) ([Ru(bpy)3]²⁺), with 2-(dibutylamino)ethanol (DBAE) as a co-reactant, showed no significant difference in light intensities when an electrochemical cell was controlled by a mobile phone in this manner, compared to the same calibration generated using a conventional potentiostat. Combining this novel approach to control the applied potential with the measurement of the emitted light through the smart phone camera (using an in-house built Android app), we explored the ECL properties of a water-soluble iridium(III) complex that emits in the blue region of the spectrum. The iridium(III) complex exhibited superior co-reactant ECL intensities and limits of detection to that of the conventional [Ru(bpy)3]²⁺ luminophore.