Evaluation of numerical procedures to determine seismic response of structures under influence of soil-structure interaction

In this study, the accuracy and reliability of fully nonlinear method against equivalent linear method for dynamic analysis of soil-structure interaction is investigated comparing the predicted results of both numerical procedures with the results of experimental shaking table tests. An enhanced numerical soil-structure model has been developed which treats the behaviour of the soil and the structure with equal rigour. The soil-structural model comprises a 15 storey structural model resting on a soft soil inside a laminar soil container. The structural model was analysed under three different conditions: (i) fixed base model performing conventional time history dynamic analysis, (ii) flexible base model (considering full soil-structure interaction) conducting equivalent linear dynamic analysis, and (iii) flexible base model performing fully nonlinear dynamic analysis. The results of the above mentioned three cases in terms of lateral storey deflections and inter-storey drifts are determined and compared with the experimental results of shaking table tests. Comparing the experimental results with the numerical analysis predictions, it is noted that equivalent linear method of dynamic analysis underestimates the inelastic seismic response of mid-rise moment resisting building frames resting on soft soils in comparison to the fully nonlinear dynamic analysis method. Thus, inelastic design procedure, using equivalent linear method, cannot adequately guarantee the structural safety for mid-rise building frames resting on soft soils. However, results obtained from the fully nonlinear method of analysis fit the experimental results reasonably well. Therefore, this method is recommended to be used by practicing engineers.

Modelling solute transport in structured soils: performance evaluation of the ADR and TRM models

The movement of chemicals through the soil to the groundwater or discharged to surface waters represents a degradation of these resources. In many cases, serious human and stock health implications are associated with this form of pollution. The chemicals of interest include nutrients, pesticides, salts, and industrial wastes. Recent studies have shown that current models and methods do not adequately describe the leaching of nutrients through soil, often underestimating the risk of groundwater contamination by surface-applied chemicals and overestimating the concentration of resident solutes. This inaccuracy results primarily from ignoring soil structure and nonequilibrium between soil constituents, water, and solutes. A multiple sample percolation system (MSPS), consisting of 25 individual collection wells, was constructed to study the effects of localized soil heterogeneities on the transport of nutrients (NO−3, Cl−, PO3−4) in the vadose zone of an agricultural soil predominantly dominated by clay. Very significant variations in drainage patterns across a small spatial scale were observed (one-way ANOVA, p < 0.001 indicating considerable heterogeneity in water flow patterns and nutrient leaching. Using data collected from the multiple sample percolation experiments, this paper compares the performance of two mathematical models for predicting solute transport, the advective-dispersion model with a reaction term (ADR), and a two-region preferential flow model (TRM) suitable for modelling nonequilibrium transport. These results have implications for modelling solute transport and predicting nutrient loading on a larger scale.

Balancing environmental impacts and benefits of wastewater reuse

Wastewater reuse is being widely promulgated to help address the global freshwater resource crisis. It can assist in reducing extraction of freshwater from the environment, and reuse of wastewater lessens the need for environmental discharge, which is clearly beneficial to receiving waters. But the practice itself also has the potential to be detrimental to natural and human environments: soil structure can become degraded, aquifers may be polluted, and human health may be threatened. The challenge facing natural resource managers is to identify the potential benefits and risks, and to achieve an appropriate balance. This paper describes environmental benefits and threats concomitant with the reuse of wastewater. We frequently draw upon examples from China and Australia-two countries that face particularly daunting water resource
challenges-but the principles can be.extended far beyond these geographical bounds and are applicable to
many parts of the world.

Sustainability: meaning and measurement with application to agriculture

Sustainability refers to having the ability to meet present needs without impacting on future generations to meet their needs. It incorporates social, economic and environmental aspects, and as a measure of sustainability, a range of sustainability indicators at the economy, regional, and individual level, have been suggested. However, given the complex and multidisciplinary nature of the concept, an interdisciplinary approach is necessary. Sustainability is not something that is easily measurable, and the aim of this paper is to present a conceptual framework for quantifying sustainability on the basis of social economic efficiency. According to neoclassical economic theory, economic activity will only be sustained by the private sector as long as it is profitable. However, private economic decisions do not always ensure long-term sustainability of environmental resources or production. The approach suggested here is to derive a measure of social economic efficiency as a measure of sustainability. For dairy farmers, increased productivity has been emphasized, while recognizing the need to reduce greenhouse emissions, pests and disease, nutrient run-off into the environment and degradation of the soil structure. By incorporating environmental and economic impacts, a fuller measure of efficiency, social economic efficiency, and sustainability of the farming practice can be developed.

Transient fluid–structure coupling for simulation of a trileaflet heart valve using weak coupling

In this article, a three-dimensional transient numerical approach coupled with fluid–structure interaction for the modeling of an aortic trileaflet heart valve at the initial opening stage is presented. An arbitrary Lagrangian–Eulerian kinematical description together with an appropriate fluid grid was used for the coupling strategy with the structural domain. The fluid dynamics and the structure aspects of the problem were analyzed for various Reynolds numbers and times. The fluid flow predictions indicated that at the initial leaflet opening stage a circulation zone was formed immediately downstream of the leaflet tip and propagated outward as time increased. Moreover, the maximum wall shear stress in the vertical direction of the leaflet was found to be located near the bottom of the leaflet, and its value decreased sharply toward the tip. In the horizontal cross section of the leaflet, the maximum wall shear stresses were found to be located near the sides of the leaflet.

Finite element modeling and analysis of thrombosis in middle cerebral artery

Thrombotic stroke, which is caused by blood clot in the cerebral artery, is a major source of increased mortality and morbidity. Considering as efficient and fastest methods, mathematical approaches have gained significant importance for analyzing and understanding the biological events like thrombosis. This paper presents a computational model to analyze the effects of thrombosis using the theory of coupled fluid dynamics-structure interaction. The finite element method is used for the modeling of thrombosis (blood clot) of different stages in the middle cerebral artery with physiological compliance. The developed model is used to investigate the consequences that occur due to the various sizes of clots in the artery in the form of blood flow velocity, blood pressure, and artery wall stress. Such numerical assessment will facilitate better understanding of the biophysical process in case of thrombosis and thus would support medical practitioners to take faster curing steps.

High colonization by native arbuscular mycorrhizal fungi (AMF) of rubber trees in small-holder plantations on low fertility soils in North East Thailand

Rubber tree is a very important crop in Thailand, representing an essential source of income for farmers. In the past two decades, rubber tree plantations have been greatly expanding in unfavorable areas, where climate conditions are difficult and soil fertility is very poor. To optimize latex yields, mineral fertilizers have been widely used. A better understanding of the roles of the biological compartment in soil fertility is essential to determine alternative management practices to sustain soil fertility and optimize latex yields. Arbuscular mycorrhizal fungi (AMF) are widely recognized as beneficial for plants, mainly through their role in improving plant nutrient uptake. The objective of this study was to assess the AMF populations in rubber tree plantations and the impact of both soil characteristics and plantation age on these communities. Our results showed that all rubber trees were highly colonized, regardless of the soil structure and nutrient contents. AMF colonization was not affected by the age of the trees, suggesting that maintaining the symbiosis is likely to be beneficial at all stages. A better understanding and management of the microbial communities would contribute to maintaining or restoring soil fertility, leading to a better tree growth and optimized latex yield.

Aspects of the interaction between Xanthorrhoea australis and Phytophthora cinnamomi in south-western Victoria, Australia

Diseases in natural ecosystems are often assumed to be less severe than those observed in domestic cropping systems due to the extensive biodiversity exhibited in wild vegetation communities. In Australia, it is this natural biodiversity that is now under threat from Phytophthora cinnamomi. The soilborne Oomycete causes severe decline of native vegetation communities in south-western Victoria, Australia, disrupting the ecological balance of native forest and heathland communities. While the effect of disease caused by P. cinnamomi on native vegetation communities in Victoria has been extensively investigated, little work has focused on the Anglesea healthlands in south-western Victoria. Nothing is known about the population structure of P. cinnamomi at Anglesea. This project was divided into two main components to investigate fundamental issues affecting the management of P. cinnamomi in the Anglesea heathlands. The first component examined the phenotypic characteristics of P. cinnamomi isolates sampled from the population at Anglesea, and compared these with isolates from other regions in Victoria, and also from Western Australia. The second component of the project investigated the effect of the fungicide phosphonate on the host response following infection by P. cinnamomi. Following soil sampling in the Anglesea heathlands, a collection of P, cinnamomi isolates was established. Morphological and physiological traits of each isolate were examined. All isolates were found to be of the A2 mating type. Variation was demonstrated among isolates in the following characteristics: radial growth rate on various nutrient media, sporangial production, and sporangial dimensions. Oogonial dimensions did not differ significantly between isolates. Morphological and physiological variation was rarely dependant on isolate origin. To examine the genetic diversity among isolates and to determine whether phenotypic variation observed was genetically based, Random Amplified Polymorphic DNA (RAPD) analyses were conducted. No significant variation was observed among isolates based on an analysis of molecular variance (AMQVA). The results are discussed in relation to population biology, and the effect of genetic variation on population structure and population dynamics. X australis, an arborescent monocotyledon indigenous to Australia, is highly susceptible to infection by P. cinnamomi. It forms an important component of the heathland vegetation community, providing habitat for native flora and fauna, A cell suspension culture system was developed to investigate the effect of the fungicide phosphonate on the host-pathogen interaction between X. australis and P. cinnamomi. This allowed the interaction between the host and the pathogen to be examined at a cellular level. Subsequently, histological studies using X. australis seedlings were undertaken to support the cellular study. Observations in the cell culture system correlated well with those in the plant. The anatomical structure of X australis roots was examined to assist in the interpretation of results of histopathological studies. The infection of single cells and roots of X. australis, and the effect of phosphonate on the interaction are described. Phosphonate application prior to inoculation with P. cinnamomi reduced the infection of cells in culture and of cells in planta. In particular, phosphonate was found to stimulate the production of phenolic material in roots of X australis seedlings and in cells in suspension cultures. In phosphonate-treated roots of X australis seedlings, the deposition of electron dense material, possibly lignin or cellulose, was observed following infection with P. cinnamomi. It is proposed that this is a significant consequence of the stimulation of plant defence pathways by the fungicide. Results of the study are discussed in terms of the implications of the findings on management of the Anglesea heathlands in Victoria, taking into account variation in pathogen morphology, pathogenicity and genotype. The mode of action of phosphonate in the plant is discussed in relation to plant physiology and biochemistry.

Female–female aggression : structure of interaction and outcome in loggerhead sea turtles

Aggressive behaviour between females of the same species is not widely documented, particularly in marine vertebrates. During a 3 yr in-water survey at the temperate loggerhead sea turtle Caretta caretta breeding area of Zakynthos, Greece, female–female interactions comprised 4% of all female loggerhead sighting events (n = 60 out of 1449 events). Male–female interactions comprised an additional 4% of sighting events, while 92% were of solitary females. The structure of interactions was analysed for 58 of these sighting events, each lasting an average of 3.4 min (SD ± 1) and comprising a total of 3.1 h observation time. We found that interactions involved ritualized escalation in behaviour from passive threat displays (e.g. head–tail circling) to aggressive combat (e.g. sparring). We suggest that circling individuals evaluate opponent size, sparring individuals test opponent strength, and that the positioning of the prehensile tail signals motivational intent to either escalate or abort. The presence of intruder females triggered a passive response in 100% of events involving basking and swimming turtles (n = 19); although residents resting on the seabed only responded on 69% of occasions (n = 27), their response was almost 4 times more likely to escalate to one of aggression. Our results suggest that certain sites may be preferentially sought after and defended by sea turtles.