Modelling based design of a pilot-scale membrane bioreactor for combined nutrient removal from domestic wastewater

A three stage-treatment of domestic wastewater including anaerobic, anoxic and aerobic phases is employed in this study while a clarifier unit is replaced with a submerged membrane in the aerobic unit. The effects of operational parameters on the performance of a pilot scale submerged membrane bioreactor (SMBR) namely hydraulic retention time (HRT), ratio of return activated sludge (QRS), ratio of internal recycle (QIR), solid retention time (SRT) and dissolved oxygen (DO) are evaluated by simulations, using a hybrid model composed of TUDP model, oxygen transfer model, biofouling model due to extra-cellular polymeric substances (EPS) and turbulent shear model. The results showed that anaerobic HRT of 3 hours, anoxic HRT of 6 hours, QRS of 20% and QIR of 300 % are satisfactory in obtaining a high removal efficiency (>90%) of COD, NH4-N, P04-P as well as a less sludge production. An increase of sludge production causes an increase in EPS, which fouls the membrane surface and increase the cleaning cycle of membrane. Operation of 5MBR system at 2 mg/I of DO and 30 days of SRT can extend the membrane cleaning cycle dramatically. The membrane cleaning cycle however is strongly dependent on the initial and terminal specific fluxes and displays inverse power relationships to those fluxes.

Application of submerged membrane bioreactor for aquaculture effluent reuse

Discharging the nutrient rich aquaculture effluents into inland water bodies and oceans is becoming a serious concern due to the adverse effect that brings in the form of eutrophication and subsequent damages to those waters. A laboratory scale biological reactor consisting of a denitrifying compartment followed by a submerged membrane bioreactor (SMBR) compartment was used to treat 40 L d−1 of aquaculture effluent with an average concentration of 74 mg L−1 nitrate (NO3 − ). Sugar was added to the aquaculture effluent in order that to enter into the denitrifying compartment at a carbon: nitrogen ratio (C:N) of 2:1 and 4:1. A hollow fibre membrane with a pore size of 0.4 μm and a filtration area of 0.20 m2 was used in the SMBR and was operated at an average flux of 0.20 m3 m−2 d−1. An intermittent suction period of 12 min followed by a relaxation period of 3 min was maintained in the SMBR throughout the experiment. Different aeration rates of 1, 3, 5 and 10 Lpm were applied to the SMBR to determine the rate of membrane fouling and 5 Lpm aeration rate was found to be optimum with respect to the rate of fouling of membrane at a C:N ratio of 4:1. The average rate of fouling at 1, 3, 5 and 10 Lpm were 1.17, 0.70, 0.48 and 0.52 kPa d−1, respectively. The increase in the rate of fouling when the aeration was increased from 5 to 10 Lpm may be due to the breakage of suspended particles into finer particles which could have increased the fouling of membrane. It was also found that increasing the C:N ratio from 2:1 to 4:1 resulted in more cake being formed on the membrane surface as well as an increase in the reduction of NO3 − from 64% to 78%. Preliminary calculations show that 2.4 to 3.2 g of suspended solids could be accumulated per square meter of membrane surface before physical cleaning of membrane is required (at a transmembrane pressure of 20 kPa).