Genotoxicity assessment of soils from wastewater irrigation areas and bioremediation sites using the Vicia faba root tip micronucleus assay

Genotoxicity potential of soils taken from wastewater irrigation areas and bioremediation sites was assessed using the Vicia faba root tip micronucleus assay. Twenty five soils were tested, of which 8 were uncontaminated soils and taken as the control to examine the influence of soil properties; 6 soils were obtained from paddy rice fields with a history of long-term wastewater irrigation; 6 soils were obtained from bioremediation sites to examine effects of bioremediation; and 5 PAH-contaminated soils were used to examine methodological effects between direct soil exposure and exposure to aqueous soil extracts on micronuclei (MN) frequency () in the V. faba root tips. Results indicate that soil properties had no significant influences on MN frequencies (p > 0.05) when soil pH varied between 3.4 to 7.6 and organic carbon between 0.4% and 18.6%. The MN frequency measured in these control soils ranged from 1.6‰ to 5.8‰. MN frequencies in soils from wastewater irrigation areas showed 2- to 48-fold increase as compared with the control. Soils from bioremediation sites showed a mixed picture: MN frequencies in some soils decreased after bioremediation, possibly due to detoxification; whereas in other cases remediated soils induced higher MN frequencies, suggesting that genotoxic substances might be produced during bioremediation. Exposure to aqueous soil extracts gave a higher MN frequency than direct exposure in 3 soils. However, the opposite was observed in the other two soils, suggesting that both exposure routes should be tested in case of negative results from one route. Data obtained from this study indicate that the MN assay is a sensitive assay suitable for evaluating genotoxicity of soils.

Role of the ATP-binding cassette drug transporters in the intestinal absorption of tanshinone IIB, one of the major active diterpenoids from the root of Salvia miltiorrhiza

There is an increasing use of herbal medicines worldwide, and the extracts from the root of Salvia miltiorrhiza are widely used in the treatment of angina and stroke. In this study, we investigated the mechanism for the intestinal absorption of tanshinone IIB (TSB), a major constituent of S. miltiorrhiza. The oral bioavailability of TSB was about 3% in rats with less proportional increase in its maximum plasma concentration (C_max) and area under the plasma concentration-time curve (AUC) with increasing dosage. The time to C<sub>max sub>(T_max) was prolonged at higher oral dosage. In a single pass rat intestinal perfusion model, the permeability coefficients (P</i><sub>appsub>) based on TSB disappearance from the lumen (P</i><sub>lumensub>) were 6.2- to 7.2-fold higher (p</i> < 0.01) than those based on drug appearance in mesenteric venous blood (P</i><sub>bloodsub>). The uptake and efflux of TSB in Caco-2 cells were also significantly altered in the presence of an inhibitor for P-glycoprotein (PgP) or for multi-drug resistance associated protein (MRP1/2). TSB transport from the apical (AP) to basolateral (BL) side in Caco-2 monolayers was 3.3- to 5.7-fold lower than that from BL to AP side, but this polarized transport was attenuated by co-incubation of PgP or MRP1/2 inhibitors. The P</i><sub>app sub>values of TSB in the BL-AP direction were significantly higher in MDCKII cells over-expressing MDR1 or MRP1, but not in cells over-expressing MRP2-5, as compared with the wild-type cells. The plasma AUC<sub>0-24hrsub> in mdr1a and mrp</i>1 gene-deficient mice was 10.2- to 1.7-fold higher than that in the wild-type mice. Furthermore, TSB significantly inhibited the uptake of digoxin and vinblastine in membrane vesicles containing PgP or MRP1. TSB also moderately stimulated PgP ATPase activity. Taken collectively, our findings indicate that TSB is a substrate for PgP and MRP1 and that drug resistance to TSB therapy and drug interactions may occur through PgP and MRP1 modulation.

Preparation of bioactive porous Ti-Sn-Nb alloy for biomedical applications

A porous Ti-16Sn-4Nb alloy with an average pore size of 300 µm and porosity of 60 % was prepared by powder metallurgy, and a bone-like apatite coating was obtained by soaking the samples in a concentrated simulated body fluid (lOx SBF). The changes of the microstructure and composition on the surface with soaking time were investigated by using X-ray diffractometry (XRD), and scanning electron microscopy equipped with energy dispersive spectroscopy (SEM-EDS), The bone-like apatite granules started to deposit throughout the porous Ti alloy foam aner 1 h soaking, and the number of granules increased with the increase of the soaking time. A uniform bone-like apatite layer covered the entire surface of the sample after soaking in Ihe lOx SBF for 6h. The Ti-16Sn-4Nb foam showed a good bioactivity after a thermochemical process and soaking into a 1Ox SBF.

Enhanced thermal properties and morphology of ion-exchanged polypyrrole films

The thermal stability of electrochemically prepared polypyrrole (PPy) films with p-toluenesulfonate (p</i>TS) or perchlorate (ClO<sub>4sub><sup>&minus;sup>) counterion (PPy/p</i>TS and PPy/ClO<sub>4sub><sup>&minus;sup>) is improved by simple treatment with aqueous sulfuric acid, sodium sulfate or sodium bisulfate. The degree of stabilization achieved depends on the solution, temperature and duration of treatment. Although the mechanism for improved stability is not yet clear, it is apparent that the level of ion exchange and the original polymer microstructure are important. A model for the conductivity decay as a function of thickness has been proposed. The early stages of ion exchange are not symmetrical, and diffusion is facilitated at the electrode side of the film. Furthermore, X-ray diffraction shows no evidence of morphological change after treatment of PPy/p</i>TS (43 μm), but in PPy/pTS (12 μm) and PPy/ClO<sub>4sub><sup>&minus;sup> (41 μm) films an additional peak is indicative of more ordered structure following treatment. The glass transition temperature, T<sub>gsub>, of PPy/p</i>TS and PPy/ClO<sub>4sub><sup>&minus;sup> films obtained by modulated differential scanning calorimetry is approximately 155°C.

Ion exchange, anisotropic structure and thermal stability of polypyrrole films

The thermal stability of electrochemically prepared polypyrrole (PPy) films with p</i>-toluene sulfonate (p</i>TS) or perchlorate (CIOP<sub>4sub><sup>&minus;sup>) counter ion (PPy/p</i>TS and PPy/ClO<sub>4sub><sup>&minus;sup>) is improved by simple treatment with aqueous sulfuric acid, sodium sulfate or sodium bisulfate. The degree of stabilization achieved depends on the solution, temperature and duration of treatment. PPy/p</i>TS is easily stabilized and thick films (43μm) retain 90 % of the initial conductivity after long period (300 h) at 150 °C, while thinner films (12 μm) retain slightly less (70 %). A model for the conductivity decay has been proposed. Although the mechanism for improved stability is not yet clear it is apparent that the level of ion exchange and the original polymer microstructure are important. The early stages of ion exchange are not symmetrical and diffusion is facilitated at the electrode side of the film. Furthermore, X-ray diffraction shows no evidence of morphological change after treatment of thick PPy/p</i>TS but in thin PPy/p</i>TS and PPy/ClO<sub>4sub><sup>&minus;sup> films an additional peak is indicative of more ordered structure following treatment. These observation may imply that there is a higher density of crosslinks and branching at the growth side than at the electrode side of the film.

Crystal structures and textures in the hot-forged Ni-Mn-Ga shape memory alloys

Three ferromagnetic shape-memory alloys with the chemical compositions of Ni<sub>53sub>Mn<sub>25sub>Ga<sub>22sub>, Ni<sub>48sub>Mn<sub>30sub>Ga<sub>22sub>, and Ni<sub>48sub>Mn<sub>25sub>Ga<sub>22sub>Co<sub>5sub> were prepared by the induction-melting and hot-forging process. The crystal structures were investigated by the neutron powder diffraction technique, showing that Ni<sub>53sub>Mn<sub>25sub>Ga<sub>22sub> and Ni<sub>48sub>Mn<sub>25sub>Ga<sub>22sub>Co<sub>5sub> have a tetragonal, 14/mmm martensitic structure at room temperature, while Ni<sub>48sub>Mn<sub>30sub>Ga<sub>22sub> has a cubic, L2<sub>1sub> austenitic structure at room temperature. The development of textures in the hot-forged samples shows the in-plane plastic flow anisotropy from the measured pole figures by means of the neutron diffraction technique. Significant texture changes were observed for the Ni<sub>48sub>Mn<sub>25sub>Ga<sub>22sub>Co<sub>5sub> alloy after room temperature deformation, which is due to the deformation-induced rearrangements of martensitic variants. An excellent shape-memory effect (SME) with a recovery ratio of 74 pct was reported in this Ni<sub>48sub>Mn<sub>25sub>Ga<sub>22sub>Co<sub>5sub> polycrystalline alloy after annealing above the martensitic transformation temperature, and the “shape-memory” influence also occurs in the distributions of grain orientations.

Variation in the whiteness and brightness of mohair associated with farm, season, and mohair attributes

This work aimed to quantify factors affecting the reflectance attributes of Australian white mohair sourced from five different farms and to evaluate the effect of season and year on mohair grown by goats of known genetic origin in a replicated study. For the season study the mohair was harvested every three months for two years. All goats and their fleeces were weighed. Mid-side samples were tested for fibre diameter attributes, clean washing yield (CWY), staple length (SL) and for tristimulus values X, Y, Z and Y-Z. For the farm study (n = 196), linear models, relating Y, Z and Y-Z were fitted to farm of origin and other objective measurements. For the season and year study (n = 176), data were analysed by ANOVA and then by linear analysis. The variation accounted for by farm alone was: X, 22%; Y, 24%; Z, 12%; Y-Z, 30% (P < 0.001). Once farm had been taken into account, the regression models for X, Y and Z had similar significant terms: mean fibre diameter (MFD), CWY, SL and fibre diameter CV; and correlation coefficients (057&ndash;0.65). For Y-Z, in addition to farm only MFD was significant (P = 1.8 &times; 10&minus;9). While X, Y, Z and Y-Z were significantly associated with clean fleece weight (CFwt), CFwt was not significant in any final model. Season affected mohair Y (P = 2.5 &times; 10&minus;24), Z (P = 2.3 &times; 10&minus;20) and Y-Z (P = 6.8 &times; 10&minus;22). Autumn grown mohair had higher Y and Z, and summer grown mohair had lower Z than mohair grown in other seasons. This resulted in summer grown mohair having the highest Y-Z and winter grown mohair having the lowest Y-Z than mohair grown in other seasons. The differences between years in Y, Z and Y-Z were significant but not large. When Y, Z and Y-Z were modeled with season and other mohair attributes, MFD, CWY, CFwt, incidence of medullated fibre (Med) and sire were also significant terms. This model accounted for 62.1% of the variance. Over the range of Med (0.3&ndash;4.2%), Y-Z increased by 11 T units. Increasing CFwt 0.5 kg was associated with a decline in Y-Z of 7.5 T units. The variation in Y, Z and Y-Z associated with sire effects were respectively 2.66, 3.77, and 1.04 T units. In the farm and the season studies increasing MFD was associated with lower Y and Z and higher Y-Z. The extent of the differences in tristimulus values between seasons and years, were unlikely to be of commercial importance. The extent of the differences between farms, and to variations in MFD and Med were large enough to be of commercial importance. Clean mohair colour was artefactually biased by MFD.

Identify kinetic features of fibers growing, branching, and bundling in microstructure engineering of crystalline fiber network

Fibers growing, branching, and bundling are essential for the development of crystalline fiber networks of molecular gels. In this work, for two typical crystalline fiber networks, i.e. the network of spherulitic domains and the interconnected fibers network, related kinetic information is obtained using dynamic rheological measurements and analysis in terms of the Avrami theory. In combination with microstructure characterizations, we establish the correlation of the Avrami derived kinetic parameter not only with the nucleation nature and growth dimensionality of fibers and branches, but also with the fiber bundles induced by fiber-fiber interactions. Our study highlights the advantage of simple dynamic rheological measurements over other spectroscopic methods used in previous studies for providing more kinetic information on fiber-fiber interactions, enabling the Avrami analyses to extract distinct kinetic features not only for fibers growing and branching, but also for bundling in the creation of strong interconnected fibers networks. This work may be helpful for the implementation of precise kinetic control of crystalline fiber network formations for achieving desirable microstructures and rheological properties for advanced applications of gel materials. This journal is &copy; the Partner Organisations 2014.