Electrostatic complex of didodecyldimethylammonium and DNA: Langmuir monolayer, Langmuir–Blodgett film and dye recognition at air/water interface

DNA–didodecyldimethylammonium (DNA–DDDA) electrostatic complex was prepared and characterized through Fourier transformation infrared (FT-IR), 1H NMR and circular dichroism (CD) spectroscopy. When the dye molecule aqueous solutions were used as the subphase, the interaction between three dye molecules, acridine orange (AO), ethidium bromide (EB) and 5,10,15,20-tetrakis(4-N-methylpyridyl)porphine tetra(p-toluenesulfonate) (TMPyP) and the complex at air/solution interface were investigated through the surface pressure–area (π–A) isotherms, Brewster angle microscopy and UV-Vis spectroscopy, respectively. Our investigation indicates that the interaction capabilities of the three dyes to DNA–DDDA complex are different and present an order of TMPyP>AO>EB. For the interaction forms, we believe that TMPyP intercalates into the double helix of DNA, and AO adsorbs onto the surface of the DNA. As for EB, the measured signal is too weak to give a definite interaction form in the present experiment.

Monolayer behavior of a pyridyl head-group-containing amphiphile and its miscibility with poly(D,L-lactide-co-glycolide) on different pH subphase

In this paper, we investigated the Langmuir film and Langmuir–Blodgett (LB) monolayer film of a nonionic amphiphilic molecule, 4-(6-p-pyridyloxyl)hexyloxyl-4′-dodecyloxylazobenzene (C12AzoC6Py) and its mixture with poly(d,l-lactide-co-glycolide) (PLG) at different subphase pH values (2.0, 2.6, 3.3, 4.4, and 6.5, respectively) by surface pressure–area (π–A) isotherms, in situ interface Brewster angle microscopy (BAM), and ex situ atomic force microscopy (AFM). For pure C12AzoC6Py, its π–A isotherms display a plateau when the subphase pH value is lower than 3.0. The pressure of the plateau increases with the decrease of pH until 2.0. Over the plateau, the π–A isotherms become almost identical to the one under neutral conditions. The appearance of such a plateau can be explained as the coexistence of protonation and unprotonation of pyridyl head groups of the employed amphiphile. In contrast to the homogeneous surface morphology of pure C12AzoC6Py near the plateau by BAM observation, the surface in the case of its mixing with PLG exhibits a dendritic crystalline state under low surface pressure at subphase pH lower than 3.0. The crystalline state becomes soft and gradually melts into homogeneous aggregates with surface pressure increasing to a higher value than that of the plateau. Meanwhile, the hydrolysis of PLG in the mixture system at the interface has been affirmed to be restrained to a very large extent. And the PLG was believed to be compelled to the up layer of the LB film due to the phase separation, which is examined by AFM. Based on the experimental results, the corresponding discussion was also performed.

Evaluation of an evaporation suppressing monolayer system in a controlled wave tank environment: a pilot investigation

Due to long-term drought conditions coupled with the apparent influence of global warming, compounding water loss has been a very serious issue across the vast majority of the Australian continent. During these drought conditions, the evaporative effect outweighs the amount of precipitation being received on a year to year basis. Several methods have been introduced in recent history to inhibit the amount of evaporative loss from various types of water bodies such as the application of thin layer chemical films (monolayers). A series of solvent, solid and suspension derived prototype monolayers, based on ethylene glycol monooctadecyl ether (C18E1), are examined in this current study as an approach to eliminate the problems seen to occur with the previous types of monolayers. This research evaluates the fundamental effect of wind and wave based activity upon these prototype monolayers in an atmospherically controlled enclosure positioned over a large extended water tank using real-time environmental measurements. Selected performance results for the prototype monolayers as measured within the enclosed water tank were compared to results measured from a control monolayer film based on a commonly used octadecanol suspension film. The results show that under varying wind and wave conditions the prototype monolayers inhibit evaporation at a level similar to or better than the octadecanol standard, even when delivered at lower raw dosages.