On- and off-campus engineering student usage of a computer conferencing system

This article reports on the introduction of a computer-conferencing component into a first-year study unit in technology management at Deakin University, Australia. It was found that significant variations in computer usage were correlated to student study mode, including source of computer access, source of Internet access, hours-per-week computer usage, regular use of e-mail, regular use of the Internet, number of times the conference was accessed, use of computers for games, and use of computers for learning. Other moderate differences were also noted. Following exposure to the computer conference, on-campus students were more likely to agree that computers could assist their learning, and off-campus students were less likely to agree that learning from computers would be better than classes/lectures.

Usage of a computer conferencing system by on- and off-campus engineering students

This paper reports on the introduction of a computer conferencing  component into a first year study unit in Technology Management at Deakin University, Australia. It was found that significant variations in computer  usage were correlated to student study mode, including source of computer access, source of Internet access, hours per week computer usage, regular use of email, regular use of the Internet, and number of times the conference was accessed. Other moderate differences were also noted. Following  exposure to the computer conference, on-campus students were more likely to agree computers could assist their learning, and off-campus students  were less likely to agree that learning from computers would be better than classes/lectures.

Evaluation of a heat pump system for greenhouse heating

Greenhouse heating costs for some commercial growers in southern Australia are now a significant production cost. This is particularly the case for those operators who installed heating systems using liquefied petroleum gas (LPG) when this fuel was relatively inexpensive. Heat pump systems used in various configurations have been suggested as an option for reducing energy use and costs for greenhouse heating, particularly if off-peak electricity is used. This paper investigates the financial and environmental viability of an air-to-water heat pump system for a 4000 m2 greenhouse, located 120 km north of Melbourne, Victoria. The simulation software, TRNSYS, was used to predict the performance of the system. The heat pump system was found to have a simple payback period of approximately six years and reduce LPG consumption by 16%. Greenhouse gas emissions were 3% higher using the heat pump system, compared to the existing LPG boiler.

Blue whale habitat selection and within-season distribution in a regional upwelling system off southern Australia

Blue whales Balaenoptera musculus aggregate to feed in a regional upwelling system during November–May between the Great Australian Bight (GAB) and Bass Strait. We analysed sightings from aerial surveys over 6 upwelling seasons (2001–02 to 2006–07) to assess within-season patterns of blue whale habitat selection, distribution, and relative abundance. Habitat variables were modelled using a general linear model (GLM) that ranked sea surface temperature (SST) and sea surface chlorophyll (SSC) of equal importance, followed by depth, distance to shore, SSC gradient, distance to shelf break, and SST gradient. Further discrimination by hierarchical partitioning indicated that SST accounted for 84.4% of variation in blue whale presence explained by the model, and that probability of sightings increased with increasing SST. The large study area was resolved into 3 zones showing diversity of habitat from the shallow narrow shelf and associated surface upwelling of the central zone, to the relatively deep upper slope waters, broad shelf and variable upwelling of the western zone, and the intermediate features of the eastern zone. Density kernel estimation showed a trend in distribution from the west during November–December, spreading south-eastward along the shelf throughout the central and eastern zones during January–April, with the central zone most consistently utilised. Encounter rates in central and eastern zones peaked in February, coinciding with peak upwelling intensity and primary productivity. Blue whales avoided inshore upwelling centres, selecting SST ~1°C cooler than remotely sensed ambient SST. Whales selected significantly higher SSC in the central and eastern zones than the western zone, where relative abundance was extremely variable. Most animals departed from the feeding ground by late April.

Analysis of residues of prometryne and acetochlor in soil-water system by solid-phase extraction and gas chromatography/mass spectrometry

A highly sensitive and simple analytical method was developed for analyzing the binary mixed pesticides of prometryne and acetochlor in soil–water system by gas chromatography/mass spectrometry (GC/MS). The sample solution was first purified by C18 solid-phase extraction column, which was leached by acetone. The leachate was enriched to 1.0 mL by pressure blowing concentrator and then analyzed by GC/MS. The linear calibration curves were showed in the range of 1–15 μg/mL with a correlation coefficient of 0.9991. The average recoveries (n = 5) were between 95.3 and 115.7%, with relative standard deviations ranged from 1.71 and 7.95%. The limits of detection of Prometryne/Acetochlor were up to 0.06 and 0.17 μg/mL, respectively. This method provides a reliable approach to examine and evaluate the residues of prometryne and acetochlor in the soil–water system.

Gas flow unified measurement system for sequential measurement of gas diffusion and gas permeability of partially hydrated geosynthetic clay liners

A gas flow unified measurement system (UMS-G) for sequential measurement of gas diffusion and gas permeability of geosynthetic clay liners (GCLs) under applied stress conditions (2 to 20 kPa) is described. Measurements made with the UMS-G are compared with measurements made with conventional experimental devices and are found to give similar results. The UMS-G removes the need to rely on two separate systems and increases further the reliability of the gas properties’ measurements. This study also shows that the gas diffusion and gas permeability reduce greatly with the increase of both gravimetric water content and apparent degree of saturation. The effect of applied stress on gas diffusion and gas permeability is found to be more pronounced at gravimetric water content greater than 60%. These findings suggest that at a nominal overburden stress of 20 kPa, the GCL used in the present investigation needs to be hydrated to 134% gravimetric water content (65% apparent degree of saturation) before gas diffusion and gas permeability drop to 5.5 × 10−11 m2·s−1 and 8.0 × 10−13 m·s−1, respectively, and to an even higher gravimetric water content (apparent degrees of saturation) at lower stress.

Legal ethics is (just) normal ethics: towards a coherent system of legal ethics

The standards governing how lawyers ought to conduct themselves consist of a number disparate principles and rules, which are devoid of an overarching rationale. We argue that legal ethics is not a stand-alone social construct. Rather, it is the application of normal ethical principles so far as they relate to the law. Approached in this manner, legal ethics becomes a far more coherent and justifiable institution. In this paper we apply general moral theory to several key dilemmas facing lawyers. This results in outcomes which some may find counter-intuitive. We conclude that lawyers should not do pro bono work; that the first cab rank off the rank principle is unsound and that there is no relevant difference between expressly misleading the court and putting the other side to the proof of its case.

A low-cost 3-D laser imaging system

This paper presents the design and development of a low cost three-dimensional laser imaging system for scanning suitable surfaces. A generic, low cost, off-the-shelf laser range finder is used to obtain the primary one dimensional distance measurement. The range finder’s laser beam is reflected by a twin-axis mirror assembly driven by stepper motors providing the system with two angular degrees of freedom, allowing 3-D measurements to be determined. A camera and image processing techniques are used to determine the measured 1-D range value from the generic range-finding device. A computer program then uses the obtained data to create a 3-D point cloud. An algorithm is then used to construct a 3-D wire frame mesh representing the scanned surface. The system has an angular resolution of 1.8° and the results obtained demonstrate the system to have an accuracy of approximately ± 2cm at a scanning distance of 1.0m.

Photosynthesis of hydrogen and methane as key components for clean energy system

While researchers are trying to solve the world's energy woes, hydrogen is becoming the key component in sustainable energy systems. Hydrogen could be produced through photocatalytic water-splitting technology. It has also been found that hydrogen and methane could be produced through photocatalytic reduction of carbon dioxide with water. In this exploratory study, instead of coating catalysts on a substrate, pellet form of catalyst, which has better adsorption capacity, was used in the photo-reduction of carbon dioxide with water. In the experiment, some water was first absorbed into titanium dioxide pellets. Highly purified carbon dioxide gas was then discharged into a reactor containing these wet pellets, which were then illuminated continuously using UVC lamps. Gaseous samples accumulated in the reactor were extracted at different intervals to analyze the product yields. The results confirmed that methane and hydrogen were photosynthesized using pellet form of TiO₂ catalysts. Hydrogen was formed at a rate as high as 0.16 micromoles per hour (μmol h⁻¹). The maximum formation rate of CH₄ was achieved at 0.25 μmol h⁻¹ after 24 h of irradiation. CO was also detected.

The effectiveness of the levonorgestrel-releasing intrauterine system in menorrhagia: a systematic review

Objective: To determine whether the levonorgestrel-releasing intrauterine device (LNG-IUS), licensed at present for contraceptive use, may reduce menstrual blood loss with few side effects. If effective, surgery could be avoided with consequent resource savings. Methods: A systematic review addressing the effectiveness and cost effectiveness of the LNG-IUS for menorrhagia was undertaken. Results: Five controlled trials and five case series were found which measured menstrual blood loss. Nine studies recorded statistically significant average menstrual blood loss reductions with LNG-IUS (range 74%–97%). Another showed reduction in menstrual disturbance score. The LNG-IUS was more effective than tranexamic acid, but slightly less effective than endometrial resection at reducing menstrual blood loss. In one study, 64% of women cancelled surgery at six months, compared with 14% of control group women. In another, 82% were taken off surgical waiting lists at one year. No cost effectiveness studies were found. Discussion: Small studies of moderate quality indicate the LNG-IUS is an effective treatment for menorrhagia. Costs may be less than for tranexamic acid in primary and secondary care. Although its use may reduce surgical waiting lists, cost effectiveness assessment requires longer follow up. Conclusion: Effectiveness and cost effectiveness relative to other treatments and the effect on surgical waiting lists can only be established in larger trials measuring patient-centred outcomes in women with menorrhagia.

Is off-campus engineering study off the agenda? Professional accreditation and distance education

In engineering, distance/off-campus study is an essential element of access to education for those in remote locations and/or seeking to upgrade their qualifications via the lifelong learning route whilst employed. Internationally, engineering education accrediting bodies have moved toward outcomes-based assessment of graduate competency, but are still struggling to relinquish their historical attachment to the measurement of inputs. A genuinely outcomes-based accreditation system based on the demonstrated individual student attainment of appropriate graduate attributes (which might be delivered/gained by a range of means) offers the best way forward for an equitable, representative and socially just undergraduate engineering education system that encourages suitably qualified candidates from a range of social, employment, educational, gender, age and geographic circumstances to aspire to the professional sphere of the engineering workforce. Until outcomes-based education becomes the norm in engineering, it is likely that distance learners in engineering will face significant difficulties.

Design and analysis of hull configurations for a low-cost, autonomous underwater robot as an enabling technology for system of system applications

The objective of this research is to model and analyze candidate hull configurations for a low-cost, modular, autonomous underwater robot. As the computational power and speed of microprocessors continue to progress, we are seeing a growth in the research, development, and the utilization of underwater robots. The number of applications is broadening in the R&D and science communities, especially in the area of multiple, collaborative robots. These underwater collaborative robots represent an instantiation of a System of Systems (SoS). While each new researcher explores a unique application, control method, etc. a new underwater robot vehicle is designed, developed, and deployed. This sometimes leads to one-off designs that are costly. One limit to the wide-scale utilization of underwater robotics is the cost of development. Another limit is the ability to modify the configuration for new applications and evolving requirements. Consequently, we are exploring autonomous underwater vehicle (AUV) hull designs towards the goal of modularity, vehicle dexterity, and minimizing the cost. In our analysis, we have employed 3D solid modeling tools and finite element methods. In this paper we present our initial results and discuss ongoing work.

A low-cost intelligent gas sensing device for military applications

The field of electronic noses and gas sensing has been developing rapidly since the introduction of the silicon based sensors. There are numerous systems that can detect and indicate the level of a specific gas. We introduce here a system that is low power, small and cheap enough to be used in mobile robotic platforms while still being accurate and reliable enough for confident use. The design is based around a small circuit board mounted in a plastic case with holes to allow the sensors to protrude through the top and allow the natural flow of gas evenly across them. The main control board consists of a microcontroller PCB with surface mount components for low cost and power consumption. The firmware of the device is based on an algorithm that uses an Artificial Neural Network (ANN) which receives input from an array of gas sensors. The various sensors feeding the ANN allow the microcontroller to determine the gas type and quantity. The Testing of the device involves the training of the ANN with a number of different target gases to determine the weightings for the ANN. Accuracy and reliability of the ANN is validated through testing in a specific gas filled environment.