Peak to average power ratio analysis for LTE systems

The 3rd generation partnership project (3GPP) long term evolution (LTE) standard uses single carrier frequency division multiple access (SCFDMA) scheme for the uplink transmissions and orthogonal frequency division multiplexing access (OFDMA) in downlink. SCFDMA uses DFT spreading prior to OFDMA modulation to map the signal from each user to a subset of the available subcarriers i.e., single carrier modulation. The efficiency of a power amplifier is determined by the peak to average power ratio (PAPR) of the modulated signal. In this paper, we analyze the PAPR in 3GPP LTE systems using root raised cosine based filter. Simulation results show that the SCFDMA subcarrier mapping has a significantly lower PAPR compared to OFDMA. Also comparing the three forms of SCFDMA subcarrier mapping, results show that interleave FDMA (IFDMA) subcarrier mapping with proposed root raised cosine filter reduced PAPR significantly than localized FDMA (LFDMA) and distributed (DFDMA) mapping. This improves its radio frequency (RF) power amplifier efficiency and also the mean power output from a battery driven mobile terminal.

Low complexity MMSE based channel estimation technique for LTE OFDMA systems

Long term evolution (LTE) is designed for high speed data rate, higher spectral efficiency, and lower latency as well as high-capacity voice support. LTE uses single carrierfrequency division multiple access (SC-FDMA) scheme for the uplink transmission and orthogonal frequency division multiple access (OFDMA) in downlink. The one of the most important challenges for a terminal implementation are channel estimation (CE) and equalization. In this paper, a minimum mean square error (MMSE) based channel estimator is proposed for an OFDMA systems that can avoid the ill-conditioned least square (LS) problem with lower computational complexity. This channel estimation technique uses knowledge of channel properties to estimate the unknown channel transfer function at non-pilot subcarriers.

PAPR reduction technique for LTE OFDMA systems

Long term evolution (LTE) is the final step toward the 4th generation (4G) of radio technologies designed to increase the capacity and speed of mobile networks. LTE uses orthogonal frequency division multiple access (OFDMA) for the downlink transmission and single carrier-frequency division multiple access (SC-FDMA) for uplink. OFDMA meets the 4G requirement for spectrum flexibility and enables cost-efficient solutions for very wide carriers with high peak rates. However, the potentially large peak-to-average power ratio (PAPR) of the transmitting signals has limited its application. This high PAPR causes interference when the OFDM signals are passed through an amplifier which does not have enough linear range. In this article, we investigate a clipping based PAPR reduction method for LTE OFDMA systems. Simulation results show that the clipping method is reduced PAPR significantly which decreases as the number of clip and filtering level is increased. As a results, increase the mean transmit power, and improve the power amplifier efficiency. This comes at the outlay of complexity, efficiency as well as cost.

Channel estimation scheme for 3.9G wireless communication systems using RLS algorithm

Main challenges for a terminal implementation are efficient realization of the receiver, especially for channel estimation (CE) and equalization. In this paper, training based recursive least square (RLS) channel estimator technique is presented for a long term evolution (LTE) single carrier-frequency division multiple access (SC-FDMA) wireless communication system. This CE scheme uses adaptive RLS estimator which is able to update parameters of the estimator continuously, so that knowledge of channel and noise statistics are not required. Simulation results show that the RLS CE scheme with 500 Hz Doppler frequency has 3 dB better performances compared with 1.5 kHz Doppler frequency.

The role of the ord arid intrusion in the historical and contemporary genetic division of long-tailed finch subspecies in northern Australia

The effect of separation by biogeographic features followed by secondary contact can blur taxonomic boundaries and produce complex genetic signatures. We analyzed population structure and gene flow across the range of the long-tailed finch (Poephila acuticauda) in northern Australia (1) to test the hypothesis that Ord Arid Intrusion acted as the causative barrier that led to divergence of P. acuticauda subspecies, (2) to determine whether genetic data support the presence of a gradual cline across the range or a sudden shift, both of which have been suggested based on morphological data, and (3) to estimate levels of contemporary gene flow within this species complex. We collected samples from 302 individuals from 10 localities. Analyses of 12 microsatellite loci and sequence data from 333 base pairs of the mitochondrial control region were used to estimate population structure and gene flow, using analysis of molecular variance (AMOVA), haplotype network analysis, frequency statistics, and clustering methods. Mitochondrial sequence data indicated the presence of three genetic groups (regions) across the range of P. acuticauda. Genetic diversity was highest in the east and lowest in the west. The Ord Arid Intrusion appears to have functioned as a biogeographic barrier in the past, according to mtDNA evidence presented here and evidence from previous studies. The absence of isolation by distance between adjacent regions and the lack of population genetic structure of mtDNA within regions indicates that genetic changes across the range of P. acuticauda subspecies are characterized by discrete breaks between regions. While microsatellite data indicate a complete absence of genetic structure across this species’ range, it appears unlikely that this results from high levels of gene flow. Mitochondrial data do not support the presence of contemporary gene flow across the range of this species.