Solid state ion transport and phase behaviour in composites of N,N-methyl propylpyrrolidinium tetrafluoroborate and amorphous polyethylene oxide

The binary and ternary addition of 2 wt.% LiBF₄ and 2 wt.% amorphous polyethylene oxide (aPEO) respectively to the plastic crystal forming salt P₁₃BF₄ (where P₁₃⁺=methylpropyl pyrrolidinium cation) was investigated with specific focus on the phase behaviour and evaluation of transport characteristics. Differential scanning calorimetry (DSC), optical thermomicroscopy, solid state nuclear magnetic resonance (NMR), and AC impedance spectroscopy were used to develop an understanding of the conduction process in the pure and mixed systems. The morphology of the ternary compound appeared as hexagonal spherulites upon solidification. Multinuclear NMR Pulsed Field Gradient measurements (¹H,¹⁹F,⁷Li) to probe both cation and anion diffusion coefficients are reported. The anion is shown to be the most diffusive (at 320 K:¹⁹F=2.5×10⁻¹¹ m² s⁻¹; 1H: 1.8×10⁻¹¹ m² s⁻¹; ⁷Li: 1.1×10⁻¹¹ m² s⁻¹) in the ternary compound, with enhanced conductivity (2.7×10⁻⁵ S cm⁻¹ at 310 K) just below the melt.

Transport and phase dynamics of poly(vinyl pyrrolidone) doped plastically crystalline N-methyl-N-propylpyrrolidinium tetrafluoroborate

The plastic crystal phase forming N-methyl-N-propylpyrrolidinium tetrafluoroborate organic salt (P₁₃BF₄) was combined with 2, 5 and 10 wt.% poly(vinyl pyrrolidone) (PVP). The ternary 2 wt.% PVP/2 wt.% LiBF₄/P₁₃BF₄ was also investigated. Thermal analysis, conductivity, optical thermomicroscopy, and Nuclear Magnetic Resonance (¹¹B, ¹⁹F, ¹H, ⁷Li) were used to probe the fundamental transport processes. Both the onset of phase I and the final melting temperature were reduced with increasing additions of PVP. Conductivity in phase I was 2.6 × 10^{− 4} S cm^{− 1} 5.2 × 10^{− 4} S cm^{− 1} 1.1 × 10^{− 4} S cm^{− 1} and 3.9 × 10− 5 S cm− 1 for 0, 2, 5 and 10 wt.%PVP/P₁₃BF₄, respectively. Doping with 2 wt.% LiBF₄ increased the conductivity by up to an order of magnitude in phase II. Further additions of 2 wt.% PVP slightly reduced the conductivity, although it remained higher than for pure P₁₃BF₄.

Effect of sorghum flour addition on resistant starch content, phenolic profile and antioxidant capacity of durum wheat pasta

Foods containing elevated levels of health functional components such as resistant starch and polyphenolic antioxidants may have beneficial effects on human health. Pasta incorporating either red sorghum flour (RSF) or white sorghum flour (WSF) each at 20%, 30% and 40% substitution of durum wheat semolina (DWS) was prepared and compared to pasta made from 100% DWS (control) for content of starch fractions, phenolic profile and antioxidant capacity, before and after cooking. Total, digestible and resistant starch contents were determined by the AOAC method; individual phenolic acids and anthocyanins by reverse phase-HPLC analysis; total phenolic content by the Folin–Ciocalteu method and antioxidant capacity by the ABTS assay. The addition of both RSF and WSF increased the resistant starch content, bound phenolic acids, total phenolic content and antioxidant capacity at all incorporation levels compared to the control pasta; while free phenolic acids and anthocyanins were higher in the RSF-containing pasta only. Cooking did not change the resistant starch content of any of the pasta formulations. Cooking did however decrease the free phenolic acids, anthocyanins, total phenolic content and antioxidant capacity and increased the bound phenolic acids of the sorghum-containing pastas. The study suggests that these sorghum flours may be very useful for the preparation of pasta with increased levels of resistant starch and polyphenolic antioxidants.

Dynamic nuclear polarisation enhanced (14)N overtone MAS NMR spectroscopy.

Dynamic nuclear polarisation (DNP) has been used to obtain magic angle spinning (14)N(OT) (nitrogen-14 overtone) solid-state NMR spectra from several model amino acids, with both direct and indirect observation of the (14)N(OT) signal. The crystalline solids were impregnated with biradical solutions of organic liquids that do not dissolve the crystalline phase. The bulk phase was then polarized via(1)H spin diffusion from the highly-polarized surface (1)H nuclei, resulting in (1)H DNP signal enhancements of around two orders of magnitude. Cross polarisation from (1)H nuclei directly to the (14)N overtone transition is demonstrated under magic angle spinning, using a standard pulse sequence with a relatively short contact time (on the order of 100 μs). This method can be used to acquire (14)N overtone MAS powder patterns that match closely with simulated line shapes, allowing isotropic chemical shifts and quadrupolar parameters to be measured. DNP enhancement also allows the rapid acquisition of 2D (14)N(OT) heteronuclear correlation spectra from natural abundance powder samples. (1)H-(14)N(OT) HETCOR and (13)C-(14)N(OT) HMQC pulse sequences were used to observe all single-bond H-N and C-N correlations in histidine hydrochloride monohydrate, with the spectra obtained in a matter of hours. Due to the high natural abundance of the (14)N isotope (99.6%) and the advantages of observing the overtone transition, these methods provide an attractive route to the observation of C-N correlations from samples at natural isotopic abundance and enable the high resolution measurement of (14)N chemical shifts and quadrupolar interaction parameters.

New insights into the thermal behaviour of organic ionic plastic crystals: magnetic resonance imaging of polycrystalline morphology alterations induced by solid-solid phase transitions

Organic ionic plastic crystals (OIPCs) show strong potential as solid-state electrolytes for lithium battery applications, demonstrating promising electrochemical performance and eliminating the need for a volatile and flammable liquid electrolyte. The ionic conductivity (σ) in these systems has recently been shown to depend strongly on polycrystalline morphology, which is largely determined by the sample's thermal history. [K. Romanenko et al., J. Am. Chem. Soc., 2014, 136, 15638]. Tailoring this morphology could lead to conductivities sufficiently high for battery applications, so a more complete understanding of how phenomena such as solid-solid phase transitions can affect the sample morphology is of significant interest. Anisotropic relaxation of nuclear spin magnetisation provides a new MRI based approach for studies of polycrystalline materials at both a macroscopic and molecular level. In this contribution, morphology alterations induced by solid-solid phase transitions in triisobutyl(methyl)phosphonium bis(fluorosulfonyl)imide (P1444FSI) and diethyl(methyl)(isobutyl)phosphonium hexafluorophosphate (P1224PF6) are examined using magnetic resonance imaging (MRI), alongside nuclear magnetic resonance (NMR) spectroscopy, diffusion measurements and conductivity data. These observations are linked to molecular dynamics and structural behaviour crucial for the conductive properties of OIPCs. A distinct correlation is established between the conductivity at a given temperature, σ(T), and the intensity of the narrow NMR signal that is attributed to a mobile fraction, fm(T), of ions in the OIPC. To explain these findings we propose an analogy with the well-studied relationship between permeability (k) and void fraction (θ) in porous media, with k(θ) commonly quantified by a power-law dependence that can also be employed to describe σ(fm).