Local structure and photocatalytic property of mechanochemical synthesized ZnO doped with transition metal oxides

Co and Mn doped ZnO nanoparticles with up to 5 at% doping level were prepared using a mechanochemical method. The location of dopant ions and the effect of doping on the photocatalytic activity were investigated by Synchrotron X-ray Absorption (XAS) Spectroscopy and photo-degradation of Rhodamine B solution. The XAS results showed that the Co ions substituted the Zn ions in the ZnO wurtzite phase structure. It was revealed that Co-doping strongly reduced the photocatalytic activity, while Mn-doping increased the photocatalytic activity at low doping levels but reduced the activity at high doping levels.

Photocatalytic activity of manganese-doped ZnO nanocrystalline powders

ZnO nanocrystalline powders doped with up to 5 at% manganese were synthesized and their photocatalytic activity was studied. Doped ZnO powders were prepared using a sol-gel process. The crystal structure and grain size of the particles were characterized by X-ray diffractometry and optical properties were studied using UV-Vis spectroscopy. The photoactivity of undoped and doped ZnO nanocrystalline powders was evaluated by monitoring the photo-bleaching of the aqueous solutions of Rhodamine B dye in the presence of ZnO under simulated sunlight. The results showed that up to 3 at% manganese were successfully doped into the nanocrystalline ZnO and that manganese-doping reduced the photocatalytic activity of ZnO.

Mechanochemical synthesis of nanocrystalline SnO2-ZnO photocatalysts

Mechanochemical processing of anhydrous chloride precursors with Na₂CO₃ has been investigated as a means of manufacturing nanocrystalline SnO₂ doped ZnO photocatalysts. High-energy milling and heat-treatment of a 0.1SnCl₂+0.9ZnCl₂+Na₂CO₃+4NaCl reactant mixture was found to result in the formation of a composite powder consisting of oxide grains embedded within a matrix of NaCl. Subsequent washing with deionized water resulted in removal of the NaCl matrix phase and partial hydration of the oxide reaction product with the consequent formation of ZnSn(OH)₆. The extent of this hydration reaction was found to decrease in a linear fashion with the temperature of the post-milling heat-treatment over the range of 400–700 °C. For a heat-treatment temperature of 700 °C, the SnO₂ doped ZnO powder was found to exhibit significantly higher photocatalytic activity than either single-phase SnO₂ or ZnO powders that were synthesized using similar processing conditions. The heightened photocatalytic activity of the SnO₂ doped ZnO was attributed to its higher specific surface area and the enhanced charge separation arising from the coupling of ZnO with SnO₂.

Na+-doped zinc oxide nanofiber membrane for high speed humidity sensor

A novel sensitive humidity nanosensor based on Na1-doped ZnO nanofiber membrane has been prepared via electrospinning and calcination. The product was characterized by scanning electron microscopy and X-ray diffraction. During the whole relative humidity (11%–95%) measurement, the response and recovery time is about 3 and 6 s, respectively, with good linearity, and reproducibility. These remarkable and sensitive sensing performances make our product a good candidate in fabricating humidity sensors.

Graphene quantum dots directly generated from graphite via magnetron sputtering and the application in thin-film transistors

This work presents a novel method to prepare graphene quantum dots (GQDs) directly from graphite. A composite film of GQDs and ZnO was first prepared using the composite target of graphite and ZnO via magnetron sputtering, followed with hydrochloric acid treatment and dialysis. Morphology and optical properties of the GQDs were investigated using a number of techniques. The as-prepared GQDs are 4-12 nm in size and 1-2 nm in thickness. They also exhibited typical excitation-dependent properties as expected in carbon-based quantum dots. To demonstrate the potential applications of GQDs in electronic devices, pure ZnO and GQD-ZnO thin-film transistors (TFTs) using ZrOx dielectric were fabricated and examined. The ZnO TFT incorporating the GQDs exhibited enhanced performance: an on/off current ratio of 1.7 × 107, a field-effect mobility of 17.7 cm2/Vs, a subthreshold swing voltage of 90 mV/decade. This paper provides an efficient, reproducible and eco-friendly approach for the preparation of monodisperse GQDs directly from graphite. Our results suggest that GQDs fabricated using magnetron sputtering method may envision promising applications in electronic devices.

Local structure and photocatalytic property of sol-gel synthesized ZnO doped with transition metal oxides

ZnO nanoparticles doped with up to 5 at% of Co and Mn were prepared using a co-precipitation method. The location of dopant ions and the effect of doping on the photocatalytic activity were investigated. The crystal structure of nanoparticles and local atomic arrangements around dopant ions were analyzed by X-ray absorption spectroscopy. The results showed that the Co ions substituted the Zn ions in the ZnO wurtzite phase structure and induced lattice shrinkage, while Mn ions were not completely incorporated in the crystal lattice. The photocatalytic activity under simulated sunlight was characterized by the decomposition of Rhodamine B dye molecules. It was revealed that Co-doping strongly reduced the photocatalytic activity but Mn-doping showed a weaker effect on the reduction of the photoactivity.

Effects of undoped and manganese-doped zinc oxide nanoparticles on the colour fading of dyed polyester fabrics

This paper describes the effects of applying coatings of an acrylic polymer containing nanoparticles of zinc oxide (ZnO) on the fading rate in artificial sunlight of polyester fabrics dyed with disperse dyes containing anthraquinone and benzopyran chromophores. Factors affecting the transparency and UV absorbance of the coatings are discussed. Removing the UV component of sunlight with ZnO nanoparticles markedly decreased the fading rate of the dyes, provided the polymer/ZnO film was not in direct contact with the fabric. When the treatment was applied directly to the fabrics, however, the protection against colour fading was different for the two dyes studied. Whereas the rate of colour fading of a benzopyran dye, of relatively low lightfastness, was decreased by the polymer-ZnO film, the treatment increased the fading rate of the dye of higher lightfastness, based on anthraquinone. This effect has been attributed to the generation of reactive oxygen species (ROS) when ZnO is exposed to UV. The effect of decreasing the photoactivity of ZnO by doping with manganese has been examined. For the benzopyran dye, the UV protection was greatly increased, whereas a much smaller improvement was found for the anthraquinone-based dye.

ZnO flower/PEDOT:PSS thermoelectric composite films

ZnO flower/poly(3,4-ethylenedioxythiophene):poly(4-styrenesulfonate) (PEDOT:PSS) composite films were prepared by spin-coating dimethyl sulfoxide doped PEDOT:PSS on the ZnO flowers grown on glass substrate. The thermoelectric properties of the ZnO flower/PEDOT:PSS composite films were measured at room temperature. As the number of spin coated PEDOT:PSS layer increased, the electrical conductivity of the ZnO flower/PEDOT:PSS composite films increases dramatically from 1-layer (177.3 S/m) to 4-layer (910.4 S/m), however, all the composite films have almost the same Seebeck coefficient (~20–22 μV/K). A maximum power factor of ~0.4 μWm−1 K−2 at room temperature was obtained from the composite film with 4-layer PEDOT:PSS.