Electrowetting measurements with mercury showing mercury/mica interfacial energy depends on charging

We demonstrate that the interfacial energy between mercury and mica is a function of charge on the mercury surface, decreasing with increasing positive charge. The contact angle of mercury on mica has been measured as a function of potential applied to the mercury, which forms the working electrode of a cell containing either KC1 or NaF electrolyte solution. At high negative applied potentials, a stable aqueous film exists between the mercury and mica surface. As potential is made less negative, the film collapses and mercury partial1 wets the mica at a critical potential, close to the electrocapillary maximum. Upon increasing the potential further (making the Hg surface more and more positive), the contact angle measured within the mercury continually decreases. Electrowetting with mercury is not unexpected since its interfacial tension with the aqueous phase is known to be a function of applied potential. However, the observed decrease goes against the trend expected from the Young equation if only this effect is considered. To explain the data we must allow the mercury/mica interfacial tension also to vary with applied potential. This variation indicates that the mercury surface is positively charged by contact with mica, consistent with known contact electrification between these two materials. The inherent charges at the mercury interfaces with mica and electrolyte solution result in contact angle changes of some tens of degrees with a change in applied potential of half a volt orders of magnitude less than the potentials required to effect comparable changes in other electrowetting systems.

Measurement of aqueous film thickness between charged mercury and mica surfaces : a direct experimental probe of the Poisson-Boltzmann distribution

A stable aqueous electrolyte film is formed between a mercury drop and a flat mica surface due to electrical double-layer repulsion when a negative potential is applied to the mercury. Film thickness has been measured as a function of applied potential while keeping the film pressure constant. By making measurements in this way, it is possible to map the data directly according to the Poisson-Boltzmann equation. An excellent fit to the data is obtained, providing direct evidence for this classical equation and its use as the basis of the Gouy-Chapman model of the diffuse double layer in electrolyte solutions.

Structural characterization of rare intramolecularly (1,4-Te· · ·N) bonded diorganotellurides and their monomeric complexes with mercury(II) halides: metal assisted C-H· · ·X (Hg) interactions leading to supramolecular architecture

Monomeric tellurides 4-RC₆H₄(SB)Te [SB = 2-(4,4'-N0₂C₆H₄CH=NC₆H₃-Me); R = H, 1a; Me,1b; OMe, 1c], which incidentally represent the first example of a telluride with 1,4-Te···N intramolecular interaction, have been prepared and characterized by solution and solid-state ¹²⁵Te NMR, ¹³C NMR and X-ray crystallography. Interplay of weak C-H···O and C-H-··π{ interactions in the crystal lattice of 1b and1c are responsible for the formation of supramolecular motifs. These tellurides undergo expected oxidative addition reactions with halogens and interhalogens and also interact coordinatively with mercury(II) halides to give 1:2 complexes, HgX₂[4-RC₆H₄(SB)Te]₂ (X = CI, R = H, 2a; Me, 2b; OMe, 2c and X = Br, R = H, 3a; Me, 3b; and OMe, 3c) with no sign of Te-C bond cleavage, as has been reported for some 1,5-Te·· ·N(O) intramolecularly bonded tellurides. The complexes 2a and 3c are the first structurally characterized monomeric 1:2 adducts of mercury(II) halides with Te ligands. The 1,4-Te···N intramolecular interactions in the solid-state are retained in the complexes highlighting simultaneously the Lewis acid and base character of the Te(lI) atom. Packing of molecules in the crystal lattice of 2a
and 3c reveals that non-covalent C-H· . ·Cl/Br interactions involving metal-bound halogen atoms possess significant directionality and in
combination with coordinative covalent interactions may be of potential use in creating inorganic supramolecular synthons.

Cadmium, copper, mercury, and zinc concentrations in tissues of the King Crab (Pseudocarcinus gigas) from southeast Australian waters

The concentrations of cadmium, copper, mercury, and zinc were determined in muscle (body, claw, and leg), hepatopancreas, and gill tissues of Pseudocarcinus gigas, an exceptionally large, long-lived, and deep-dwelling crab species. The accumulation patterns observed are discussed in terms of both intra- and interspecies variations, with particular attention to the possible consequences of the extreme size and depth range of P. gigas. Metal concentrations did not depend significantly on sex of the crab. Significant differences between tissues were detected for all metals, and the distribution of metal between the tissues was different for each metal. Significant correlations were found between metal concentrations in the various tissues and crab size, and these are discussed and rationalised. The concentrations of mercury and zinc in muscle tissue increased with crab size and were high compared to other crab species. The concentrations of cadmium and copper present in edible tissues were not especially high compared to other crab species, but the concentration of cadmium in the hepatopancreas is of dietary concern.

Trace metal concentrations in edible tissue of snapper, flathead, lobster, and abalone from coastal waters of Victoria, Australia

The concentrations of heavy metals in the edible tissue of commonly fished species of the Victorian coast of Australia are reported. The metals studied were As, Cd, Cu, Hg, Pb, Se, and Zn and the fish species examined were snapper (Pagruss auratus), flathead (Platycephalus bassenssis and Neoplatycephalus richardsoni), lobster (Jasus edwardsii), and abalone (Haliotis rubra). None of the fish species studied had average concentrations exceeding the maximum levels specified for As, Cd, Hg, and Pb by the Food Standards Australia and New Zealand Food Standards code. Additionally, the concentrations of Cu, Se, and Zn were close to or below the median values generally expected in these species. Essential trace elements Se and Zn were found to be well regulated by all fish species. Although also essential, Cu was not so well regulated, especially in abalone. Nonessential metals As, Cd, and Hg are not regulated in the studied fish and their concentrations in the fish tissue are dependent on size and fishing zone. Metal concentrations were not largely affected by sex. Surprisingly, the concentrations of metals in fish in Port Phillip Bay, a zone, which includes the major cities of Melbourne and Geelong and is known to have high concentrations of metals in the water and sediment, were not consistently higher than those in other less-populated fishing zones.

Electrochemical and spectroscopic investigation of redox processes for labile metal dithiocarbamate complexes

Although metal dithiocarbamate complexes have been studied extensively, there is in sate cases a distinct lack of data concerning redox properties and the products thereof. This is particularly true for complexes of the late transition and main group metals which are important in agriculture, industry, and chemical analysis. Hence, using electrochemical techniques, the redox behaviour of dithiocarbamate complexes of zinc, cadmium, mercury, lead, and tellurium has been examined. The products of oxidation and reduction have also been characterized by spectroscopic techniques (NMR, EPR, UV, and IR), mass spectrometry, conductivity, and Where possible, crystallographic study of an isolated compound. The species studied were without exception labile with the result that electrochemistry at mercury electrodes was influenced by the great stability of the mercury dithiocarbamate (Hg(RR’dtc) 2) complexes. Investigation of the latter showed that oxidative processes in the presence of mercury led to a new class of expounds: polymeric mercury dithiocarbamato cations. Oily one of these could be isolated as a solid, with the formula [Hg5(RR’dtc) 8](C104)2 For R=R’=ethyl the crystal structure was determined. For other metal dithiocarbamates the electrochemical behaviour at mercury electrodes in many ways paralleled that of the mercury analogues. Thus oxidative processes involved oxidation of electrode mercury to form mixed metal cationic species. Polarographic reduction led to the metal amalgam, usually via formation of mercury dithiocarbamate. Electrochemical studies at inert electrode materials such as platinum yielded distinctly different responses, with both oxidation and reduction being more difficult. Oxidation products at platinum electrodes gave identical polarographic responses to those firm mercury electrodes due to rapid interaction of the former with electrode mercury. The results are in sharp contrast to much of the previous work on transition metal dithiocarbamates for which electrochemical redox processes are often metal based arid not explicated by interaction with the electrode material.

Simple and signal-off electrochemical biosensor for mercury(II) based on thymine-mercury-thymine hybridization directly on graphene

Abstract A simple, signal-off and reusable electrochemical biosensor was developed for sensitive and selective detection of mercury(II) based on thymine-mercury(II)-thymine (T-Hg²⁺-T) complex and the remarkable difference in the affinity of graphene with double strand DNA (ds-DNA) and single strand DNA (ss-DNA). Our system was composed of ferrocene-tagged probe DNA and graphene. Due to the noncovalent assembly, the ferrocene-tagged probe ss-DNA was immobilized on the surface of graphene nanosheets directly and employed to amplify the electrochemical signal. In the presence of Hg²⁺, the ferrocene-labeled T-rich DNA probe hybridized with target probe to form ds-DNA via the Hg²⁺-mediated coordination of T-Hg²⁺-T base pairs. As a result, the duplex DNA complex kept away from the graphene surface due to the weak affinity of graphene and ds-DNA, and the redox current decreased substantially. Meanwhile, the graphene decorated GCE surface was released for the reusability. Under the optimal conditions, the proposed sensor showed a linear concentration range from 25 pM to 10 μM with a detection limit of 5 pM for Hg²⁺ detection. The strategy afforded exquisite selectivity for Hg²⁺ against other metal ions in real environmental samples.

Mercury vapor sorption and amalgamation with a thin gold film

Understanding the amalgamation mechanisms between mercury and gold is of fundamental interest and importance to many mercury sensing applications. However, there is only limited and piecemeal discussion in the literature of the mechanisms by which Au-Hg amalgams are formed on thin Au films. Here, we present a comprehensive description of a series of morphological changes occurring in a thin polycrystalline Au film during Au-Hg amalgamation investigated by scanning electron microscopy (SEM), energy-dispersive X-ray spectroscopy (EDX), and atomic force microscopy (AFM). These microscopic investigations enable us to offer a coherent explanation for the features and the mechanisms of amalgamation of Hg with Au in the film. We also use an optical technique (fringes of equal chromatic order, FECO) to observe changes in optical thickness and reflectivity of the film. Amalgamation reactions in the film render it inhomogeneous, thus making optical techniques unsuitable as a method for quantitative monitoring of Hg vapor using Au films of this type.