Calcium chemistry of Blue Lake, Mt Gambier, Australia, and relevance to remarkable seasonal colour changes

Calcium speciation and other water quality variables in the Blue Lake, Mt Gambier, Australia, were monitored between August 1999 and August 2000 in order to test previously proposed mechanisms for the seasonal colour changes of this lake. The concentration of calcite was found to be highest in winter when the lake appears grey, and lowest in summer when the lake appears blue. A potential component of the colour change mechanism is therefore identified in which the lake is grey in winter because of non-selective scattering of light by calcite particles, and blue in summer because of the absence of absorbing or scattering impurities.

One-step synthesis of graphene quantum dots from defective CVD graphene and their application in IGZO UV thin film phototransistor

Chemical vapor deposition (CVD) has recently been considered as the most reliable method to prepare high-quality monolayer graphene films, yet the as-grown graphene usually contains wrinkles and cracks or suffers from discontinuity. These defects can easily result in the shredding of large-sized graphene into small pieces even under a gentle disturbance. Herein, this work presents a cost-effective new method to produce high-quality GQDs by vigorous sonication of defective CVD graphene. The prepared GQDs can be easily and stably dispersed in organic solvents. Morphology and optical properties of the GQDs are investigated using a number of techniques. And we observed the as-prepared GQDs are highly homogeneous, mostly consisted of single-layered graphene, roughly round shapes less than 8 nm in a diameter, and exhibited a strong blue luminescence. Impressively, it is also confirmed that the as-obtained GQDs can act as a promising light absorption material for phototransistor with a hybrid film of GQDs and indium gallium zinc oxide (IGZO) as the channel layer. The GQD/IGZO phototransistor exhibited an appreciated photocurrent, which is 10 times larger than that of the IGZO one when exposed to 270 nm light.

Light emission and excitonic effect of boron nitride nanotubes observed by photoluminescent spectra

Photoluminescent (PL) and optical absorption spectra of high-yield multi-wall BN nanotubes (BNNTs) were systematically investigated at room temperature in comparison with commercial hexagonal BN (h-BN) powder. The direct band gap of the BNNTs was determined to be 5.75 eV, just slightly narrower than that of h-BN powder (5.82 eV). Two Frenkel excitons with the binding energy of 1.27 and 1.35 eV were also determined. However, they were not a distinctive characteristic of the BNNTs as reported previously. Observed broad UV–visible–NIR light emission demonstrates the potential of the BNNTs as a nano light source.

UV absorption property of bamboo

This article describes ultra violet (UV) light shielding behaviour of Australian grown bamboo (Phyllostachys pubescens). Optical reflectance showed that untreated bamboo plant has UV absorption properties. To reveal the origin of the UV absorption property, its chemical components were extracted using several polar and non-polar solvents. The extracts in most of the polar and non-polar solvents showed UV absorption property. Protic polar solvents showed better ability to extract UV absorbing chemicals than aprotic and non-polar solvents, except hexane. The chemical components of bamboo were analysed by FT-IR spectroscopy and the findings were correlated with the UV absorbance characteristics. The results confirmed that the UV absorption ability of bamboo originates from nothing but lignin. It is thus indicated that the conventional methods to manufacture bamboo fibres, such as complete degumming or viscose methods, that involve the removal of lignin, cannot retain the unique UV absorption property of bamboo plant in bamboo fibres.

Fabrication and visible-light photocatalytic behavior of perovskite praseodymium ferrite porous nanotubes

Perovskite praseodymium ferrite (PrFeO3) porous nanotubes are prepared by electrospinning of the precursor solution into nanofibers, subsequently by annealing the precursor fibers at a low temperature (e.g. 40 °C) and finally by calcination at a high temperature. The low temperature annealing treatment is found to play a key role in the formation of porous nanotube. The porous tubes show a perovskite-type PrFeO3 crystal characteristic with high optical absorption in the UV-visible region and an energy band gap of 1.97 eV. When compared with PrFeO3 porous nanofibers and PrFeO3 particles, the PrFeO3 porous nanotubes show better visible-light photo-catalytic ability to degrade Rhodamine B in aqueous phase because of the increased surface area and more active catalytic sites on the inner walls and outer surfaces.

Plasmon-enhanced two-photon-induced isomerization for highly-localized light-based actuation of inorganic/organic interfaces

Two-photon initiated photo-isomerization of an azobenzene moiety adsorbed on silver nanoparticles (Ag NPs) is demonstrated. The azobenzene is linked to a materials-binding peptide that brings it into intimate contact with the Ag NP surface, producing a dramatic enhancement of its two-photon absorbance. An integrated modeling approach, combining advanced conformational sampling with Quantum Mechanics/Capacitance Molecular Mechanics and response theory, shows that charge transfer and image charges in the Ag NP generate local fields that enhance two-photon absorption of the cis isomer, but not the trans isomer, of adsorbed molecules. Moreover, dramatic local field enhancement is expected near the localized surface plasmon resonance (LSPR) wavelength, and the LSPR band of the Ag NPs overlaps the azobenzene absorbance that triggers cis to trans switching. As a result, the Ag NPs enable two-photon initiated cis to trans isomerization, but not trans to cis isomerization. Confocal anti-Stokes fluorescence imaging shows that this effect is not due to local heating, while the quadratic dependence of switching rate on laser intensity is consistent with a two-photon process. Highly localized two-photon initiated switching could allow local manipulation near the focal point of a laser within a 3D nanoparticle assembly, which cannot be achieved using linear optical processes.