A low-cost 3-D laser imaging system

This paper presents the design and development of a low cost three-dimensional laser imaging system for scanning suitable surfaces. A generic, low cost, off-the-shelf laser range finder is used to obtain the primary one dimensional distance measurement. The range finder’s laser beam is reflected by a twin-axis mirror assembly driven by stepper motors providing the system with two angular degrees of freedom, allowing 3-D measurements to be determined. A camera and image processing techniques are used to determine the measured 1-D range value from the generic range-finding device. A computer program then uses the obtained data to create a 3-D point cloud. An algorithm is then used to construct a 3-D wire frame mesh representing the scanned surface. The system has an angular resolution of 1.8° and the results obtained demonstrate the system to have an accuracy of approximately ± 2cm at a scanning distance of 1.0m.

Local laser heat treatment in dual-phase steels

This research deals with processes leading to local strengthening effects in hot-rolled dual-phase (DP) steels. For this purpose, a method was investigated to achieve local strengthening, namely, local laser heat treatment (LHT). DP sheet steels were globally and homogenously deformed with different degrees of prestrains by cold rolling and subsequently locally heat treated by laser. Following this treatment with selected parameters, the microstructure of the surface and cross section of the heat-treated area as well as the mechanical properties were evaluated by light optical microscopy (LOM), scanning electron microscopy (SEM), as well as transmission electron microscopy (TEM), hardness measurement, and tensile testing. It can be stated that with partial heat treatment, local high strengthening can be produced. At lower heat treating temperatures, this effect could be attributed to bake hardening (BH). Increasing the prestrain as well as temperature results in improving the local properties. With increased heat treating temperature, the initial microstructure near the surface is affected. Partial strengthening of DP steels by laser can open up new fields of application for locally using the strengthening effect to only influence relevant areas of interest, thus providing the potential for saving energy and designed the component's behavior.

An improved static model for tool deflection in machining of Ti–6Al–4V acetabular shell produced by selective laser melting

Tool deflection during milling operation leads to dimensional error, decreasing surface quality and increasing rejection rate. In this study, tool deflection during the milling of the inner surfaces of Ti–6Al–4V prosthetic acetabular shell produced by selective laser melting (SLM) was modelled. The first purpose of this research is to provide a general static cutting tool deflection model for ball nose cutters where deviation of machine components and tool holder are so small as to be considered negligible. This is because the values of machine component and tool holder deflection were lower than standard tolerances (10 μm) and found to be lower than 1/15 of tool deflection. The second and third objectives of this work involve calculating contact surfaces by determining workpiece and tool geometry and choosing second moment of inertia using a novel cross section method (CSM). Static models for three quasi-analytical methods (QAM) that are simple cantilever beam model (SCBM), two-section model (TWSM) and our three section model (THSM) are presented. THSM showed high accuracy which was validated by 3D finite element method (FEM3D) and experimental measurements. The accuracy of tool deflection calculation using THSM by computing, shank, flute and ball head deflection and also utilizing CSM to determine second moment of inertia showed notable improvements.