Ion conductivity in amorphous polymer/salt mixtures

Amorphous polymer/salt mixtures based on polyvinyl alcohol and poly(hydroxyethylacrylate) and poly(hydroxyethylmethacrylate) are described. The polyvinylalcohol materials have been prepared by a solvent free hot pressing technique as well as the traditional solvent casting method. The hot pressing technique allows the production of samples which are genuinely free of solvents and thereby has allowed an assessment in this work of the effect of residual solvent on conductivity. The acrylate materials were prepared by direct polymerization of monomer/salt mixtures, thus avoiding the need for solvents. These materials have glass transitions around or well above room temperature, but nonetheless have conductivities as high as 10⁻⁷ S/cm at room temperature. The temperature and composition dependence of conductivity are also presented.

Surprising effect of nanoparticle inclusion on ion conductivity in a lithium doped organic ionic plastic crystal

Doping lithium bis(trifluoromethanesulfonyl)amide (Li[NTf₂]) into the N-ethyl,N′-methylpyrrolidinium bis(trifluoromethanesulfonyl)amide ([C₂mpyr][NTf₂]) plastic crystal material has previously indicated order of magnitude enhancements in ion transport and conductivity over pure [C₂mpyr][NTf₂]. Recently, conductivity enhancements in this ionic plastic crystal induced by SiO₂ nanoparticles have also been reported. In this work the inclusion of SiO₂ nanoparticles in Li ion doped [C₂mpyr][NTf₂] has been investigated over a wide temperature range by differential scanning calorimetry (DSC), impedance spectroscopy, positron annihilation lifetime spectroscopy (PALS), Raman spectroscopy, NMR spectroscopy and scanning electron microscopy (SEM). Solid state ¹H NMR indicates that the addition of the nanoparticles increases the mobility of the [C₂mpyr] cation and positron lifetime spectroscopy (PALS) measurements indicate an increase in mean defect size and defect concentration as a result of nanoparticle inclusion, especially with 10 wt% SiO₂. Thus, the substantial drop in ion conductivity observed for this doped nanocomposite material was surprising. This decrease is most likely due to the decrease in mobility of the [NTf₂] anion, possibly by its adsorption at the SiO₂/grain boundary interface and concomitant decrease in mobility of the Li ion.

High conductivity molten salts based on the imide ion

The bis(trifluoromethanesulfonyl)imide ion has recently been used in its lithium salt as a useful ion in solid polymer electrolytes because of the reduced degree of ion interaction its diffuse charge generates. In this work we have synthesised a number of novel salts based on the ammonium and pyrrolidinium cations of this anion. The salts all show reduced melting points compared with analogous halide salts. In some cases they are molten at room temperature. This latter group of salts have been characterized with respect to their properties as ionic liquids; the highest room temperature conductivity 2 mS cm⁻¹ being exhibited by methyl butyl pyrrolidinium imide. Many of the salts are glass forming, exhibiting glass transition temperatures in the region of −90°C.

Ionic conductivity in poly(diethylene glycol-carbonate)/sodium triflate complexes

New polymer electrolytes were synthesized and characterized based on a new polymer host. The motivation was to produce a host polymer with a high dielectric constant which should reduce ion clustering with an attendant increased conductivity. The new polymer host, poly(diethylene glycol carbonate) and its sodium triflate complexes were characterized by thermal analysis and AC impedance measurements. The polycarbonate backbone appears less flexible than the polyether hosts as evidenced by the higher glass transition temperatures. The conductivity for the sodium triflate complexes was measured as ~ 10⁻⁵ S cm⁻¹ at 55 °C and the dielectric constant of the host polymer was found to be 3.6 at 3 GHz. The low conductivity is attributed to rigidity of the polycarbonate.

Structural studies of ambient temperature plastic crystal ion conductors

A number of novel organic ionic compounds based on the pyrrolidinium cation are described which have been found to be ion conductors in their solid states around room temperature. The properties of the compounds are consistent with their exhibiting plastic crystal phases. In order to understand some of the molecular origins of the plastic crystal behaviour and the ion conductivity that it promotes, a number of related compounds based on the imidazolium and ammonium cations are also described which have structural elements in common with the pyrrolidinium cation, but which do not show the plastic behaviour. It is found therefore that the nature of the cation is quite critical to the development of this behaviour. The alkyl methyl pyrrolidinium cation is found to produce plastic crystal phases when the alkyl chains are short, thereby preserving the ability of the cation to rotate with minimal steric hindrance. The ammonium and imidazolium cations of comparable size and structure are less able to produce these plastic phases, in many cases because the low temperature phase proceeds to melt rather than forming a stable rotator phase.

Pyrrolidinium imides : a new family of molten salts and conductive plastic crystal phases

A new family of molten salts is reported, based on the N-alkyl, N-alkyl pyrrolidinium cation and the bis(trifluoromethane sulfonyl)imide anion. Some of the members of the family are molten at room temperature, while the smaller and more symmetrical members have melting points around 100 °C. Of the room-temperature molten salt examples, the methyl butyl derivative exhibits the highest conductivity; at 2 × 10^-3 S/cm this is the highest molten salt conductivity observed to date at room temperature among the ammonium salts. This highly conductive behavior is rationalized in terms of the role of cation planarity. The salts also exhibit multiple crystalline phase behavior below their melting points and exhibit significant conductivity in at least their higher temperature crystal phase. For example, the methyl propyl derivative (mp = 12 °C) shows ion conductivity of 1 × 10^-6 S/cm at 0 °C in its higher temperature crystalline phase.

Ion association and molar conductivity in polyether electrolytes

The ion association behaviour observed in our earlier studies of a polyether electrolyte system at elevated temperatures, was reminiscent of the molar conductivity behaviour typical of low dielectric constant systems. Further investigation of this relationship has led to some suggestions about the types of ionic species present in the polymer electrolyte systems. FT-IR spectroscopy has been used in this work to contrast ion association in an amorphous polyether electrolyte with two liquid electrolytes, N,N-dimethyl-formamide and tetraethylenegylcol dimethylether, containing lithium trifluoromethan sulfonate.

Oligomethylene-bridged dinuclear triorganotin triflates and diphenylphosphinates. Ion pairing in the solid state and electrolytic dissociation in solution of [Ph2Sn(CH2)nSnPh2X](O3SCF3) (X = OH, O2PPh2; n = 1-3)

The condensation of [Ph₂(OH)Sn(CH₂)_nSn(OH)Ph₂] (1-3; n = 1-3) with HO₃SCF₃ and HO₂PPh₂ provided [Ph₂Sn(CH₂)_nSnPh₂(OH)](O₃SCF₃) (4-6; n = 1-3) and [Ph₂(O₂PPh₂)Sn(CH₂)_nSn(O₂PPh₂)Ph₂] (10-12; n = 1-3), respectively. The reaction of [Ph₂Sn(CH₂)_nSnPh₂(OH)](O₃SCF₃) (4-6; n = 1-3) with HO₂PPh₂ and NaO₂PPh₂ gave rise to the formation of [Ph₂Sn(CH₂)_nSnPh₂(O₂PPh₂)](O₃SCF₃) (7-9; n = 1-3) and [Ph₂(OH)Sn(CH₂)_nSn(O₂PPh₂)Ph₂] (13-15; _n = 1-3), respectively. In the solid state, compounds 4-9 comprise ion pairs of cationic cyclo-[Ph₂SnCH₂SnPh₂(OH)]₂²⁺, cyclo-[Ph₂Sn(CH₂)_nSnPh₂(OH)]⁺ (n = 2, 3), and cyclo-[Ph₂Sn(CH₂)_nSnPh₂(O₂PPh₂)]⁺ (n = 1-3) and triflate anions. In MeCN, the eight-membered-ring system cyclo-[Ph₂SnCH₂SnPh₂(OH)]₂²⁺ appears to be in equilibrium with the four-membered-ring system cyclo-[Ph₂SnCH₂SnPh₂(OH)]⁺. In contrast, compounds 10-15 show no ionic character. Compounds 1-15 were characterized by multinuclear NMR spectroscopy in solution and in the solid state, IR spectroscopy, conductivity measurements, electrospray mass spectrometry, osmometric molecular weight determinations, and X-ray crystallography (4, 5, 7, and 12).

Enhancement of ion dynamics in PMMA-based gels with addition of TiO2 nano-particles

Solvent and ion dynamics in PMMA based gels have been investigated as a function of the loading of nanosized TiO₂ particles. The gels have a molar ratio of 46.5:19:4.5:30 of ethylene carbonate (EC), propylene carbonate (PC), lithium perchlorate and PMMA, respectively. A series of samples with 0, 4, 6 and 8 wt.% TiO₂ filler were investigated. The diffusion coefficients for the lithium ions and for the two solvents (EC and PC) were investigated by pfg-NMR. It was shown that the addition of filler to the gel electrolytes enhances the diffusion of the cations, while the diffusion of the solvents remains constant. Raman measurements show no significant changes in ion–ion interactions with the addition of fillers, while the ionic conductivity is seen to decrease. However, the sample with 8 wt.% TiO₂ had a conductivity close to that of the unfilled sample.

Cation dynamics in dimethyl-pyrrolidinium-based solid-state ion conductors

Dimethyl-pyrrolidinum-based salts have been investigated by means of DSC, conductivity, NMR and Raman spectroscopy. The investigation aims to study the effect of the anion on the behaviour of the salt, in terms of plastic properties as well as rotational degrees of freedom of the cation. The materials range from the non-plastic iodide salt to the highly plastic BF₄ salt, which flows under its own weight at elevated temperatures. The different rotational and translational motions of the cations, and the difference between rotator and plastic phases are discussed.

Conductivity in amorphous polyether nanocomposite materials

Using a completely amorphous polyether we have investigated the effect of the inclusion of a nano-particulate filler on a polymer electrolyte. Nano-sized TiO₂ is shown not to significantly affect the conductivity of composite electrolytes containing 1.0 or 1.25 mol/kg LiClO₄ or 1.5 or 2.0 mol/kg LiTFSI. At 1.5 mol/kg LiClO₄ a significant increase in conductivity is observed. Raman spectroscopy experiments have been used to investigate the effect of filler on ion-aggregation. Only one new vibrational mode can be assigned to the composite which is not due to the polymer electrolyte or the filler. From this work, we believe the increased conductivity observed by previous researchers as a result of filler addition may be largely attributed to the effect on the degree of crystallinity along with some disruption of ion-aggregation by the fillers in PEO based electrolytes.

FT-IR investigation of Ion association in plasticized solid polymer electrolytes

FT-IR spectroscopy has been utilized to monitor ion association in plasticized solid polymer electrolytes (SPEs). The SPEs were prepared from a random copolymer of ethylene oxide (EO) and propylene oxide (PO) and the salt lithium trifluoromethanesulfonate (lithium triflate, LiTf). Tetraethylene glycol dimethyl ether (tetraglyme) and N,N‘-dimethylformamide (DMF) were chosen as model plasticizers. Despite having a similar dielectric constant to that of the polymer host, ε ~ 5, the incorporation of tetraglyme into the SPEs resulted in increased ion association. The addition of a higher dielectric constant solvent , DMF, ε = 36.7, resulted in decreased ion association in the SPE. The effects of salt concentration (0.05−1.25 mol dm^-3) and temperature (25−100 °C) upon ion association in SPEs were also investigated. At low salt concentrations, ion association was found to increase with temperature, however, at 1.25 mol dm^-3 the temperature dependence of ion association was dominated by concentration effects. There appears to be a maximum in the fraction of “free” ions at a LiCF₃SO₃ concentration of 0.4 mol dm^-3, preceded by a minimum at approximately 0.2 mol dm^-3, consistent with the molar conductivity behavior previously observed in these electrolytes.