Evaluating irradiation dose for sterility induction and quality control of mass-produced fruit fly Bactrocera tryoni (Diptera : Tephritidae)

The sterile insect technique has been routinely used to eradicate fruit fly Bactrocera tryoni (Froggatt) incursions. This study considers whether fly quality in a mass-rearing facility can be improved by reducing irradiation doses, without sacrificing reproductive sterility. Pupae were exposed to one of five target irradiation dose ranges: 0, 40-45, 50-55, 60-65, and 70-75 Gy. Pupae were then assessed using routine quality control measures: flight ability, sex ratio, longevity under nutritional stress, emergence, and reproductive sterility. Irradiation did not have a significant effect on flight ability or sex ratio tests. Longevity under nutritional stress was significantly increased at 70-75 Gy, but no other doses differed from 0 Gy. Emergence was slightly reduced in the 50-55, 60-65, and 70-75 Gy treatments, but 40-45 Gy treatments did not differ from 0 Gy, though confounding temporal factors complicate interpretation. Reproductive sterility remained acceptable (> 99.5%) for all doses--40-45 Gy (99.78%), 50-55 Gy (100%), 60-65 Gy (100%), and 70-75 Gy (99.99%). We recommend that B. tryoni used in sterile insect technique releases be irradiated at a target dose of 50-55 Gy, providing improved quality and undiminished sterility in comparison with the current 70-75 Gy standard while also providing a substantial buffer against risk of under dosing.

Predator control promotes invasive dominated ecological states

Invasive species are regarded as one of the top five drivers of the global extinction crisis. In response, extreme measures have been applied in an attempt to control or eradicate invasives, with little success overall. We tested the idea that state shifts to invasive dominance are symptomatic of losses in ecosystem resilience, due to the suppression of apex predators. This concept was investigated in Australia where the high rate of mammalian extinctions is largely attributed to the destructive influence of invasive species. Intensive pest control is widely applied across the continent, simultaneously eliminating Australia’s apex predator, the dingo (Canis lupus dingo). We show that predator management accounts for shifts between two main ecosystem states. Lethal control fractures dingo social structure and leads to bottom-up driven increases in invasive mesopredators and herbivores. Where control is relaxed, dingoes re-establish top–down regulation of ecosystems, allowing for the recovery of biodiversity and productivity.

Stop jumping the gun : a call for evidence-based invasive predator management

Invasive mammalian predators are major drivers of species extinctions globally. To protect native prey, lethal control is often used with the aim of reducing or exterminating invasive predator populations. The efficacy of this practice, however, is often not considered despite multiple practical and ecological factors that can limit success. Here, we summarize contemporary knowledge regarding the use and challenges of both lethal control and alternative approaches for reducing invasive predator impacts. As the prevailing management approach, we outline four key issues that can compromise the effectiveness of lethal control: release of herbivore and mesopredator populations, disruption of predator social systems, compensatory predator immigration, and ethical concerns. We then discuss the relative merits and limitations of four alternative approaches that may enhance conservation practitioner's ability to effectively manage invasive predators: top-predator conservation or reintroduction, maintaining habitat complexity, exclusion fencing, and behavioral and evolutionary ecology. Considerable uncertainty remains regarding the effectiveness of management approaches in different environmental contexts. We propose that the deficiencies and uncertainties outlined here can be addressed through a combination of adaptive management, expert elicitation, and cost-benefit analyses. Improved management of invasive predators requires greater consideration and assessment of the full range of management approaches available.

Evaluation of fixed sample-size plans for Plutella xylostella (Lepidoptera: Plutellidae) on broccoli crops in Australia

Fixed sample-size plans for monitoring Plutella xylostella (L.) (Lepidoptera: Plutellidae) on broccoli and other Brassica vegetable crops are popular in Australia for their simplicity and ease of application. But the sample sizes used are often small, ≈10–25 plants per crop, and it may be that they fail to provide sufficient information upon which to base pest control decisions. We tested the performance of seven fixed sample-size plans (10, 15, 20, 30, 35, 40, and 45 plants) by resampling a large data set on P. xylostella in commercial broccoli crops. For each sample size, enumerative and presence-absence plans were assessed. The precision of the plans was assessed in terms of the ratio of the standard error to the mean; and at least 45 and 35 samples were necessary for the enumerative and presence-absence plans, respectively, to attain the generally accepted benchmark of ≤0.3. Sample sizes of 10–20 were highly imprecise. We also assessed the consequences of classifications based on action thresholds (ATs) of 0.2 and 0.8 larvae per plant for the enumerative case, and 0.15 and 0.45 proportion of plants of infested for the presence-absence case. Operating characteristic curves and investigations of the frequency of correct decisions suggest improvements in the performance of plans with increased sample size. In both the enumerative and presence-absence cases, the proportion of incorrect decisions was much higher for the lower of the two ATs assessed, and type II errors (i.e., failure to suggest pest control upon the AT is exceeded) generally accounted for the majority of this error. Type II errors are the most significant from a producer’s standpoint. Further consideration is necessary to determine what is an acceptable type II error rate.

Fabrication of ultrafine powder from eri silk through attritor and jet milling

Fibroin protein derived from silk fibres has been extensively studied with exciting outcomes for a number of potential advanced biomaterial applications. However, one of the major challenges in applications lies in engineering fibroin into a  desired form using a convenient production technology. In this paper, fabrication of ultrafine powder from eri silk is reported. The silk cocoons were degummed and the extracted silk fibres were then chopped into snippets prior to attritor and air jet milling. Effects of process control agents, material load and material to water ratio during attritor milling were studied. Compared to dry and dry–wet attritor milling, wet process emerged as the preferred option as it caused less colour change and facilitated easy handling. Ultrafine silk powder with a volume based particle size d(0.5) of around 700 nm could be prepared following the sequence of chopping ➔ wet attritor milling ➔ spray drying ➔ air jet milling. Unlike most reported powder production methods, this method could fabricate silk particles in a short time without any pre-treatment on degummed fibre. Moreover, the size range obtained is much smaller than that previously produced using standard milling devices. Reduction in fibre tenacity either shortened the milling time even further or helped bypassing media milling to produce fine powder directly through jet milling. However, such reduction in fibre strength did not help in increasing the ultimate particle fineness. The study also revealed that particle density and particle morphology could be manipulated through appropriate changes in the degumming process.

Graphical Abstract:  Fabrication of eri silk powder using attritor and jet milling is reported. Volume based particle size d(0.5) of around 700 nm could be prepared following the sequence chopping ➔ wet attritor milling ➔ spray drying ➔ air jet milling. No pre-treatments were used and the particle size range obtained is much smaller than that previously produced using standard milling devices. Particle density morphology could be manipulated through appropriate changes of cocoon degumming conditions.

Fishways in Australia

In Australian regulated rivers, dams and weirs have contributed to serious declines in the distribution and abundance of migratory fish. This thesis has evaluated four fishways in Victoria, New South Wales and Queensland and provided new information for 51 migratory fish species. Fishways will be crucial for management and conservation of biodiversity.

Cholinesterase Research Outreach Project (CROP): measuring cholinesterase activity and pesticide use in an agricultural community

BACKGROUND: Australian farmers and their workers are exposed to a wide variety of pesticides. Organophosphate (OP) insecticides are a widely used class of pesticide used for animal husbandry practices (Naphthalophos for sheep dipping, jetting and drench), crop production for pest control (Dimethoate) and in public health (Maldison for head lice). Acute poisonings with this class of insecticide are reported among agricultural workers and children around the globe, due to the inhibition of acetylcholinesterase (AChE). Less is known about chronic exposures. Regular monitoring of erythrocyte AChE will enable farmers to identify potential exposure to organophosphate insecticides and take action to reduce exposures and improve their health and safety practices. This study aims to assess and improve the integration of AChE monitoring into routine point of care health clinics, and provide farming and non-farming people with a link between their AChE activity and their household chemical and agrichemical use. METHODS/DESIGN: The research will target individuals who work on mixed farming enterprises and routinely using OPs (n = 50) and non-farmers (n = 30). Baseline data are collected regarding demographic, health conditions and behaviours, Kessler 10 (K10) scores, chemical use and personal protection. Baseline anthropometric measures include height, weight, hip and waist circumference, body fat analysis and, biochemical analysis of fasted total serum cholesterol, triglycerides, low-density cholesterol (LDL), high-density cholesterol (HDL) and blood glucose. Analysis of erythrocyte cholinesterase (EAChE) activity is also conducted using a finger prick test. Testing of EAChE is then repeated in all participants every 3 weeks for a maximum of three times over a period 10 weeks. Participants are provided with full feedback and counselling about their EAChE activity after each reading and a detailed summary provided to all participants at the completion of the study. Data will be analysed using repeated measures within a general linear model. DISCUSSION: This work will provide an evidence base and recommendations for the integration of EAChE monitoring into Australian rural health clinics, leading to research which will further quantify pesticide exposure both on the farm and in the home, highlighting the importance of sustaining and providing a safe work and home environment for farming communities. TRIAL REGISTRATION: ACTRN12613001256763.