Contact pressure and wear in sheet metal forming - an FEM analysis

Wear is the principal cause of tool failure in most sheet metal forming processes. It is well known that the contact pressure between the blank and the tool has a large influence on the wear of the tool, and hence the tool life. This investigation utilises the finite element method to analyse the contact pressure distribution over the die radius for a particular deep drawing process. Furthermore, the evolution of the predicted contact pressure distribution throughout the entire stroke of the punch is also examined. It was found that the majority of the process shows a steady state pressure distribution, with two characteristic peaks over the die radius, at the beginning and end of the sheet contact area. Interestingly, the initial transient contact pressure response showed extremely high localised peak pressures; more than twice that of the steady state peaks. Results are compared to wear reported in the literature, during similar experimental deep drawing processes. Finally, the significance and effect of the results on wear and wear-testing techniques are discussed.

Consumer complaint behaviour in sport consumption

While consumer complaint behaviour, and specifically voicing, has been extensively investigated from the perspective of goods (see Volkov et al., 2003, for a review), there have been fewer studies investigating consumer voicing with regard to services (Andreasen, 1984, 1985; Singh, 1988, 1990; Zeithaml, Berry, & Parasuraman, 1996). Further, no research can be identified in the extant literature with respect to experiential consumer voicing. This research proposes an examination of voicing behaviour of consumers in an experiential consumption setting and uses sport consumption as the context. A review of literature in the area is presented and a proposal for experiential research is offered.

In experiential consumption settings, consumers are more likely to experience emotional reactions to, and be actively involved in, the experience than in traditional consumption episodes (Addis & Holbrook, 2001; Hoffman, Kumar, & Novak, 2003; Lofman, 1991). Further, experiential consumption episodes
involve greater emotional processing, more activity, more evaluation, but less overall cognitive processing than traditional episodes (Lofman, 1991), which in turn is likely to result in different consumer behaviour in these experiential settings.

Tn this study, traditional consumer complaint behaviours are re-examined in an experiential context; specifically, consumption of live sport. It is proposed that these behaviours are not motivated by the traditional antecedents of anger and involvement and, further, that they are not enacted with the purpose of
reducing dissonance. Instead, it would appear that traditional complaint behaviour concepts such as voicing, overt aggression, and assignment of blame take on a more functional role in the sport consumption experience. The possibility exists that for some spectators these complaining behaviours that have traditionally been cJassitIed as negative, actually contribute to overall enjoyment o( and satisfaction with, a sport consumption experience.

Objections to the teaching of business ethics

To date the teaching of business ethics has been examined from the descriptive, prescriptive, and analytical perspectives. The descriptive perspective has reviewed the existence of ethics courses (e.g., Schoenfeldtet al., 1991; Bassiry, 1990; Mahoney, 1990; Singh, 1989), their historical development (e.g., Sims and Sims, 1991), and the format and syllabi of ethics courses (e.g., Hoffman and Moore, 1982). Alternatively, the prescriptive literature has centred on the pedagogical issues of teaching ethics (e.g., Hunt and Bullis, 1991; Strong and Hoffman, 1990; Reeves, 1990; Castro, 1989; George, 1987; Golenet al., 1985) and in providing recommendations for teachers of business ethics (e.g., Nappi, 1990; Hosmer and Steneck, 1989). From the analytical perspective judgments have been made as to whether courses in ethics are in fact effective in achieving value and attitudinal modifications in students (e.g., Loeb, 1991; Weber, 1990; Wynd and Mager, 1989; Pamental, 1989; Martin, 1982; Purcell, 1977). The evidence to date suggests that courses can be a means of achieving ethical awareness and sensitivity in students although it should be recognized that significant objections to the teaching of business ethics do exist and greatly inhibit their successful introduction. This paper addresses a number of the common objections to the teaching of business ethics that must be overcome if ethical programs are to continue in the future, and concludes with recommendations to facilitate the establishment of ethical training in an academic context.

What has transcranial magnetic stimulation taught us about neural adaptations to strength training? A brief review

The evidence for neural mechanisms underpinning rapid strength increases has been investigated and discussed for over 30 years using indirect methods, such as surface electromyography, with inferences made toward the nervous system. Alternatively, electrical stimulation techniques such as the Hoffman reflex, volitional wave, and maximal wave have provided evidence of central nervous system changes at the spinal level. For 25 years, the technique of transcranial magnetic stimulation (TMS) has allowed for noninvasive supraspinal measurement of the human nervous system in a number of areas such as fatigue, skill acquisition, clinical neurophysiology, and neurology. However, it has only been within the last decade that this technique has been used to assess neural changes after strength training. The aim of this brief review is to provide an overview of TMS, discuss specific strength training studies that have investigated changes, after short-term strength training in healthy populations in upper and lower limbs, and conclude with further research suggestions and the application of this knowledge for the strength and conditioning coach.

The effect of lumbosacral manipulation on corticospinal and spinal reflex excitability on asymptomatic participants

Objective The aim of the study was to examine the effects of a high-velocity, low-amplitude (HVLA) manipulation to the lumbosacral joint on corticospinal excitability, as measured by motor evoked potentials (MEPs) using transcranial magnetic stimulation, and spinal reflex excitability, as measured by the Hoffman reflex (H-reflex).

Methods In a randomized, controlled, crossover design, 14 asymptomatic volunteers (mean age, 23 ± 5.4 years; 10 men; 4 women) were measured for MEPs and H-reflexes immediately before and after a randomly allocated intervention. The interventions consisted of HVLA applied bilaterally to the lumbosacral joint and a control intervention. Participants returned a week later, and the same procedures were performed using the other intervention. Data for H-reflex and MEP amplitudes were normalized to the M-wave maximum amplitude and analyzed using 2-way analysis of variance with repeated measures.

Results A significant interaction of treatment by time was found for MEP (F1,13 = 4.87, P = .04), and post hoc analyses showed that the MEP/M-wave maximum ratio decreased significantly in the HVLA treatment (P = .02; effect size, 0.68). For H-reflex, there was a significant effect of time (F1,13 = 8.186, P = .01) and treatment and time interaction (F1,13 = 9.05, P = .01), with post hoc analyses showing that H-reflexes were significantly reduced after the HVLA manipulation (P = .004; effect size, 0.94). There were no significant changes in MEP latency or silent period duration.

Conclusion An HVLA manipulation applied to the lumbosacral joint produced a significant decrease in corticospinal and spinal reflex excitability, and no significant change occurred after the control intervention. The changes in H-reflexes were larger than those in MEPs, suggesting a greater degree of inhibition at the level of the spinal cord.

The millipedes of Barrow Island, Western Australia (Diplopoda)

Six species of millipedes are recorded from Barrow Island, including three species of pin-cushion millipedes of the order Polyxenida, Lophoturus madecassus (Marquet and Condé, 1950) (Lophoproctidae), Unixenus mjoebergi (Verhoeff, 1924) (Polyxenidae) and Phryssonotus novaehollandiae (Silvestri, 1923) (Synxenidae), a single species of the order Spirobolida, Speleostrophus nesiotes Hoffman, 1994 (Trigoniulidae), and two species of the order Polydesmida, Boreohesperus dubitalis Car and Harvey, 2013 (Paradoxosomatidae) and one species of the family Haplodesmidae (genus and species indet.). Lophoturus madecassus is circum-tropical in distribution, Unixenus mjoebergi and Phryssonotus novaehollandiae are found also on mainland Australia, but the other three species are endemic to the island. Speleostrophus nesiotes is a highly modified troglobiotic species, currently listed as threatened by the Western Australian government. It is unclear at present whether the haplodesmid specimen is a troglobite.

Using the functional independence measure to assess adults with cerebral palsy: an exploratory report

The Functional Independence Measure (FIM) was selected as an assessment to be conducted annually with adults attending The Spastic Centre of New South Wales (SCNSW), Australia, an organisation specifically for individuals with cerebral palsy. Service-providers were trained in the administration of the FIM and in the use of a customised data base. Initially 173 adults with cerebral palsy were assessed, this number included 135 individuals in supported and open employment. The FIM is currently being used to assess all adults attending the SCNSW as part of an annual review. The data from this ongoing assessment procedure will assist in lobbying government to ensure that individuals have access to the attendant care services that they require to function optimally in the community and will provide a longitudinal data base for study of some of the effects of the ageing process on individuals with cerebral palsy. A case study is presented which illustrates the use of the FIM with a couple who live independently in the community.

Fatigue crack growth in ultrafine grained aluminium alloy

The microstructure, fatigue crack growth behaviour and hardness of ultra fine grained 6061 aluminium alloy obtained by equal angle channel processing was studied. ECAP resulted in significant grain refinement down to the sub micron level and corresponding increase in hardness. Results point to a similar fatigue threshold stress intensity range and fatigue crack growth rates for 1, 2, 4 and 6 passes of ECAP.

Scalable nonparametric Bayesian multilevel clustering

Multilevel clustering problems where the con-tent and contextual information are jointly clustered are ubiquitous in modern datasets. Existing works on this problem are limited to small datasets due to the use of the Gibbs sampler. We address the problem of scaling up multi-level clustering under a Bayesian nonparametric setting, extending the MC2 model proposed in (Nguyen et al., 2014). We ground our approach in structured mean-field and stochastic variational inference (SVI) and develop a tree-structured SVI algorithm that exploits the interplay between content and context modeling. Our new algorithm avoids the need to repeatedly go through the corpus as in Gibbs sampler. More crucially, our method is immediately amendable to parallelization, facilitating a scalable distributed implementation on the Apache Spark platform. We conduct extensive experiments in a variety of domains including text, images, and real-world user application activities. Direct comparison with the Gibbs-sampler demonstrates that our method is an order-of-magnitude faster without loss of model quality. Our Spark-based implementation gains an-other order-of-magnitude speedup and can scale to large real-world datasets containing millions of documents and groups.