IFHTSE Global 21: heat treatment and surface engineering in the twenty-first century: Part 11 – survey of the heat treatment and surface engineering industry in Argentina at the beginning of the twenty-first century

Heat treatment and surface engineering are enabling technologies for modern industry in technologically developed countries. However, the technical requirements of industry in the developing countries, and particularly in Argentina, are often not so demanding. This article is an attempt to reflect the current status of heat treatment and surface engineering in Argentina at the beginning of the twenty-first century, particularly in terms of available technology and human resources. Emphasis is also given to the future prospects of this area of engineering.

Heat and mass transfer in fluidised-bed heat-treatment furnaces

The mechanisms of heat and mass transfers between heat-treatment fluidised beds and immersed workpiece were studied by using computational simulation and experimental validation. A model called Double Particle-layer and Porous Medium was developed to simulate the gas flow and heat transfer between fluidised beds and immersed workpiece.

Nanofiltration for the concentration of heat stable salts prior to MEA reclamation

While monethanolamine has shown great potential as a solvent for the capture of carbon dioxide, impurities can build within the solution over time, leading to increased viscosity and corrosivity. Classically, these impurities are removed by a combination of neutralization and either thermal reclamation, ion exchange or electrodialysis. In this work, we evaluate the use of nanofiltration to concentrate the heat stable salts within the solution prior to such reclamation. This allows the recirculating solvent to operate with low concentrations of these impurities, while providing a low volume, concentrated solution for reclamation. Results show that nanofiltration can reject greater than 80% of the heat stable anions, while allowing the monoethanolamine to permeate through the membrane, for return to the process. Rejection of the MEA itself is less than 7%. The nanofiltration operation is only effective on lean solvent with CO2 loadings of less than 0.2 and neutralization would be required upstream to deprotonate the amine. The two membranes tested (Koch MPF-34 and MPF-36) appeared stable to exposure to the solvent for over four months.

Electrospun poly(vinyl alcohol)/phase change material fibers: morphology, heat properties, and stability

A phase change material (PCM) from a mixture of plant oils was incorporated into electrospun poly(vinyl alcohol) (PVA) nanofibers using an emulsion electrospinning technique. Effects of PCM and PVA content in the emulsions on nanofiber morphology, heat properties, and phase change stability were examined. Higher PCM loadings in the nanofibers led to increased fiber diameter, gouged fiber surfaces, and higher heat enthalpies. The fibers maintained their morphological integrity even if the PCM melted. They showed reliable heat-regulating performance which can undergo at least 100 cycles of phase change. Such PCM fibers may be used for the development of thermoregulating fabrics or in passive heat storage devices.

Analytical thermal study on nonlinear fundamental heat transfer cases using a novel computational technique

In this paper a novel computational technique called Parameterized Perturbation Method (PPM) is used to obtain the solutions of nonlinear fundamental heat conduction equations. Three well known problems in the area of heat transfer are addressed to be solved. An analytical investigation is carried out for: (a) the temperature distribution in a fin with a temperature-dependent thermal conductivity, (b) the cooling of the lumped system with variable specific heat, and (c) the temperature distribution of a convective-radiative fin. The validity of the results of PPM solution was verified via comparison with numerical results obtained using a fourth order Runge-Kutta method. These comparisons revealed that PPM is a powerful approach for solving these problems. Also, the results showed that the main attributions of this method are very straightforward calculations and low computational burden compared to previous analytical and numerical approaches.